Tender For corrigendum : combined package of the following workswork a establishing 1x20mva, 110/33kv and 2x20mva, 110/11kv substation at ahmedabad and construction of 110kv lilo line to proposed 110/11kv ahmedabad substation from existing 110kv halbarga santhpur line for a distance of about 0.237kms in bhalki taluk, bidar district. work b construction of 110kv lilo line to existing 110/11kv nirna substation from existing 110kv manna e khelli chincholli ine for a distance of 1.406kms and construction of 110kv terminal bays at existing 110/11kv nirna sub station for termination of proposed 110kv lilo line from existing 110kv manna e chincholi line in humnabad taluk, bidar district on partial turnkey basis including supply of all matching materials/equipments (excluding supply of 11kv switchgear) and erection (including dismantling and civil works) of all materials/ equipment, testing and commissioning
Tender For supply of various electrical lt switch gears control equipment and cables in the ltdb of power load b b - supply of 630 amp 3 pole mccb 415 volt, , supply of spreader link for 630-amp 3 po , supply of extended rod with handle 630-a , supply of ring ct make- kappa, ratio- 60 , supply of 400 amp 3 pole mccb 415 volt, , supply of spreader link for 400-amp 3 po , supply of extended rod with handle 400-a , supply of ring ct make- kappa, ratio- 40 , supply of 200 amp 3 pole mccb 415 volt, , supply of spreader link for 200-amp 3 po , supply of extended rod with handle 200-a , supply of ring ct make- kappa, ratio- 20 , supply of 100 amp 3 pole mccb 415 volt, , supply of spreader terminal for 100-amp , supply of extended rod with handle 100-a , supply of ring ct make- kappa, ratio- 10 , replacement and retrofitting of 630 amp 3 , replacement and retrofitting of 400 amp 3 , replacement and retrofitting of 200 amp 3 , replacement and retrofitting of 100 amp 3 , supply of 95 sq mm single core copper fl , laying of 95 sq mm single core copper ca , supply, replacement and re-fixing of 95 , supply of indicating led lamp red- 60 n , replacement and re-fixing of indicating , supply of multifunction meter make- secu , installation, calibration, testing and ret , supply of auxiliary contactor for mccb m , ring ct installation and retrofitting , control cable connection and circuit mod , supply of 2.5 sq mm flexible wire , supply of 400 amp 3 pole power contactor , supply of 160 amp 3 pole power contactor , supply of 160 amp 3 pole mccb for capaci , supply of spreader terminal for 160-amp , supply of extended rod with handle 160-a , replacement and retro-fitting of 400 am , replacement and retro-fitting charges fo , replacement and retro-fitting of 160 amp , supply of 12 window apfc relay, make- ep , replacement and retro-fitting charges fo , supply of 3-phase digital voltmeter make , supply of 3-phase digital ammeter make- , replacement and retro-fitting of 3-phase , rectification and restoration of mechanic , supply of 300 sq mm, 3.5 core, 1.1 kv gr , supply, fitting and fixing of gland for 30 , laying of 3.5 core, 1.1 kv grade armoure , supply and replacement of socket for 300 s , manual disconnecting of power supply, di , supply, installation, testing and commis
Tender For clearing of dismantled terminal equipment and materials from 220kv kathalguri switchyard at agbps, neepco, bokuloni, dibrugarh and their systematic transportation to 220kv tinsukia gss, aegcl store along with proper staging
Tender For air break contactor, 24v ac, 200amps 1. coil voltage: 24v (+/-10%) ac, 50 hz 2. poles:3 3. rated operational current: 200amps @415v ac 4. duty: ac 3 5. contactmaterial: silver alloy tips 6. terminal: bolt & nut 7. insulation class: fr4 or higher 8. auxuliary contacts: 2no+2nc 9. auxiliary contact current: 4 amps @ 440v ac, 10. duty: ac 15 11. mounting: 35mm standard din rail or screw mounting on base plates 12. standard:is 13947-4-1/iec60947-4-1 or latest 13. the bidder should submit the catalogue and detailed specification at the time of bidding. 14. only original equipment manufacturers or their authorized dealers to quote 15. warranty- 18 months from the date of supply or 12months from the date of commissioning, whichever is earlier. [ warranty period: 18 months after the date of delivery ] ]
