Get complete information related to latest Corrugated Gi Sheet Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Corrugated Gi Sheet Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Corrugated Gi Sheet Tenders.
Tender For corrigendum : supply material for other work - cement 53 grade, steel 6 mm bar, steel 8 mm bar, steel 10 mm bar, steel 12 mm bar, steel 14 mm bar, steel 16 mm bar, steel 18 mm bar, steel 20 mm bar, struchural steel, color coated sheets, gisheet, khadi (all size), crush sand, vrs sand, r.c.c cement pipe 6 inchi, r.c.c cement pipe 8 inchi, r.c.c cement pipe 10 inchi, r.c.c cement pipe 12 inchi, r.c.c cement pipe 18 inchi, r.c.c cement pipe 24 inchi, r.c.c cement pipe 36 inchi, chembar hd 1*1.5* foot, chembar hd 2*2 foot, chembar hd 3*3 foot, chembar hd 21 inchi, bricks 4 inchi, bricks 6 inchi, farshi 2*2
Tender For corrigendum : supplying material for grampanchayt other work at bare bk tal bhor - cement 53 grade, steel 6 mm bar, steel 8 mm bar, steel 10 mm bar, steel 12 mm bar, steel 14 mm bar, steel 16 mm bar, steel 18 mm bar, steel 20 mm bar, struchural steel, color coated sheets, gisheet, khadi (all size), crush sand, vrs sand, r.c.c cement pipe 6 inchi, r.c.c cement pipe 8 inchi, r.c.c cement pipe 10 inchi, r.c.c cement pipe 12 inchi, r.c.c cement pipe 18 inchi, r.c.c cement pipe 24 inchi, r.c.c cement pipe 36 inchi, chembar hd 1*1.5* foot, chembar hd 2*2 foot, chembar hd 3*3 foot, chembar hd 21 inchi, bricks 4 inchi, bricks 6 inchi, farshi 2*2
Tender For supply of ferritic steel sheet 8x1250x3000mm., as per drawing: is:6911-1992,grade x04cr1 2 (405), surface finish 2d as per tab. 8., packing instruction: stainless steel sheets, coils an d plates:- (a) stainless steel (austenitic & ferritic steel) coils. the coil shall be protect ed in reasonably good condition to withstand normal handling hazard during transit with the following provision as the barest minimum: i) coil should be wrapped with a la yer of water proof paper through out whole length. ii) coil should be wrapped with a l ayer of biodegradeable sheet. iii) outer & inner of coil should be wrapped with gisheet . iv) side of the coil should be covered with card board sheet. v) after this whole coil should be wrapped with biodegradeable plastic sheet of suitable thickness. vi) the inne r edge of the coil should be protected by gi ring followed by another iron ring. vii) ou ter edge of the coil should be wrapped with gi ring. viii) coil should be securely strapp ed with minium 5 steel bands through the eyes of the coil and minium 3 steel bands on t he circumference of the eye. ix) whole coil should be mounted on wooden blocks for e asy lifting/stacking. x) the sheets in coil form for thickness 2mm and above shall have: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 tonnes xi) the sheets in coil form for thickness below 2mm shall have: inner dia of coil 450-650 mm outer dia of coil 1000-1300mm weight of coil 5.0 - 10 tonnes. (b) stainless steel (aust enitic & ferritic steel plates/sheets) i) the sheets/plates shall be supplied in bundles of optimum weight: 2mt+/-10% & each sheet/plate shall be seprated with a layer of water p roof paper, after this the whole bundle should be wrapped with double layer of water proof paper and a biodegradeable plastic sheet of suitable thickness. a metal protecti on in edges should also be provided. ii) all bundles shall have a minimum of 2 hoops upt o 1.2 meter in length and one extra hoop for every additional meter. the bundles shall also be provided with skid (wooden packing under neath) to facilitate handling. mecha nical damange & corrosion during transit if any shall be at the cost of supplier. , procti on procedure: covered in pi [ warranty period: 30 months after the date of delivery ]
