Latest diving wear Tenders | Government diving wear Tenders

Central Government/Public Sector

CTN :38005126

18 Nov, 2024 45.72 Lacs

Mundra - Gujarat

Tender For corrigendum : provn of 02 in nos bore wells alongwith associated items at icgs mundra - material and labour for drilling of 02 nos pilot/trial bore by direct rotary rig method including all t&p through any kind of starta (soil, kankar, boulder or soft or hard rock) down up to 150 m depth below ground level by using suitable drill bit according to levering of casing pipe including the cost of mud pit, channels, etc and disposal of soil obtained to a distance not exc. 1 km away complete all as specified. note:- (i) the drilling shall be continued up to specified depth and in case sticky clay occurs in between the drilling must be stopped and hydrologist of gws & sb shall be contacted & eggr-in-charge shall be informed.(ii)cost of this consultant shall be borne by contractor (iii) taking the samples from the bore well cutting for every 3 meter interval and every change in strata if less than 3meter. (iv) preparation of litho logs based on these samples.(v) drill time log to be prepared and prescribed., (vi) aquifer performance tests at constant discharge with draw down and recovery reading.(vii) after completion of pilot bore, the contractor shall have to arrange for electro eater logging test of each bore.(viii) contractor have also produced bore well water test report for drinking water parameters before levering of motor and pump.(note:- if water quality not found fit for domestic purpose use then all other connected items of trial bore will not be executed.) , supply assembling, jointing, lowering and fixing in the bore hole pvc casing pipe of nominal dia 315 mm (medium well) ,10 kg/cm2 working pressure, confirming to is 4985-2000 including providing pea gravel of 8 mm to 4.6mm size for packing around the casing/slotted pipe in bore well all as specified and directed. make: astral/ashirwad/ajay/sfmc, all as per item no 2.00 above but slotted pipe. , supply, assembling, jointing, lowering lead free pvc column pipes of nominal dia 65 mm, od 75 mm (min), non toxic, pressure 16 kg/cm2 with and including top and bottom adaptor (ss) and accessories like epdm ring and double ss stud all as spd and directed by engineer-in-charge. make: astral/ashirwad/ajay/sfmc, development of tube well with compressed air by means of air compressor of suitable capacity not less than 300 cfm and over pumping using suitable capacity pump to make available water free from turbidity complete all as specified and directed by engineer-in-charge., m & l for conducting yield test for the bore well by continuously pumping for 24 hours by using a submersible pump set to determine safe pumping yield and produced water test report of samples which is collect every hour complete as directed by the engineer-in-charge. [ all arrangements for yield test shall be made by contractor and cost for the same borne by contractor ], supply and fix ms reducer, bail plug, top cover made of 3mm thick ms plate for bore well in two half sections having a hole of 75 mm bore in centre to accommodate pvc pipe and submersible cable suitable for fixing to the pvc casing pipe top, electric logging and simple strata box including provision of 2 sets of ms clamps made of 50x6mm ms flat including nuts, bolts, etc. including one coat of epoxy primer and two coats of epoxy paint wherever necessary complete all as specified and directed by engineer-in-charge., supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, water lubricate, 3 phase, 10.0hp (appx) 415 volts, 50 hz with suitable submersible electric motor suitable for discharge of 2 liters per second against total head of 125m in the bore complete all as specified and directed by the engineer-in-charge. [ note : column pipe, submersible cable and control gear will be measured and paid separately]. [make: kirloskar / crompton / ksb], supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, wa

CTN :38047796

19 Nov, 2024 NA

Agra - Uttar Pradesh

Tender For corrigendum : supply of spanners, screwdrivers, rain coats, ln keys etc. for city street lighting.

CTN :38158691

23 Nov, 2024 2.26 Lacs

Multi City - Andhra Pradesh

Tender For procurement of rain coats to water supply workers of ae-hww, raiwada scheme under the control of ee - ii, water supply section of gvmc

corporations/Associations/Others

CTN :38159611

25 Nov, 2024 NA

Chennai - Tamil Nadu

Tender For echs dn shot blasting and epoxy painting of conveyor structure of bcn 55 with three coats epoxy paint including supply of paints

corporations/Associations/Others

CTN :38128291

22 Nov, 2024 49.36 Lacs

Pulwama - Jammu And Kashmir

Tender For development of link roads by way of rbm filling, providing laying wbm grade 2nd in two coats at igc lassipora, pulwama

CTN :38067339

13 Nov, 2024 NA

Nilgiris - Tamil Nadu

Tender For supply of iron gratex (25x25x6mm) along with painting (1 coat of primer & 2 coats of acid resistance

