Get complete information related to latest Axis Gimbal Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Axis Gimbal Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Axis Gimbal Tenders.
Tender For 5hp non clog submersible sewage pump set, pumping capacity 72 cubic meter per hour at 8 mtrs head with speed 1450 rpm, complete with water protected seal for continuous operating 415v, 50 hz, supply with 10 mtrs, resin filled control cable and 10mtrs s.s chain with shackle and suitable fully automatic three phase starter control panel( dol/star delta starter which is suitable for that pump) along with single phase preventer with phase reversal sensing and dry run relay protection (current sensing type), thermistor relay and moisture control relay, analog /digital voltmeter , analog /digital ammeter , power on/trip and indication lamps, on/off switch and auto/manual mode switch (authorized dealership certificate to be enclosed while submitting offer, test certificate and warranty certificate to be submitted along with supply). make: ksb, kirloskar, mbh. karvel or similar [ warranty period: 30 months after the date of delivery] ]
Tender For bid to ras corrigendum : supply of service 11 kv ht panel as per sepcifications , sf new mineral oil for panel etc as per sepcifications , calibration relay etc as per sepcifications , replacement digital ammeter for ht panel , replacement digital voltmeter for ht panel , replacment ryb ind lamp led type in ht panel , sf 2a hrc fuselink in ht panel , servicing 1500kva dry type transformer as per sepcifications , servicing 2 runs 2500a tpn bustrunking as per sepcifications , service mv lt panel with 2500a 4p acb 3 nos as per specifications , service mvlt panel with mccb incoming as per specifications , checking and repair of em intelocking , dismentaling 3.5 sq mm 240 or 300 sq mm al cable as required , pf adaptor box aprx 1.5 ft x 1.5 ft x 1.5ft of 16swg ms sheet as reqd , pvdg panel module door key as reqd , pvd and fixing operating handle for 250a 4p changeover as reqd , replacement 160a hrc fuse with base in extg cap panel , replacement 3p 50kvar cap duty contactor in extg cap panel , replacement 25sq mm cu lead wire 1ft length in extg cap panel , checking etxg 2no 25kvar cap bank and fault repair reinstallation , dismentaling uv protection connections as reqd , replacement digital ammeter for lt panel , replacement digital voltmeter for lt panel , replacment selector switch in lt panel , replacment ryb ind lamp led type in lt panel , sf 2a hrc fuselink in lt panel , sf 32a hrc fuseling incl removing faulty item from lt panel as reqd , sf 63a hrc fuseling incl removing faulty item from lt panel as reqd , sf 100a or125a hrc fuseling incl removing faulty item from lt panel as reqd , sf 250a hrc fuseling incl removing faulty item from lt panel as reqd , sf new 5 or 6 amp piano switch in replacement of faulty item , sf new 5 or 6 amp 3pin socket outlet in replacement of faulty item , sf new 15 or 16 amp piano switch in replacement of faulty item , sf new 15 or 16 amp 6pin socket outlet in replacement of faulty item , rewinding ceiling fan motor , sf 4ft 20w led fitting against faulty fitting , service of 750kva dg set as per specification , service dgset control panel 1250a 4p acb as per specification , repacement ryb ind lamp in dg set panel , repacement digital ammeter in dg set panel , earthing testing in existing earth pits and report submission
Tender For supply ere commi of various electromechanical equipment like 5 no 5 cs vt pump electric motors starter panel and other allied material for flood protection works from the field area of village dang khurd outfall at rd 65000r of nigana feeder - supply, erection & commissioning of 5 c/s axial/mix flow water lubricated vertical flood pumps of 5 cs. discharge at 1440 rpm at static head of approx 6.0 mtr. having adjustable height, including ms bend including flange welding, ss/ht nut & bolts etc complete in all respect as per site requirement with epoxy coating & as per approved specifications of the department, supply, erection & commissioning of solid shaft motor of capacity 30 hp, 1440 rpm, 3 phase, 380 volt+- 10%, with eficiency class ie2 (with 35 mtr compatible 3 phase submersible cu cable from motor to panel/starter) suitable for fitment with 5 cs. v.t axial/mix flow pump type vertical flange mounted as per approved specifications of the department., supply, erection & commissioning of fully automatic star delta starter of cap. 150 amp including all accessories as one incomer of mccb (150amp) with 1 no mcb for lighting load, contactor rating 120 amp, 90 amp, 70 amp with control transformer for control supply, outgoing indicator, having mpr & all types of protections i.e.uv/ov/ over current, phase imbalance/phase reversal protection, locked rotor, dry run etc, digital meters, push buttons, bus bars, capacitor bank, seperate relay for single phase protection etc. complete in all respect suitable for open fields operation of 1 no. motor of capacity of 30 hp with a stand of ms channel with canopy having suitable operating height above the kachha open fields as per approved specifications of the department. (suitable for voltage range 380 +- 10%,) panel should be outdoor type., supply, erection & commissioning of m.s delivery pipe 10" dia. made of ms plate both end flanged (equal to or less than 6 mtr length of pipe) as per approved specification & make. (including ss/ht nut & bolt, rubber packing & other fitment accessory required), supply, erection and commissioning of ms girder parallel flange section ismb 150 with primer and bituminous based paint inside & outside of length 4mtr (approx wt 60 kg per pc) as per approved make & conforming to is808:2021.