Tender For ktps-vii stage - civil - o and m-i - sd-iii - supplying and fixing corrugated g.i sheets and plain gisheet at ridges for roofing to shed no. 45 at ktps(o and m) premises
Tender For supply of manufacturing and supply of structural items of fol shed of size 4200 x 3200 x 3000 mm using mild steel structure , side walls stores using 0.60mm of ppgl sheets , roofing sheets as per ts , ms doors as per ts , self screw for fixing of roof size as reqd on site. , star screw full thread 25 mm isi mark , nuts and bolts 8mm dia 60mm to 120mm long with washer , gi j hook 8mm with 1 nut 2 bitumin washer and limped washer , rivit of 500 nos , led tube light complete set 18w 4 feet long , switch piano flush type , pvc switch board 6 inch x4 inch , pvc casing and capping of size 25 mm , wire single core copper conductor 2.5 sqmm , mcb 10 amp sp , armoured cable10 sqmm 4 core copper , lt panel board factory fabricated , shelves for storage 2100 mm x 450 mm x 750mm , insulation tape 45 mtr with isi mark , change over switch 100 amp 04 pole , ceiling rose. , service wire 10 sq mm flat 2 core aluminium connector cable , gi wire 14swg , fire extinguisher 6 kgs abc dry powder stored pressure type , paint for touch up green , paint for touch up black , distemper , plywood as per ts , scantling teak wood size 140 to 160 inch , frp storage tank conforming to ul 1316 of capacity 5kl with standard accessories , wire single core copper conductor 2.5 sq mm , pvc pipe 100 mm dia , gi elbow 20mm , gi gate valve connector , gi socket 20mm with thread , gi union 20mm , pvc flexible hose pipe 20 mm dia , lightening conductor made of copper tube with five copper prongs of length 15 cm with complete stores , industrial fuel transfer pump automation grade , provision of fire extinguisher 50 kgs abc dry powder stored pressure type trolley mounted. , hdpe tarpaulin of size 30 feet x 30 feet , ordinary portland cement grade 43 , coarse sand , stone aggregate 20 mm , stone aggregate 40 to 60 mm , 10 mm tmt bar , connected stores as per final design ) /bid number : gem/2025/b/6426388 * /dated: 08-07-2025 & & / bid document 1 / 43
Tender For supply of fabrication and supplying of structural stores for orl 20 men of size 12000mm x 6000mm , wall panel compatible to structure as per ts , roof set 0.60mm thick pre colour coated pre profiled steel sheets green colour of size 1.00 m x 13 feet , roof set 0.60mm thick pre colour coated pre profiled steel sheets green colour of size 1.00m x 10 feet , ridge cover will be of 0.60mm thick and 1800mm wide tct sheet , puf insulated sandwich puf panels , aluminium frame windows of size 1200mm x 1200mm alongwith wire mesh and sliding shutters of 5mm thick toughened glass , fixed aluminium frame of 900x900mm along with 6mm thick acrylic sheet glazing to the entire length of the verandah , aluminium door single shutter of size 900mm x 2100mm , puf insulation door single shutter of size 900mm x 2100mm , sunshades of size 1500 mm x 500 mm , self tapping screw 1 inch long , self tapping screw 2 inch long , self tapping screw 3inch long , star screw half inch of isi mark pkt of 300 nos , screw 1 inch of isi mark pkt of 300 nos , nut and bolts 8mm dia 60mm long with washer , nuts and bolts 12mm dia 25mm long with washer , led tube light complete set 20w 4 feet long , switch piano flush type 5 amp , switch socket combination 5 amp 5 with pvc box pin , switch socket combination 2 in 1 as per ts , pvc switch board 8 feet x10 feet isi mark , pvc switch board 6 inch x4 inch isi mark , pvc casing and capping of size 25 mm , pvc casing capping tee bend make , pvc casing capping l bend make , pvc square box 4 inch x4 inch , wire single core copper conductor 1.5 sqmm , wire single core copper conductor 2.5 sqmm , mcb box 6 way double door , mcb 10-32 amp sp , wire 02 core 6 sqmm copper as