Get complete information related to latest Contact Clip Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Contact Clip Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Contact Clip Tenders.
Tender For supply of auxilary contact and support assembly with six block switch assembly for motor contactor as per clw drg.no.4twd.112.090 alteration-5. (sheet no.0) and to specification. 4tes.111.028 alt-1.
Tender For supply of 52ab switch 16 way for 11 kv vcb , tripping block assembly , closing coil 220v dc , spring charge motor 220v dc , closing unit assembly , motor cut off limit switch assembly , braker roller for 11 kv , shutter brass bolt for 11 kv , jaw contact polycarbonate finger shroud for 11kv , auxiliary switch assembly , plunger assembly set for 11 kv , swing bolt for 11 kv , diode plate
Tender For electric line materials under o&m head for f.y. 2025-26 - male female contact of 33 kv ab switch 600-630 a, male female contact of 11 kv ab switch 600 amp, male female contact of 11 kv ab switch 400 amp, connector pipe to panther, connector panther to panther, connector panther to ab switch, connector pipe to ab switch, connector dog to ab switch, led flood outdoor light with ip 66 protection rectangular (100w), suitable lugs, suspension clamp assembly suitable up to 70-95 mm2 bare messengers(including 1 no.suspension clamp with bracket 2 mtr. stainless steel strap &2nos.ss buckles), dead end clamp suitable above 70 s mm2 bare messengers (including 1 no. dead end bracket + 1 no. dead end + 2 mtr ss strap + 2 nos. ss buckle) (minimum breaking load-15 kn), lt ab cable accessory, 1.1 mtr. stainless steel strap if207(20x0.7), buckle for strap, insulation piercing connector for db charging, insulation piercing connector branching suitable for t joints, spring loaded distribution bus bar insulated box for fixing on pole suitable for ab xlpe cable and three phase connection 1 incoming and outgoing 3 phase connection as per field requirement, lt phase separator, service main anchor clamp for proper support of service cable (4 mm2 and 10 mm2), lt pre insulated mid span joint suitable 50 mm2 phases, lt pre insulated mid span joint suitable 95 mm2 phases, suspension clamp suitable for 95 mm2 bare messenger (including 1 no. suspension clamp with bracket 2 mtr stainless steel strap & 2 nos. ss buckle), p.g clamp for 200/150 mm2 conductor, p.g clamp for 80/100 mm2, aluminum pipe 40mm dia, rubber mat along length of panel, earthing g.i strip (65x6) mm2, aluminum winding wire/tape/strips etc.