Latest fastener item Tenders | Government fastener item Tenders

Central Government/Public Sector

CTN :45291823

12 Jun, 2026 1.45 Lacs

Sunderbani - Jammu And Kashmir

Tender For supply of liner cylinder std , seal o ring liner , bush cam shaft , bearing crank shaft 0 10 , bearing connecting rod 0 20 , piston with pin with lock , piston ring std , thrust washer upper std , thrust washer lower std , bush connecting rod u b , rod and cap assy connecting rod with bolt and nut , pin dowel block , engine overhauling gasket set complete , valve air intake , valve exhaust , seal valve stem , valve seat , valve guide , seal oil crank shaft rear , seal o ring spacer , seal oil crank shaft front , bolt fan , bearing fly wheel , belt drive fan belt , filter assembly secondary for turbo charger , filter assy engine oil , tap and screen assy fuel fuel tank , disc clutch pto , disc clutch main , kit fuel filter primary and secondary , gasket oil sump , gasket fip ear inspection plate , gasket water pump , gasket crank shaft rear oil seal , gasket timing gear housing , gasket timing gear cover , gasket cylinder head , gasket cylinder head cover , gasket air intake manifold , filter assy hydraulic lift oil intake , seal o ring hydraulic , clamp radiator upper , seal o ring , seal benjo washer , u j cross propeller shaft , yoke propeller shaft , bush pin swivel housing upper front axle , bearing sp herical lower , pin swivel housing upper wing pin post , seal o ring front axle , seal oil half axle shaft 4wd front axle , seal wheel housing 4wd front axle , tie rod end , cylinder assy power steering pipe inner and outer , clamp assy house , gasket water outlet , ring thermostat sealing , gasket exhaust manifold , hose assy fuel filter to fip pump , hose assy fuel feed pump to fuel filter , gasket hydraulic pump , hydraulic oil filter , gasket turbo charger oil outlet , pipe metal power steering to inter oil , pipe metal hydraulic pump , jubilee clip half inch , benjo washer copper all size , benjo bolt 19 no , benjo bolt 17 no , bolt and nut 10 no , bolt and nut 12 no , bolt and nut 14 no , valve grinding stick , seal oil gear box , gasket egr valve , injector fuel return pipe rubber , gasket fuel tank , gasket turbo charger to adopter , stopper cable , temperature sending unit , oil pressure sending unit , front indicator sparking light assy , back light assy , insulation tape , 0 to 20 no size writing brush short hair , 0 to 20 no size writing brush long hair //bid details 2 / 64

Central Government/Public Sector

CTN :45337994

09 Jun, 2026 NA

Hubli - Karnataka

Tender For supply of swivel handrail for dtc toilet of vande bharat coaches of make dolphy model no. dhgb0002 or jaquar make model no.wac-wht-bg0800 /wac-sapbg0800cs only. [ warranty period: 30 months after the date of delivery ] ]

Central Government/Public Sector

CTN :45337304

30 May, 2026 NA

Mumbai - Maharashtra

Tender For supply of subject: swivel union as per drawing no. gz22lcf of m/s parker or equivalent make of rcfapproved sources only. note:.material to be supplied from rcf approved source only(rcf sub item id 2400025001 and 2400025003). ]

Central Government/Public Sector

CTN :45037536

29 May, 2026 NA

Hoshangabad - Madhya Pradesh

Tender For supply of "set of three yearly overhauling kit consisting of 15 items (27 nos) for master controllerof emd pt. no.40055299, dlw pt.no.17050455 of hhp diesel locomotive suitable for kepco make master controller as per annexure attached." [ warranty period: 30 months after the date of delivery ]- pin spring-3/16 diameter x 7/8 inch long, pin spring-1/8 diameter x 1 inch long, pin spring-3/16 diameter x 1 inch slotted, pin spring-3/16 diameter x 1.5 inch slotted, pin clevis-1.60 inch long, ring retaining-metric, spring detent arm, pin swivel, ring retaining-1/4 inch, spring reverser lock, spring clevis, pin spring 3/16 diameter x 1-3/8 inch long, ring retaining, bracket throttle handle, screw 8-32 fcs for bush 7/16

Central Government/Public Sector

CTN :45297896

01 Jun, 2026 NA

Chennai - Tamil Nadu

Tender For supply of oh kit for controller assembly dynamic brake for hhp locos, consisting of 18 items as follows: 1) pin spring -3/16 diameter x 7/8 inch long (spiral pin modified) -kepco partno:100015 qty:2nos. 2) pin spring -1/8 diameter x 1 inch long (spiral pin modified) - kepco part no: 100019 qty: 1no. 3) pin spring -3/16 diameter x 1 inch slotted (spiral pin modified) - kepco part no: 100028 qty: 3nos. 4) pin spring -3/16 diameter x 1 1/2 inch slotted - kepco part no: 100032 -qty: 2nos. 5) pin clevis - 1.60 inches long - kepco part no: 100135 -qty: 2nos. 6) ring retaining -metric - kepco part no: 100039 -qty: 1no. 7) spring detent arm- kepco part no: 100042 -qty: 1no. 8) pin swivel - kepco part no: 100231 -qty: 2nos. 9) ring retaining - 1/4 - kepco part no: 100054 -qty:4nos. 10) spring reverser lock- kepco part no: 100055 -qty: 2nos. 11) spring clevis - kepco part no: 100080 -qty: 1no. 12) pin spring 3/16 diameter x 1-3/8 inches long - kepco part no: 100092-qty: 1no. 13) ring retaining - kepco part no: 100123 -qty: 2nos. 14) spring plunger - kepco part no: 100133 -qty: 1no. 15) socket bulb - kepco part no: 100085 -qty: 1no. 16) handle directional - phelolic - kepco part no: 100087 -qty: 1no. 17) bracket throttle handle - kepco part no: 100122 -qty: 1no. 18) screw 8-32 fcs for bush 7/16 - kepco part no: 100200 -qty: 2nos. make: kepco or equivalent supplied by approved vendors of master controller of emd locomotive, pl no: 17050455 are acceptable. hsn code: 86079100. [ warranty period: 30 months after the date of delivery ] ]

Central Government/Public Sector

CTN :45338708

15 Jun, 2026 NA

Ajmer - Rajasthan

Tender For supply of swivel union as per drawing no. gz22lcf of m/s parker or m/svoss or m/s volz or m/s eaton or m/s blange armaturen or equivalent. [ warranty period: 30 months after the date of delivery ]]

Central Government / Public Sector

CTN :45297627

12 Jun, 2026 NA

Tirupati - Andhra Pradesh

Tender For supply of swivel elbow 1" od to drg. no. icf/std 3-5-022, item-2, alt. a. or latest material specification-icf/md/spec.-166. note : item to supplied by rcf approved sources vide uvam sub item id : 2400025003. (warranty period : upto30 months from the date of delivery.) [ warranty period: 30 months after the date of delivery ] ]

Central Government / Public Sector

CTN :45336850

02 Jun, 2026 NA

Hyderabad-T - Telangana

Tender For supply of 110v dc brushless (bldc) 400mm sweep fan swivel type with ss guard ,rubber gasket connector & hardware included as per rdso/pe/spec/tl/0021/2005(rev-2) [ warranty period: 30 months after the date of delivery ] ]

Central Government / Public Sector

CTN :45335124

15 Jun, 2026 NA

Mahabubnagar - Telangana

Tender For supply of contact wire swivel clip pin of ri. no-1222 as per re drawing no. ri/33/p/1222 and rdso specification no. ti/spc/ohe/fittings/0130(10/13) rev-1. make/brand: rdso approved vendors accepted only. [ warranty period: 30 months after the date of delivery ] ]

Central Government And Public Sector

CTN :45302725

13 Jun, 2026 NA

Surat - Gujarat

Tender For supply of 1_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 4inch hose length_12800 mm as per boq specification. , 2_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 4inch hose length_13280 mm as per boq specification. , 3_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 4inch hose length_13560 mm as per boq specification. , 4_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_12270 mm as per boq specification. , 5_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_12650 mm as per boq specification. , 6_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_13290 mm as per boq specification. , 7_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_13500 mm as per boq specification. , 8_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_13700 mm as per boq specification. , 9_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_14300 mm as per boq specification. , 10_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _3 by 4inch hose length_12300 mm as per boq specification. , 11_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _3 by 4inch hose length_12650 mm as per boq specification. , 12_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 4inch hose length_1200 mm as per boq specification. , 13_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 4inch hose length_1200 mm as per boq specification. , 14_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 4inch hose length_1500 mm as per boq specification. , 15_fm main catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_1100 mm as per boq specification. , 16_fm sub catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _1 by 2inch hose length_1300 mm as per boq specification. , 17_fm sub catenary with end fittings of danfoss _former eaton or aeroquip_ make hose id _3 by 4inch hose length_1100 mm as per boq specification. fm main catenary with end fittings of danfoss (former eaton/ aeroquip) make hose id :1/4" hose length:12800 mm part no :2781-4 along with 316 stainless steel sae 37 deg (jic)reusable swivel fitting(part no: 259-4721-8-4 at one end & 259-4721-8-4 at other end), fm main catenary with end fittings of danfoss (former eaton/ aeroquip) make hose id :1/4" hose length:13280 mm part no :2781-4 along with 316 stainless steel sae 37 deg (jic) reusable swivel fitting(part no: 259-4721-8-4 at one end & 259-4721-8-4 at other end), fm main catenary with end fittings of danfoss (former eaton/ aeroquip) make hose id :1/4" hose length:13560 mm part no :2781-4 along with 316 stainless steel sae 37 deg (jic) reusable swivel fitting(part no: 259- 4721-8-4 at one end & 259-4721-8-4 at other end), fm main //bid details 2 / 32

Fastener Item Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors