Tender For supply of material for the work of construction of harvesting structure threshing floor including pucca storage at thiruvettakudy vp in kottucherry commune - collection and supply of fine sand including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of gravel including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of portland cement, collection and supply of stone aggregate (single size) :40 mm nominal size including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of stone aggregate (single size) : 20 mm nominal size including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of stone aggregate (single size) : 10 mm nominal size including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of coarse sand (zone iii) including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of common burnt clay f.p.s (non modular) bricks class designation 3.5, hire charges of wall form panel 1250x500 mm, hire charges of 100mm channel shoulder 2.5m long, hire charges of double clip (bridge clip), hire charges of single clip, hire charges of m.s.tube 40mm dia, supply of twisted steel / deformed tmt bars fe-500d, hire charges of flame retardant face insulating , impregnated fibre board 12mm thick, supply of bitumen hot sealing compound : grade a, supply of bitumen solution primer of approved quality, supply of dehradun white lime, supply of welding by electric plant, supply of mild steel tubes hot finished welded type., supply of red oxide zinc chromate primer, supply of galvanised steel j or l hooks 8mm dia, supply of precoated galvanised iron profile sheet 0.5mm tct, supply of mild steel sheets for tanks, supply of structural steel such as tees, angles channels and r.s.joists, supply of iron pintels including welded pin, supply of mild steel sheets with bolts and nuts to rest on pintels, supply of synthetic enamel paint in black or chocolate shade, supply of plasticizer / super plasticizer, supply of c.i.pile shoe, supply of m.s.clamps for pile shoe, hire charge for loader including operating staff,diesel& lubricant oil etc,complete., hire charge for hydraulic excavator (3d) with driver and fuel including operating staff,diesel& lubricant oil etc,complete., hire charge for vibrator(needle type 40mm) including operating staff,diesel& lubricant oil etc,complete., hire charges of concrete mixer 0.25 to 0.40 cum with hooper including operating staff,diesel & lubricant oil etc,complete., hire charges of diesel road roller 8 to 10 tonne including operating staff,diesel & lubricant oil etc,complete., hire charge of hydraulic piling rig with power unit etc.,complete accessories and shifitin including operating staff,diesel& lubricant oil etc,complete., hire charge for pumping of concrete-h/c of pump, piping work, & accessories etc including operating staff,diesel& lubricant oil etc,complete., hire charge production cost of concrete by batch mix plant(rolling every layer and top-most layer ) including operating staff,diesel& lubricant oil etc,complete., supply and fixing of r.c.c. precast citizen name board size of 3.5 feet breadth, 6.00 feetheight and 2 inches thick with painting, drawing work, lettering the name board work. the rate includingcost of 1:2:4 p.c.c., earth work and refilling for fixing of post, loading unloading and transport charges etc.,complete as per the standard drawing of mord. mgnrega
Tender For supply of material for the work of providing and laying cement concrete road kundusamy koil theru at t.r.pattinam (north) vp in t.r.pattinam commune - hire charge for loaderincluding operating staff,diesel& lubricant oil etc,complete., hire charge for hydraulic excavator (3d) with driver and fuelincluding operating staff,diesel& lubricant oil etc,complete., collection and supply of fine sand including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., hire charge for vibrator(needle type 40mm)including operating staff,diesel& lubricant oil etc,complete., hire charges of concrete mixer 0.25 to 0.40 cum with hooperincluding operating staff,diesel& lubricant oil etc,complete., collection and supply of portland cement, collection and supply of stone aggregate (single size) :40 mm nominal size including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of stone aggregate (single size) : 20 mm nominal size including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., hire charges wall form panel 1250x500 mm, hire charges 100mm channel shoulder 2.5m long i, hire charges double clip (bridge clip), hire charges single clip, hire charges m.s.tube 40mm dia, collection and supply of gravel including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of stone aggregate (single size) : 10 mm nominal size including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., collection and supply of coarse sand (zone iii) including stacking to standard departmental gauage for pre-measurement at the site as directed by the engineer-in-charge., hire chargesflame retardant face insulating , impregnated fibre board 12mm thick, supply of bitumen hot sealing compound : grade a, supply of bitumen solution primer of approved quality, supply and fixing of r.c.c. precast citizen name board size of 3.5 feet breadth, 6.00 feetheight and 2 inches thick with painting, drawing work, lettering the name board work. the rate includingcost of 1:2:4 p.c.c., earth work and refilling for fixing of post, loading unloading and transport charges etc.,complete as per the standard drawing of mord. mgnrega
Tender For srm e-tender: work of providing & fixing of electrical insulation, acid & alkati proof synthetic, insulating mat (1.0m width &3.0mm thick) at various substations under ehv o&m division parbhani.
