Latest incense making machine Tenders | Government incense making machine Tenders

CTN :42771762

08 Dec, 2025 NA

Darjeeling - West Bengal

Tender For corrigendum : supply of supply of plant spares--bucket teeth , teeth locking pin , locking pin washer , bucket side cutter rh , bucket side cutter lh , bucket pin shim 1 point 2 th , rock breaker chessel , rock breaker hose , hyd filter , side mirror , hyd filter in line , pilot filter , bucket ram seal kit , roller carrier assy , master pin , master pin bush , master pin seal dust , bolt track , nut track , air element inner , air element outer , kit gasket top overhal , kit gasket bottom , thermostat , fuel baby filter , belt v ribbed , radiator cap , radiator hose top , radiator hose bottom , bucket side cutter lh , bucket side cutter rh , tooth bucket , tooth bolt , tooth nut , windscreen front , silicon sealant , mirror rear view , loader bush arm , loader bush , bucket pin , exterior mirror , battery 12v 130ah , head lamp 12v , tail lamp lh , tail lamp rh , arm wiper blade assy , knob gear lever , throttle hand knob , parking breake assy , gear box solenoid assy , hyd jack piston seal kit , boom jack piston seal kit , front tyre tube , front tyre , rear tyre tube , rear adaptor air filling , txn filter , torque conv drive plate , breake master cyl , front belt fan belt , exhaust spring extention , air element inner , fuel line tank to water seprator , fuel filter assy , fuel filter element , eng oil filter , tie rod , alternator , turbo charger , self starter , water seprator , fuel filter , filter , air element set , fuel water serator , teeth bucket , bucket cyl seal kit , fan belt , carring roller upper , oil filter , swing mounting bolt , lower roller assy , black light assy , wiper blade , wiper motor , accelerator cable , g box main shaft brg gb 40 , fuel flexible pipe 19 oblique 19mm , fuel flexible pipe 17 oblique 19mm , oil filter , fuel filter primary , fuel filter secondary , water separator , hub seal front , hub seal rear , hub brg rear inner oblique outer , air filter , 4 x 4 cable , non skid chain front wheel single chain 10 point 00 point 20 16 ply , non skid chain rear wheel double chain 10 point 00 point 20 16 ply , pressure plate with clutch plate , propeller shaft nut bolt with lock patti , rear view mirror both side , clutch cylinder assy , fog light assy , steering oil filter , paint og , fog light bulb , brake shoe for both tyres , battery charger 72v 10 amp , grease gun 5 kg

CTN :43066303

13 Dec, 2025 NA

Shahjahanpur - Uttar Pradesh

Tender For providing of repair, maintenance, and installation of plant/ systems/equipments (version 2) - supply& fixing of 6 mtr. gi octagonal pole of approved make (top dia 70mm, bottom dia 130mm and base plate 12mm thik) having 3mm thickness without bracket on rcc foundation bolt including the cost of foundation, excavation & back filling and required t&p complete in all respects. [s.r. no. 641]

CTN :43066313

13 Dec, 2025 NA

Shahjahanpur - Uttar Pradesh

Tender For providing of repair, maintenance, and installation of plant/ systems/equipments (version 2) - supply & fixing of 6 mtr gi octagonal pole of approved make (top dia 70mm, bottom dia 130mm and base plate 12mm thik) having 3mm thickness without bracket on rcc foundation bolt including the cost of foundation, excavation& back filling and required t&p complete in all respects. [s.r. no. 641]

CTN :43066352

13 Dec, 2025 NA

Shahjahanpur - Uttar Pradesh

Tender For providing of repair, maintenance, and installation of plant/ systems/equipments (version 2) - supply & fixing of 6 mtr gi octagonal pole of approved make (top dia 70mm, bottom dia 130mm and base plate 12mm thik) having 3mm thickness without bracket on rcc foundation bolt including the cost of foundation, excavation & back filling and required t&p complete in all respects. [s.r. no. 641]

Co-operative

CTN :43071441

19 Dec, 2025 45.58 Lacs

Malappuram - Kerala

Tender For general cleaning, liquid milk plant operation, milk packing, storage and disptach, cream melting, ghee filling and dispatch, tray washing, vehicle loading and unloading, milk powder packing, boiler feeding and operation and other general works

