Tender For supply of data logger and sensors c c - data logger and control module-cr1000xe with software - pc400 , ambient temperature and relative humidity sensor ee181 with solar radiation shield rad10e , water pressure sensor cs451 , windspeed and direction sensor 05103v-45 , noise sensor ta120 , precipitation sensor ws100 , snow depth sensor snovue , solar radiation sensor ms80 mounting kit - mis-local , single-level soil moisture sensor cs655
Tender For supply of laboratory equipment - laboratory equipment, sensor trainer kit (with ir proximity sensor, inductive proximity sensor, soil moisture sensor, ic temperature sensor with relay, buzzer and led indication with terminals), digital storage oscilloscope with usb interface50mhz/ 500 msam/s, maxwell s bridge trainer kit, edm type dc ammeter (0-100) ma, edm type dc voltmeter (0- 10) v, water level control unit for interface with plc(with tank fitted with level sensors, solenoid valve, pump and inbuilt power supply), conveyor control with inbuilt power supply and output terminals for interface with plc, car parking system with sensors & pilot lamps for interface with plc, forward & reverse control of dc motor setup for interface with plc
Tender For rrsmp/25-26 sheohar/02 - dekuli to dharampur reo road to raam swarth rai ke ghar tak, clearing and grubbing road land including uprooting wild vegetation , grass,bushes,shurbs,saplings and trees of girth upto 300mm, removal of stumps of such trees cut earlier and unseviceable materials & stacking of serviceable materials to be used or auctioned upto a lead of 1000m including removal and disposal of top organic soil not exceeding 150mm in thickness as per technical specification(clause201.1), construction of subgrade and earthen shouldersconstruction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300.2 with lead upto 1000 m as per technical specification clause 303.1., construction of dry lean cement concreteconstruction of dry lean cement concrete sub-base over a prepared sub-grade with coarse and find aggregates conforming to is:383, the size of coarse aggregate not exceeding 25mm, aggregate cement ratio not to exceed 15:1 aggregate gradation after blending to be as per table 600-1 cement content not to be less than 150kg/cum optimum moisture content to be determined during trial length construction, concrete strength not be less than 10 mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing., cement concrete pavement (pqc)construction of un-reinforced, plain cement concrete pavement (m35 grade) over a prepared sub base with 43 grade cement @ 400 kg per cum, coarse and fine aggregate conforming to is 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form paver, spread, compacted and finished in a continuous operation including provision of 0.5 x 0.5 panel, joint filler, separation membrane, sealant primer, joint sealant, debonding strip as approved, curing compound, finishing to lines and grades as per drawing., end edgingedging with 1st class bricks, laid dry length wise, including excavation, refilling, consolidation, with a hand packing and spreading nearly surplus earth within a lead of 50 metres, kilometre stone reinforced cement concrete m15 grade kilometre local stone of standard design asper irc:8 fixing in position including painting and printing , etc as per drawing and technical specification clause 1703.ii) km stone , iii) 200 m stone, painting lines, dashes, arrows, etc. on roads in two coats on old work painting lines, dashes, arrows, etc. on roads in two coats on old work with ready mixed road marking paint conforming to is:164 on bituminous/concrete surface, including cleaning the surface of all dirt, dust and other foreign matter, demarcation at site and traffic control as per drawing and technical specification clause 1702, retro-reflectorised traffic signsproviding and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per irc:67 made of encapsulated lens type reflective sheeting vide clause 1701.2.3 fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm firmly fixed to the ground by means of properly designed foundation with m15 grade cement concrete 450 mm x 450 mm x 600 mm, 600 mm below ground level as per drawings and technical specification clause 801600 mm equilateral & triangle, 600 mm circular, 600 mm x 450 mm rectangular, 900 mm side octagon, boundary pillar/gaurd postreinforced cement concrete m15 grade boundary pillars/local stone of standard design as per irc:25, fixed in position including finishing and lettering but excluding painting as per drawing and technical specification clause 1704, printing new letters and figures of any shadeprinting new letter and figures of any shade with synthetic enamel paint black or any other