Tender For corrigendum : : supply, installation, testing & commissioning of electrical equipment for dg block 119a of inrp - ht panels (119a)supply, installation, testing & commissioning of indoor type floor mounted, single front, metal clad, 1250 a, 6.6 kv, 3 phase, 3 wire, vcb switchgear panel suitable for a short circuit current of 31.5 ka for 3 seconds, internally arc tested for 31.5 ka for 1 second, comprising of following incoming & outgoing feeders : incoming feeder: 1 no. 1250 a, 3p vcb outgoing feeders: i) 7 nos. 630 a, 3p vcbii) 1 no. 1250 a, 3p vcb as tie feederwith surge arrestors, relays, pts, cts & other necessary accessories including associated structural steel required for complete installation of the panel & equipment earthing of the panel from both the earthing terminals of the panel to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & drawings. reference drg. nos: ip1/119a/05027339/dwg/001/r0 & ip1/119a/05027339/dwg/002/r0(note: terminal box of each incomer of 6.6kv switchboard shall be suitable for terminating 4x3cx400 sq.mm., 6.35/11kv (e), a2xwy cables.), supply of spares for ht panels as per attached spares list mentiond in section c, part ii of tender, 2.5 mva, 6.6/0.433 kv dry type transformers (119a)supply, installation, testing & commissioning of 6.6/0.433 kv, 2.5 mva, dyn11 dry type cast resin transformer having percentage impedance of 8.5% complete with ht cable end box, lt bus duct flange, off load tap changer on ht side with range of +/-5% in steps of 2.5%, wti scanner, ct for restricted earth fault protection and other necessary accessories including associated structural steel required for complete installation of the transformer & equipment & neutral earthing of the transformer from both the earthing terminals of the transformer to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & drawings.reference drg. no. : ip1/119a/05034347/dwg/001/r0, supply of spares for dry type transformers as per attached spares list mentiond in section c, part ii of tender, 2000 kva diesel generator sets (119a)supply, installation, testing & commissioning of 3 phase 2000 kva prime power 433v, 50hz, 0.8 p.f. diesel-generator sets with 110% overload capacity for 1 hr with four (4) stroke inline or vee type cylinder arrangement having engine speed 1500 rpm, 24v electric battery starting system with a provision of interchangeability of battery bank between two dg sets, complete with all auxiliary equipment including amf control panel, auxiliary mcc panels, heat exchanger cooling system, raw water pump, remote radiator with fans on terrace, ms exhaust piping, exhaust structure (maximum 30 m stack), 4 nos. of 3.6 cubic metre fuel day tank outside dg building (for all 4 dg sets) & 1 no. of 990 ltr intermittent tank inside each dg room, ms "c" class fuel piping between engine & fuel tank, dg room accoustic treatment & complete ventilation of dg room, brushless excitation for alternator, one no. 3200 amp 415 v 4p acb, ms structural steel supports/ channels/ angles & other necessary accessories including associated structural steel required for complete installation of the dg & equipment & neutral earthing of the dg from both the earthing terminals of the dg to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & necessary statutory clearances from cpcb etc. as required and as per tender technical specifications & drawings. design and construction of foundation for exhaust pipe rack/ structure of dg set is included in the scope of the contractor.reference drg. nos. : i) ip1/119a/05034347/dwg/001/r0ii) ip1/119a/05044831/dwg/003/r0iii) ip1/119a/05044831/dwg/004/r0iv) ip1/119a/05044831/dwg/005/r0v) ip1/119a/05044831/dwg/006/r0, supply of sp
Tender For bid to ras supply of items for establish of perimeter svl setup d d - ptz camera , mounting box house terminal equipment , sc connector , spike arrestor , switch eight port , switch four port , screen sixty five inch , nvr sixteen channel , hard disk four tb , three kva online ups , twenty four port switch , ethernet cable , ofc cable twelve core , joint enclosure , rj fourty five connector , ote single fiber , electric wire one square mm dual core cable with insulated outer cover
Tender For auction sale of e-waste - e- waste scrap such as: used, unserviceable electrical consumable scrap items such as ballast, chokes, relays, voltage transformers with or without aluminium fittings/ss fitting /ms fittings/ci fittings/gi fittings, condensers, capacitors, hrc fuses, switches, fuse units, fused / broken tube lights, bulbs, incandescent lamps halogen lamps, light domes, electrical fittings. etc. with or without attachment of any other metal. scrap electronic consumables consisting of all types such as pcb boards, integrated circuits/electric cords, card readers, different types of chargers, reader boards, cassette recorders, door open switches, video jet 8000, heaters, power supply units, modems & temperature controllers, telephone instruments, telephone accessories cd drive, line driver, terminal server modems, eliminators, printer parts, printer cartridges of laser jet / ink jet / dot matrix, thin clients, monitors of all types & sizes, desktops, cpus, assorted types of cameras, c.c.t.v. cameras, metal detectors, projectors, air conditions, cellular telephones, answering systems, television sets, heat exchangers, scrap package type/window /split air conditioners, water coolers of different capacities, deep fridge, led lights, mcbs,elcbs etc. m.s./c.i. power distribution board control panels & transformer switchgear equipment of used / scrap in assorted sizes with / without electrical fittings, copper / aluminium cable, bus bars etc