Latest pipe joint Tenders | Government pipe joint Tenders

Central Government/Public Sector

CTN :41710025

25 Sep, 2025 NA

Mumbai - Maharashtra

Tender For supply of thermoplastic textile reinforced water hose size: 31.5 mm x 15 mtrs. long to specn.is:12585-2023. type-2 [reinforcement synthetic textile cover 5 smooth finish] note: i] the water hose shall be warranted for a period of 18 months from the date of delivery at depot. ii] material should be flexible to insert in respective pipe joints and to tight hold the conventional worm drive clips to is: 4762-2002 reaffirmed-2021 or latest. iii] colour of water hose yellow/black. iv] manufacturer should be a bis registered source and indicate cm/l no. in the offer.

Central Government/Public Sector

CTN :41666756

22 Sep, 2025 44.00 Lacs

Mumbai - Maharashtra

Tender For repair/replacement of water supply distribution pipe, joints, repair to internal wiring, submain wiring, security light, control panel, high mast light and other connected electrical works at various pockets of af stn mumbai under ge(af)thane

CTN :41704765

15 Sep, 2025 1.30 Lacs

Kupwara - Jammu And Kashmir

Tender For supply of pipe joints , english seat cera , english seat pearl , pvc pipe , pvc pice

CTN :41642410

22 Sep, 2025 NA

Leh Ladakh - Jammu And Kashmir

Tender For supply of serving repairing of blockage choke in the hot water boilers of capacity 350000 kcal hr including repair of control panel , serving repairing of blockage choke in the hot water boilers of capacity 150000 kcal hr including repair of control panel , serving reparing of the coil unit in 128 men barrack ie motor re binding , providing and replacement of pipe joint seal , replacement of butterfly valve 100 mm , supply glycol unit existing central heating system as per approved specification and direction of engineering in , providing and replacment of ignition rod and direction of engineering in charge , replacemnt of 15 hp motor starter and direction of engineering in charge , providing and replacement of fule pump and direction of engineering in charge , providing and replacement of fule pipe and direction of engineering in charge , providing and replacement of fule filter and direction of engineering in charge , providing and replacement of buner nozzel and direction of engineering in charge , providing and replacement of photo cell and direction of engineering in charge , providing and replacement of sequence controller and direction of engineering in charge ) /bid number : gem/2025/b/6629716 * /dated: 31-08-2025 & & / bid document 1 / 17

Central Government/Public Sector

CTN :41605725

06 Sep, 2025 3.21 Lacs

Bhadrawati - Maharashtra

Tender For providing and fixing of open / green gym item in palasgaon village under kuchana housing complex of majri area. - earth work in excavation by mechanical means (hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.all kinds of soil., supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete., providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level : 1:3:6 (1 cement : 3 coarse sand (zone-iii) derived from natural sources : 6 graded stone aggregate 20 mm nominal size derived from natural sources) , providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level : 1:1 :3 (1 cement:1 coarse sand (zone-iii) derived from natural sources: 3 graded stone aggregate 20 mm nominal size derived from natural sources), providing and laying 60mm thick factory made cement concrete paver block of approved shape and colour of m - 30 grade made of c&d waste by block making machine with vibratory compaction laid in required pattern and including over 50mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge., providing and fixing pommel horse size 2200 x 710 x 610 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing / pole cap made of hdpe/frp material and seat structure made of m.s sheet laminated by frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing sky walker size 1700 x 710 x 1700 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bearing / pole cap made of hdpe/frp material and foot rest structure made of m.s sheet laminated by frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing single shoulder press size 1200 x 760 x 1670 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bearing / pole cap made of hdpe/frp material and seat structure made of m.s sheet laminated by frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing seating standing twister size 1820 x 610 x 1520 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bearing / pole cap made of hdpe/frp material and twister plate structure made of m.s sheet / frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing outdoor traidmill size 1200 x 610 x 1220 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. plate. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bea

Central Government/Public Sector

CTN :41652326

09 Sep, 2025 NA

Jalandhar - Punjab

Tender For supply of hydraulic filter , air brake connector male , air brake connector female , air bellow , bush jack , on off switch , fuel pipe , jointing sheet , stopper cable

