Latest meter seal Tenders | Government meter seal Tenders

State Government

CTN :43000121

22 Dec, 2025 NA

Sundernagar - Himachal Pradesh

Tender For supply of electrical connection lugs or thimbles (q3) , mcb miniature circuit - breakers for a. c. operation as per is / iec 60898 (part 1) (q2) , pvc channel (q3) , switch fuse unit (q3) , piano type non modular domestic fan regulator as per is 11037 (q3) , ht tape (q3) , electronic component cleaner (co2) (q3) , m - seal as per is 9197 (q3) , modular electrical enclosure switch board boxes for modular type accessories (q3) , electrical sleeves as per is 11654, is 5831 (q4) , function generator (q3)

Central Government/Public Sector

CTN :42996564

22 Dec, 2025 NA

Jaisalmer - Rajasthan

Tender For supply of assy cylinder block , assy cylinder head , gasket engine over hall , piston std , set of piston ring std , set of thrust washer , set of main bearing , con rod bearing , con rod bush , srdg ball bearing , locking plate , key-8x13 crank , cam shaft bush , propeller key camshaft , valve tappet in ex gaed , push rod inlet and exhaust , lock retainer valve spting , valve spring lock half , valve spring washer , gasket for support inj pump , rubber tube 140 injector , hose reducer for leak off inj , head water separator spin on , hose clamp , element air cleaner primary , element air cleaner softy , valve inlet and exhaust , valve oil seal , thermostat plastic assy , thermostat hose pipe with clamp , speedo meter sensor f14 wheel , banjo washer 10,12,14,17,19 , clutch sleeve cylinder assy. , clutch master cylinder assy. , diesel filter , oil filter body with filter , wiper motor reserve tank , timing cover oil seal front , crank shaft rear oil seal rear , diesel rubber pipe , jumble clip big medium , oil pipe rubber , rubber pipe hose , cam shaft tikki , oil jet , clutch plate assy , locking wire release brg , back light assy. rh ) /bid number: gem/2025/b/6949870 * /dated: 01-12-2025 & & / bid document1 / 38

State Government

CTN :42886737

08 Dec, 2025 4.63 Lacs

Kinnaur - Himachal Pradesh

Tender For corrigendum : providing, replacement, and successful commissioning of electrically insulated driven end bearing oil seal , filter elements, and mechanical flow controllers for hydraulic equipment at 4.5 mw bap kafnu power house

Central Government / Public Sector

CTN :42998272

11 Dec, 2025 NA

Dhanbad - Jharkhand

Tender For supply of impeller with shaft for fd fan , bearing without housing , bearing housing without bearing , shaft seal , resilient type flexible coupling , ivc damper with linkage without actuator , inlet air filters

State Government

CTN :42966383

04 Dec, 2025 30.00 Lacs

Kota - Rajasthan

Tender For name of work:- rmc to nagpura. - clearing and grubbing road land clearing and grubbing road land including uprooting wild vegetation, grass, bushes, shrubs, saplings and trees of girth upto 300 mm, removal of stumps of such trees cut earlier and disposal of unserviceable materials and stacking of serviceable material to be used or auctioned, upto a lead of 1000 m including removal and disposal of top organic soil not exceeding 150 mm in thickness as per morth specification clause 201. by mechanical means in area of thorny jungle, preparation of foundation for embankment scarifying existing bituminous surface to a depth of 150 mm by mechanical means scarifying the existing bituminous road surface to a depth of 150 mm and disposal of scarified material with a lift upto 3 m and lead upto 1000 m as per morth specification clause 305.4.3, wet mix macadam providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the material with water at omc in mechanical mixer (pug mill), carriage of mixed material by tipper to site, laying in uniform layers in sub-base/base course on a well prepared sub-base and compacting with smooth wheel roller of 80 to 100kn weight to achieve the desired density including lighting, barricading and maintenance of diversion, etc as per tables 400-12 & 400-13 and morth specification clause 406. by mechanical means with all lead, prime coat providing and applying primer coat with bitumen emulsion (ss-1) on prepared surface of granular base(wbm/wmm) including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per morth specification clause 502, tack coat providing and applying tack coat with bitumen emulsion (rs-1) using emulsion distributor at the rate of 0.25 to 0.30 kg per sqm on the prepared granular surfaces treated with primer & cleaned with hydraulic broom as per morth specification clause 503., bituminous macadam providing and laying bituminous macadam with hot mix plant using crushed aggregates of grading as per table 500-7 premixed with bituminous binder, transported to site with all leads laid over a previously prepared surface with paver finisher to the required grade, level and alignment and rolled to achieve the desired compaction as per morth specification clause 504. bitumen (vg-30), 20mm thick open-graded premix carpet using bituminous (viscosity grade/modified bitumen) binder providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using viscosity grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kn static roller capacity, finished to required level and grades to be followed by seal coat of either type a or type b or type c as per morth specification clause 510. case - ii by mechanical means bitumen (vg-30), seal coat providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using type a, type b and type c as per morth specification clause 511 by mechanical means case - ii : type b bitumen (vg-30), construction of subgrade and earthen shoulders construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300-2 with lead upto 50 m as per morth specification clause 305.3, carriage of material from quarry / crusher to work site including loading, unloading and stacking all complete. earth, sand, lime, morrum manure or sludge, marking centre line and stop lines etc. on road as per irc pattern with thermoplastic paint of approved quality and make with 8% glass beads laid on the road surface at temperature 160" c with a special applicator mach

State Government

CTN :42915120

03 Dec, 2025 90.65 Lacs

Kota - Rajasthan

Tender For - rmc to mawasa - clearing and grubbing road land clearing and grubbing road land including uprooting wild vegetation, grass, bushes, shrubs, saplings and trees of girth upto 300 mm, removal of stumps of such trees cut earlier and disposal of unserviceable materials and stacking of serviceable material to be used or auctioned, upto a lead of 1000 m including removal and disposal of top organic soil not exceeding 150 mm in thickness as per morth specification clause 201. by mechanical means in area of thorny jungle, preparation of foundation for embankment scarifying existing bituminous surface to a depth of 150 mm by mechanical means scarifying the existing bituminous road surface to a depth of 150 mm and disposal of scarified material with a lift upto 3 m and lead upto 1000 m as per morth specification clause 305.4.3, wet mix macadam providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the material with water at omc in mechanical mixer (pug mill), carriage of mixed material by tipper to site, laying in uniform layers in sub-base/base course on a well prepared sub-base and compacting with smooth wheel roller of 80 to 100kn weight to achieve the desired density including lighting, barricading and maintenance of diversion, etc as per tables 400-12 & 400-13 and morth specification clause 406. by mechanical means with all lead, prime coat providing and applying primer coat with bitumen emulsion (ss-1) on prepared surface of granular base(wbm/wmm) including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per morth specification clause 502, tack coat providing and applying tack coat with bitumen emulsion (rs-1) using emulsion distributor at the rate of 0.25 to 0.30 kg per sqm on the prepared granular surfaces treated with primer & cleaned with hydraulic broom as per morth specification clause 503., bituminous macadam providing and laying bituminous macadam with hot mix plant using crushed aggregates of grading as per table 500-7 premixed with bituminous binder, transported to site with all leads laid over a previously prepared surface with paver finisher to the required grade, level and alignment and rolled to achieve the desired compaction as per morth specification clause 504. bitumen (vg-30), 20mm thick open-graded premix carpet using bituminous (viscosity grade/modified bitumen) binder providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using viscosity grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kn static roller capacity, finished to required level and grades to be followed by seal coat of either type a or type b or type c as per morth specification clause 510. case - ii by mechanical means bitumen (vg-30), seal coat providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using type a, type b and type c as per morth specification clause 511 by mechanical means case - ii : type b bitumen (vg-30), construction of subgrade and earthen shoulders construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300-2 with lead upto 50 m as per morth specification clause 305.3, carriage of material from quarry / crusher to work site including loading, unloading and stacking all complete. earth, sand, lime, morrum manure or sludge, marking centre line and stop lines etc. on road as per irc pattern with thermoplastic paint of approved quality and make with 8% glass beads laid on the road surface at temperature 160" c with a special applicator machine complete wi

State Government

CTN :42955278

03 Dec, 2025 24.12 Lacs

South Tripura - Tripura

Tender For mtc. of road from nh-08 to achaichi mog para (mla para) (l=3.50 km) / sh:-metaling, grouting, re-carpeting, tack coat, seal coat, pucc drain etc. during the year 2025-26 (gr-ii).

State Government

CTN :42955279

03 Dec, 2025 23.22 Lacs

South Tripura - Tripura

Tender For mtc. of road from purba pilak to bagmara via sukulbari (l= 5.50 km) / sh:- grouting, wbm iii, re-carpeting, seal coat, surface drain, palasiding, gunny bag placing etc. during the year 2025-26. (portion from ch.2.50 km to ch. 3.640 km) (group- i)

State Government

CTN :42955280

03 Dec, 2025 24.19 Lacs

South Tripura - Tripura

Tender For mtc. of road from jolaibari-kowaifung road to naba ram para (l=1.444 km)/ sh:-metaling, grouting, re-carpeting, tack coat, seal coat, surface drain etc. during the year 2025-26

State Government

CTN :42972796

05 Dec, 2025 72.80 Lacs

Sepahijala - Tripura

Tender For mtc. of road from takarjala to gobinbari (l=6.25km)under jampuijala block, sepahijala tripura/s.h:- wbm-3, carpeting, seal coat,paver blocks,drain etc. during the year 2025-26(portion from 3.00 to 6.25km).

Meter Seal Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors