Latest explosive vapor detector Tenders | Government explosive vapor detector Tenders

Central Government And Public Sector

CTN :39429490

14 Mar, 2025 NA

Kaiga - Karnataka

Tender For supply of low voltage card section , high voltage module type , area gamma radiation indicating meter with auto ranging type , mains transformer with line filter card type , detector assembly , 6 digit degital electromagnetic counter 12 v , photo-multiplier tube

State Government

CTN :39388359

28 Feb, 2025 60.00 Lacs

Katra - Jammu And Kashmir

Tender For supply installation testing and commissioning of 01 no of table top powder xrd at school of physics smvdu kakryal katra - supply and installtion of table top powder xrd with detailed specifications as follows:, x-ray generator: max. continuous rated output: 600 w guidance based software system, voltage: 20- 40 kv with increment of 1kv / current: 2 15ma with increment of 1ma (variable voltage and current). ht stability better than +/-0.01% for mains stability +/- 10 %.x-ray tube:cu target with 1000w and k-beta filter, should be upgradable for cr, co & fe.goniometer:high precision, vertical type, goniometer with theta two theta geometry, range: -3 to +1400 or better, radius: 150mm, scanning speed: 0.01 ~ 100 degree/min, max scanning speed: 500deg/min, sollar slit(incident & receiving): 2.5 deg, incident height limiting slit(dhl): open (10mm), necessary software and hardware for diagnostics capable of checking the equipment parameters/ calibration etc.divergent slit:variable to keep the x-ray illumination of sample same from low angle to high angle of 2 theta. detector:high speed silicon strip detector, it should work in 1d mode. also fluorescence reduction mode should be available. cu efficiency 99% samples holder: glass (0.2mm) qty 20, glass(0.5mm)-qty -20, aluminum (20 mmx20 mm) hole - qty 20, low background si sample holder- qty 02software: guidance based software system software should have a provision for the following: 1) all active operations should be controllable through the software 2)simultaneous data collection and data processing facility. facilities for peak search, peak match, and pattern treatment such as data smoothing, background subtraction, 2 correction, 3d multiple pattern display, k 2 calculation and removal, integrated intensity calculation, relative intensity ratio (rir) quantitative analysis and crystallite size. xrd-rietveld analysis. hybrid search / match algorithms which combines the features of peak based and profile based, phase identification techniques. it offers improves, qualitative analysis performance which makes, identification of crystalline phase with preferred, orientation or a complex lattice deformation.computer systems:latest pc along with latest operating system (latest 8.1 or 10), laser colour printer, necessary software for operation and data acquisition, analysiscod-data base:software is compatible with cod (crystallography open database) which is available on internet. (internal /external ) chiller:suitable compact for smooth running of xrd ups: online 6kva with 30 mts. backup.installation and commissioning: the instrument to be installed tested and commissioned by representative of supplier at our premises to the satisfaction of user free of cost.training: the supplier should provide the training on site free of cost.safety:the system should be housed in a high safety standard radiation enclosure as per international norms.warranty: at least one year from the date of installation(the supplier should provide the certificate of successful installation of benchtop xrd from the head of the department of concerned government labs/ institutes. )

Central Government/Public Sector

CTN :39171113

03 Mar, 2025 1.80 Crore

Secunderabad - Telangana

Tender For corrigendum : replacement of security equipment installations at dmde office complex under ge i rnd kanchanbagh, hyderabad - supply and fixing of electric fencing - 520 rm as specified below as per site requirement including taking down existing fencing with all connected accessories viz. energizer, boom barrier, hydraulic tyre killer, turnstile gate, swing lane barrier, fencing posts, fencing wire, insulators, door frame metal detector etc, complete all as specified and directed by engineer-in-charge., (a) general description(a) this scope involves, design, supply, installation, testing and commissioning of a non-lethal high security. electrical fencing for the purpose of deterrence, detection, and movement control of people / unwarranted trespassing into the premises for 520-meters perimeter length.(b) anyone who touches the power fencing when the system is armed shall be repelled by a short, sharp, painful, but safe pulsed dc high voltage shock. alarms shall be generated when someone touches, tries to climb through or tampers with the power fencing system., (c) the electric fencing shall be divided into two zones.(d) this system should be able to alert security personnel of an attempted intrusion and identify the zone around the perimeter of the site.(e) the electric fence is to be installed on the existing wall and the height of the fence will be 1.1 meters from top of the wall with 11 nos. of fence wires having 100mm gap between adjacent wires and it measure 1mtr.(f) electric fence posts are to be hot dip galvanized., (g) distance between strain fence posts spacing shall not exceed 50-meter nominal.(h) distance between intermediate fence posts spacing shall not exceed 3-meter nominal.(j) the electric fence shall incorporate uv stabilized intermediate post insulators.(k) warning signs shall be mounted around the fence line at intervals not exceeding 10m or at every turn on the physical fence.(l) dual zone fence energizer shall be installed to create 2 zones at site., (m) one dual zone led keypad shall be connected to fence energizer for local control and programming purpose.(n) a touchscreen controller should be placed in control room. fence energizer should communicate with touch screen controller over rs485 network.(o) the space between adjacent wires on the electric fence shall be no more than 10cm.(p) anti-climb configuration at strain points shall be provided. electric fence wire shall be looped around the strain post and connected back onto itself.(q) all high voltage impulse wiring shall be run in conduit separate from any other wiring.(r) the fence energizer shall be mounted in the weatherproof enclosure.(s) the energizer should comply with iec 60335-2-76 and is302-2-76 standards., (b) technical specification (electric fence system):energizerthe fence energizer should have the following minimum features: energizer should be dual zone with independent zone control. energizer should communicate with control room on rs485 network. energizer should have lcd display with background colours which changes according to the status of the energizer. green colour should indicate that all is fine, orange indicate that attention is required and red indicates an alarm condition., energizer should display the following information when specific codes are inserted from keypad: fence health on a scale of 1 to 9 for each zone independently, fence output voltage, fence return voltage, energy stored, capacity used and battery voltage. output energy 3.7 joule with 500 ohms load. pulse interval 1 sec. pulse duration should be less than 0.1ms. energizer should have apt - adaptive power technology functionality. which means the energizers should offer a unique technology to detect how much power a fence can accept and handle before it starts to arc and waste energy. this maximises the power on the fence and minimises false alarms., individual high voltage transformer for each zone. magnetic tag switch should be provided for on/off the ene

