Latest rail tester scrap Tenders | Government rail tester scrap Tenders

CTN :42408779

03 Nov, 2025 NA

Sirsa - Haryana

Tender For corrigendum : supply of fuse 15 amp , ignition key , electronic governor controller , dc power contractor 1 pole , charging alternator belt , dc load bleeder , diesel filter mico make type1 , diesel filter mico make type2 , cable electric single core , fuel pipe , fuse10 amp 12v , fuse 30 amp 24v

State Government

CTN :42533433

10 Nov, 2025 NA

Bangalore - Karnataka

Tender For supply, installation, testing and commissioning of 40mt electronic lorry weigh bridge (without cabin) on turnkey basis by replacement of the corroded platform and load cell structure of existing elwb at fsd androth (lakshadweep islands) for the fy 2025-26

Central Government/Public Sector

CTN :42550923

10 Nov, 2025 1.43 Lacs

Dhanbad - Jharkhand

Tender For supply and fixing of gi pipe with cable from load cell upto junction box routed inside flexible steel conduit with both ends of the conduits duly sealed with epoxy for 03 nos. of weighbridges (akashkinaree, block iv and tundoo electronic road weighbr

CTN :42413755

03 Nov, 2025 NA

Sirsa - Haryana

Tender For supply of relay 24v dc , voltage regulator 24v , fuse 15amp , ignition key , electronic governor controller , dc power contractor 1 pole , charging alternator belt , dc load bleeder , diesel filter mico type1 , diesel filter mico type2 , cable electrical single core , fuel pipe , fuse 10amp 12v , fuse 30amp 24v

Central Government/Public Sector

CTN :42402145

17 Nov, 2025 NA

Sonipat - Haryana

Tender For supply of ceiling fan coil winding , collapsible tap with attachment , combined surface and thickener , compound angle vice(standard vine) , connecting rod alignment fixture , cell phone power source with charger chords for different cell phones , coventry die head , d. c. compound motor , d. c. shunt motor , dc series motor coupled with spring balance load , de scaling pump set , depth gauge micrometer , dumpy level with all accessories , digimatic electronic vernier caliper , fan coil unit , front axle (rzeeppa joint) with stand for dismantling and assembly , direct reading vernier caliper , conduit pipe bending machine, suitable , drum brake assembly in working condition , c. r. o single beam , display cabinet , digimatic electronic outside micrometer

Central Government/Public Sector

CTN :42493535

08 Nov, 2025 NA

Krishnarajapuram - Karnataka

Tender For supply of dc electronic load

Central Government/Public Sector

CTN :42283705

06 Nov, 2025 NA

Bhavnagar - Gujarat

Tender For corrigendum : supply of details description of specification for 100 watt led flood light - led rating in warm)/system wattage/rated power, led luminaire conformity to 15:10322/part 5/section 5/2012 latest and 15: 16107, (part 2/sec 1):2012, photo biological safety of leds used shall be as per 15:16108/2012 (exempt grou, types of led luminave as per the 15: 161070part-2/sec-11/2012, types of led modules as per the 25: 16103(part 2)/2012, led rating/system wattage/rated power, luminaire system efficacy bumen/watt), ingress protection (ip rating) as per 1 10322 (part 1): 1982 latest, mounting brackets fincluded, warranty for free replacement (in year), input operating voltage range and frequency, automatic higher cut off voltage above 300 volt, rated voltage, ac power factor at hill load, driver efficiency lin sage), total harmonics distortion (in lage), the total circut power shall not be more than 110 percent of the valve declared, by the manufacturer, led chip efficacy, colour temperature (+500), working life for led (minimum 50,000 buming hours as per lm-80 report), coltur rendering index(cri), optic lenise materal (uv stabilued) (write na or without optic lense supply), heat sink should be die-cast aluminum along with sufficient heat sink fins to desipate heat effectively, capacitor shall be ratail for a temperature of 105 deg. ceblus or better, junction temperature, operating temperature range, operating humidity range, short circuit protection, overload protection, over voltage geutection, reverse polarity, high voltage test (1.5 kv for ane minute between napply terminats and body of the, unit), insulation resistance between earth and current carrying part, the luminaire shad be protected against surges and transients (internal), the luminaire shall be protected against surges and transients of >/1kv, (external, the luminaires casing/housing (single piece housing) shall be pressure de catted, aluminum alloy with higher thermal.conductivity, the lummaire body must be corrosion resistant epoxy powder couted, all fasteners must be of stainless steel, the entire housing (both led section and driver section) shall be dust and water proof having ip 66 protection as per 15:10322 (part 11:1987 latest, luminaries light transparency should be of toughened glass, toughened transparent glass cover thickness, toughened glass shall not get discolored shall not suffer degration due to heat and agning within warranty period, number of electronic control gest (power sanoles), driver components shall be industrial grade or above, pci shall be fre grade minimum 0.8 to 1.0 mm thick or mom, the luminaires works on single phase three wires system (phase, neutral and, earth, suitable connector shall be provided for led connection between driver output, and led, length of st marked three cors wire (shall be provided along with supply of, materiall, ught source, manufactures name and and brand on the aluminium die cast body, manufacturer's name, model number, serial number, date of manufactiare (month-year), and int number as identification mark inside each unit and the outside of each packaging box, the operation characteristics voltage and power be marked inside of each led, system must have emi/emc compliance as applicable (test reports shall be furnish on demand by buyer/consignee)

CTN :42464367

04 Nov, 2025 NA

Rudrapur - Uttarakhand

Tender For supply of electronic toe load measuring device (etlmd) no. tm/sm/ etlmd/218

Central Government And Public Sector

CTN :42499802

01 Dec, 2025 NA

Multi City - Multi State

Tender For various equipments for electronic lab of 3ph locomotives,one set consists of (a) mfr dual port solder/de-solder system, internal pump,(b) hot air convection tool 220 v, (c). fiber opticcable lest set with power meter, adaptor & source with carrying case, (d). ac variac ,(e). load test setup consist of mults range 150v/10a dc power supply & dc electronic load , (f). pressure calibrator, (g). universal programmer for programming device , (h). lcr tweezer ,(i). optical inspection system as per annexure attached. [ warranty period: 30 months after the date of delivery ]

Corporations And Associations And Others

CTN :42458241

04 Nov, 2025 10.00 Lacs

Sonipat - Haryana

Tender For purchase of microprocessor based three load cell simplex electronic net weighning bagging machine 2 nos from manufacturer authorized dealer stockies make high tech accurate dy net power built

Rail Tester Scrap Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

State Government

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government/Public Sector

Central Government And Public Sector

Corporations And Associations And Others