Tender For electrical insulating hand gloves class 4 hand gloves for ohe work with 36kv working voltage as per iec60903:2014 without joint, size: 360 -38 0 mm length. color :red/ivory. warranty period: 30 month(s) from the date of supply [ warranty period: 30 months after the date of delivery ]
Tender For corrigendum : supply of ht motors spares for emd-1,wtps,gsecl. - skf make induction heater model no. tih 100m / 230v for bearing fitting work., hydraulic jack with pump & accesories capacity: 100 mt., hydraulic jack with pump & accesories capacity: 50 mt., greasing pipe for ht motors - r1 type hydraulic hose pipe ( rubber hose with single inner wire braiding), araldite 180 gram/tube, red insulating varnish-class f epoxy insulation & protection coating., dr. back make backtol red in 1 lit. tin varnish, digital multimeter 4.1/2 digit (true rms), digital clamp on meter lcd display with backlight, 3-3/4 digit., digital megger (insulation tester) dual voltage 500/1000 v 0 to 2000 megaohms resolution of 1 m? weght: 500 gm approx., analog multi range insulation tester.hand driven type,voltage range-250v/500v/1000v., brass connectors for pstb of ht motor, plastic dori (sutari) for binding of plastic ,0.5 thick &2mm width., insulating cable gland for pstb of ht motor, grease gun, fevicol sr 998 (200 ml/tin), self fusing rubber tape black , class b , 31 kv die electric strength , size 2.5 cm x 10 mtr., pvc tap roll, insulating box for pstb for ht motor, ht pvc insulation tape size 0.18 mm x25 mm x 65 mtr length, 6.6 kv busbar /cable couductor protection heat shrinkable sleeve dia .before shrink:50 mmdia. after shrink :20 mm, heat shrinkable sleeve,size:45mm/18 mm( for 240/300 sq.mm )for 11 kv, 6.6 kv busbar /cable couductor protection heat shrinkable sleeve dia .before shrink: 75 mm dia. after shrink : 28 mm for 11 kv ht cable, z 801 fast steel epoxy stick (1 stick - 114 grm), impact wrench power/battery operated, cordless screw driver power/battery operated, w963 play safe high voltage tape (50 mm x 0.76 mm x 9.1 mtr) roll, w963 play safe high voltage tape (25 mm x 0.76 mm x 9.1 mtr) roll, becktol gray varnish in 1 ltr tin dr.back make, electical saftey equipment tester taparia product no:814 voltage range:110v to 230v
Tender For srm e tender notice for work of providing and fixing high voltage busbar insulation tape, and heat shrinkable busbar insulating tubing at various 132 kv & 220 kvsubstations under ehv o&m division, nashik.
Tender For requirement of material for psi installation for psi/pnp. - supply of ballast/gravel in the switch yard. (supply), spreading of ballast/gravel in the switch yard. (erection), 3.painting of fencing panel/masts., .cable trench cover (supply)., cable trench cover (erection)., base painting & writing work on ohe structure (supply), .supply of single earth electrode with earth pit complete as per rdso drg. no. eti/ohe/p/7020 or latest, erection of single earth electrode with earth pit complete as per rdso drg. no. eti/ohe/p/7020 or latest., fire bucket set consisting of 4 nos of fire buckets with stand confirming to is no. 2546-1974 with 9 litre capacity for mounting painted bright red and have the word "fire" stenciled on them in white paint., supply of safety 33000 volts electrical hand gloves, seamless natural latex rubber of size: 300 mm, with stand test potential: 33000 volts, maximum working potential: 7500 volts as per is: 4770-1991 or latest. note: original test certificate of nabl/any central government laboratory required for genuineness of item must be submitted along with supply, supply and erection of 25 kv caution boards (supply)., supply and erection of 25 kv caution boards (erection), .supply and erection of retro-reflective type number plates (supply)., supply and erection of retro-reflective type number plates (erection)., insulating mats for electrical trd purpose, extra on erection rates @ 100% for work under a power block for item no. 12. supply and erection of 25 kv caution boards
Tender For requirement of material for psi installation for psi/mut & psi/smql. - supply of ballast/gravel in the switch yard. (supply), spreading of ballast/gravel in the switch yard. (erection), 3.painting of fencing panel/masts., .cable trench cover (supply)., cable trench cover (erection)., base painting & writing work on ohe structure (supply), .supply of single earth electrode with earth pit complete as per rdso drg. no. eti/ohe/p/7020 or latest, erection of single earth electrode with earth pit complete as per rdso drg. no. eti/ohe/p/7020 or latest., fire bucket set consisting of 4 nos of fire buckets with stand confirming to is no. 2546-1974 with 9 litre capacity for mounting painted bright red and have the word "fire" stenciled on them in white paint., supply of safety 33000 volts electrical hand gloves, seamless natural latex rubber of size: 300 mm, with stand test potential: 33000 volts, maximum working potential: 7500 volts as per is: 4770-1991 or latest. note: original test certificate of nabl/any central government laboratory required for genuineness of item must be submitted along with supply, supply and erection of 25 kv caution boards (supply)., supply and erection of 25 kv caution boards (erection), .supply and erection of retro-reflective type number plates (supply)., supply and erection of retro-reflective type number plates (erection)., insulating mats for electrical trd purpose, extra on erection rates @ 100% for work under a power block for item no. 12. supply and erection of 25 kv caution boards
Tender For supply of supply of 4x8.5 ton ductable ceiling mount air conditioning plants equipment , supply and installation of 28.60 mm copper pipes of 15 mtr length each with suitable insulating material from indoor unit of 8.5 ton ac plant to outdoor unit. , supply and installation of 15.88mm copper pipes of 15 mtr length each with suitable insulating material from indoor unit of 8.5 ton ac plant to outdoor unit. , supply of 10 sq. mm 4 core copper cables and wiring of equipment upto switch board. , supply of 1.5 sq.mm 8 core copper control cables and wiring of equipment upto switch board. , supply of 4 sqmm 4 core copper cables and wiring of equipment upto switch board. , supply of pvc conduit pipe and other required misc. hardware as per requirement , misc essential work for hanging the machine and proper level with 10mm full threaded g.i. rod includes dismantling of old existing 5.5 ton indoor units , providing and fixing of ms stand of proper size suitable for the outdoor unit. the stand should be made up of 50mmx50mmx5mm mild steel. , supply of misc. items required for completion of installation such as nut bolts, rubber gasket, 35mm dia drain pipe with insulation approx 30mtr etc. , providing and fixing of 475mm x 475mm canvas of reputed make in between the plenum and machines. , providing, fabrication and fixing of powder coated aluminium grill for supply air , providing, fabrication and fixing of powder coated aluminium grill for return air , installation, testing and commissioning of 4x8.5 ton ductable air conditioning plants and dismantling of 4 nos old existing 5.5 ton ac outdoor units. , providing and fixing of 40 amp tpn with mcb box bid number/ & ( * ) : gem/2025/b/6259116 dated/ + : 02-06-2025 bid document/ 2 2 1 / 20