Tender For supply of materials for mahathma gandhi nregs material works - work materials, stone aggregate(single size): 40 mm nominal size, stone aggregate(single size):20 mm nominal size, stone aggregate(single size): 10 mm nominal size, portland cement, royalty for good earth, coarse sand (zone iii), fine sand (zone iv), mild steel round bar above 12 mm dia, twisted steel/deformed bars, structural steel such as tees, angles, channels and r.s. joists, flats up to 10 mm in thickness, galvanised steel bolts & nuts 6 mm dia and 25 mm long round head with slots,10 nos, galvanised steel j or l hooks 8 mm dia,10 nos, stone for masonry work, g.i limpet washer,50 nos, bitumen washer,50 nos, wire nails, diesel oil, polyethylene water storage tank with cover and suitable locking arrangemnet, mild steel tubes hot finished welded type, red oxide zinc chromate primer, white vitreous china 10 lit. (full flush) capacity controlled low level flushing cistern with all fittings, epoxy paint, wall form panel 1250x500 mm, corner angle 45x45x5 mm 1.50 m long, 100 mm channel shoulder 2.5 m long, double clip (bridge clip), single clip, m.s. tube 40 mm dia, wall form panel 1250x450xmm, corner angle 45x45x5 mm 2.50 long, column clamp 450x1070 mm, prop 2 m (2-3.5m), adjustable span eso+si (2.35-3.40), adjustable telescopic prop 3 m (2.02-3.75m), 15 mm ptmt bib cock, boulder 50 mm to 200 mm, gravel 5 mm to 10 mm, stainless steel screws 50 mm,50 nos, puddle clay, empty cement bag, gi trafford profile sheet 0.35mm thick, galvanised wire mesh of average width of aperture 1.4 and nominal dia. of wire 0.63 mm, solvent, 63 mm nails for fixing the clamp, material - 75 mm mta, material - 75 mm valve, aracanut post, solid blocks of size 40x20x15cm, solid blocks of size 30x20x15cm, pvc pipe 25 mm outer dia. 10kgf cm2, solid blocks of size 40x20x10cm, pvc pipe 63 mm outer dia. 4 kgf/cm2, pvc pipe 63 mm outer dia . 6kgf/cm2, pvc elbow 63 mm dia, pvc bend 63 mm dia, pvc 45 degree elbow 63 mm dia, pvc tee 63x63x63 mm dia, pvc reducer 63x50 mm dia, laterate stone of size 40x20x15cm, quarry waste
Tender For request for bids for supply, installation and commissioning of slaughter house plant as per apeda standard - a: civil work items, dismantling the reinforcement cement concrete (r.c.c.) work 1:2:4 and sorting out the materials such as steel etc. as directed and stacking them within the specified lead as directed etc. complete., dismantling brick masonry in lime or cement mortar and stacking the material as directed with all leads, lifts etc., removing doors and windows with frames and stacking the materials as directed with all leads, lifts etc. complete., removing ventilators and small windows with frame and stacking the materials with all leads, lifts etc. complete., removing cement tiles, or marble or polished shahabad floor or dado without bed concrete including stacking the materials as directed with all leads, lifts etc. complete, removing purlins from roof including stacking as directed with all leads , lifts etc. complete., removing rafters from roof including the materials as directed with all leads , lifts etc. complete., removing queen post truss from roof and stacking the materials as directed with allleads and lifts etc. complete, removing galvanized iron (g.i.) or asbestos cement (a.c.) sheet roofing including purlins, principal rafters etc. including sorting serviceable and unserviceable materials, stacking the same as and where directed in the compound including scaffolding etc. complete., excavation for foundation in earth, soil of all types, sand, gravel and soft murum, including removing the excavated material up to a distance of 50 m. beyond the building area and stacking and spreading as directed, dewatering, preparing the bed for the foundation and necessary back filling, ramming, watering including shoring and strutting etc. complete. (lift upto 1.5 m.) by mechanical means, lift upto 1.50 m, excavation for foundation in hard murum including removing the excavated material upto distance of 50 meters beyond the building area and stacking and spreading as directed, dewatering, preparing the bed for the foundation and necessary back filling, ramming, watering including shoring and strutting etc. complete. (lift upto 1.50 m) by mechanical means, lift upto 1.50 m, excavation for foundation in hard murum including removing the cubic meter (cu.m) excavated material upto a distance of 50 metres beyond the building area and stacking and spreading as directed, dewatering, preparing the bed for the foundation and necessary back filling, ramming, watering including shoring and strutting etc. complete. (lift from 1.5 to 3.0m.) by mechanical means, excavation for foundation in soft rock and old cement or lime masonry foundations including removing the excavated material upto a distance of 50 metres beyond the building area and stacking as directed, including dewatering, preparing the bed for the foundation and necessary back filling with available earth/murum, ramming ,watering including shoring and strutting etc. complete. (lift from 1.5m to 3.0 m.) by mechanical means, lift upto 3.0 m, excavation for foundation in hard-rock by blasting including cubic meter (cu.m) trimming and levelling the bed by chiselling where necessary and removing the excavated material and stacking it in measurable heaps within a distance of 50 metres from the building area including dewatering and back filling with available earth/murum watering, ramming etc. complete. (lift from 1.5m to 3.0 m) by mechanical means, filling in plinth and floors with approved excavated materials available at site in 30 cm layers include- ing watering and compaction with plate compactor to required proctor density etc complete., filling in plinth and floors with contractors material/brought from outside and approved by engineer in charge in layers of 15 cm to 20 cm including watering and compaction etc. complete., providing dry trap / granite / quartzite gneiss 200 mm thick hard core metal spread in two layers each of 125mm thick crushed to 100 mm consisting of m