Tender For corrigendum : national competitive bidding for the supply of machinery and equipment for bone and joint hospital srinagar (burr system for spine and craniotomy surgery )
Tender For tender for supply of hand held fetal dopler rechargeble clear display and sound vaginal examination lamp leather mattresses for labour room infrared light machine for episiotomy laryngoscope with blade (adult) laryngoscope with blade (paed) pulse oximeter x-ray view bак nibbler all size curve/straigh pariasotome elevator all size bone holding forceps all type torniquet machine laryngo scope set bhuji adult/paediatric patient shifting trolly with reeling trial lens set golden & silver stainless steel trail frames adult size valk lens +900 otoscopes headlight beamsplitter with endopaet (opto dolight ent microscope) ent microdrill burr set rechargeble torche nasal packs 8" abgel dcr stents bed side multipara trolly swd (short wave diathermy) 500w/1000w ift (interfenen tial therapy) mgior tens (major) muscle stimulator (major) air compressor 1.1hp, 40 ltr. tank retractors all size right angle kinesiotape rails ultra sound therapy (1mhz+3mhz) stethoscope operation table/trolly and operation instrument trolly freeze refrigerator 220 lit volk 200 (super field) schiotz tonometer torch (55 with yellow light) vision charts distant near suction machine tourniquet machine
Tender For supply of corrigendum : e- 225/mmgpa/equipments for ent (2025-26)--, ent operating microscope , two sets of micro drill with head pieces and burr head hole , two sets of micro ear surgery instrument , puretone audiometer , impedence audiometer , otacaustic emission analyzer (oae)
Tender For corrigendum : tender for rate contract of orthopedic spine implants - spine implants, pedicle screw set for spine consisting of 4 screws with ini and 2 connecting rods; top loading, polyaxial screws 4.5mm/5.5mm/6.5mm, length- all sizes, with one trans rod connector(all sizes). titanium., pedicle screw set for spine consisting of 4 screws with ini and 2 connecting rods; top loading, monoaxial screws 4.5m25m/5.5mm/6.5mm, length- all sizes with one trans rod connector(all sizes). titanium., pedicle screw set for spine consisting of 8 screws with ini and 2 connecting rods; top loading, polyaxial screws 4.5mm/5.5mm/6.5mm, length- all sizes. titanium., pedicle screw set for spine consisting of 8 screws with ini and 2 connecting rods; top loading, monoaxial screws 4.5mm/ 5.5mm/ 6.5mm, length- all sizes. titanium, cervical spine locking plate set, titanium. plate length 36mm to 90mm (adequate for one to four level vertebral fixation), 4 screws 4.0 mm( length 14mm/16mm)., top loading implant system for posterior stabilization of cervical spine and upper thoracic spine -the system should have locking screws for angularly stable locking and fixation of the rod. the system must have self- tapping screws. the system must have 3.5 mm ti rod. the system should have oc fusion option. the system should offer hooks. cancellous profile bone screws: 3.5 mm: 8 mm 50 mm (2 mm increments ) 4.0 mm: 8 mm 50 mm (2 mm increments). cortical profile bone screws: 3.5 mm: 28 mm 50 mm (2mm increments). screw head profile: height = 11 mm, diameter=9 mm. rod run = 9 mm. shaft screws (cortical profile):3.5mm: 22 mm 36 mm (2mm increments). shaft screws (cortical profile):3.6mm: 22 mm 36 mm (2mm increments). shaft screws should have 10 mm unthreaded portion rods must be of the following specifications: 3.5 mm ti rod: 80 mm, 120 mm and 240 mm lengths. 3.5 mm/5.0 mm ti rod, 120 mm/170 mm. 3.5 mm/6.0 mm ti rod, 120 mm/170 mm. trans-connector: 60 mm and 75 mm. short and long/left and right hooks. 3.5 mm ti transverse bar. the system should have occipital plate/rods options. should be quoted as a set of 4/6/8 screws with inner nuts and 2 rods. should provide undertaking to provide the instrumentation one day prior to surgery. price of transverse connectors and occipital plate with screws to be quoted separately., titanium mesh cage, fenestrated and hollow from inside to accept bone graft- all sizes (10-16mm dia, 80mm length)., titanium tlif banana cage - all sizes (6/8/10/12mm height, small/medium/large foot print), titanium expandable cage for cervical/ thoracic/ lumbar spine. misc sizes *, device for intervertebral assisted motion 8mm, 10mm, 12mm, 14mm *, titanium anterior staples 13 mm, 15mm, 17 mm, plif cage peek 7-14 mm, foot print 22-28 mm. 1 set consists of 2 pcs *, tlif cage peek 7-14 mm, foot print small/ medium/ large. 1 set consists of 1 pc *, laminoplasty spacer peek with 2 screws misc sizes *, kyphoplasty kit *, vertebroplasty kit *, absorbable haemostat (oxidized regenerated cellulose), sterile 1.25 x 5cm, hemostatic matrix plus flex tip (flowable haemostat)*, non- suture self adhesive artificial dural membrane (small / medium size), round tip diamond burr with long handle (2mm diameter) stryker, round tip diamond burr with long handle (3mm diameter) stryker, round tip carbide burr with long handle (3mm diameter) stryker, hydroxyapatite trapezoidal spacer (2cm x 1cm x 0.5cm) for cervical laminoplasty, titanium lateral mass/ pediclescrews set (4 screws 3.5mm and 2 rods and transverse connector) *, titanium cannulated lag screw for odontoid all sizes *
Tender For corrigendum : technical specification point wise dbs implant & accessories - dbs rechargeable with directional lead with25yr battery life & image guided programming integrated inside clinician programmer with micc multiple independent current control technology with zero volt technology,bluetooth connectivity with clinician and patient programmers, usfda & ce approved kit contents: rechargeable pulse generator-1 , directional lead kit -2 , extension kit -2 , burr hole locking kit -2 , tunneling tool -1 , patient remote control kit -1, patient charging kit -1 , dbs rechargeable with non directional lead with 25yr battery life & image guided programming integrated inside clinician programmer micc multiple independent current control technology with zero volt technology,bluetooth connectivity with clinician and patient programmers. have 8 contact non-directional lead kit with array span of 15.5mm for maximum coverage, usfda & ce approved kit contents:rechargeable pulse generator -1, non-directional lead kit -2, extension kit -2, burr hole locking kit -2, tunneling tool -1, patient remote control kit -1, patient charging kit -1, dbs non rechargeable with directional lead with image guided programming integrated inside clinician programmer micc multiple independent current control technology &bluetooth connectivity with clinician and patient programmers,usfda & ce approved kit contents: non-rechargeable pulse generator -1 , directional lead kit -2 , extension kit -2, burr hole locking kit -2 , tunneling tool -1 , patient remote control kit -1,), dbs non rechargeable with non-directional lead with image guided programming integrated inside clinician programmermicc multiple independent current control technology withbluetooth connectivity with clinician and patient programmers. should have 8 contact non-directional lead kit with array span of 15.5mm for maximum coverage,usfda & ce approved kit contents: non-rechargeable pulse generator -1, non-directional lead 1), dbs implant kit with non-rechargeable, 3t mri compatible and sensing enabled ipg and directional leads.the implanted pulse generator (dbs neurostimulator- ipg) should have a minimum service life of 5-7 years and there should not be a need to recharge it periodically.ipg should have the capability for group programming and ability to store the programming data in ipg itself and retrieve from ipg.the system should be able to sense local field potentials (lfps) from brain targets and this data should be accessible through the physician programmer. the leads should be able to stimulate in specific directions, in addition to the ability to stimulate circumferentially. markers on leads should facilitate directional programming even if lead rotates. the leads should also be able to sense lfps.burrhole kit should be there for securing lead in place. microelectrodes for intra op stimulation and recording should be there.the extension connecting the lead and ipg should be flexiblethere should be a tunneller to place the extension wire and the tunneller should be metallic and firm to enable smooth tunnelling.the system should have approval for conditional full-body 1.5t & 3t mri compatibility.patient programmer, enabling the patient to see and if needed, modify the stimulation under guidance, should be available. patients should be able to mark dyskinesia, tremor etc. using the programmer., dbs implant kit with rechargeable, 1.5t & 3t mri compatible and sensing enabled ipg and directional leads.the implantable pulse generator (dbs neurostimulator- ipg) should have a service life of 15+ years if regularly recharged by the patient at specified intervals.ipg should have the capability for group programming and ability to store the programming data in ipg itself and retrieve from ipg.the system should be able to sense local field potentials (lfps) from brain targets and this data should be accessible through the physician programmer. the system shou