Latest coach set Tenders | Government coach set Tenders

Central Government/Public Sector

CTN :45034298

09 May, 2026 NA

Koraput - Odisha

Tender For tender for supply o machining of 34 lines established components with hal material - plug , lever , taper , clamp , gasket , screw , bolt , nipple , pipe connection , l.h.pad.nut , pin , rod , bush , ring , nipple , ring , stud , union , stop nut , bush , bush , bush , bush , bush , bush , piston , axle , socket , jet , union , union , bush , lower clamp , rivet

CTN :45037937

11 May, 2026 NA

Samba - Jammu And Kashmir

Tender For supply of mt store e e - starter motor 24v 5kw , eng comolete gasket , piston assy compete , tie rod steering , bearing rear axle , ac fan belt , head light relay , seal tf input shaft

CTN :45042595

07 May, 2026 NA

Jamalpur - Bihar

Tender For auction sale of depot ferrous scrap - pl no. 98057054, scrap m.s. light jung kachera, rusted and pitted g.i. sheet consisting of net, spray bottle, rusted karkat, box, stopper spring, rusted rod of different sizes, switch box, fan blade, rusted off cut, rusted angle and channel, pipe, fencing, m.s. electrical fittings and other material available on the lot. condition:-(i) cutting is allowed for loading facilities only.(ii) excluding draft gear, wheel, axle and steel bobrn door if available on the lot.

CTN :45037987

11 May, 2026 NA

Patiala - Punjab

Tender For supply of one coach set of fuel level gauge as per drawing no. dmu/dpc3-9-0-312/col.ii alt. d/2 [ warranty period: 30 months after the date of delivery ]

CTN :45004668

18 May, 2026 2.32 Lacs

Kinnaur - Himachal Pradesh

Tender For supply of automobiles d d - clutch plate pressure plate with bearing for tata , pilot bearinig for tata , radiator assambley for tata , clutsh sleeve cylinder for tata , fan belt cummins for tata , feed pump assy fuel for tata , accelerator cable for tata , speed sensor gear 24volt for tata , tail light glass rh lh for tata , front axle needle bearing for tata , front axle seal for tata , ddu major kit for tata , spring brake chamber rear rh lh for tata , side view mirror rh lh for tata , radiator cap 0.5 for tata , ignition switch 24volt for tata , hand primary feed pump for tata , brake lining complete front and rear for tata 407 , wiper blade for tata 407 bs iii , fuel filter for maruti gypsy 413 , wiper blade for maruti gypsy 413 , clutch cable for maruti gypsy 413 , u j cross shaft for maruti gypsy 413 , conscentric sleeve cylinder for scorpio s10 , wiper blade for scorpio s10 , horn 24volt for tata bs iii or bs iv , welding rod 10mm for tata all vehicle , insulation tape for all vehicle , l t wire 1 mm for all vehicle , bulb parking 24 volt 21 w for all vehicle , bulb parking 24 volt 10 w for all vehicle ) /bid number : gem/2026/b/7477427 * /dated: 26-04-2026 & & / bid document 1 / 26

CTN :45037973

15 May, 2026 NA

Kharagpur - West Bengal

Tender For supply of one coach set of ic doors to drg. ed56000, alt-a. [ warranty period: 36 months after the date of delivery ]

CTN :45021169

08 May, 2026 NA

Thane - Maharashtra

Tender For supply of inductor and quench ring for rod pinion drg no. m46.21-1 for carrying out induction hardening opertio , locator for rod pinion drg no. m46.21-1 for carrying out induction hardening operation on inductoth , inductor and quench ring for partition 172-52-140-1/a with lamination for carrying out induction , inductor and quench ring for toothed coupling drg. no. 175.45. 112 with lamination for carrying out , inductor and quench ring for drum pressure 172.23. 021 for carrying out induction hardening operation , locator for toothed coupling drg. no. 175.45. 112 required for carrying out induction hardening operti , locator for worm 176.23. 051-1 required for carrying out induction hardening operation on inductothe , locator for axle 172.23. 100 for carrying out induction softening operation on inductotherm inducti , inductor and quench ring for worm 176.23. 051-1 for carrying out induction hardening operation on , locator for partition 172-52-140-1/a required for carrying out induction hardening operation on , inductor and quench ring for axle 172.23. 100 for carrying out induction softening operation on induc , locator for drum pressure 172.23. 021 required for carrying out induction hardening operation on , induction hardening/softening process development, trial and programming of defence component on in

CTN :45024826

07 May, 2026 NA

Leh - Jammu And Kashmir

Tender For supply of boq23 d d - harness assy wiring no.1 , gasket cylinder head , spring assy rear lh , joint assy axle shaft lh , switch assy starting motor , oil seal , lever assy parking brake , gasket set , housing starter , back assy rh , end steering tie rod , yoke reverse shaft , bush , horn assy high , bearing input shaft

CTN :44974379

04 May, 2026 20.00 Lacs

Medininagar - Jharkhand

Tender For meterial required for wtp - ferric alum /non ferric alum grade 4, bleaching ( aditya birla ) industrial grade (for wtp), lime ( hydrated lime ) industrial grade (for wtp), galansuta 8, 10, 12 & 16 , 20 mm, grease ( castrol /servo /nbc ), coupling tyre 15, 16 & 17 no., nut & bolt, washer, tyre coupling set different sizes, rubber ( for gasket ), copper lug (ring) 16 ,25, 35,50 mm, alluminiam lug 35, 50, 70,95, 240, 300 mm, relay ( l&t/ havels ) 110 amp. , 70 amp., contactor ( l&t/ havels ) 110 amp. , 70 amp., copper wire 3 core 50 sq.mm , 3 core 35 sq.mm, alluminium wire 4 core 50 sq.mm , 3 core 35 sq.mm, copper wire 16 sq.mm, insulation tape (pvc) red , yellow , blue, glass tape roll, cotton tape roll, transformer oil, sluce valve 150 mm, 200 mm, 300 mm, check valve 100 mm, 150 mm,, ball valve (brass ) 1/2 inch, 3/4 inch, 1 inch dia., g.i pipe nipple size 3 & 4 inch 1/2 inch, 3/4 inch, 1 inch dia., pvc end plug ( solid type ) 1/2 inch, 3/4 inch, 1 inch dia., m-seal 250 grm. pack, materials required for hand pump handle ( bharat/india mark ii ), head ( bharat/india mark ii ), pedastal ( bharat/india mark ii ), water tank ( bharat/india mark ii ), chain ( heavy ), axle ( heavy ), ball bearing, conecting rod with socket 12 mm 10 length (stainless steel ), g.i pipe ( tata/jindal/supreme ) 10 length , 32 mm dia., cylinder assembly complete set 2.5" (gun metal ), black tape 1" & 2", cylinder body2.5", rod socket ( ss) 12 mm, pipe coupling/socket ( tata ) 1.25" ( 32 mm ), front cover ( bharat/india mark ii ), check valve with washer, cylinder ring ( lather ), croom washer ( burhani/ nizora ), dlp nut bolt, plunger, handle axle (stainless steel ), check valve washer, three plate, cylinder rod, ss hexagonal bolt m-6x25 mm long, chain nut bolt

Central Government / Public Sector

CTN :45025471

07 May, 2026 NA

Puri - Odisha

Tender For supply , installation & commissioning of provision of aspiration type smoke detector (sampling point) in lavatories in place of hasp in ir coaches to rdso specification no. rdso/2008/cg-04 rev.05 or latest and design no. md22161 dated 18.08.21., one coach set consists of 1) aspirating nozzle - 04 nos, 2) adapter for aspirating nozzle - 04 nos, 3) capillary sampling connectors- 8 nos 4) trunk adapter- 4 nos, 5) safety cover for aspirating nozzle - 04 nos, make- fogpro india [ warranty period: 30 months after the date of delivery ]

Coach Set Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government / Public Sector