Tender For corrigendum : provn of 02 in nos bore wells alongwith associated items at icgs mundra - material and labour for drilling of 02 nos pilot/trial bore by direct rotary rig method including all t&p through any kind of starta (soil, kankar, boulder or soft or hard rock) down up to 150 m depth below ground level by using suitable drill bit according to levering of casing pipe including the cost of mud pit, channels, etc and disposal of soil obtained to a distance not exc. 1 km away complete all as specified. note:- (i) the drilling shall be continued up to specified depth and in case sticky clay occurs in between the drilling must be stopped and hydrologist of gws & sb shall be contacted & eggr-in-charge shall be informed.(ii)cost of this consultant shall be borne by contractor (iii) taking the samples from the bore well cutting for every 3 meter interval and every change in strata if less than 3meter. (iv) preparation of litho logs based on these samples.(v) drill time log to be prepared and prescribed., (vi) aquifer performance tests at constant discharge with draw down and recovery reading.(vii) after completion of pilot bore, the contractor shall have to arrange for electro eater logging test of each bore.(viii) contractor have also produced bore well water test report for drinking water parameters before levering of motor and pump.(note:- if water quality not found fit for domestic purpose use then all other connected items of trial bore will not be executed.) , supply assembling, jointing, lowering and fixing in the bore hole pvc casing pipe of nominal dia 315 mm (medium well) ,10 kg/cm2 working pressure, confirming to is 4985-2000 including providing pea gravel of 8 mm to 4.6mm size for packing around the casing/slotted pipe in bore well all as specified and directed. make: astral/ashirwad/ajay/sfmc, all as per item no 2.00 above but slotted pipe. , supply, assembling, jointing, lowering lead free pvc column pipes of nominal dia 65 mm, od 75 mm (min), non toxic, pressure 16 kg/cm2 with and including top and bottom adaptor (ss) and accessories like epdm ring and double ss stud all as spd and directed by engineer-in-charge. make: astral/ashirwad/ajay/sfmc, development of tube well with compressed air by means of air compressor of suitable capacity not less than 300 cfm and over pumping using suitable capacity pump to make available water free from turbidity complete all as specified and directed by engineer-in-charge., m & l for conducting yield test for the bore well by continuously pumping for 24 hours by using a submersible pump set to determine safe pumping yield and produced water test report of samples which is collect every hour complete as directed by the engineer-in-charge. [ all arrangements for yield test shall be made by contractor and cost for the same borne by contractor ], supply and fix ms reducer, bail plug, top cover made of 3mm thick ms plate for bore well in two half sections having a hole of 75 mm bore in centre to accommodate pvc pipe and submersible cable suitable for fixing to the pvc casing pipe top, electric logging and simple strata box including provision of 2 sets of ms clamps made of 50x6mm ms flat including nuts, bolts, etc. including one coat of epoxy primer and two coats of epoxy paint wherever necessary complete all as specified and directed by engineer-in-charge., supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, water lubricate, 3 phase, 10.0hp (appx) 415 volts, 50 hz with suitable submersible electric motor suitable for discharge of 2 liters per second against total head of 125m in the bore complete all as specified and directed by the engineer-in-charge. [ note : column pipe, submersible cable and control gear will be measured and paid separately]. [make: kirloskar / crompton / ksb], supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, wa
Tender For supply of spares for electrotenica make vcb pannel - shunt trip coil assembly 110v dc part no nvcbv0001 , electrical release coil assly part no v0022 , aux switch assy part no v0024 , flex connector part no v0028 , secondary plug and socket part no v0032 , fiber glass cover part no v0037 , fibre glass barrier set for fixed type v part no v0039 , drive insulator for vcb part no v0041 , push to trip assly part no v0042 , spring charge indicator paart no v0043 , operating mechanism part no om009 , spring for operating mechanism part no om0010 , castle lock with key part no fsv00118 , vaccum interrupter part no v0048 , vacuum circuit breaker assly vcb9576 part no vfs0062 , indicating lamp part no p0043 , trip neutal close switch part no p0045 , ammeter voltmeter selection switch part no p0046 , earth leakage relay test reset switch part no p0047 , rectifier capacitor unit part no p0048 , resin cast core balance transformer part no p0051 , resin class ct class isp10 by ci10 part no p0056 , under voltage release part no p0057 , auxiliary contactor 110 vac part no p0061 , control fuse 2 to 10a part no fsv00116 , fuse base and carrier part no fsv00117 , fiber glass barrier set part no i0036 , 4 hole support insulator part no i0039 , oil dash pot over load release part no p0058 , breaker terminal top part no v0029 , breaker charging handle part no v0030 , push button switch part no p0044 , kwh meter part no fsv00107 , ht hrc fuse for p t part no fsv00110 , earth leakage relay part no p0049
Tender For supply of machines and laboratory equipments for department of civil engineering in the premises of government engineering college banka - automatic mortar mixer, digital capacity 5l,half cell potential measurement apparatus, rebar locators, diameters and cover meter with software, concrete permeability apparatus 3 cell model for 150mm cube, slump test apparatus, vee bee consistometer, oven, cement mortar moulds, cube moulds, le chatelier flask, vicat apparatus, cement tensile testingmachine, digital weighing balance, digital platform balance, sieves, split tensile strenth apparatus, trowel, guniyas, spirit level, micrometer, spatula, tensile, plate vibrator, floor tile testingmachine, strain gauge indicator, sieve shaker
Tender For procurement of spares for mi-17 helicopter - pin, adapter for bore sighting tube, block, pkv sight cover, adapter assembly, device for eksr-46 circuit check, adapter assembly, tools for measuring gaps of ees, reference oscillator, converter test unit, movable disc lever, friction clutch, zeroing device, adapter, plug, socket for wheels, key ko 50, collar, tester for kt-70, installation for checking, test bench harness for ark-15m, frequency meter, capacitive voltage divider with dummy antenna( c = 100pf ), analogue signal simulator, fuel sensor test device, fixture, hoist for mrb, belt connection/disconnection device, screw clamp, device for checking mrb tracking, sarsat beacon test, attenuator, frequency counter(upto 500 mhz), meter test set, test panel, spectrum analyzer, 100 watt 30 db attenuator, test bench harness for hf radio station khf 1050, anteena simulator, low power 30 db attenuator, registrar of speech information, protective test unit, hf signal generator, test programming set for cma-2012, protractors, seat bracket (lh), modulator module, bracket lh, on line contamination checking tester with adaptor &sensor