Tender For administrative approval for complete repairing & rewinding of 150hp kirloskar make ventilationfanmotor 550volt at manderboni unit of msam colliery under pandaveswar area.
Tender For supply of ventilationfanmotor of 5.0-5.5 kw/6.7-7.5 hp of rating, 415v ac, 3 phase, 50hz. ip-65,insulation clash-h, min 1440 rpm, roof mounted as per rdso spec. no. rdso/pe/spec/ac/0084-2008 (rev. 1) the item is reflected at sr. no. (iv) in rdso spec. suitable for use in lhb type power car. accepted make: m/s abb, m/s laxmi hydraulic, m/s crompton, m/s siemens, m/s kirloskar electric, or any other rdso approved make.
Tender For tender for supply of robotic lab consumables - rasberry pi 5 (8gb ram) with case , rasberry pi 4 (4gb ram) with case , arduino nano , arduino mega 2560 , arduino uno , led (green red white and orange) , female to female jumper wires , male to female jumper wires , male to male jumper wires , quadcopter diy drone combo kit , e88 pro drone kit with 1080p hd camera , 11.1v 5200 mah lipo battery , 11.1v 3300mah 25c 3s lithium polymer battery pack , 11.1v 2200 mah lipo battery , 920kva brushless dc motor , mini servo motor (180 degree) plastic gear , mini servo motor (180 degree) metal gear , dc motor (12v 100rpm) , dc motor (12v 1000rpm) , dc motor speed controller (12v 10a) , l293d 4 channel motor driver , stepper motor (12.6 kg.cm) , stepper motor (18.9 kg.cm) , 60kgcm metal gear servo motor , 80kgcm metal gear servo motor , 150kgcm metal gear servo motor , l293d motor driver ic module board , l293d motodriver ic , 12v relay module , ir sensors , ultra sonic sensors , hc05 blue tooth , sensor kit , inertial measurement unit (imu) , 9v lipo battery , rasbeery pi camera module 3 , rasberry pi 5mp camera module , bread boards big size , bread boards small size , soldering iron rod with stand (25watts) , soldering wire , soldering flux , branded screw driver set small size , branded tester , branded wire stripper , branded wire snipper , two wheel drive robot with chasis , smps (24v 10a) , smps (12v 10a) , smps (5v 10a) , l298 motor driver , gps module , pixhawk 2.4.8 kit , 40a 2-6s esc 3.5mm banana connector , spaneer (12-13 size) , m2 (6 mm) and m3 (10 mm) hexhead screws , f450 / q450 quadcopter frame with plastic landing gear combo kit , fs-i6s remote control 2.4g 10ch afhds with fs-ia10b receiver and mobile holder , 30cm nylon strap belt , lidar sensor (8m) , polymer materials pla , polymer materials abs , polymer materials petg , polymer materials tpu , lipo battery balance charger , plastic boxes , extension boxes 10m (4 plugs)
Tender For supply of operation and maintenance of electrical and mechanical installations etc. , rewinding of ceiling fanmotor upto 1400 mm , rewinding of exhaust fanventilationfanmotor upto etc. , rewinding of pedestal fan upto 600 mm etc. , rewinding of wall mounting upto 450 mm etc. , repairing and replacement of heating element and thermostate etc. , painting of feeder pillars panels dbs including removing etc , dehydration of transformer oil in order to improve the bdv , testing and calibration earth protection digital relay , testing and calibration idmt earth fault protection relay , testing and calibration auxilary relays , servicing of ht vcbs etc. , checking and servicing of lt acbs 800 amp merlin gerin make , checking and servicing of lt acbs 1600 amp merlin gerin make , checking and servicing of lt acbs 800 amp ge make , checking and servicing of lt acbs 1000 amp ge make , checking and servicing of lt acbs 1600 amp ge make , checking and servicing of lt acbs 2500 amp ge make , checking and servicing of lt acbs 1600 amp abb make , checking and servicing of lt acbs 1600 amp lnt make , checking and servicing of lt acbs 800 amp lnt make , painting of electrical panels , painting of street light poles 4 mtrs height , painting of street light poles 7 to 9 mtrs height , lifting and lowering of submersible water pump upto 10 hp , carrying out the works covered under dsr electrical of value upto etc.
Tender For operation and maintenance of electrical and mechanical installations etc. , rewinding of ceiling fanmotor upto 1400 mm , rewinding of exhaust fanventilationfanmotor upto etc. , rewinding of pedestal fan upto 600 mm etc. , rewinding of wall mounting upto 450 mm etc. , repairing and replacement of heating element and thermostate etc. , painting of feeder pillars panels dbs including removing etc , carrying out the works covered under dsr electrical of value upto etc.