Latest draft gear spares Tenders | Government draft gear spares Tenders

Central Government / Public Sector

CTN :38190632

09 Dec, 2024 NA

Vijayawada - Andhra Pradesh

Tender For supply of gear case complete for wag9 locos as per clw drg. no. 1209.01.013.014 alt.7 or latest (ab b drg. no. ib.011.00266, rev-2 or latest). note: clw approved sources shall only participate in the tender or supplier offers shall be considered with valid tender specific authorisation certificate from clw source s hall be submitted along with their offer. [ warranty period: 30 months after the date of delivery ]

Central Government / Public Sector

CTN :38208397

05 Dec, 2024 NA

Vijayawada - Andhra Pradesh

Tender For ht hex head bolt full threaded size: m10 x 30mm, grade: 8.8 as per is: 1364(part-2) along wi th suitable spring washer as per is: 3063 for fixing of gear case. makes: tvs/lps/unbrako/bmi/dfl. note: o ne sample set should be got approved before effecting bulk supply. [ warranty period: 30 months after t he date of delivery ]

Central Government/Public Sector

CTN :38005126

18 Nov, 2024 45.72 Lacs

Mundra - Gujarat

Tender For corrigendum : provn of 02 in nos bore wells alongwith associated items at icgs mundra - material and labour for drilling of 02 nos pilot/trial bore by direct rotary rig method including all t&p through any kind of starta (soil, kankar, boulder or soft or hard rock) down up to 150 m depth below ground level by using suitable drill bit according to levering of casing pipe including the cost of mud pit, channels, etc and disposal of soil obtained to a distance not exc. 1 km away complete all as specified. note:- (i) the drilling shall be continued up to specified depth and in case sticky clay occurs in between the drilling must be stopped and hydrologist of gws & sb shall be contacted & eggr-in-charge shall be informed.(ii)cost of this consultant shall be borne by contractor (iii) taking the samples from the bore well cutting for every 3 meter interval and every change in strata if less than 3meter. (iv) preparation of litho logs based on these samples.(v) drill time log to be prepared and prescribed., (vi) aquifer performance tests at constant discharge with draw down and recovery reading.(vii) after completion of pilot bore, the contractor shall have to arrange for electro eater logging test of each bore.(viii) contractor have also produced bore well water test report for drinking water parameters before levering of motor and pump.(note:- if water quality not found fit for domestic purpose use then all other connected items of trial bore will not be executed.) , supply assembling, jointing, lowering and fixing in the bore hole pvc casing pipe of nominal dia 315 mm (medium well) ,10 kg/cm2 working pressure, confirming to is 4985-2000 including providing pea gravel of 8 mm to 4.6mm size for packing around the casing/slotted pipe in bore well all as specified and directed. make: astral/ashirwad/ajay/sfmc, all as per item no 2.00 above but slotted pipe. , supply, assembling, jointing, lowering lead free pvc column pipes of nominal dia 65 mm, od 75 mm (min), non toxic, pressure 16 kg/cm2 with and including top and bottom adaptor (ss) and accessories like epdm ring and double ss stud all as spd and directed by engineer-in-charge. make: astral/ashirwad/ajay/sfmc, development of tube well with compressed air by means of air compressor of suitable capacity not less than 300 cfm and over pumping using suitable capacity pump to make available water free from turbidity complete all as specified and directed by engineer-in-charge., m & l for conducting yield test for the bore well by continuously pumping for 24 hours by using a submersible pump set to determine safe pumping yield and produced water test report of samples which is collect every hour complete as directed by the engineer-in-charge. [ all arrangements for yield test shall be made by contractor and cost for the same borne by contractor ], supply and fix ms reducer, bail plug, top cover made of 3mm thick ms plate for bore well in two half sections having a hole of 75 mm bore in centre to accommodate pvc pipe and submersible cable suitable for fixing to the pvc casing pipe top, electric logging and simple strata box including provision of 2 sets of ms clamps made of 50x6mm ms flat including nuts, bolts, etc. including one coat of epoxy primer and two coats of epoxy paint wherever necessary complete all as specified and directed by engineer-in-charge., supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, water lubricate, 3 phase, 10.0hp (appx) 415 volts, 50 hz with suitable submersible electric motor suitable for discharge of 2 liters per second against total head of 125m in the bore complete all as specified and directed by the engineer-in-charge. [ note : column pipe, submersible cable and control gear will be measured and paid separately]. [make: kirloskar / crompton / ksb], supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, wa

CTN :37971234

15 Nov, 2024 NA

Ramgarh - Jharkhand

Tender For bid to ras supply of repair of vehicles - crown wheel bearing , tail bearing small , rear shalf oil seal , transfer case oil seal , clutch cylinder assy , slave cylinder booster assy , water pump assy , brake booster rear , air filter , stopper cable , rear view mirror , acelerator cable , wiper motor , tail light assy , wiper blade , gear lever kit , self starter overhaul , oil filter , fuel filter , water separator , clutch plate , pressure plate with release bearing , fly wheel ring , bty on off switch , four by four cable , main oil seal , air dyer assy , fog light assy , rotator switch

Central Government/Public Sector

CTN :37969356

20 Nov, 2024 NA

Bhandara - Maharashtra

Tender For corrigendum : supply of spares for ir air compressor - airend 226 mm rebuild 39632211 , element air filter 23487457 , element separator 23545841 , coolant filter r-series 23424922 , o ring 95023396 , o ring 23404817 , gasket gear case to motor 39454558 , coolant ultra 20 ltrs 38459582 , seal shaft 89292445 , sleeve motor shaft 89292478 , o ring 95022125 , o ring 95023388

CTN :38191010

12 Dec, 2024 NA

Kolkata - West Bengal

Tender For supply of one rake set of mr300 series gear case hardware items as per annexure-1 per mtro railway s drawing no. (1) mr/poh/ac-1-021, (2) mr/poh/ac-0-013 (3) mr/poh/ac-0-012 (4) mr/poh/ac-0-011 [ wa rranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38191215

04 Dec, 2024 NA

Multi City - Multi State

Tender For supply of sealant of gear case assly. of emd locos.dc 3 - 0100 rtv silicone sealant (dow corning) or loctite 5910 (loctite) as per rdso. inst. bulletin no.mp.ib.en.02.06.09 (rev.02 ) dt.26.04.2019 or late st. (the residual shelf life of item should be minimum of 12 months) [ warranty period: 12 months afte r the date of delivery ]

Central Government/Public Sector

CTN :38190234

25 Nov, 2024 NA

Multi City - Multi State

Tender For supply of cardium compound for gear case of traction motor of (1) bpcl -gr. bharat camex compo und f. (2) hpcl - gr. gear tak 2/hytak 2 [ warranty period: 30 months after the date of delivery ]

CTN :38175901

02 Dec, 2024 NA

Gurdaspur - Punjab

Tender For supply of as per bid - needle brg nk 55 35 knuckle brg , cross kit spider brg , flexible bush for mtg bkt rh lh tfr case mtg bush , bush bolt for tfr case mtg bush , mounting rh rear , 4x4 gear lever rep kit , rectifire plate , regulator for alternator , rectifire

CTN :37881590

30 Nov, 2024 NA

Jabalpur - Madhya Pradesh

Tender For corrigendum : supply of 6095893 catch for hopper automatic , m2 bof 5063816 stop actuating crank ring breech , m2 bof 6110090 roller for hopper automatic , m2 bof 6097952 plunger retaining cover casing breech , m2 bof 6097944 plunger firing for casing breech , m2 bof 5049395 lever operating breech lever casing b , m2 bof 5049172 cover for casing breech , m2 bof 6097131 spring return catch loader automatic , m2 bof 6125522 lever lower for hopper automatic , m2 bof sp 2x10 pin cotter split sp 2x10 , m2 bof 6137591 plate guide hand operating gear arc pawl , m2 bof 6095894 lever lifting feed arm for hopper automatic , m2 bof 6095451 lever cocking outer ring breech assy , m2 bof 6006850 loop lock eccentric u2 12 no 3b , m2 bof 5111757 rammer rod loader automatic , m2 bof 6100400 collar frame guard , m2 bof 6097926 catch locking mm casing breech , m2 bof fs 8x35 screw csk head fs 8x35 , m2 bof 6146356 ring spring , m2 bof fs 8x40 screw csk head fs 8x40 , m2 bof 6067006 eye screwed 10 mm hole casing breech , m2 bof n5 13 10x15x44 spacer bearing n5 13 10x15x44 , m2 bof 6135093 pawl for loader automatic , m2 bof 6110053 handle for hopper automatic , m2 bof 6137588 pawl hand operating gear arc loader a , m2 bof 6137351 plunger for loader automatic , m2 bof 5061219 2 shaft breech opening lever loader automatic , m2 bof 6110063 lever gate right for hoper automatic , m2 bof 6146479 pawl for hopper automatic , m2 bof 6139884 spring return firing lever for casing breech , m2 bof 6120149 stud stop for casing breech , m2 bof 6115923 plunger for stay ammunition , m2 bof 5051009 ring seating barrel assembly , m2 bof 6095910 lever top for hopper automatic , m2 bof 6097101 roller for loader automatic , m2 bof 6112129 plunger return stop lever for loader automatic , m2 bof 6146430 plunger block for hopper automatic , m2 bof 6135078 2 lever operating rammer cocking lever , m2 bof 6115424 spring striker outer for ring breech assembly , m2 bof 6120151 bolt feed arm bracket for hopper automatic , m2 bof 6089160 screw anchor pin for ring breech assembly , m2 bof 6146425 plunger cartridge aperture cover , m2 bof 6144971 roller for head automatic cocking rammer , m2 bof 6095452 lever cocking inner for ring breech assy , m2 bof 6242247 spring loader automatic , m2 bof n5 13 15x21x30.5 spacer bearing n5 13 15x21x30.5 , m2 bof 6112140 plunger rammer stop pawl for loader automatic , m2 bof 6095911 lever hand release for hopper automatic , m2 bof 6095454 striker for ring breech assembly , m2 bof 6112126 2 lever trip case ejection for loader automatic , m2 bof 6095898 bearing rear right for hopper auto , m2 bof 6135086 lever feeding for loader automatic m2 bof 6083112 40mm aa gun l 70 bush assy ring breech assy , m2 bof 6097933 bush operating lever for casing breech , m2 bof 6115925 spring for stay ammunition , m2 bof 6242245 rod connecting, m2 bof 6095461 spring safety plunger ring breech assy, m2 bof 6095880 2 stop hopper automatic , m2 bof 6095869 pawl small for hopper automatic , m2 bof 6095459 washer roller for ring breech assy , m2 bid details/ 2 / 66

Draft Gear Spares Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government / Public Sector

Central Government / Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector