Fiberglass Tenders

Get complete information related to latest Fiberglass Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Fiberglass Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Fiberglass Tenders .

Filter

Loading....

Get Tender in Email

CTN :40062013

03 May, 2025 2.53 Crore

Karanjia - Odisha

Tender For procurement and installation of different instruments for instrumentation of earth dam and spillway in deo irrigation project for the year 2025. - supply of fiberglass reinforced plastic (frp) make universal enterprises an improved venturi plate conformed to is: 9108 for accurate measurement of water flowing through channels comprising of masonry construction provided with pre-fabricated glass fiber lining on both sides, a side chamber provided in one side masonry wall of the said flume on the upstream side, a pipe provided at the bottom of the chamber connecting the said chamber with the water flowing through the notch, a float means provided in the said chamber, enabling recording the rising or falling level of water in the said chamber such as a scale provided in the said chamber, moulded engraved gauge marking in lit/sec and also in centimeter including moulded and engraved discharge table, capacity marking, flow direction, m.s pipe stiffeners, hold fasts, sand treatment on the backside of plate but excluding gst as per the instruction of engineer-in-charge etc. complete, inside spillway foundation gallery - 15 lit./sec. v-notch, seepage drain - 90 lit./sec. v-notch, calibration marks:- supply of polymers composites improved calibration marks make universal enterprises with contact molding process, both side finish, m.s. strip embedded inside, engraved and molded marking for bands and figures covered with radium and covered with two coats of polyurethane for surface protection with marking in reduced levels, sill, fsl, frl, mwl but excluding gst as per the instruction of engineer-in-charge etc. complete, supply vw up-lift pressure meter provision for connected to das make : aimil ltd. uplift pressure meters are used for measuring and recording of uplift pressures acting in foundations of concrete/masonry dams. vibrating wire type uplift pressure meter : range: 0.2 mpa to 5.0 mpa./7ksc accuracy: 0.5 -1 % fs. temp limit: - 10 to 70 deg c. coil resistance: 140 - 160 ohm thermistor: ysi-44005 or equivalent. material: stainless steel cable: 1m, 4-core borehole for uplift pressure meter at foundation gallery (inside spillway) should be straight from foundation level and clear. proposed location : inside spillway foundation gallery in overflow section: 7 no. non overflow section: 2 no. purpose: uplift water pressure measurement. (but excluding gst), supply automatic seepage measuring system make : aimil ltd / sysgeo italy or equivalent vibrating wire water leakage measuring systems are used for measuring water leakage and flow in dam galleries by installing v notch weir coupled with vibrating wire sensor for remote monitoring of water leakage. sensor type: sensor : vibrating wire precision water level sensor range: 300mm resolution: 0.025%fs material : stainless steel excitation : sweep or pluck assembly: v.w. type sensors enclosed in an environmental proof fibre glass box. splicing kit & adhesive required accessories. proposed location : inside spillway foundation gallery: 1 no. toe drain: 1 no. (drainage outlet) purpose: seepage water measurement in liter per second (but excluding gst), supply data logger or data acquisition system aimil make dt85g with cem20 or ace s korea analog channels 16 analog input channels each channel is independent and supports: one isolated 3-wire or 4-wire input, or two isolated 2-wire inputs, or three common referenced 2-wire inputs. expansion requires optional cem20 sampling integrates over 50/60hz line period for accuracy and noise rejection maximum sample speed: 40hz effective resolution: 18 bits linearity: 0.01% common mode rejection: >90db line series mode rejection: >35db vibrating wire frequency range: 500 to 5khz coil resistance: 50 to 200 stimulation method: single pulse pluc digital channels 8 bi-directional channels input type: 8 logic level (max 20/30v) output type: 4 with open drain fet(max: 30v, 100ma) 4 with logic output alarms power supply , sim card will be in your scope. propo

Central Government/Public Sector

CTN :39910212

22 Apr, 2025 NA

Vellore - Tamil Nadu

Tender For corrigendum : supply of resin bonded fiberglass wool, 50 mm thk, as per the specification tfn no: 313 rev 00 dt 19.12. 2019.

CTN :39926688

20 May, 2025 NA

Haridwar - Uttarakhand

Tender For tender for supply of inflation valve cap , locking wire , sealing ring , connector 130sux7 , analog amperemeter 100ma , screw , sealing ring , sealing ring , ring , blank , wire , oscilloscope probe with crocodile clip , gasket , spare fuse slowly blowing 12a , dust cap , nut , filter section , heat treated wire , locking washer , paste vpt 1 vpt 1i , high voltage volt meter , analog milli ampere meter 500ma , washer , sealing ring , sealing ring , relay , sealing ring , fiberglass cloth , polyethylsiloxane liquid , rf cable set ram1701ac , analog megger , analog amperemeter 100ma , ring , sealing ring , sealing ring , bracket , inflation valve cap

Central Government/Public Sector

CTN :39896842

23 Apr, 2025 NA

Howrah - West Bengal

Tender For supply of spanner 18 inch, drop forged, phosphate finish , thread pitch gauge 0.35-6mm , hammer 500 grams with wooden handle , sledge hammer 900 grams with wooden handle , sledge hammer 1500 grams with wooden handle , sledge hammer 2500 grams with fiberglass handle , hand drilling machine , impact wrench single hammer kit , open end hammering spanner 24 mm , open end hammering spanner 27 mm , open end hammering spanner 30 mm , open end hammering spanner 32 mm , open end hammering spanner 36 mm , open end hammering spanner 41 mm , ring hammering spanner 24 mm , ring hammering spanner 27 mm , ring hammering spanner 30 mm , ring hammering spanner 32 mm , ring hammering spanner 36 mm , ring hammering spanner 41 mm , 1000v insulated electric screwdriver set , solder flux paste brush rebaelling repair tool , soldering iron rework station handle heat pencil tool 60w 220v , 30w electric vacuum solder sucker welding desoldering pump , solder wick braid copper wire with flux 2.5mm x 1.5m , electronic cutting nippers 10 x 5 x 5 cm , soldering flux paste 500gm , combination pliers with joint cutter 165 x 50 x 10.5 cm , two way double faced mallet hammer 35mm with rubber mallet head , octagonal chiesel high grade forged steel, 6 inch. length , octagonal chiesel high grade forged steel, 10 inch. length , flat screw driver 0.6 x 0.4, length 110mm , flat screw driver 3.0 x 0.4, length 175mm , flat screw driver 3.5 x 0.5, length 225 mm , flat screw driver 6.0 x 0.8, length 236mm , flat screw driver 8.0 x 1.2, length 355 mm , philips screw driver tip size-0, length 108mm , philips screw driver tip size-1, length 235 mm , philips screw driver tip size-2, length 248 mm , philips screw driver tip size-3, length 255 mm , philips screw driver tip size-4, length 327mm , allen key set 1.5mm, 2mm, 2.5mm, 3mm, 4mm, 5mm, 6mm, 8mm,10mm , allen key-12mm , allen key-14mm , allen key-17mm , allen key-16mm , allen key- 19mm , square drive hex bit socket, output size 14 mm , square drive hex bit socket,output size 17 mm , square drive hex bit socket, output size 19 mm , 20 l aluminum horizontal jerry can with spout , fuel transfer pump kit with 1.2m pipe on both sides , tool cabinet 650x450x960mm,wt 70kg, 7 drawer , plastic mallet hammer face dia 40 mm , plastic mallet hammer face dia 25 mm , 17 inch 60 pockets nylon water proof tool bag , 18 tpi hacksaw blades, material hss, length 12 inch. , metal hacksaw frame, blade size 12 inch. , gi heavy metal funnel, size 4 inch. with strainer , oil filter wrench strap type , ms drum trolley capacity 350kg , hydraulic crimping tool , flat bastard file with plastic handle, 150mm , half round bastard file with plastic handle, 150mm , round bastarad file with plastic handle, 150mm , flat bastard file with plastic handle, 250mm , half round bastard file with plastic handle, 250mm , round bastard file with plastic handle, 250mm , triangular bastard file with plastic handle, 250 mm , half round smooth file with plastic handle,250mm , round smooth file with plastic handle, 250mm , tap set m8x1.25, material hss , tap set m10x1.5, material hss , tap set m12x1.75, material hss , tap set m14x2, material hss , tap set m16x2, material hss , tap set m18x2.5, material hss , tap set m24x3, material hss , tap set m27x3, material hss , tap set m30x3.5, material hss , tap wrenches size 1-0.5, thread sizes m1-m12 , tap wrenches size 3, thread sizes m5-m20 , tap wrenches size 5,thread sizes m13-m32 , oil tray 60cm x 50 cm x 10 cm , silicon sealant gun manual type , leakage arrest tape 2 inch. , bid details/ 2 / 149 leakage arrest tape 1 inch. , grease tape or denso tape, 1 inch. , grease tape or denso tape, 2 inch. , wire rope lubricator 6mm to 44mm , stainless steel scale or ruler , stainless steel try square scale ruler measurement tool 6 inch , steel spring caliper divider 6 inch , steel spring caliper divider 12 inch , spirit level length 300 mm , spirit level length 500 mm , straight nose tin snippers 255 mm , 250 mm length bent tin s

Loading, Please wait...

Fiberglass Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government/Public Sector