per ts , insulation tape half inch x 25 mtr with isi mark , pvc earthing cable 1 sqmm , ceiling rose , change over switch 32 amp dp , gi wire 14swg , black screw 15mm pkt of 500 nos , flexible conduit pipe 20mm dia , led bulk head fitting , lightening conductor jelly filled complete set , double bunk of size 6 feet x 3 feet , steel locker of size 750x600x950mm half hanging and half shelving , looking mirror of size 1200x750 x 3.5mm , provision of fire extinguisher 6.0 kgs abc dry powder stored pressure type , 25 mm dia drapery rod 1500mm each with both end socket and brackets , 3 kw roof top solar system on the roof , water dispenser mini magic super tt of capacity 20 ltr with bottle , cement in polythene bags 50 kgs opc 53 grade , crushed stone aggregate 20 mm graded confirming to is 383 to 1970 , coarse sand confirming to is 383 to 1970 , hard core of broken stone aggregate of size 45 to 63 mm , cement white make , vitrified colour tiles 8 to 10 mm thick square or rectangular polished area of each tiles not exceeding 0.36 sqm including colour pigment as required for joints. , quick setting compound , water proofing compound , 3mm thick app membrane as per ts , bitumen primer ready to apply for laying of app membrane , silicon sealant with gun , multipurpose expandable pu foam as per ts , connected stores as per final design //bid details 2 / 52
Tender For corrigendum : supply of spare components and replacement of damaged components in induced draft pultruded frp counter flow cooling tower at heavy water plant (kota) site. - supply of pvc film fill block of size 6 x2 x2 ., supply of square channels of pultruded frp material of size (width/height x thickness x length): 4 inch x 1/4 inch x 24 feet., supply of c-channels of pultruded frp material of size (width x height x thickness x length): 4 inch x 1-1/8 inch x 1/4 inch x 18 feet., supply of c-channels of pultruded frp material of size (width x height x thickness x length): 6 inch x 1-5/8 inch x 1/4 inch x 18 feet., supply of complete partition sheets (frp sheets) of adjacent cells and replacement of existing partition sheets. sheet thickness: 3 mm. fasteners for installation of sheet shall be arranged by contractor., supply of hex head gi bolts with hex nut. size: m12 x 130 mm long., supply of self threading screws having hex head. size: dia 5 mm x 60 mm long., replacement of old neoprene rubber seal/grommet for distribution pipe with new seal/grommet (spare neoprene rubber seal/grommet shall be provided by dept.)., replacement of damaged water distribution nozzles with new nozzles (fasteners and gasket shall also be replaced) (spare nozzles along with fasteners and gasket shall be provided by dept.)., replacement of damaged pvc film fill blocks of size 6 x2 x2 with new fills blocks (for 410 nos. fills, spare pvc film fill sheets shall be provided by dept., contractor shall prepare fill blocks by corrugating, arranging adhesive, application of adhesive and assembly). scrap fills shall be shredded into pieces, packed in bags and shifted to designated place., replacement of damaged pvc drift eliminators with new pvc drift eliminators. (spare c type drift eliminators along with spacers shall be provided by dept., contractor shall assemble the drift eliminators)., removal, cleaning/de-choking and re-installation of water distribution nozzles., repair of leaky joints of outer frp sheets of cells by aligning sheets, jointing with fasteners and providing frp lining on joints from inside/outside. frp lining shall be of four chopped mat and two surface mats laminated with resin for 4 mm thickness., internal structural maintenance of main header, branch pipes, fill supports, main structural members of ct cells etc by replacing/providing square channels/c-channels etc supplied at sr. no. 2, 3 & 4 above.