Description :
Tenders for Corrigendum : Supply Of Spares For Esp System Of Unit#1 To 4, Ctpp, Chhabra For Fy. 2025-26 - Inner Arm Assembly For Cerm & Eerm Consistsi)inner Arm Half-2 Nos.ii)hex Bolt M16x90-1 Nos.(half Threaded, Grade 4.6) Iii) Hex Bolt M16x40-1 Nos.(half Threaded, Grade 4.6) Iv) Hex Nuts M16-2 Nos.( Grade 4.6) (moc En-08 For Flats ) As Per Drawing / Sample, Outer Arm For Cerm (total Weight 8kg+/-2.5-5%)i)roller Wheel- 1 No.ii) Arm- 2 Nos.(10 Mm Thick Flat)iii)washer- 2 Nos.(45x28x3 Mm)iv)pin - 2 Nos.(l114xdia25mm Round Bar) As Per Drawing / Sample*moc En-08 For Roller Wheel & Pin And Ms For Arms & Washers, Sleeve Bearing Bracket Assy. Consistsi)sleeve Bearing/ci Liner (in Two Halves),c.i.fg-210 - 2nos.ii)ht Hex Nut+ Bolt M12x50- 2nos.iii)ms Strip (40x40x10)- 4 Nos.iv)weld Type - 6 (moc For Liner Set Is As Per Is-210 Fg-210) As Per Drawing / Sample, Set Ring (material En-08)id-50+/-0.5mm , Od-75.0m, Height-18.00mm Grub Screw,m10x15 Mm-2nos., Grip Coupling For Eerm (moc En-08 For Flat) Consistsgrub Screw M10x25 Mm -1 No.as Per Drawing / Sample, Shaft Sleeve 50 Mm (en-24)inner Dia -50+/- 0.5 Mmouter Dia-70+/- 0.5 Mmlength- 130+/-1 Mm Thickness-10 Mm,, Shaft Sleeve 40.5 Mm (en-24)inner Dia -40+/- 0.5 Mmouter Dia-50+/- 0.5 Mmlength- 120+/-1 Mm Thickness-5 Mm, Plain Bearing Assembly For Rapping Mechanism Consistsi)lower Half -01(is-210-fg 200)ii) Upper Half -01 01(is-210-fg 200)iii)hex Bolt M16x120 Mm-02 Nos (4.6 Grade Half Threded)iv)hex Nut M16 -02 Nos.( 4.6 Grade)*casting Must Be Free Of All Kinds Of Casting Defects., Top Sleeve For Emmiting Shaft Dia.40 Mm (material En-8), End Shaft For Cermdia 50mmlenth : 790mmhole Dia 17mmmaterial : En-8 As Per Drawing / Sample, Gd Screen Material As Per Is 513,crca Sheet 2.5mm (as Per Drawing),material Of Hook Ms, 4.00mm Thick, Emitting Rapping Shaft I, Emitting Rapping Shaft Ii, Emitting Rapping Shaft Iii, C.i. Liner In Two Halves (moc As Per Is 210 Fg 210), Shock Bar Guide Angle, U-guide/clamp For Collecting Electrodes, Material - Cold Rolled Ms Sheet Is 513, 2.50 Mm Thick Or As Per Drawing/sample, Screen Tube For Emmitting Drives Of Esp, Material - Ms Sheet 5.00 Mm Thick Or As Per Drawing/sample, Item Should Be Painted With Red Oxide Inner/outer Side
