Latest gas mask Tenders | Government gas mask Tenders

Central Government / Public Sector

CTN :43095024

19 Dec, 2025 NA

Vadodara - Gujarat

Tender For supply of half face gas mask with twin cartridges

corporations/Associations/Others

CTN :43122394

17 Dec, 2025 1.34 Crore

Amreli - Gujarat

Tender For construction work of protection wall, pick-up stand, office renovation, stage, parking stand, childern playing equipment, speaker equipment, tiranga flag foundation, cctv camera, fire hydrant system, led street light, cement concrete road with tri-mix and paving block road as per various area of dhari, dist.: amreli under swarnim jayanti mukhya mantri saheri vikash yojana year-2024-25 and 25-26 and 15 percentage vivekadhin yojana year-2025-26. (second attempt)

CTN :43096326

26 Dec, 2025 NA

Kangra - Himachal Pradesh

Tender For supply of power management equipment d d-- stationary valve regulated lead acid batteries (v2) as per is 15549 (q3) , high low input voltage disconnector 3 phase , phase and neutral balancing system 3 phase , voltage and current protector 3 phase , surge protection thundering arrester , power cable 4 core 16 mm copper outdoor , 20 kva servo motorcontrolled stabillizer 3 phase in 3 phase out , ups 20 kva 3 phase in single phase out with 2 hrs backup

CTN :43119594

31 Dec, 2025 NA

Patiala - Punjab

Tender For supply of gas mask respirat0r.

CTN :42901834

24 Dec, 2025 NA

Coimbatore - Tamil Nadu

Tender For corrigendum : purchase of equipments - purchase of equipment, 1. configuration design an 8-channel battery analyzer and its accessories 2. power 425 w3. voltage measuring range: 25 mv to 5 v, discharge minimum voltage: 0v or better, accuracy: 0.05% of fs4. current range: 0.5 ma to 6 a, accuracy: 0.05% of fs or better 5. power per channel output power: 30w, stability; +/- 0.1% of fs or better6. time rise time: 1ms (0~full range)7. frequency 10hz8. charge mode of operation: cc, cv, cccv, cp end conditions: voltage, current, relative time, capacity.9. discharge mode of operation: cc, cv, cp, cr, end conditions: voltage, current, test time, capacity, energy.10. pulse mode charge: cp mode, cc mode, discharge: cc mode, cp mode, min pulse width: 500ms, automated switch: automated switch from charge to discharge for each pulse end condition: voltage, relative time11. dcir support for the calculation of the point of the dcir12. cycle cycles: 1 65500 or better, steps: 250 or better, nested function: max three levels of loops13. protective function software, power-down data protection, user-defined safety (upper and lower) tolerance of current, voltage, and delay time14. channel features independent pairs of closed loops for the constant current source and constant-voltage source15. test reports and curves for analysis different types of curves created by software based on user definition. (voltage-time curve, current-time curve, capacity-voltage curve, loops times charge/discharge capacity curve, loops times charge/ discharge efficiency curve, etc.), data reports created by the software. comparison of the performance of the batteries tested in channels, both visually and statistically16. channels independent control17. ac input ac 220v 10% / 50hz 18. voltage and current testing sample 4 wire connecting 19. noise 85db20. data management mysql database21. communication means tcp/ip protocol22. data output excel, txt23. communication interface ethernet port24. number of channels per cabinet 825. accessories: 1. bi-potentiostat: electrochemical workstation or moduletechniques the system should be capable of running the rde / rrde technique simultaneously cyclic voltammetry (cv) with simulation/fitting programs linear sweep voltammetry (lsv) with stripping bulk electrolysis with coulometry (be) differential pulse voltammetry (dpv) with stripping normal pulse voltammetry (npv) with stripping tafel plot (tafel), potentiodynamic deactivation, pitting corrosion, corrosion rate, linear polarization, corrosion current, etc. multi-current steps (istep) amperometric i-t curve (i-t) lifetime testing open circuit potential time (ocpt) chrono amperometry (ca) chrono coulometry (cc) chronopotentiometry with current ramp (cpcr) potentiometric stripping analysis (psa) auxiliary signal measurement channel ir compensation external potential input galvanostatic charge discharge single/multiple cycle -chrono potentiometry (cp) with potential limits, polarity by potential or time, no. of cycles etc. voltage vs current density curves single or multiple potential steps with charge limits, single or multiple current steps, mixed voltage/current control using macro. i-v measurements, i max, pmax, fill factor, etc.impedance ac impedance (imp) 10 hz to 3mhz impedance time (impt) (mott-schottky) impedance potential (impe) impedance simulator with fitting open circuit potential time (ocpt)hardware specification of bi-potentiostat workstation/ module: potentiostat / galvanostat module, 2- or 3- or 4-electrode configuration maximum potential: 10v, maximum current: 250 ma peak or better and 2 amps with +/-25 volts for higher current measurement. compliance voltage: > 13v or better, potentiostat rise time: 300 ns or better galvanostat applied current range: 3na to +/- 100ma or better and upto 2 amps applied current accuracy: 20 pa or better input bias current: 1 pa or better cv and lsv scan rate: 0.000001 to 10,000 v/s. ca and cc pulse width: 0.0001 to 1000 sec imp freque

