Get complete information related to latest Iron Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Iron Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Iron Tenders.
Tender For corrigendum : supply of pipe line fittings - unplsticized pvc pipes for water supply conforming to is 4985 (q3) , earth work in excavation for pipe trench in ordinary soil , earth work in excavation for pipe trench in hard soil , upvc bends , upvc tees , upvc flanged tail , upvc end cap plugs , upvc coupler , valves including jointing and testing with cost of jointing material , iron double flanged slduice valves , watering lead upto 50m and lift upto 1.5 in all kind of soils , gi union cl flange, gi reducers upvc mta fta etc. , garden pipe 1 inch , installation charges
Tender For corrigendum : auction sale of depot non ferrous scrap - scrap released cut pieces of copper contact wire. all sort and size. copper 99 percent. carbon, iron and dust 01 percent. [qty on approx basis] note- delivery will be given on 1000 kgs. electronic weighing machine of non-ferrous godown. note- actual composition of various metals in the lot may vary from the percentage described above, therefore purchase may satisfy themself in all respect about quality of lot before bidding. purchasers are also advised to read and understand the para 3 of terms & conditions governing sale of scrap material through e-auction attached under depot document.
Tender For corrigendum : auction sale of depot non ferrous scrap - scrap released cut piece of copper catenary wire, jumper, dropper wire, l.s. wire, runner, catenary clips, and other ohe copper item. copper 99 percent, carbon, iron and dust 01 percent. [qty on approx basis] note- delivery will be given on 1000 kgs. electronic weighing machine of non-ferrous godown. note- actual composition of various metals in the lot may vary from the percentage described above, therefore purchase may satisfy themself in all respect about quality of lot before bidding. purchasers are also advised to read and understand the para 3 of terms & conditions governing sale of scrap material through e-auction attached under depot document.
Tender For corrigendum : auction sale of depot non ferrous scrap - scrap released cut piece of copper catenary wire, jumper, dropper wire, l.s. wire, runner, catenary clips, and other ohe copper item. copper 99 percent, carbon, iron and dust 01 percent. [qty on approx basis] note- delivery will be given on 1000 kgs. electronic weighing machine of non-ferrous godown. note- actual composition of various metals in the lot may vary from the percentage described above, therefore purchase may satisfy themself in all respect about quality of lot before bidding. purchasers are also advised to read and understand the para 3 of terms & conditions governing sale of scrap material through e-auction attached under depot document.
Tender For corrigendum : auction sale of depot non ferrous scrap - scrap mix alluminium consisting of dump valve bracket, light frames, led light, heat sink, strainer b. p. , junction box bracket, indicator wheel set, earthing equipment box, ladder, door frame pannel, tappet cover, various utensils, various distributor valve, light fitting, false ceiling beading pannel, door clouser, cut pieces of tubes, bas bar, guage, radiator, cable boxes, and various other type alluminium items. all sort and size. alluminium 98 percent, paint, plastic, iron, grease, dust and rubber 2 percent (qty.on approx basis) note-delivery will be given on 50 mts. weigh bridge of osy jhansi. note- actual composition of various metals in the lot may vary from the percentage described above, therefore purchase may satisfy themself in all respect about quality of lot before bidding. purchasers are also advised to read and understand the para 3 of terms & conditions governing sale of scrap material through e-auction attached under depot document.
Tender For supply of ferritic steel sheet 3x1250x2100mm., as per drawing: rdso spec. no. c-k201, grade x2crni12 (409m) table 1&2, heat treatment condition 2b as per table-5., packing instruction: stainless steel sheets, coils and plates:- (a) stainless steel (austenitic & ferritic steel) coils. the coil shall be protected in reasonably good condition to withstand normal handling hazard during transit with the following provision as the barest minimum: i) coil should be wrapped with a layer of water proof paper through out whole length. ii) coil should be wrapped with a layer of biodegradeable sheet. iii) outer & inner of coil should be wrapped with gi sheet. iv) side of the coil should be covered with card board sheet. v) after this whole coil should be wrapped with biodegradeable plastic sheet of suitable thickness. vi) the inner edge of the coil should be protected by gi ring followed by another iron ring. vii) outer edge of the coil should be wrapped with gi ring. viii) coil should be securely strapped with minium 5 steel bands through the eyes of the coil and minium 3 steel bands on the circumference of the eye. ix) whole coil should be mounted on wooden blocks for easy lifting/stacking. x) the sheets in coil form for thickness 2mm and above shall have: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 tonnes xi) the sheets in coil form for thickness below 2mm shall have: inner dia of coil 450-650mm outer dia of coil 1000-1300mm weight of coil5.0 - 10 tonnes. (b) stainless steel (austenitic & ferritic steel plates/sheets) i) the sheets/plates shall be supplied in bundles of optimum weight: 2mt+/-10% & each sheet/plate shall be seprated with a layer of water proof paper, after this the whole bundle should be wrapped with double layer of water proof paper and a biodegradeable plastic sheet of suitable thickness. a metal protection in edges should also be provided. ii) all bundles shall have a minimum of 2 hoops upto 1.2 meter in length and one extra hoop for every additional meter. the bundles shall also be provided with skid (wooden packing under neath) to facilitate handling. mechanical damange & corrosion during transit ifany shall be at the cost of supplier. [ warranty period: 30 months after the date of delivery ]
Tender For supply of set of water filling material as per details. 1.reducer 1.5 to 1 inch material-gi 2. hose thread connector(lenght-90mm) material-gi 3. suitable u clamp with nut. material-ss-304 4. suitable bracket as approved (thickness 3mm minimum) material-ss-304 full assembly shall be painted with fluorescent paint orange/red) sample to be approved before bulk supply. note: details are attached as annexure-a [ warranty period: 30 months after the date of delivery ]