Tender For bid to ras supply of 2 w electric vehicle working model training setup in open learning format , evse test system for lab purpose , embedded development kit , trainer for studying chopper fed separately exited dc motor drive operation , trainer for studying brushless dc drive operation and control. , trainer for studying controlled rectifier fed separately excited dc motor drive operation. , ac and dc distribution trainer kit , three phase transmission line trainer kit , air circuit breaker trainer kit , linear system simulator , study of temperature control system , study of temperature transducers , dc motor torque speed study , ac motor torque speed study , setup for dc motor speed control with matlab
Tender For corrigendum : purchase of consumables - department of electronics engineering, wire (1sq.mm. coil) red, wire (1sq.mm. coil) black, wire (1sq.mm. coil) green, bulb(filament)-40w, bulb(filament)-60w, bulb(filament)- 100w, straight batten holder, switch-one way, bread board, capacitors-0.22 f (400v), capacitors-0.47 f (400v), capacitor(disc)-100pf, capacitor(disc)-220pf, capacitor(disc)-330pf, capacitor(disc)-470pf, capacitor(disc)-0.1 f, capacitor(disc)-0.01 f, db3(diac), diode-1n 4007, fet-bfw 10, ic 7400, ic 7402, ic 7411, ic 7432, ic 7447, ic 7446, ic 7473, ic 7474, ic 7476, ic 7483, ic 7486, ic 7490, ic 7493, ic 74150, ic 74151, ic 555, ic 565, ic 741, ic- ad 534, ic-ad 633, ic-cd 4046, ic-lm 311, ic-lm 324, ic-lm 380, ic- lm 723, ift, resistors-1.2k (0.5w), resistors-1.5k (0.5w), resistors-2.2k (0.5w), resistors-4.7k (0.5w), resistors-56 ohm(0.5w), resistors-1k (0.5w), resistors-10k (0.5w), scr-2p4m, single strand wire(22 swg), transistor-bc 107, transistor-bc 194 b, ujt- 2n2646, battery water, battery 9v, combination plier(210 mm), insulation tape, paper cutter blade(18 mm) (1 box), thinner(sp 58 nc), 2 pin chord wire, solder 60/40, linear potentiometer (10k), linear potentiometer 100k, linear potentiometer 4.7k, linear potentiometer 1m, linear potentiometer 22k, led (red), led (green), led (blue), led (yellow), hdmi cable (1.5 meter), 2 pin chord wire (1 .5meter), solder 80g (60/40), insulation tape (nc), transistor (bc548), transistor (bc 547), wire stripper (), resistor (270 ohm,0.5w), resistor (1k,0.5w), resistor (10k,0.5w), resistor (120k,0.5w), linear potentio meter (10k), linear potentio meter (100k), linear potentio meter (4.7k), linear potentio meter (1meg), linear potentio meter (22k), ic (741), ic (7805), ic (cd4016), capacitor (2200mf,50v), capacitor (0.01mf), capacitor (0.1mf), led (red), led (green), led (blue), single strand hook up wire (23awg/coil), digital ic (7400), digital ic (7402), digital ic (7404), digital ic (7408), digital ic (7432), digital ic (7486), digital ic (7410), digital ic (7411), digital ic (7420), digital ic (7421), digital ic (7473), digital ic (7474), digital ic (7476), digital ic (7490), digital ic (7493), digital ic (74154), digital ic (74151), digital ic (7483), ppt slide changer with laser pointer (2.4g hz), pen drive (64gb), crimping tool, rj 45 connector, rj 45 cable tester, extension board (4-way), department of electrical and electronics engineering, capacitor bank: 10 kva 440 v 3 phase, capacitor: 60 mfd 440 v, capacitor: 50 mfd 440 v, 3 pin plug: 5a, 250v, pvc wire: 1.5 sq. mm, contact switch: 4 pole 15a 250v nc, surge protective device dc 270v 20ka, surge protective device ac 270v 20ka, 3core wire 1.5 sq. mm, capacitor: 33 mfd, capacitor: 10 mfd, resistor: 820 ohm, resistor: 1.5 kilo ohm, push button nc, push button no, floating switch, soldering lead, relay, buzzer, wire: single stranded, dc motor, battery, npn transistor, cro probe, ic 7476, ic 7410, mercury, cotton waste, thinner, diesel, department of instrumentation engineering, arduino uno, raspberry pi 5 with - 16gb,bcm2712 2.4ghz quad-core 64-bit arm cortex-a76 cpu,2 usb 2.0 ports, 2 usb 3.0 ports, bluetooth 5.0 / bluetooth low energy (ble),gpio standard 40-pin gpio header, video and sound 2 micro hdmi ports (up to 4kp60 supported), 4-pole stereo audio and composite video port, on board ports 1 x dsi, 1 x ethernet, 2 x micro hdmi, 2 x usb 2.0, 2 x usb 3.0, 40-pin 2.54 mm (2 20 strip) gpio, usb type-c port, micro sd card slot - supports high-speed sdr104 mode and raspberry pi 5 case-red-white, micro sd card 32gb, power supply and memory card reader., ir sensor module, pir sensor module, ultra-sonic sensor module, heat sensor module, temperature and humidity sensor module, blue tooth module, mq 3 air quality/gas detector module, ultrasonic sensor module, motor driver module- l298, buzzer, colour recognition sensor module, desoldering pump, battery 9v, diode 1n 4007, ujt 2n2646, regulator ic - 7805, regulator ic - 7809
Tender For supply of dc portable welding generator diesel drive as per rdso specification no. tm/sm/20 dt. 19.11.1992,second revision, 2022 or latest [ warranty period: 30 months after the date of delivery ]
Tender For corrigendum : supply of impulse generator ipg001 for efka make dc servo motor model no. dc 1550/ab 321 , efka make electronic motor model no. dc 1550/ab 321 complete with drive panel suitable for minerva m
Tender For supply of as per store list d d -mob trolley mounted 4-6 mm carbon steel fabrication fully welded leak proof 5 kl fuel bowser for safe transport, storage and dispensing capacity 5000 ltr under job no 0175 oblique 25-26 , manhole 400-500 mm dia with bolted cover venting sys- flame arresting breather vents pressure- vacuum type filling point - 3 inch or 4 inch anti-splash port with lockable cap , 1 inch ball valve for fuel drain , heavy duty steel chassis of overall length 4.5 meter, width 1.9 meter and height 1.8 mtr payload and gross vehicle mass 7000-10000 kg with landing jack 10000 kgs capacity , dual axle configuration wheels oblique tyre-heavy duty rated tyres e.g. 235 oblique 85r16 incl suspension leaf spring or rubber torsion braking system-pneumatic air break breakaway sys , spare wheel 235 oblique 85r 16 standard , landing oblique parking jack, wheel chocks and holders, reflective tape and hazard marking , pump type diesel oblique petrol compatible positive displacement or centrifugal flow rate 20 - 40l oblique min standard, drive type 12v oblique 24v dc motor petrol engine as per store list attached , antistatic fuel hose of length 8 mtr x 3 oblique 4 inch dia, and nozzle automatic shutoff oblique manual with digital flow meter , emergency stop switch, fire extinguisher 2 x 9 kg dry chemical powder, earthing cable and bonding point, anti-static bonding strap, pressure relief valves. , lighting for trailer, indicators, brake lights and tail lamps , spare tools spanner de open jaw 30 x 32, ring spanner 30 x 32 plier side cutting, tyre lever, screw driver, hammer 200 gm, tester and oil can each one as per store list attached , documentation and certificate. material test cert, pressure and leak test cert, welding procedure and welder qualification records, roadworthy cert records, roadworthy cert as per store list attached ) /bid number : gem/2026/b/7096356 * /dated: 09-01-2026 & & / bid document 1 / 16
Tender For supply of open spanner set inches 1 by 4 inch x 1 1 by 4 inch , ring spanner set mm upto 50mm , open spanner set mm upto 50mm , ring spanner setinches 1 by 4 inch x 1 1 by 4 inch , allen key set mm 1 pt 5 mm to 10 mm make , allen key set inches 1 by 16 inches to 3 by 8 inches , set of screw driver taparia or everest make , hand operated grease pump of 10 kg capacity with all fittings , set of ratchet handle of size 1 by 4 inch 3 by 8 inch and 1 by 2 inch , set of t handle of 1 by 4 3 by 8 and 1 by 2 drive , socket set light duty 10mm to 34mm , socket set heavy duty 3 by 4 inch square drive , battery hydrometer , screw driver small 08 inch , screw driver length 450 mm , meco digital insulation tester , sledge hammer 8 lb with wooden handle , digital multimeter 600 volts dc 600 volts ac , chisel 8 inch , center punch 6 inch , feeler gauge 0 pt 05 mm to 1 mm length 200 mm , cutting plier 8 inch , nose plier 6 inch