CTN :43087089

13 Dec, 2025 5.96 Lacs

Delhi - Delhi

Tender For a/r & m/o of e&m service at abvims in dr. rml hospital, new delhi. (sh: supply, installation, testing and commissioning of automatic strontium nitrate based compact electrical equipment fire protection system subwork/packages:sitc of automatic strontium nitrate based compact electrical equipment fire protection system

CTN :43068085

26 Dec, 2025 NA

Jammu - Jammu And Kashmir

Tender For supply of power management system with accessories c c - 60 kva ups igbt based with battery bank 1 hour backup or more , automatic transfer switch 3 source with 5 nos of 3 phase balanced output power distribution for installation of power supply equipment configuration of power control system maximum 250 amp load , ups digital cpdu distribution panel 125a load max , offsite distribution panel 63 amps with isolator , armoured aluminium 4 core 135 sq mm , armoured aluminium 4 core 50 sq mm , copper cable 1 core 35 sq mm , copper cable 2 core 2. 5 sq mm , fire protection kit for pms room , power control processing unit and software , high wall pac , earthing for ups panel , integration of power generation room including spares and cable trays, anti static flooring interiors , installation programming testing and commissioning of power management system , 1 kva ups with battery 30 min backup or more , 2 kva ups with bty bank 1 hour backup or more , 5 kva ups with bty bank 1 hour backup or more , 10 kva ups with bty bank 1 hour backup or more , 20 kva ups with bty bank 1 hour backup or more , 24 or 48 v fcbc with 4 x 12v, 65 ahc bty , installation programming testing and commissioning of all ups and fcbc ) /bid number: gem/2025/b/6889911 * /dated: 05-12-2025 & & / bid document1 / 25

CTN :42714152

10 Dec, 2025 NA

Bangalore - Karnataka

Tender For bid to ras supply of stores for tac payload trg equipment c c -workbench with esd electrostatic discharge protection as per pdf uploaded , storage for parts and tools bin drawers as per pdf uploaded , lighting led task lights as per pdf uploaded , safety gear gloves googles fire extinguisher as per pdf uploaded , digital multimeter for electric testing as per pdf uploaded , battery voltage tester checker as per pdf uploaded , fpv googles as per pdf uploaded , battery charger smart or multi battery as per pdf uploaded , propeller balancer as per pdf uploaded , esc tester electronic speed controller tester as per pdf uploaded , thrust stand for testing motor output as per pdf uploaded , oscilloscope for advanced electric testing as per pdf uploaded , 3d printer as per pdf uploaded , gps tracker as per pdf uploaded , software for diagnostics and calibration as per pdf uploaded

CTN :43080054

06 Jan, 2026 NA

Kamrup - Assam

Tender For g-14- supply, installation, commissioning and testing of equipment and machinery for 9 nos. of nurseries, revival of beels and nbs related works under crbifrermp (lot 3 - monitoring and protection equipment) - grand total of schedule 1, schedule 2 and schedule 3, currency 1 - inr

CTN :43090639

31 Dec, 2025 1.57 Lacs

Bankura - West Bengal

Tender For nit-92 supply of crop protection equipment at different ranges under dfo bankura north division

Gas Mask Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government / Public Sector

corporations/Associations/Others