Tender For supply erec comm of various electromechanical equipment like 3 no 5 cs vt pump electric motors starter panel and other allied material for flood protection works from the field area of village ghuskani outfall at rd8350 l of nigana feeder - supply, erection & commissioning of 5 c/s axial/mix flow water lubricated vertical flood pumps of 5 cs. discharge at 1440 rpm at static head of approx 6.0 mtr. having adjustable height, including ms bend including flange welding, ss/ht nut & bolts etc complete in all respect as per site requirement with epoxy coating & as per approved specifications of the department, supply, erection & commissioning of solid shaft motor of capacity 30 hp, 1440 rpm, 3 phase, 380 volt+- 10%, with eficiency class ie2 (with 35 mtr compatible 3 phase submersible cu cable from motor to panel/starter) suitable for fitment with 5 cs. v.t axial/mix flow pump type vertical flange mounted as per approved specifications of the department., supply, erection & commissioning of fully automatic star delta starter of cap. 150 amp including all accessories as one incomer of mccb (150amp) with 1 no mcb for lighting load, contactor rating 120 amp, 90 amp, 70 amp with control transformer for control supply, outgoing indicator, having mpr & all types of protections i.e.uv/ov/ over current, phase imbalance/phase reversal protection, locked rotor, dry run etc, digital meters, push buttons, bus bars, capacitor bank, seperate relay for single phase protection etc. complete in all respect suitable for open fields operation of 1 no. motor of capacity of 30 hp with a stand of ms channel with canopy having suitable operating height above the kachha open fields as per approved specifications of the department. (suitable for voltage range 380 +- 10%,) panel should be outdoor type, supply, erection & commissioning of m.s delivery pipe 10" dia. made of ms plate both end flanged (equal to or less than 6 mtr length of pipe) as per approved specification & make. (including ss/ht nut & bolt, rubber packing & other fitment accessory required), supply, erection and commissioning of ms girder parallel flange section ismb 150 with primer and bituminous based paint inside & outside of length 4mtr (approx wt 60 kg per pc) as per approved make & conforming to is808:2021.
Tender For corrigendum : supply of electrical spares c c > f> f - master trip relay , side cable box , power converter 110v ac to 110v dc , digital protection relay , epoxy resin cast current transformer
Tender For corrigendum : provision of 01 x 30 kva genr with connected items as standby power requirements for sewage treatment plant under age (i) bhalra - supply, installing, commissioning and testing, water cooled, sound proof silent type, turbo charged, diesel engine driven generating set 30 kva (at 0.8 pf), 415v, 3 phase, 4 wire engine as per is: 10001/10002 and alterator as per is: 13364, complete with relay panel for automatic starting on mains failure, control panels having meters in an integral acoustic enclosure as per recommendation cpcb norms, comprising of the following:notes: quoted rates shall deemed to include the following also:-(i) supply of t and p and normal space ie., bi-hexagonal ring spanner set of 12 pieces - 01 set.(ii) fuel measuement gauge - 01 no, hand operated fuel lifting pump with steel pipe 40mm dia - 01 no, hydro meter - 01 no, set of fan belt, oil/ fuel filters initial filling of coolant (coolant-2liters).(iii) service maintenance manual along with cat part list and price list - 03 set each.(iv) make of engine and alternator will be got approved from age (i) bhalra before placing the order., (a) diesel engine. diesel engine developing suitable bhp, 1500 rpm inclusive of the following standard accessories:(i) radiator/ heat exchanger cooling system. (xiv) battery charging generator.(ii) spider coupling guard. (xv) industrial silencer.(iii) fly wheel. (xvi) lubricant oil cooler.(iv) fly wheel housing complete with starter gear ring and coupling. (xvii) flexible pipe for silencer. (v) fuel pipes. (xviii) battery volt meter.(vi) air cleaner. (xix) water temperature gauge, lub oil pressure (vii) fuel and lubricant oil filter. gauge.(viii) by pass filter. (xx) speedo meter and engine running hours meter.(ix) coolant inhibitor. (xxi) display for fault.(x) fuel pump. (xxii) turbo charger.(xi) water pump. (xii) lubricant oil pump.(xiii) self/electric starter.(b) alternator : synchronous alternator 3 phase 4 wire, 50 cycles 1500 rpm, self excited, self regulated, brushless type, 0.8 pf, 415v, ac supply, 30 kva capacity, copper wound, complete including necessary tools, mounted on strong rigid steel fabricated base frame and directly coupled through flexible coupling with diesel engine, complete all as specified and directed., (c) amf/ control panel : amf panel factory made of suitable capacity as per original equipment manufacturer make and specification or as approved by oem for dg set of capacity 30 kva of suitable size, indoor cubical type, front and back openable fabricated out of mild steel sheet 1.6mm thick grounted in floor with adequate pcc foundation and minimum consisting of following :(i) contactor of suitable size for 30 kva dg set.(ii) copper bus bar of suitable current rating and sensitivity relay set unit with auxiliary cts.(iii) electronic latch circuit with tripping indication.(iv) re-set facilities.(v) 3 phase mvr relay unit with single phase protection complete with 2 no nc auxiliary contacts.(vi) 3 phase avr relay unit complete.(vii) self sequential starting relay unit 12 volts dc complete with alarm and power contactor. (viii) electronic timer 220 volts for main contactor with 1 no nc auxiliary contactor.(ix) electronic timer 220 volts for fuel cut off operation with 1 no auxiliary contactor.(x) battery charging 2x12 volts 10 amp complete with digital voltmeter and amps meter, including trickle and boost charging, make : su-kam, amco, exide or any other make as recommended by the manufacturer.(xi) volt meter 0-500 volts panel mounting of size 96mm square with selector switch digital type.(xii) amps meter 0-100 amps with 3 nos cts, 400/5 and selector switch 96 mm square digital type.(xiii) frequency meter (45-55) hz, 415 volt, 96mm square digital type.(xiv) the amf panel should have manual by pass arrangement too in case of failure of amf panel., (d) fuel tank of capacity as per manufacturer recommendations.(e) base frame made out of suitable channel duly reinforced and provided with adequate nu
Tender For procurement of spare material for relay panel and power transformer at 132/33 kv grid sub station japla - local remote (l/r) switch for circuit breaker (make - kaycee/salzer/switron), spring charge motor for 33 kv v.c.b. (as per sample), selector switch for protection transformer, 25a, ac/dc, 110v-660v or 5 pole 10 amp : (make - switron, kaycce), petrolium jaily, annucnciator facia with in built hooter (12 windows) make - minilec, model - mbas, as per sample., annucnciator facia with in built hooter (24 windows) make - minilec, model - mbas, as per sample., motor cut - off limit switch for 33 kv vcb (as per sample), true rms digital multi meter (waco/fluke/motwani/any equivalent isi), time delay relay, 240 volt (as per specification), mccb - 32a, 4 pole, 3p + 1n (make - seimens/schneider/abb equivalent , mccb - 63a, 4 pole, 3p + 1n (make - seimens/schneider/abb equivalent ., mcb - 10 a single pole (as per sample), power contractor for transformer cooling fan 3 ph. coil 220v ac 3 pole (1 no. 1 nc) as per sample., silica gel (blue mesh) size - 6mm to 10mm, hcd, 400a - 415v / (acdb-hbc fuse) as per sample, htss-63a (a3) 415v (acdb-hbc fuse) as per sample, digital earth resistance testor complete set make - kusum, meco/metravi etc., wti for 132/33 kv, 20 mva, power transformer, oti for 132/33 kv, 20 mva, power transformer, led indicating lamp (red, yellow, blue, green)