CTN :39403766

11 Mar, 2025 NA

Jammu - Jammu And Kashmir

Tender For supply of spanner combination pack of 23 , torque wrench , electrical insulation rubber mat size 1x1 meter , heavy duty double wheeled bench grinder , electric change over switches 100a 415v 4 pole , high voltage resistant electrician work gloves , electric planer 650w , metal drill bit set of 10pc , electric impact drill machine 600w , dc voltage detector for veh , digital vernier caliper 0 to 150mm , measuring tape , ac dc clamp meter

Central Government/Public Sector

CTN :39163773

24 Feb, 2025 3.10 Lacs

Angul - Odisha

Tender For corrigendum : supply of electrical items like tester auxiliary contactor relay etc - hand driven generator type insulation tester meggar , tong tester digital clamp meter , digital earth resistance tester , analog hand driven earth resistance tester , portable type single phase inverter type welding machine , auxiliary contactor relay , potential transformer , main contactor , thermal overload relay , auxiliary contactor relay 220 volt , non contact type high voltage line detector , 2 pole mcb 20a , single pole mcb 6a

CTN :39322327

04 Mar, 2025 NA

Bardhaman - West Bengal

Tender For procrument of balance valve seating and bush with screw cast steel valve - balance valve for pluro 3 pump , seating and bush with screw bb for pluro 3 pump , neck ring with screw for pluro 3 pump , neck bush with screw moc bb for pluro 3 pump , pair of sleeve de nde moc ss410 for pluro 3 pump , one logging ring brass for pluro 3 pump , impeller for pluro 3 pump , detector high voltage non contact 230 33 kv , fuse pt 3.3kv 3a , shaft sleeve de for mla 100x125 pump , shaft sleeve nde for mla 100x125 pump , split bush for gland for mla 100x125 pump , clamping plate for mla 100x125 pump , brake band for rana 90kw haulage , worm wheel for u1200gear box , cast steel foot valve,size 6inch,body pressure 900psi, , bush bearing for rms125x300pump , impeller for rms125x300pump , balance valve for rms125x300pump , balance disc for rms125x300pump , shaft sleeve de for rms125x300pump , shaft sleeve nde for rms125x300pump , neck ring for rms125x300pump , neck bush for rms125x300pump , 1st reduction pinion and gear set of helical gear box for haulage , 2nd reduction pinion and gear set of helical gear box for haulage

corporations/Associations/Others

CTN :39323653

06 Mar, 2025 NA

Donimalai - Karnataka

Tender For supply of insulation tester,insulation tester,insulation tester,insulation tester,non-contact high voltage detector,non-contact high voltage detector,non-contact high voltage detector,non-contact high voltage detector,insulation tester,insulation tester,insulation tester,insulation tester,insulation tester,insulation tester,insulation tester,insulation tester

Central Government And Public Sector

CTN :39278075

03 Mar, 2025 2.28 Lacs

Ramgarh - Jharkhand

Tender For supply of non contact voltage sensor, 100-600v ac , voltage detector, non contact, 240v , high volt test kit, 11- 400kv , safety rescue hook, non-conductive

CTN :39164832

20 Feb, 2025 NA

Kamrup - Assam

Tender For supply of wire stripping plier - wire stripping plier , fins straightener , refrigeneration leak detector , clamp meter , thermometer sy , thermo hygrometer h , digital thermometer mt 4 , capillary gauge ss , copper stick super , brazflux fh-io ioogms , flaring tool and swaging tool set , gauge maniford set 4 ioa , ratchet spanner , voltage alert , charging hose pipe set , taparia l key set , high pressure coupler for automobile ac , low pressure coupler for automobile ac , safety googles , tool bag , relay , olp , capacitor each qty 36 mfd 45 mfd 50 mfd , coil cleaner , crimping tool , co2 cylinder , regulator , mig wire 1.2 mm

Explosive Vapor Detector Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government And Public Sector

State Government

Central Government/Public Sector

Central Government/Public Sector

corporations/Associations/Others

Central Government And Public Sector