CTN :42620789

11 Dec, 2025 NA

Dibrugarh - Assam

Tender For corrigendum : construction of equipment room at nrl rt - civil, structural & architectural, earth work in excavation (refer specification no. c-spc-103), earth work in excavation below ground level for all kinds of works in all types of soils except soft rock and hard rock as classified in specification for a depth upto 1.5m including removal of vegetation, shrubs and debris, cutting and dressing of sides in slopes, levelling, grading and ramming of bottoms, dewatering of accumulated water from any source and keeping the surface dry for subsequent works and disposal or stacking of excavated material within a lead of 100m, as directed including providing temporary supports to existing service lines like water pipes, sewage pipes, electric overhead and underground cables etc. all complete, but excluding shoring and strutting., for depth beyond 1.5m and upto & inclusive of 3.0m., earthwork in filling by excavating the earth from borrow areas arranged by contractor for all leads, transporting the earth from borrow area including cleaning & stripping the earth at borrow areas, breaking clods, loading, unloading and laying at all depths and heights in layers of thickness not exceeding 15 cms., watering, rolling and ramming by manual methods/mechanical compactors to achieve 90% of the maximum laboratory dry density, dressing, trimming, levelling the top surface etc. in foundations, plinths, trenches etc. all complete., backfilling after execution of the work to proper grade and level with selected materials from available excavated soil from spoil heaps, including re-excavating the deposited soil excavated earlier, breaking clods, laying at all depths and heights in layers of thickness not exceeding 15 cms. watering, rolling and ramming by manual methods/ mechanical compactors to achieve 90% laboratory maximum dry density, dressing, trimming etc. in foundations, plinths, trenches, pits etc. all complete., transporting and disposing the surplus earth and debris including shrubs and vegetations from construction area to areas anywhere outside the plant boundary including re-excavating the deposited soil excavated earlier, transportation, loading, unloading, laying at all depths and heights, stacking, levelling and dressing both the area (viz. from where the earth is transported and where it is deposited) to required levels and slopes complete with all lifts as directed. for carting on the basis of truck measurements (volume of truck reduced by 30% for voids) disposal area s outside plant boundary to be arranged by the contractor .royalty as applicable for disposal outside plant limits to be borne by the contractor., plain & reinforced cement concrete (refer specification no. c-spc-104), providing and laying plain cement concrete for all depths below and upto plinth level in foundations,drains, fillings, non-suspended floors, pavements & ramps or any other works etc. including shuttering, tamping, ramming, vibrating, curing etc. all as specified in any shape, position, thickness and finishing the top surface rough or smooth as specified and directed all complete for concrete of nominal mix 1:5:10 by mass (1 cement: 5 coarse sand: 10 crushed stone aggregates/gravels) with 40mm and down size graded crushed stone aggaregates/gravels.(all materials including cement supplied by contractor at their cost), providing and laying reinforced cement concrete of m-30 grade with 20mm and down size graded crushed stone aggregates/gravel in sub-structure of all types e.g. foundations, footings, raft, beams, slabs, pile caps, retaining walls, jambs, counterforts, buttresses, trenches, manholes,pipe encasement, catchpits, drains, rcc pits, equipment/machine foundations, pedestals, pipe sleepers, columns, plinth beams, suspended floors, beams, staircases, landings, steps, brackets etc. (including single pour concreting upto 250m3), including cost of admixtures if used,providing pockets, openings, recesses, chamfering etc., wherever req

Private Sector

CTN :43037367

16 Dec, 2025 58.50 Lacs

Mumbai - Maharashtra

Tender For auction sale of plant and machinery - plant and machinery ;mineral water plant comprising of bottle filling machine, jar filling machine, cup filling machine, blow molding machine, conveyor system, r. o. plants, chilling plant, shrink wrapping machine, storage tanks, air compressors, laboratory equipment’s etc.

Private Sector

CTN :43037368

16 Dec, 2025 3.52 Crore

Mumbai - Maharashtra

Tender For auction sale of land with building and machinery - description of property iall that piece or parcel of industrial land or ground along with structure thereon together with the messages, hereditaments, bearing following gut nos.gut no 213hissa no 1area in h.r 0-60-0village kondhalesituated, lying and being at revenue village kondhale, taluka-wada, dist. thane, registration sub-district of thane in area of kondhale gram panchayat.description of property iiall that piece or parcel of industrial land or ground along with structure thereon together with the messages, hereditaments, bearing following gut nos.gut no 214hissa no 5area in h.r 0-03r-05pvillage kondhalesituated, lying and being at revenue village kondhale, taluka-wada, dist. thane, registration sub-district of thane in area of kondhale gram panchayat.description of property iiiall that piece or parcel of industrial land or ground along with structure thereon together with the messages, hereditaments, bearing following gut nos.gut no 420hissa no -area in h.r 0-18r-05pvillage usarsituated, lying and being at revenue village usar, taluka-wada, dist. thane in registration sub-district of thane in area of usar gram panchayat.plant and machinery ;mineral water plant comprising of bottle filling machine, jar filling machine, cup filling machine, blow molding machine, conveyor system, r. o. plants, chilling plant, shrink wrapping machine, storage tanks, air compressors, laboratory equipment’s etc.

State Government

CTN :42971338

11 Dec, 2025 8.63 Lacs

Fatehpur-Raj - Rajasthan

Tender For - nh-27 to sanwara km 3/00 - excavation for structures earthwork in excavation for structures as per drawing and morth specifications clause 304.1 including setting out, construction of shoring and bracing, removal of stumps and other deleterious material and disposal upto a lead of 50 m, dressing of sides and bottom and backfilling in trenches with excavated suitable material. ordinary soil upto 3 m depth, providing concrete for plain/reinforced concrete in open foundations complete as per drawings and morth specifications clause 1702, 1703, 2102 & 2104 p.c.c grade m 10 nominal mix 1:3:6, providing concrete for plain/reinforced concrete in open foundations complete as per drawings and morth specifications clause 1702, 1703, 2102 & 2104 r.c.c grade m 20, supplying, fitting and placing hysd bar reinforcement in foundation complete as per drawings and morth specifications clauses 1009,1600 and 2102, granular sub-base with close graded material (table:- 400-1) plant mix method providing laying spreading and compacting specified graded sand, gravel (crushed stone) as per table 400-1,400-2 or any other course material as per design mix, as per cbr in sub base course including premixing the material at omc in wet mix plant, carriage of mixed material spreading in uniform layers with motor grader f.e loader on a prepared base and compacting with vibratory roller to achieve desired density (as per i.s.2720) including all material, labor, machinery, lighting guarding, barricading and maintenance of diversion complete.[morth specification : clause 401]. by mechanical means. for grading-iv material, back filling behind abutment, wing wall and return wall in 150mm layers, with mechanical compaction, complete with all lead and lift as per drawing and technical specification as per morth specification : clause : 304 sandy material