Central Government/Public Sector

CTN :41613074

22 Sep, 2025 NA

Noida - Uttar Pradesh

Tender For procurement of koel da rkit 26 and ard 25 - cgsd (mbi), air starter, da sea water pump / assembly of raw water pump, automatic voltage regulator,, dv electronic governor with over speed protection, set of joints, starting air pressure sensor, hp pipe assembly, speed control unit, temp sensor with inbuild transmitter (type-mbt5560,range 0-150d, outpu, limit switch, turbo oil drain pipe, double gear assembly, 0-2.5 bar danfoss make pressure transmitter for marine, pf33 individual pump, fuel pipe (from tank to feed pump tee) (marine-abs approved), set of o ring, exhaust temprature sensor with 2pin connector, fuel leakage switch, pump to leak off (marine abs approved), leakoff pipe (uniflex), piston assembly, fuel pipe (feed pump tee to filter in marine - abs approved), turning gear engaged limit switch, fuel pipe (from fuel filter to fip) (marine abs approved), centrifugal oil cleaner (band design), assly. rocker lever, oil filter element, k-coolant (26 lit can), small end bush (finished), belt v section (bx 58-pitchl ength 1520), hose reducer elbo, set of copper washers, fuel pipe (tee to pump inlet gear end) (marine abs approved), fuel pipe tee to feed pump gear end (marine abs approved), leak off pipe (from hp pipe to collector)marine _x0013_ abs approved, fuel pipe (tee to feed pump) (marine abs approved), belt for sea water pump drive, water level switch, thermostat element, hose for turbo compressor out, breather pipe, breather hose for marine, elbow connection, cly.head steel gasket 1.2 mm, bend 90 for feed pump out, top piston ring, exhaust valve, leakoff pipe for hp jacketed pipe (lh), drain cock, hose (dia 54) (bet.2 pipes), oil control ring, fuel pipe (tee to pump in), nozzle body (for oil spray nozzle), second ring piston, inlet valve, bolt (bearing cap), make up pipe, fuse terminal block 6a with 2a fuse link, exhaust valve seat insert, connecting rod bolt, rc joint, m.b.cross bolt (short), clamp(for fuel pipe), joint for governor mounting plate, special nut for exhaust manifold, valve seal, counter shunk head screw (for dv injector leakoff), valve guides, exhaust manifold stud, grommet: 22 dia ferrule, rubber bush (bottom), joint (bet.exh.manifold and expa. bellow), s.s.nut, sealing cap (for dia 25), valve collet, sealing cap (40 din 443)8, o ring: drain plug, grommet: 12 dia ferrule, stud-m10x1.5x25-8.8, set screw m8x1.25x25...8.8, washer copper, cup for valve springs, gasket (lub oil header), washer copper (18x22), plain machined washer - m6, service kit for heat exchanger, fuel feed pump, service kit for centrifugal filter, k cool super plus 50-50 premix 26 liter can, k-cool super plus, bearing, bearing, k sealent (80 ml), flat seal for oil seal housing, oil seal for drive end, conical copper washer, spring, cup for pr tube, flexible bellow, sea water outlet pipe from cac, joint for t connection, joint for sea water pump, joint for sea water piping, pipe for he raw water out, roller tappet assly, rubber sleeve, set bolt-m14x2x60-8.8, dowel pin, k cool plus 26 ltrs can, clamp (2 pipe), crank pulley, inlet valve seat semi-finish, exhaust valve seat semi- finish, cup washer (for nozzle clamp), valve guide, oil seal pulley end, timing pointer (for pulley), air shut off valve, set of main bearings, set of thrust washer, set of gasket for heat exchanger ts6m, oil pipe ( crankcase to pump), hose for air starter, sub assembly of bearing housing, joint cooler cover(rh)from fwe, k-coolant (26 ltrs can), copper washer (18x22), k-sealant, wire braided pipe from jacketed leakoff to fuel collector, temperature guage (0-120 deg), rubber bush (top), pressure guage (0-4 bar), pipe(sea water pump outlet to check valve), o-ring for drain plug, npt plug with zinc bar with he, k sealant 80 ml, drain cock, stud, set screw -m8x1.25x25-8.8, hose clip, copper washer, anti vibration mount - cori, anabond 666t max 25g, hose t bolt, hose clamp, rotary drain pump, k sealant (80 ml), automatic voltage regulator, worm drive hose clip (70mm), se

Central Government/Public Sector

CTN :41674056

15 Sep, 2025 NA

Chennai - Tamil Nadu

Tender For supply of teflon tape for sealing threaded pipe joint screwed fitting 12mm width 0.1mm thick of 12 metres roll similar to champion teflon.

Central Government/Public Sector

CTN :40447723

05 Sep, 2025 NA

Delhi - Delhi

Tender For bid to ras supply of migration of afro lan onto afnet - input output box , cat 6 a cable utp , cable manage panel , utp patch cord 3m , utp patch cord 1m , fiber junction box tjb box 24 core , fiber junction box tjb box 48 core , liu 24 port fdf , liu 48 port fdf , optical fibre cable , pvc conduit pipe 40 mm , pvc conduit pipe 25 mm , casing and capping 25 mm baten , gi flexible pipe 25 mm , gi flexible pipe 40 mm , hdpe pipe , pvc bands,elbow and t joints 40mm , pvc bands,elbow and t joints 25mm , nylon self locking cable ties , tagging stickes 2.5 inches x3 inches , rj 45 cat 6 a connector , btteries stand , jack panel 24 port cat 6 a , open rack , 5 kva ups , battery , patch cord optical 7 feet , patch cord optical 3 feet , rack 15 u wall mounting fixing , fixing and installation of cisco switch in rack , fixing of input output box , laying of cat 6 a utp cable , jack panel 24 port cat 6 a loaded with dust cover input output fixing , cable manager 1u fixing , fixing of fiber junction box 24 core , fixing of fiber junction box tjb box 48 core , fixing of liu 24 port fdf fully loaded sm lc type , fixing of liu 48 port fdf fully loaded sm lc type , laying of ofc 24 core , digging and laying of ofc 24 core

Central Government And Public Sector

CTN :41605067

11 Sep, 2025 NA

Sonitpur - Assam

Tender For supply of polyamide thread for pipe joint

Pipe Joint Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors