Tender For nanded division: upgradation of ohe/psi infrastructure to improve reliability and safety in division 1) provision of 7 mm dropper in critical locations in place of 5 mm dropper 2)replacement of composite insulators with porcelain insulators in non-polluted areas and replacement of porcelain insulator to composite insulator in polluted areas 3)replacement of steel anti-creep wire with anti-creep wire of cadmium copper catenary wire in polluted zones over nanded division
Tender For stage contract for supply of workshop/line material as and when required during financial year 2026-27 or till next contract gets finalised - electrical store/workshop items/: as per is standards and kpdcl approved vendors only wherever applicable, bush rods 12mm(lt) of standard make, bush rods 19mm(lt) of standard make, bush rods 25mm(lt) of standard make, bush rods 30mm(lt) of standard make, ht bush for dts of standard make(33/11kv as per requirement and relevant is), lt bush set for 250kva dt of standard make, lt bush set for 63kva dt of standard make, lt bush set for 100kva of standard make, aluminum thimbles 95sqmm of standard make, aluminum thimbles 120sqmm of standard make, aluminum thimbles 185sqmm of standard make, aluminum thimbles 240sqmm of standard make, aluminum thimbles 300sqmm of standard make, soldress clamp for 630kva, soldress clamp for 400kva of standard make, soldress clamp for 250kva of standard make, soldress clamp for 100kva & 63kva, gi channel/angle/flat/clamps of sizes (as per requirement), gi v cross-arm with top bracket including clamp(2 nos), 11 kv gapless surge arrestor,9 kv ,10 ka ,la with polymer housing, stn. type, 11kv go, ab switch 3-phase, 3-pole, 200 amp, vertical type, 11 kv horn gap fuse set 3 phase 200a, 11 kv heavy duty link set (polymer) line type with 6mm copper blade and 02 no. 8ft. gi channel, clamps and nuts and bolts, 11 kv pin insulators (polymer/porcelain) with pins(5kn), 11kv polymeric composite discinsulator 12kv,min failing load 45kn, lighting impulse 75kv positive and 80kv negative, creepage distance 320mm, lt shackle with mukhi clamps including gi nuts & bolts, gi nuts & bolts of sizes with full thread, manilla rope, gi wire 8 swg, suspension/tension clamp with eye hook as per kpdcl standards, insulating piercing connector (10-95sqmm), straight through cable jointing kit for 35/50sqmm ltab, straight through cable jointing kit for 75/95/120sqmm ltab, heat shrinkable outdoor cable termination kit, 50sqmm lt ab cable (3x50+1x16+1x35) sqmm xlpe (1.1kv, 3+1c, al), 35 mm ab (ht) cable (3x35+1x35 mm ) xlpe, dpc aluminium of sizes 13/14/16/18swg of standard make, super enamelled(se) of sizes 13/14/16/18/21swg of standard make, lathoride paper 10 mil of standard make, exchange of 1kg fresh al dpc by scrap dpc, exchanege of 1 kg fresh bush rods by scrap bush rods, lathoride paper 20 mil of standard make, ht paper 3 mil of standard make, hard card board 1/1.5/2/3mm of standard make, fiber tubes of standard make, cotton tape/ nawar of standard make, cork washers (32x12)5mm, cork washers (50x28)5mm, cork washers (110x74)5mm, cork washers (45x20)5mm, cork washers (60x32)5mm, cork washers (70x45)5mm, cork washers (90x50)5mm, cork sheets(24x36) 3 mm, cork sheets(24x36) 4mm, cork sheets(24x36) 5mm, cork strip(40x3) mm, cork strip(40x5) mm, oil seals for 250kva of standard make, oil seals for 100kva & 63kva of standard make, m seal, cotton tap 1" size (length 35 meter), nawar tap 1 size 35 meter long, tape roll pvc, old saree/doti cloth, insulating gum of standard make, aluminum strip of sizes (3/6, 3/7, 4/8, 4/10 mm etc ) of standard make, rubberized cork sheet 4mm thick, 2 feet *3 feet, rubberized cork sheet 3mm thick, 2 feet *3 feet, ht brown paper 3.0/2.5 mil, packing sheet (1mm)press card board 1/2/3mm, synthetic enamel paint grey colour, varnish dr.beck/empire, glass wool sleeves of sizes, fevicol, backlite tubes 1/2 inch,(1mtr length), packing gutties, electrical grade kraft paper,4mil, rubber washers ( m-12 ht oil seal),, rubber washers ( m-12 lt oil seal),, rubber washers ( m-16 lt oil seal),, rubber washers ( m-20 lt oil seal),, rubber washers ( m-25 lt oil seal),, rubber washers ( m-30 lt oil seal),, fiber glass sleeves 2mm, fiber glass sleeves 3mm, fiber glass sleeves 4mm, fiber glass sleeves 5mm, fiber glass sleeves 6mm, fiber glass sleeves 8mm, fiber glass sleeves 10mm, fiber glass sleeves 12mm, fiber glass sleeves 15mm, oxygen cylinder for welding with water c
Tender For corrigendum : supply, retrofitting, testing and commissioning of 245kv,5 core,0.2s class sf6 gas filled hermetically sealed current transformers with silicon composite insulator for 220kv switchyard of ktps-v stage.
Tender For composite stay arm insulator (very heavy polluted) (1600mm cd) rdso specification no.: ti/spc/ohe/inscom/1072 or latest. warranty period:30 month(s) from the date of supply. [ warranty period: 30 months after the date of delivery ]
Tender For composite 9 tonne insulator (very heavy polluted) with cd of 1600 mm as per rdso spec: ti/spc/ohe/inscom/1072 or latest. rdso approved make only acceptable.warranty period: 30 month(s) from the date of supply. [ warranty period: 30 months after the date of delivery ]