Tender For bid to ras supply of piston set with pin and lock , piston ring set , main bearing , big end bearing , thrust washer , connecting rod bush , engine overhauling gasket with o ring and head gasket , inlet and exhaust valve , inlet and exhaust valve guide , inlet and exhaust valve seat , inlet and exhaust valve oil seal , front and rear crank shaft oil seal , inlet and exhaust rocker , chain tensioner set of 02nos , chain tensioner protector with lock set of 05nos , oil pump assy , water pump assy with pully , fan belt , fan belt tensioner , injectors with o ring , clutch plate , pressure plate , flywheel crank shaft pilot bearing , clutch cylinder lower and upper with adaptor , clutch cylinder upper , rubber hose pipe complete set with clamp , oil filter , diesel filter , air filter , ac filter , exhaust manifold stud 12no , turbo charger assy with gasket , inter cooler cover stud with bolt , benjo washer 12 14 17 19 22 no , thermostat valve , temprature sending unit , oil sending unit , heater plug , engine dummy plug , engine mounting left side , l key 14 no , valve grinding stick big and small , steel cleaning brush big and small , grinding paste , nut bolt 10 no , nut bolt 12 no , wiper blade ) /bid number : gem/2026/b/7555899 * /dated: 18-05-2026 & & / bid document 1 / 36
Tender For auction of obsolete and unserviceable materials ci gi pvc di ms rcc ac gmpremo motor pumpsubmersible pump weight balance chain block aluminium copper torsteel and rubber under public health division aluva
Tender For 1.5hp horizontal multi stage centrifugal pump of axial suction & vertical radial delivery withthreaded ports pressure booster pump set with following technical specifications. 1) rating - 1.1kw/1.5hp 2) min & max pressure setting range - 1.5 to 4.0 bar 3) flow rate at max pressure setting - 4800 lph 4) pumpsize - (25x25) mm 5) tank capacity - 35 liters 6) supply - single phase 230v ac 7) no. of stage -6 make: texmo, aquatex, ksb, kirloskar and mbh or similar [ warranty period: 30 months after the date of delivery ] ]
Tender For supply of self priming mono block pump, 0.5 hp/0.37 kw, 415 v ac, 50 hz, 3 phase with t.o.p. (c1 & c2), confirming to rcf specification no. edts-186, rev-a, am-2 (or) latest. suitable for self priming mono block pump assembly of lhb ac coaches. specn: spec.no.edts-186,rev a am-2(or) latest [ warranty period: 30 months after the date of delivery ] ]
Tender For supply of 10 hp monoblock pumps minimum three & above star rated centrifugal water pump (monoblock), 415 v, three phase, 50 hz, a.c. supply of 7.5 kw/10 hp with discharge 1380/660 lpm for head of 24/72 m and 65 mm suction/50 mm rpm-2880, 3 phase, 415 volt. as per specification attached. [ warranty period: 24 months after the date of delivery ] ]
Tender For 750 va, 110 v dc / 415 v ac natural cooled inverter for water raising pump in train set coaches (vande bharat) confirming to if specification no. icf/elec/172. make acceptable: medha, signotron, electrowaves, and hind rectifiers. supply from oem or authorized dealers with documentary evidence. (warranty period: upto 30 months from the date of delivery.) pl no. 31726495 [ warranty period: 30 months after the date of delivery ] ]
Tender For nit 21 work of replacement of submersible pump sets and accessories of tubewell at various locations under uwss chomu under jen section chomu (urban) under sub div chomu in jurisdiction of executive engineer, phed district division ii, jaipur - 2.15 supply & installation of 3 phase isi marked submersible motor pump set of three star or better rating of bee and as per is: 8034-2018 (pump) and is 9283-2013 (motor) or as amended up to date of approved make of following duty condition with required accessories including making connection suitable for tube well/dcb. the job includes lowering of motor pump, installation of complete fitting & accessories, jointing of electrical cables up to switch board, testing of submersible pump set and interconnection up to water mains, complete in all respect.2.15.2 up to 5.5 kw (7.5 hp) & head above 120 mtr., 2.15 supply & installation of 3 phase isi marked submersible motor pump set of three star or better rating of bee and as per is: 8034-2018 (pump) and is 9283-2013 (motor) or as amended up to date of approved make of following duty condition with required accessories including making connection suitable for tube well/dcb. the job includes lowering of motor pump, installation of complete fitting & accessories, jointing of electrical cables up to switch board, testing of submersible pump set and interconnection up to water mains, complete in all respect.2.15.4 7.5 kw (10 hp) & head above 120 mtr., 2.15 supply & installation of 3 phase isi marked submersible motor pump set of three star or better rating of bee and as per is: 8034-2018 (pump) and is 9283-2013 (motor) or as amended up to date of approved make of following duty condition with required accessories including making connection suitable for tube well/dcb. the job includes lowering of motor pump, installation of complete fitting & accessories, jointing of electrical cables up to switch board, testing of submersible pump set and interconnection up to water mains, complete in all respect.2.15.6 9.3 kw (12.5 hp) & head above 120 mtr., 2.18 supply and fixing of electric control feeder panel comprising of suitable rating mccb , fully automatic star-delta starter, over load relay, ampere meter with cts, volt meter, phase preventer, suitable starting capacitors, phase indicators, lighting arrangement etc complete suitable for three phase pump set. the panel should have space for energy meter ( supplied by discom). all these equipments shall be housed by panel box made out from 18 gauge m.s. sheet with powder coating. panel should be of minimum size 900 x 600 x 450 mm with stand ( made of angle iron of size 35x35x5mm) duly bolted/screwed with enclosure box having 4 legs, each leg s length 18 and double door including in built locking system. the legs should be embedded in m-15 cement concrete plat form. the size of cc platform should be equal or bigger than the base size of panel having height of at least 200 mm from ground level. the panel should have opening of suitable size in front of space for energy meter with glass for meter reading. the operation of panel should be suitable for on 440 volt ac supply.2.18.1 above 5 hp and up to 10 hp, 2.18 supply and fixing of electric control feeder panel comprising of suitable rating mccb , fully automatic star-delta starter, over load relay, ampere meter with cts, volt meter, phase preventer, suitable starting capacitors, phase indicators, lighting arrangement etc complete suitable for three phase pump set. the panel should have space for energy meter ( supplied by discom). all these equipments shall be housed by panel box made out from 18 gauge m.s. sheet with powder coating. panel should be of minimum size 900 x 600 x 450 mm with stand ( made of angle iron of size 35x35x5mm) duly bolted/screwed with enclosure box having 4 legs, each leg s length 18 and double door including in built locking system. the legs should be embedded in m-15 cement concrete plat form. t
Tender For corrigendum : supply of pump controller suitable for self priming mono block pump assembly of lhb type ac coaches, confirming to rcf spec no. edts-186, rev- a, ammendment -2, corr-2 orlatest. specn: rcf spec. no. edts-186, rev- a, ammendment -2, corr-2 or latest. [ warranty period: 30 months after the date of delivery ][quantity tolerance (+/-): 5 %age , item category : normal , total po value variation permitted: max 8 lacs ] ]
Tender For supply of water shower diaphragm quad pump 115 volts ac, 5ohz, 3/4 inch hose barb snap-in ports, open flow 5 gpm max, 45 psi pressure, 1.5 amps, polypropylene, epdm valves, santoprene diaphragm as per flojet model no-04300-043. accepted make: flojet/racold/jascop or similar make with isi mark suitable for lhb type first ac coaches. [ warranty period: 30 months after the date of delivery ] ]
Tender For mpcb for water pump 1 & 2 with auxiliary contact (1no+1nc) and terminal block db, rated current:1- 1.6 amp, thermal release range: 1-1.6a, rated voltage: 690 v, class-10, breaking capacity 50 ka, pole-3p, cat no. ms116-1.6, hk1-11 of abb or gv2-me06+gvae11 of schneider or 3rv20111aa10 +3rv2901-1e of siemens or st41894oooo+st41945oooo of l&t make. make- as per modification sheet no.rdso/pe/ms/tl/0090-2023 (rev-0) of lhb non ac coach.abb,schneider, siemens & l&t only. oem proof of purchase, warranty and test certificate submitted at the time of supply. [ warranty period: 30 months after the date of delivery ] ]