Latest transmission item scrap Tenders | Government transmission item scrap Tenders

Central Government/Public Sector

CTN :38191294

16 Dec, 2024 NA

Ratlam - Madhya Pradesh

Tender For supply of set of modified lubricated pin for equaliser, compensation beam and link f or wag7 electric loco. set consists of 02 items and 28 items as under- (i) equaliser pin t o rdso drg. no. skvl-703 alt.4 ref.1 & 11=12 nos. (ii) equaliser pin to rdso drg. no. skvl-7 03 alt.4 ref.2 & 11=16 nos. [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38209280

13 Dec, 2024 NA

Valsad - Gujarat

Tender For supply of set of maintenance kit for ep relay valve for 3-phase electric locomotives with e-70 brake system to m/s ftrtipl kit part no. 790013105 (d&m ref no-rk-ab914-w47) c onsisting of 15 items 18 nos. as per attached annexure. [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38209137

23 Dec, 2024 NA

Dahod - Gujarat

Tender For supply of set of axle box assembly complete with normal roller bearing for wag-7 electric locos a s per rdso drg.no.sk.vl-603 (alt.07) and conforming to rdso specification no. mp.0.3600-01, rev. 0 1 nov. 2020. one set consisting of 03 items 12 nos. as under. (1) centre axle box with plain end cove r & bearing rb-5020 = 04 nos. (2) end axle box with speedometer end cover & bearing rb-5020(lh& rh) =02nos. (3) end axle box with plain end cover & bearing rb-5020 = 06 nos. [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38190265

21 Nov, 2024 NA

Darbhanga - Bihar

Tender For supply of ioh replacement kit for single bottle vcb of m/s schneider electric type 22 cb consistin g of 14 items as per part no-5510750, confirming to rdso smi no. elrs/smi/0236 (rev-1) dated 31.12 .12 as per annexure attached. [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38192782

30 Nov, 2024 NA

Delhi - Delhi

Tender For supply of overhauling kit for stop cock (part no. i88738 )and kbi kit no. xki/kit/02483 of electric ccb. (one set consists of 1 6 items 22 nos.) as per the attached annexure. [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38038702

28 Nov, 2024 NA

Nagaur - Rajasthan

Tender For design, manufacture, supply, installation, testing and commissioning of electric overhead tra veling crane of capacity 65/10t nac- (refer clause 4 of section iv with heading - scope of supply) with comp rehensive preventive maintenance during warranty period (as per para 16 of section v) and leading parame ters of eot crane as per schedule-i of annexure- specification appended with the tender. it also includes sp ares as per schedule-iv & additional spares and items viz. slings/lifting tackles/wire rope etc. as specified in s chedule-i and maintenance tools as per schedule v of specification appended with tender. cost of dsl & its i nstallation and commissioning also included as per schedule-i of specification appended with tender. all rela ted erection material required for inspection and commissioning of crane and connecting up to electrical equ ipments with cable laying and fixing accessories shall be included in the cost of basic eot crane. ]

Central Government/Public Sector

CTN :38209389

28 Nov, 2024 NA

Nagaur - Rajasthan

Tender For design, manufacture, supply, installation, testing and commissioning of electric overhead tra veling crane of capacity 65/10t nac- (refer clause 4 of section iv with heading - scope of supply) with comp rehensive preventive maintenance during warranty period (as per para 16 of section v) and leading parame ters of eot crane as per schedule-i of annexure- specification appended with the tender. it also includes sp ares as per schedule-iv & additional spares and items viz. slings/lifting tackles/wire rope etc. as specified in s chedule-i and maintenance tools as per schedule v of specification appended with tender. cost of dsl & its i nstallation and commissioning also included as per schedule-i of specification appended with tender. all rela ted erection material required for inspection and commissioning of crane and connecting up to electrical equ ipments with cable laying and fixing accessories shall be included in the cost of basic eot crane. ]

Central Government/Public Sector

CTN :38191305

18 Dec, 2024 NA

Jodhpur - Rajasthan

Tender For supply of overhauling kit for drain valve of electric ccb to kbi pt. no. i82281 for 3-phase locomotives (23 items 33 nos). [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :38005126

18 Nov, 2024 45.72 Lacs

Mundra - Gujarat

Tender For corrigendum : provn of 02 in nos bore wells alongwith associated items at icgs mundra - material and labour for drilling of 02 nos pilot/trial bore by direct rotary rig method including all t&p through any kind of starta (soil, kankar, boulder or soft or hard rock) down up to 150 m depth below ground level by using suitable drill bit according to levering of casing pipe including the cost of mud pit, channels, etc and disposal of soil obtained to a distance not exc. 1 km away complete all as specified. note:- (i) the drilling shall be continued up to specified depth and in case sticky clay occurs in between the drilling must be stopped and hydrologist of gws & sb shall be contacted & eggr-in-charge shall be informed.(ii)cost of this consultant shall be borne by contractor (iii) taking the samples from the bore well cutting for every 3 meter interval and every change in strata if less than 3meter. (iv) preparation of litho logs based on these samples.(v) drill time log to be prepared and prescribed., (vi) aquifer performance tests at constant discharge with draw down and recovery reading.(vii) after completion of pilot bore, the contractor shall have to arrange for electro eater logging test of each bore.(viii) contractor have also produced bore well water test report for drinking water parameters before levering of motor and pump.(note:- if water quality not found fit for domestic purpose use then all other connected items of trial bore will not be executed.) , supply assembling, jointing, lowering and fixing in the bore hole pvc casing pipe of nominal dia 315 mm (medium well) ,10 kg/cm2 working pressure, confirming to is 4985-2000 including providing pea gravel of 8 mm to 4.6mm size for packing around the casing/slotted pipe in bore well all as specified and directed. make: astral/ashirwad/ajay/sfmc, all as per item no 2.00 above but slotted pipe. , supply, assembling, jointing, lowering lead free pvc column pipes of nominal dia 65 mm, od 75 mm (min), non toxic, pressure 16 kg/cm2 with and including top and bottom adaptor (ss) and accessories like epdm ring and double ss stud all as spd and directed by engineer-in-charge. make: astral/ashirwad/ajay/sfmc, development of tube well with compressed air by means of air compressor of suitable capacity not less than 300 cfm and over pumping using suitable capacity pump to make available water free from turbidity complete all as specified and directed by engineer-in-charge., m & l for conducting yield test for the bore well by continuously pumping for 24 hours by using a submersible pump set to determine safe pumping yield and produced water test report of samples which is collect every hour complete as directed by the engineer-in-charge. [ all arrangements for yield test shall be made by contractor and cost for the same borne by contractor ], supply and fix ms reducer, bail plug, top cover made of 3mm thick ms plate for bore well in two half sections having a hole of 75 mm bore in centre to accommodate pvc pipe and submersible cable suitable for fixing to the pvc casing pipe top, electric logging and simple strata box including provision of 2 sets of ms clamps made of 50x6mm ms flat including nuts, bolts, etc. including one coat of epoxy primer and two coats of epoxy paint wherever necessary complete all as specified and directed by engineer-in-charge., supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, water lubricate, 3 phase, 10.0hp (appx) 415 volts, 50 hz with suitable submersible electric motor suitable for discharge of 2 liters per second against total head of 125m in the bore complete all as specified and directed by the engineer-in-charge. [ note : column pipe, submersible cable and control gear will be measured and paid separately]. [make: kirloskar / crompton / ksb], supply, install, test and commissioning of submersible pump stainless steel body electric driven with submersible motor, wa

Central Government/Public Sector

CTN :38175619

02 Dec, 2024 13.95 Lacs

Ajmer - Rajasthan

Tender For supply of electrical capital items spares-250mm plastic ventilation fan with bldc motor., 300mm metal ventilation fan with 240v., 300mm plastic body ventilation fan with 240v., 1200mm ceiling fan with 240v bldc motor., 400mm pesedtila fan bldc motor., 400mm wall fan bldc motor., 0.5 hp monioblock submersible pump 230v 1lps at 8 mtr., 2 hp monoblock submersible pump., 5 hp monoblock submersible pump 415v., 3500t 750watt came make sliding gate motor. , gear box airport avaition beacon motor make manairco., conventional photo electric smoke detector., 1kva ups 30minute backup. , electric grass cutting machine. , erathing rod set 33kv., battery powered impact wrench., marble cutter machine 230v. , double ended fire siren 3.25 km range 6000 rpm., 18 mtr tricolor led rope light., cable drum lifting screw jack., midium intensity aviation warning led light., 2000watt 230v heat convertor. , 25 w 110 lumen led street light., 72 w 110 lumen led street light

Transmission Item Scrap Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors