Latest fuse set Tenders | Government fuse set Tenders

CTN :38497470

21 Dec, 2024 NA

Kasganj - Uttar Pradesh

Tender For corrigendum : the work of supply & erection/installation of tail less unit, d.o. fuse set, boots and sleeves & diffrent types of material use in dtr protection (bp 2024-25 phase-ii) edd i & edd (rural) kasganj under the juridiction of edc, kasganj on semi turn-key basis. - supply of material by the contractor, do fuse set, m.s. top channel (125x65x2240 mm.), holding clamps for ms top channel, tail less unit 500a/650v with fitting suitable for pcc/stp pole., nut, bolt & washer, m.s. angel with clamp and nut & bolt, m.s. earthing with earth rod as per respo norms, boots & sleeves, al lugs 120 sq.mm, distribution panel box no.2 circuit with stud type tail less unit 500 amp, 650 v with brass holding studs, copper contacts, height of tail less unit 48 inch width 3 inch and pannel size h-1650+300 mm, w-750 mm, d-520 mm & thickness of crca sheet gauge 14x16 along with alu busbar of size 50x6 mm for phases & neutral with color code heat shrink sleeve and mounting stand of 40x40x5 mm ms angle with earthing arrangement., distribution panel box no.3 circuit with stud type tail less unit 500 amp, 650 v with brass holding studs, copper contacts, height of tail less unit 48 inch width 3 inch and pannel size h-1650+300 mm, w-1400 mm, d-520 mm & thickness of crca sheet gauge 14x16 along with alu busbar of size 50x6 mm for phases & neutral with color code heat shrink sleeve and mounting stand of 40x40x5 mm ms angle with earthing arrangement., safe carriage of following/ any other material from electricity store center soron/etah/aligarh to pit site of work from the kaccha & pakka road including loading & unloading at the respective ends including the cost of arrangement of labour, t&p etc. which required for topper completion of work., lt xlpe cable al. 1x120 sq.mm., acsr weasel conductor for jumpering, erection of material, erecetion/installation of d.o. fuse set, fixing of m.s. top channel (125x65x2240 mm.) with all accessories., foundation of distribution panel box no.2 circuitwith fixing arrangement & replacement of cable with lugs., foundation of distribution panel box no.3 circuitwith fixing arrangement & replacement of cable with lugs., fixing of tail less unit 500a/650v with fitting suitable arrangement like bus bar etc. for pcc/stp pole., erection of m.s. earthing with earth rod as per respo norms.

corporations/Associations/Others

CTN :38579981

21 Dec, 2024 32.00 Lacs

Garhmukteshwar - Uttar Pradesh

Tender For for various works regarding do. fuse set tailless unit dp/mcb etc and other associated works 07 nos. works. in business plan 2024-25 in the area of edd garhmukteshwar under edc hapur

State Government

CTN :38542862

24 Dec, 2024 68.86 Lacs

Noida - Uttar Pradesh

Tender For maintenance of w/s (rewinding of vt motors, tpmo, transformer, fuse set cable, lighting and other allied work at network sector- 86, 87, 88, 89, 150 and 168), noida (for two year)

State Government

CTN :38503384

31 Dec, 2024 72.24 Lacs

Medininagar - Jharkhand

Tender For supply of electric line materails - electrical items :, connector pipe to panther, connector panther to panther, connector panther to ab switch, connector pipe to ab switch, connector dog to ab switch, pg clamp for 80/100mm2 conductor, pg clamp for 232/150mm2 conductor, pg clamp(ring type) for 232/150mm2 conductor, led flood light out door with ip 66 protection rectangular (100 watt), al. winding wire, lt pin insulator with pin(porcelain type), lt pre-insulated mid span joint suitable 95mm 2 phase, insulation piercing connector for db charging, insulating piercing connector bracing suitable for t. joints, 33 kv disc insulator with fitting 90 kn (b&s) type polymer, 33 kv polymer type pin insulator with pin 10 kn, (nuts & washer), 33 kv post insulator, 33 kv fuse set, 11 kv (b&s type) disc insulator with fitting polymer, 70 kn, 11 kv polymer type pin insulator with pin 5 kn nuts & washer type, 11 kv fuse set, suitable lungs, suspension clamp (assembly suitable up to 70-85 sq mm bare messenger including 1 no suspension clamp with bracket two meter stainless steel strap & 2 no ss buckle), spring loaded (distribution bus bar insulated box for fixing on pole suitable for ab xlpe cable and three phase connection 1 incoming & 3 outgoing 3 phase connection as per field requirement), dead end bracket suitable above 70 sq mm bare messenger including 1 no dead end bracket + i no dead end +2 mtr ss strap + 2 nos ss buckle.(minimum braking load 15 kn), jointing sleeve suitable for 150-232 sq mm, lt shackle insulator with strap porcelain type

State Government

CTN :38503386

31 Dec, 2024 30.87 Lacs

Medininagar - Jharkhand

Tender For supply of electric materials under electric supply area medininagar - electrical items :, 33kv v cross arm (100x50x6mm galvanized 19.7 kg), 33kv line dp channel (100x50x6m galvanized 65.2 kg), 33kv pole top bracket (50x10mm galvanized 2.5 kg), 33 back/support clamp for v cross/top (1.6 kg each 50x10 mm galvanized), 33kv g i stay set (1900x20mm) complete with stay wire 7/10 galvanized and guy insulator, 11kv v cross arm (75x40x6mm galvanized 14.6 kg), 11kv line dp channel (75x40x6mm galvanized 41.3 kg), 11kv pole top bracket (50x8mm galvanized 2.2 kg), 11kv back clamp for v,top,dp (50x6mm galvanized 3 kg), 11 kv g.i stay set (1800x16mm) with stay wire 7/10 galvanized and guy insulator, channel for transformer base (100x50x6mm galvanized 52.63 kg), channel for transformer hg fuse set (75x40x6mm galvanized 19.3 kg), channel for transformer ab switch (100x50x6mm galvanized 52.63 kg), tr. belting (50x50x6mm) with support (40x40x6mm galvanized 52.3 kg), lt stay set (1700x16mm) complete with stay wire 7/12 galvanized, earth clamp for earth wire (50x6mm galvanized 1.8 kg), angle/side stay clamp (50x6mm galvanized 1.08 kg), lt angle bracket (50x50x6mm galvanized 4.75 kg), lt back clamp for lt angle (50x6mm galvanized 1.1 kg), m/s nuts & bolts (10 x5/8 half thread), m/s nuts & bolts (8 x5/8 half thread), m/s nuts & bolts (5 x5/8 full thread), m/s nuts & bolts (3 x5/8 full thread), m/s nuts & bolts (2 x5/8 full thread), clamp for dss as per field req. (50x6mm galvanized 3.2 kg), spike earthing made of (20 mm gi solid rod

CTN :38504109

19 Dec, 2024 11.00 Lacs

Multi City - Multi State

Tender For tender for supply of analog repeater - analog repeater , junction box , repeater control pcb , stepper motor (course 360 & fine 10) , visor assembly , leds/fuse set