CTN :38074950

25 Nov, 2024 1.60 Lacs

Khurda - Odisha

Tender For supply of supply and fixing of 20 mm bore upvc tubes , sypply and fixing of 25 mm bore upvc tubes , sypply and fixing of 1000 litres capacity tripple layered rotational moulded polyethylene water storage tank , sypply and fixing of 25 mm bore high pressure brass float valves with polythene float ball , supply of materials for construction of brick work as per scope of work , construction of 15 mm thick water proofing compound as per scope of work , supply only integral water proofing compound for plastering or concrete work as per scope of work , supply and applying three coats of white wash on newly plastered surfaces of wall , sypply of materials required construction of concrete column as per scope of work , sypply of manpower service with materials required for form work as per scope of work , supply of materials required slabs supported on walls as per scope of work

Central Government/Public Sector

CTN :38109240

18 Nov, 2024 NA

Mumbai - Maharashtra

Tender For supply of stiffener plate of front carrier plate for aar-h-type cbc with bdg as per rdso drg. no. rds o/cg/drg/24034, alt-nil or latest. note: the item should be painted with rozc as per is:2074, foll owed by two coats of synthetic enamel paint with dft upto 160 micron as per is: 8662 (colou r - green). [ warranty period: 30 months after the date of delivery ]

CTN :37859838

20 Nov, 2024 NA

Rupnagar - Punjab

Tender For corrigendum : supply and application of insulation and allied material on boiler and its auxilliaries, turbine piping and equipments at ggsstp 4x210mw units - supply & application(including removal of damaged insulation) of lightly resin bonded rockwool confirming to is 8183 latest version on all types of surface of ducts, pipes, tubes, bends of following sizes.(single layer), 75mm thick mattresses density 120kg/m3, 50mm thick mattresses density -do-, 40mm thick mattresses density -do-, 50mm thick mattresses density 150kg/m3, supply & application (including removal of damaged plaster)of 12mm thick hardsetting plaster comprising of asbestos powder and cement over insulation of steam lines, supply & application of plain gi sheet (24 gauge) sheet confirming to is 277 latest version, over insulation to be screwed on the m.s.flat ring with self tapping screws duly joint sealed with sealant & 2 coats of bitumestic paint in inside portion of sheet including any welding work and hardware etc, supply & application of corrugated g.i. sheet (24 gauge) sheet., removal of al /gi/ribbed sheet etc.(all thickness)from all types of ducts,pipes, tubes, dampers and bends etc, application of useable dismentled gi/al/ribbed sheet over insulation to be screwed on the ms.flat rings with self tapping screws duly joint sealed with sealant, screwing, sealing & resetting of already existing al/gi/ribbed sheet including any welding work and hardware etc, to remove, supply and application of pad insulation, then to be covered with gi sheet of 26 swg thickness (gi sheet also to be supplied by contractor) for tg piping & equipment of following thickness:, i) 60mm thickness, ii) 120 mm thickness, iii) 180 mm thickness, supply & application of new g.i. sheet of 26 swg over the existing insulation, to remove existing insulation then supply & application of pad insulation only for tg piping & equipment of following thickness:, i) 60mm thickness, ii) 120 mm thickness, iii) 180 mm thickness, application of reusable removed gi sheets from turbine piping\equipment at ggsstp, repair of spray insulation of hpt, ipt and governing valves casings by supply & application of material., covering insulation mattresses with hard setting plaster comprising of asbestos fluff and cement by supply & application of material.

CTN :38057355

18 Nov, 2024 NA

Visakhapatnam - Andhra Pradesh

Tender For renovation of samagri at naval park-1) providing and fixing of tensile membrane structure using 2" and 3" dia ms box or round pipes with base plate foundation and finished with two coats of red oxide final spray painting of selected color of esdee/aspa make and the tensile fabric white multifilament polyester pvc both sides lacquered top side pvdf with 900 gsm and tensile strength of 4200n/s cm, tear resistance 450/450n, light transmission 7% of serge ferrari make inclusive of all fixture and fittings. 2) providing and installation of electrical cabling using finolex make and led lighting, outdoor garden lighting, wall washers and profile lights inclusive of all fixtures and fittings. 3) providing and installation od offices waiting area furniture tables as per the design. 4) providing and installation of officers waiting area chair as shown in the design 5) beatification on both sides of the officers waiting area by rising up the flooring with concrete mix and finished with 2' x 2' antiskid vitrified tiles and done side with 9" brick wall with antique finish and entrance side with designer wall using terracotta bricks and ms frame structure, including lighting electrical vabling and plantation with all necessary arrangement as shown in the design given by the architect. 6) providing and installation of milk booth using ms base structure and closed with 9" brick wall on all sides and gl roof cover inclusive of gypsum false ceiling 2'x2' vitrified floor tiles and lighting kitchen flat form with granite top finished with putty and painting as shown ion the design.-quantity - 1- msme exemption - yes | startup exemption - yes

Diving Wear Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

corporations/Associations/Others

corporations/Associations/Others

Central Government/Public Sector