Latest traction generator scrap Tenders | Government traction generator scrap Tenders

CTN :45048307

08 Jun, 2026 NA

Tarapur - Maharashtra

Tender For : supply, installation, testing & commissioning of electrical equipment for dg block 119a of inrp - ht panels (119a)supply, installation, testing & commissioning of indoor type floor mounted, single front, metal clad, 1250 a, 6.6 kv, 3 phase, 3 wire, vcb switchgear panel suitable for a short circuit current of 31.5 ka for 3 seconds, internally arc tested for 31.5 ka for 1 second, comprising of following incoming & outgoing feeders : incoming feeder: 1 no. 1250 a, 3p vcb outgoing feeders: i) 7 nos. 630 a, 3p vcbii) 1 no. 1250 a, 3p vcb as tie feederwith surge arrestors, relays, pts, cts & other necessary accessories including associated structural steel required for complete installation of the panel & equipment earthing of the panel from both the earthing terminals of the panel to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & drawings. reference drg. nos: ip1/119a/05027339/dwg/001/r0 & ip1/119a/05027339/dwg/002/r0(note: terminal box of each incomer of 6.6kv switchboard shall be suitable for terminating 4x3cx400 sq.mm., 6.35/11kv (e), a2xwy cables.), supply of spares for ht panels as per attached spares list mentiond in section c, part ii of tender, 2.5 mva, 6.6/0.433 kv dry type transformers (119a)supply, installation, testing & commissioning of 6.6/0.433 kv, 2.5 mva, dyn11 dry type cast resin transformer having percentage impedance of 8.5% complete with ht cable end box, lt bus duct flange, off load tap changer on ht side with range of +/-5% in steps of 2.5%, wti scanner, ct for restricted earth fault protection and other necessary accessories including associated structural steel required for complete installation of the transformer & equipment & neutral earthing of the transformer from both the earthing terminals of the transformer to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & drawings.reference drg. no. : ip1/119a/05034347/dwg/001/r0, supply of spares for dry type transformers as per attached spares list mentiond in section c, part ii of tender, 2000 kva diesel generator sets (119a)supply, installation, testing & commissioning of 3 phase 2000 kva prime power 433v, 50hz, 0.8 p.f. diesel-generator sets with 110% overload capacity for 1 hr with four (4) stroke inline or vee type cylinder arrangement having engine speed 1500 rpm, 24v electric battery starting system with a provision of interchangeability of battery bank between two dg sets, complete with all auxiliary equipment including amf control panel, auxiliary mcc panels, heat exchanger cooling system, raw water pump, remote radiator with fans on terrace, ms exhaust piping, exhaust structure (maximum 30 m stack), 4 nos. of 3.6 cubic metre fuel day tank outside dg building (for all 4 dg sets) & 1 no. of 990 ltr intermittent tank inside each dg room, ms "c" class fuel piping between engine & fuel tank, dg room accoustic treatment & complete ventilation of dg room, brushless excitation for alternator, one no. 3200 amp 415 v 4p acb, ms structural steel supports/ channels/ angles & other necessary accessories including associated structural steel required for complete installation of the dg & equipment & neutral earthing of the dg from both the earthing terminals of the dg to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & necessary statutory clearances from cpcb etc. as required and as per tender technical specifications & drawings. design and construction of foundation for exhaust pipe rack/ structure of dg set is included in the scope of the contractor.reference drg. nos. : i) ip1/119a/05034347/dwg/001/r0ii) ip1/119a/05044831/dwg/003/r0iii) ip1/119a/05044831/dwg/004/r0iv) ip1/119a/05044831/dwg/005/r0v) ip1/119a/05044831/dwg/006/r0, supply of spares for diese

CTN :45147381

26 May, 2026 NA

Kheri - Uttar Pradesh

Tender For providing of custom bid for services - diesel generator set repairing spares

State Government

CTN :44804634

18 May, 2026 35.89 Lacs

Rewa - Madhya Pradesh

Tender For corrigendum : procurement, installation, testing commissioning of one no. 250 kva diesel generator set along with complete accessories and mandatory spares at 3x20 mw, bhps iii deolond

Central Government/Public Sector

CTN :44047450

13 May, 2026 NA

Barabanki - Uttar Pradesh

Tender For corrigendum : providing of custom bid for services - supply of spares for cummins make 500 kva diesel generator set (model vta-28-g3-i) at 765 kv lucknow substation

CTN :45063218

23 May, 2026 NA

Jammu - Jammu And Kashmir

Tender For supply of spares and repair of op wks generator sets c c - 5 hp wss pump , 5 hp submerssible pump , 3 hp submerssible pump , genr set 15 kva , genr set 5 kva , 10 hp diesel engine , 38 hp diesel engine , genr set 30 kva , 72 hp diesel engine pump , 70 hp elect motor with pump , genr set 10 kva , genr set 7.5 kva , pump set 43 hp , pump set 7.5 hp , genr set 12.5 kva , genr set 7 kva , solar panel , 65 hp diesel engine , 5 hp submerssible pump , 7.5 hp submerssible pump , fuel cell genr , 70 hp elect motor , 5 hp submerssible motor with pump , 65 diesel engine , 105 diesel engine , genr set 19 kva ) /bid number : gem/2026/b/7496162 * /dated: 02-05-2026 & & / bid document 1 / 76

Central Government/Public Sector

CTN :45041068

20 May, 2026 4.85 Lacs

Sivasagar - Assam

Tender For re-tender _procurement of operational spares spare parts for revival of 380 kva koel diesel generator set at ds#03 in rds field of assam asset.

CTN :44514166

18 Apr, 2026 NA

Jammu - Jammu And Kashmir

Tender For bid to ras supply of proc of spares and repair of op wks generator sets and pumps e e -supply of spares of genr set 30 kva , supply of spares of genr set 11 kva , supply of spares of 52 hp diesel eng with pump , supply of spares and repair of genr set 11 kva , supply of spares and repair of genr set 5 kva , supply of spares of genr set 5 kva , supply of spares of genr set 100 kva , supply of spares of genr set 3 kva , supply of spares and repair of genr set 30 kva , supply of spares and repair of supply of spares of genr set 100 kva , supply of spares and repair of supply of spares of genr set 30 kva , supply of spares and repair of supply of spares of 20 hp water pump , supply of spares and repair of supply of spares of genr set 10 kva , supply of spares and repair of supply of spares ofgenr set 10 kva , supply of spares of genr set 30 kva , supply of spares of genr set 15 kva , supply of spares and repair of supply of spares of genr set 7.5 kva , supply of spares and repair of genr set 7.5 kva , supply of spares and repair of genr set 5 kva , supply of spares and repair of genr set 30 kva , supply of spares of genr set 5 kva , supply of spares of genr set 7.5 kva , supply of spares and repair of genr set 15 kva , supply of spares of genr set 62.5 kva , supply of spares of genr set 15kva ) /bid number : gem/2026/b/7363692 * /dated: 17-03-2026 & & / bid document 1 / 59

CTN :44410422

30 Apr, 2026 NA

Mumbai - Maharashtra

Tender For corrigendum : tender for supply of 25bz2c005 spares of convertor diesel alternature emergency diesel generator and emergency genset d d -diodes for rev diodes disc , automatic voltage regulator , discrete protection relay unit , indicating lamp bulbs set of 4 nos , diodes for rev diode disc , air cleaner , piston ring set , ball sheel with bush , packing for fuel filter , gear wheel for de comp auto , sliding disc , governor lever , rocker assy inlet , gasket for fuel pump , shims for fuel pump o 30mm , disc for ball hub , cylinder head nut , packing for bearing flange gasket , cover for crank shaft , cylinder head gasket 0 05 mm , cylinder head gasket , cylinder head gasket 0 80 mm , fly wheel nut , valve cup collet , piston std , automatic voltage regulator solid state electronic , manual voltage adjuster potentiometer set of 1 no , lamp bulbs indicating set of 6 nos , dip stick , roller bearing nu 307 , diodes for rev diode disc set of 7 nos , diodes for rev diode disc set of 7 , revolving diode set disc complete with diodes , fuel tank cap , oil seal flywheel end , air filter inlet cap , banjo bolt 8mm , key for fly wheel , cotter pin 2x22 din 94 for hand lever , gudgeon pin , o ring 5x7x1 for pin of de comp , o ring for oil filter cap , o ring for bottom cover lever , injector assembly , v ring , o ring for decompressor , fuel pipe 26 tank to filter , key for hand lever , banjo bolt 12mm , protection cap , valve guide , cam flower spindle

State Government

CTN :44798192

28 Apr, 2026 1.97 Lacs

Durg - Chhattisgarh

Tender For the detail of works includes:a. the tenderer shall carryout the following works during annual maintenance contract period along with the servicing of the diesel generator set.1. general checkup & preventive maintenance and to fill up preventive checkup schedule as follows:a) check lube oil level and conditioning of lube oil, top up/refill if required.b) the oil filters shall be replaced whenever oil is changed.c) the air filters shall be cleaned periodically with compressed air, check batteries and top up the distilled water if required.d) check functioning of changing alternator.e) engine safety viz. high water temperature gauge, oil temperature gauge and high speed gauge shall be checked for their functions and repaired/replaced if required.f) coolant level and conditioning of coolant shall be checked and refilled if required.g) check fan and alternator drive belts and tightened if required.h) the governor shall be checked and tuned for proper functioning.i) check for leaks if any and shall be rectified.j) check reports shall be submitted every month/every breakdown calls.2. checking and servicing of engine for smooth running, its unusual sound and color of smoke and exhaust and set it right in case of deviations.3. checking and repairing and leakage of fuel, lubricating oil and coolant.4. cleaning and changing of air filters as per requirement.5. setting of valves tappets whenever required.6. checking and repairing of accessories drive, turbo charger and crankshaft endplay whenever required.7. checking of alignment of engine & alternator as per requirement.8. checking of throttle control and its setting.9. checking of instrument panel including replacement as and when required.10. checking of rotating diodes assembly in brushless alternator including replacement as and when required.11. checking of wiring system and repairing/replacement as and when required.12. repair and maintenance of relays including contractors in control panel.13. checking of battery terminal and de-sulphating.14. diagnosis of faults in engine and alternator and its rectification.15. breakdown calls to be attended on priority within 6 hrs.16. providing spare avrs, self-starter and accessories, free of charge, if the repair/overhaul/replacement is expected to be taken in more than two days.17. checking/repair/adjustment/replacement/servicing shall be carried under annual maintenance contract except cost of component/parts to be replaced due to wear & tear.18. the firm should undertake to arrange genuine spares of the diesel engine, alternator and amf panel as and when required within two working days.19. the tendererâ€™s service engineer shall visit the site for attending the generator sets not less than twelve times during the contract period (minimum once in a month) and shall inspect the generator set thoroughly. each visit shall take place during 1st week of each month.20. the tendererâ€™s service engineer shall visit once in two month for checking of electrical side viz. alternator, amf control panel, if any.21. the engine shall be run on no load or at available load, and should be checked for any leakage and abnormal noise. if any such abnormality noticed shall be diagnosed and remedial action shall be taken.22. standard check list:a) replace minor parts (i.e hoses and filters etc) sub-assemblies as and when required.b) service engineers during the visit will report on the performance or any other abnormality and inform parts requirement. he shall also submit the report on work done and recommendations as well as spare parts required.c) attend emergency call on priority (usually same day). however, if the engineer is required or any particular date and time, it would be the responsibility of the customer to intimate the contractor in advance.d) major overhauling/ top overhauling / pt pump & injector calibration /replacement of major parts/ rewinding of alternator or repairs or breakdown of the diesel generator set are to be charge