Tender For corrigendum : supply of spares for abc electricals pvt ltd make flpstarter drillcontrolpanel gateendbox lightingtransformer - chasis wired up with all components fdb 100a dol , isolator reversing 300a fdb 101 c dol , sensetive earth leakage relay up to 750 ma fdb 114ma dol , main contactor 90 150 hp fdb 102 b dol , main contactor kit for 90 150 hp fdb 102 b2 dol , thermal overload ct operated fdb 109bn dol , isolator reversing 300a fsd 101c sds , internal chasis wired up 150kw 200hp fsd 136 sds , contactor for 100 175 hp fsd 102a sds , contactor kit for 100 175 hp fsd 102 a2 sds , contactor for 190 250 hp fsd 102b sds , transformer panel with all components but without transformer , transformer only , electromagnetic earth leakage system , earth leakage relay , pilot relay , bridge rectifier unit , diode , condenser , relay base with wiring , hrc fuse base with carrier , main contactor 25 amps , contactor spare kit 25 amp , thermal overload relay , neutral resistor , resistance for pilot relays , test reset microswitch , leakage indication lamp , leakage indication lamp holder , 30a restrained plug and socket complete , terminal with insulator bushing , bush insulator for terminal , isolator switch 40 amps , front cover bolt , top cover bolt , sensitive earth leakage relay up to 750 ma , sensitive cbt for 750 ma earth leakage relay , mechanical latch type earth leakage relay with contact block , isolator reversing 200a , isolator reversing 300 a , copper busbar 300a with sleeving r y b , 150a restrained plug and socket complete , main contactor 200 amps , auxiliary contactor , magnetic overload relay , sensitive cbt for earth leakage relay 750 ma , selenium bridge rectifier , auxiliary transformer 100va , auxiliary transformer 150va , auxiliary transformer 250va , ct for overload , test microswitch , start stop microswitch , chasis wiring complete with all components including elr cbct , single phase preventor , plug and socket assy. comp. 200 amp sdl side , plug and socket assy. comp. 200 amp geb side , pt for lighting transformer 400va 550v 12v 24v sdl side , fail safe relay to ensure continuity between neutral and the ground , transformer panel complete with all component without transformer , internal chasis wired up with all protections , control transformer , terminal with insulatar incoming throughgoing interconnecting , outgoing terminal , copper busbar with sleeving r y b , isolator switch , earth leakage relay sensitive up to 750 ma , throughgoing cable box with gland and lead cone , sensitive cbt for 750 ma earth leakage relay
Tender For supply of electrical protective devices - electrical protective devices ( l & t / legrand / indoasian), mcb single pole, a) 1 a, b) 2 a, c) 3 a, d) 6 a, e) 10 a, f) 16 a, g) 20 a, h) 25 a, i) 32 a, j) 40 a, k) 63 a, mcb double pole, a) 1 a, b) 2 a, c) 3 a, d) 6 a, e) 10 a, f) 16 a, g) 20 a, h) 25 a, i) 32 a, j) 40 a, k) 63 a, mcb tpn , a) 10 amp, b) 16 amp, c) 20 amp, d) 25 amp, e) 32 amp, f) 40 amp, g) 63 amp, mcb triple pole three phase, a) 10 amp, b) 16 amp, c) 20 amp, d) 25 amp, e) 32 amp, f) 40 amp, g) 63 amp, mcb single pole iron box (mds/l&t/indo asian/havel s/siemens/legrand), mcb d.p. iron box (mds/l&t/indo asian/havel s/ siemens/legrand)), mcb tp iron box, mcb four pole iron box, mcb 6 way box (mds/l&t/indo asian), mcb 8 way box (mds/l&t/indo asian), mcb 12 way box (mds/l&t/indo asian/ siemns), mcb tpn db 12 way box (mds/l&t/indo asian), icdp main switch 16 amp. fuse type, icdp main switch 32 amp. fuse type, ictp main switch 32 amp. fuse type, ictp main switch 63 amp. fuse type, ictp main switch 100 amp. fuse type, ictp main switch 200 amp. fuse type, kit-kat 15 amp. 250 volt, kit-kat 30 amp. 440 volt, kit-kat 63 amp. 440 volt, kit-kat 100 amp. 440 volt, kit-kat 200 amp. 440 volt, motor protection circuit breaker . as per is/iec : 60947-4-1 (l&t/indo asian/siemens/legrand), a) 0.4 to 0.63 amp, b) 0.63 to 1.6 amp, c) 1.6 to 2.5 amp, d) 2.5 to 4 amp, e) 4 to 6 amp, f) 5.5 to 8 amp, g) 7 to 10 amp, h) 10 to 13 amp, i) 13 to 18 amp, 1) star delta starter 10 h.p. (l&t/ siemens), 2) dol starter(0.5 hp to 5hp), 3) 4 pole contactors 16 amp, 4) 4 pole contactor 25 amp, 5) 4 pole contactor 40 amp, 6) 4 pole contactor 95 amp, 7) 4 pole contactor 125 amp, 8) contactors for 10 hp motors (mk), 9) on delay timer (eletx), 10) off delay timer (eletx), 11) timer (3-10 sec), a) c - channel for mounting mcb & contactor within panel, b) d rail channel for mounting mcb, mpcb & contactors, relay within panel., hrc fuse, a) 4a, b) 6 a, c) 10 a, d) 16 a, e) 20 a, f) 25 a, g) 32 a, h) 40 a, i) 63 a, j) 100 a, k) 200 a, m) 400 a, fuse wires, a) 5 a;, b) 10 a;, c) 16 a;, d) 25 a;, e) 32 a;, f) 63 a;, over load relay as per is/ iec : 60947-4-1 ( l& t, siemens, legrand, indoasian), a) 0.4 to 0.63 amp, b) 0.63 to 1.6 amp, c) 1.6 to 2.5 amp, d) 2.5 to 4 amp, e) 4 to 6 amp, f) 5.5 to 8 amp, g) 7 to 10 amp, h) 10 to 13 amp, i) 13 to 18 amp, mccb four pole ( l& t, siemens, legrand, indoasian), a) 32 amp, b) 40 amp, c) 63 amp, d) 100amp, e) 125amp, f) 200 amp, g) 250 amp, h) 400 amp, elcb ( l& t, siemens, legrand, indoasian), a) dp 16 amp, b) dp 25 amp, c) dp 40 amp, d) fp 16 amp, e) fp 25 amp, f) fp 40 amp, g) fp 63 amp, h) fp 125 amp, rccbconforms to is : 12640 & iec 61008-1,degree of protection : ip 20,sensitivity rating : 30ma / 100ma / 300ma short circuit with stand capacity of 10ka with scpdon-off indication,test button t is provided for periodic check up, a) dp 25 amp, b) dp 40 amp, c) dp 63 amp, d) fp 25 amp, e) fp 40 amp, f) fp 63 amp, switch fuse unit three phase, hrc type (l & t, indoasian, siemns), a) 125 amp, b) 200 amp, c) 400 amp, level cotroller (l & t, siemens, gic, ), a) for single tanks control, b) for two tanks control, level sensing probes (ss), level monitoring switches, floating switch with two contacts (no+ nc), magnetic level sensing probe, electronic timer chrono (radix, gic, siemens, schnider), electronic timer astrological (radix, gic, siemens, schnider), vertical tpn db with provision for mccb upto 125 aas incomer (indoasian /havells/siemens), a) 4 way, b) 6 way, c) 8 way, earthing plate, 1) copper 300x300x3, 2) copper 600x600x3, 3) g.i. plate 600x600, 4)g.i. bare conductor, 5)copper bare conductor (10swg), 6)g.i. strip, 7)copper strip
Tender For re babbiting-dismantling of bearings and pads from housing,rebabbiting of 10 nos tgb thrust pad along with all accessories,rebabbiting of turbine guide bearing, mid bearing & end bearing along with floating seals and all accessories,material composite test, ut test and dp test should be done for re-babbitted material,assembly of re-babbited bearings with blue match,submitting the video graphs of re-babbiting and reports of re-babbiting.re-alignment-the reason for shifting of generator shaft by 2 to 3 mm shall be analyzed and rectification works needs to be carried out,complete dismantling, assembling, painting and re-alignment of machine shaft,inspection of turbine shaft journal surface and repairs if required,inspection/replacement of worn out bushes and seals of guide vane, if necessary,inspection and repair of labyrinth ring, face plates, guide vanes and runner,guide vanes bed setting,tgb water cooler descaling work to improve the efficiency of cooler,complete assembly of machine,checking the magnetic axis of the generator and to ensure its alignment, checking of the unit leveling at all places and complete alignment of machine shaft,testing & commissioning of complete machine,painting of entire machine,checking of vibration & site balancing of machine,submission of vibration, balancing & alignment reports.flow switch-supply and installation of flow switch (flow rate110 lpm) along with 01 no 01 nc contact for inlet and outlet lubrication oil pipelines,supply and installation of pressure switch (30bar) for inlet and outlet lubrication oil pipelines,supply and installation of level switch for in tgb oil sump.replacement of new miv trunion shaft-dismantling of miv counter weight, miv servomotor assembly, and other related parts,lifting of miv from the bed,transportation of miv to the firms place, if required,replacing old nitrile rubber trunnion seals with existing profile by new one on both sides,replacements of miv trunnion shaft. providing of necessary drawings,material composite test, ut test and dp test should be done for new trunnion shaft & trunnion seals, bushes etc,all related fasteners and dowel pin to be replacing by new one,drive and non drive end trunnion bush, cupseals, stop end plate, washer ring etc need to be replacing by new one,repair of miv discand main body to be attended, if required,supply and replacement of miv disc rubber seal,pressure testing and commissioning should be carried out as per standard in presence of kpcl engineers,all tools & tackles required for the above mentioned works shall be arranged by contactor only.
Tender For supply of electro magnetic contactor assembly with two aux. contact blocks to clw's drawing no.- 1 twd.291.033, alt. 8 and spec. no. 4tes.291.001 dated 02.12.94 with alt. 6 dated 30.7.99 or latest, type -291.01, capacity - 80 amps. [ warranty period: 30 months after the date of delivery ]
Tender For supply, installation and commissioning of microprocessor based electro magnetic contactor ( emc) test bench as per technical specification uploaded as annexure-i. [ warranty period: 30 months aft er the date of delivery ]
Tender For supply of magnetic contactor 9a 110vac , magnetic contactor 9a 230vac , magnetic contactor 12a 230vac , magnetic contactor 22a 230vac , magnetic contactor 32a 230vac , magnetic contactor 38a 230vac , magnetic contactor 70a 230vac , magnetic contactor 140a 230vac , magnetic contactor 170a 230ac , magnetic contactor 400a 415vac , magnetic contactor 9a 24vac , magnetic contactor 12a 24vac , magnetic contactor 32a 24vac , magnetic contactor 9a 24vdc , magnetic contactor 12a 24vdc , solid state relay dc , solid state relay ac , pid controller 4 to 20ma , pid controller ssr output , magnetic contactor 110a 230vac
Tender For supply of non magnetic shim for e.m.contactor as per clw drg.no. 4twd.291.030 alt-2. [ warranty period: 30 months after the date of delivery ]