Get complete information related to latest Rubber Flange Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Rubber Flange Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Rubber Flange Tenders.
Tender For corrigendum : supply of tata mobile ba no 09c 086852k - labour charge for complete vehicle servicing , engine oil 15w40 , diesel fuel filter , oil filter , coolant , steering oil , break oil , clutch oil , air filter , labour for wheel alignment and wheel balancing , labour for fuek tank cleaning , labour for check front disc brake rubber boots calliper , brake rubber boot , labour charge for external clogging of intercoolers and radiator , labour for check all drive belts conditions , labour charge for carryout bleeding of clutch actuation system , labour charge for check proper sealing of air intake system , labour charge for check and tightening all fasterners , fasterners with accessories , labour charge for checking electrical system ensure usage of geniune fuses with correct rating condition of fuse and relay holding base , fuses with relay , labour for check steering wheel play check for proper condition of ball joints and rubber boots of tie rod drag link , rubber boots of tie rod , labour charge for complete servicing of door with necessary replacement , labour charge for checking of wiper assembly and replacement of unserviceable parts , wiper motor assy , wiper linkage , wiper blade , wiper arm , labour charge for complete dismantling and servicing of rear load leaf spring and bending and refitting the same and replacement of unseerviceable parts , rear spring bushing kit , centre bolt , clamp , labour for complete burnt starter from vehicle and replacing following parts , solenoid switch , carbon brush set , bushing set , fitting kit , labour charge for complete dismantling of steering from the vehicle and repair replacement of worn out spares , replacement of steering centre line assy , replacement of steering centre line pin kit , material and labour for servicing washing and greasing bid number/ ( ( ) ): gem/2024/b/5660450 dated/* : 12-12-2024 bid document/ 1 1 / 26
Tender For supply of cast steel non return valve with bypass,size 6inch , cast steel foot valve,size 6inch,body pressure 900psi , m seal hot compound with hardner , earth leakage relay with cbct,12v,1 to 750ma , intrinsically safe and bis certified audio visual alarm with dgms approved and bis certified , p.t.400va,550 to 220v 110v 24v 12v , isolator 200amp , bushing insulator with stud , turn buckle 10 tonne capacity , chain pulley block 10tonne capacity , lashing chain,0.75 inch, with test certificate,load bearing capacity 8 tonne , mccb,400amps,4 pole , fixed contact,cb200b1 , moving contact, cb200b2 , over load relay,300a 5 daspot , on delay timer,110v,ac,0.1 to 30sec , 3.3kv vulcanising rubber tape 6inchx10mtr per roll
Tender For supply of bushing rubber (center pivot arm bush) for hhp locomotive emd pt.no.40076 807 to dlw pt. no. 17452200 to dlw drg. no. 40076807 alt-b [ warranty period: 30 months aft er the date of delivery ]
Tender For supply and installation of neoprene rubber bellow - 1_supply of 1000 mm od neoprene rubber bellow _ 1013 mm gt side _ as per specification in drawing k-12-51130- 2512-ed and k-12-51130-2513-ed , 2_installation of neoprene rubber bellow 1000 mm od _1013 mm gt side _ as per specification in drawing k-12-51130-2512-ed and k- 12-51130-2513-ed , 3_supply of 1000 mm od neoprene rubber bellow as per specification in drawing k-12-51130- 2512-ed and k-12-51130-2513-ed , 4_installation of neoprene rubber bellow 1000 mm od as per specification in drawing k-12-51130-2512-ed and k-12-51130-2513-ed , 5_supply of 680 mm od neoprene rubber bellow as per specification in drawing k-12-51130-2512-ed and k-12- 51130-2513-ed , 6_installation of 680 mm od neoprene rubber bellow as per specification in drawing k-12-51130- 2512-ed and k-12-51130-2513-ed , 7_installation of 500 mm od neoprene rubber bellow at generator terminal as per specification in drawing k-12-51130-2511-ed , 8_supply of spare 500 mm od neoprene rubber bellow generator terminal as per specification in drawing k-12-51130-2511- ed , 9_supply and installation of ipbd inspection window gasket and repairing of lock nut arrangement as per specification in drawing k-12-51130-2524-ed and k-12- 51130-2544-ed , 10_installation of 1000 mm od seal-off bushing as per specification in drawing k-12-51130-2529- ed , 11_supply of 1000 mm od seal-off bushing as per specification in drawing k-12-51130-2529-ed , 12_installation of 680 mm od seal-off bushing as per specification in drawing k-12-51130-2529-ed and k-12- 51130-2508-dd , 13_supply of spare 680 mm od seal-off bushing as per specification in drawing k-12-51130-2529- ed and k-12-51130-2508-dd , 14_installation of 24 kv bus support insulator as per specification in drawing k-12- 51130-2527-ed and k-12-51130-2525-ed , 15_supply of spare 24 kv bus support insulator as per specification in drawing k-12-51130-2527-ed and k-12-51130-2525-ed