Latest gas duct Tenders | Government gas duct Tenders

State Government

CTN :44809791

30 Apr, 2026 NA

Korba - Chhattisgarh

Tender For procurement of alloy weld cast liners with sintered silicon abrasion & erosion resistant for flue gas duct of boiler- i, ii, iii, htps, korba west.

State Government

CTN :44798287

15 Apr, 2026 NA

Chandrapur - Maharashtra

Tender For procurement of bracing pipes for air preheater and flue gas duct for aoh at unit 8, cstps chandrapur.

Central Government And Public Sector

CTN :44823319

01 May, 2026 1.49 Crore

Raebareli - Uttar Pradesh

Tender For tender for supply of aircraft spare parts d d - fuel tank , break cylinder assy , nut nlg , elbow , brake plate , rtv sealant (pack 50ml) , rtv sealant (pack 50ml) , birssen hardner , moleykote insulating compound (pack 100gram) , resin birressen cr132fr (liter) , engine drain valve , rubber damper63x50 , ignition switch , nut , nut , blind rivet , engine shock mount , bolt engine mount , lock washer , o ring fuel tank , o ring fuel tank , oring fuel tank , spark plug , rubber damper 32x40 , hose , hose , hose , filter , hose fuel , potentiometer dual gauge , nlg bolt , fuel flow sensor , support muffler brace , connector3ptab , wheelhubassy , nut hexa slef lock , compression gas , brake lining , rivet brk pad , screw csk , gascolator filter , cotter pin , gasket magneto , fuel tank cap , nut exchaust , reflector , washer , gasket exhaust , placard main , placard tyre pressure , placard , placard pitot static , placard cp , placard , fuel pump make-weldon , inlet duct , valve body , flange , shim alt bracket , bolt , seal push rod , seal push rod , gasket rocker , switch ap trim , washer , camloc , rubber hose interconnecting , pin protection , turn coordinator , canopy bobble tall painted plastic , trim tab painted , hinge for knowckout window clear , safety walk step lh , strobe light green , o ring , kit nut replace mlg dampner , spring mlg , fuel level trans , camloc fastener , hose assy.fuel , clamp exhaust , flap actuator motor , gas spring , rocker switch white , clamp oet138r , resin pack size 1 ltr. , hardener pack size 1 ltr. , egt sensor , coupler exhaust , cable bush , collector power flow , hose fuel , hose fuel , hose fuel lh , hose fuel rh , hose oil rh , hose oil , hose oil , hose fuel , hose press manifold , door handle outside assy. , oil filter , make-champion , gasketing and jointing compound pack 100g

CTN :44823266

30 Apr, 2026 NA

Visakhapatnam - Andhra Pradesh

Tender For tender for supply of bush (bar) , assembly valve gear , rocker cover with o ring(w/o inj.cooler) , copper washer 8x22x1.5 , adjusting screw(bar) , metafram bush bp25-16/20x20 , oil seal 25x42x8 , exhaust manifold(lag) , sheathed injection pipe , stud m12-40/30n j12 nse1.181 , oring an7 , 31b6 , mb 40x30 bearing bush , o ring 151i.d.3d nse6.531 21a7 , set of gaskets for pd filter , sealing ring , pin , fuel filter element , bush bearing , sealing bush , piston ring(p3712) , ring saftey , bush , cap , locating pin , lgc pin (bar)lgc g5 8x30 , plut , cam shaft plug , roller bearing 110 60 22 , loctite 641 , con rod small end bush , piston pin , chrome plated piston ring , compression ring , cyl.liner (light fuel) assy , pin roller , roller , rocking arm assembly , snap ring , ring nse6.531 21a7no ms 229 , washer , stud , exhaust valve seat , outside spring , tappet , plug , valve rockers assly , sealing product glue 1005l , copper washer 8x22x1.5 , piston ring , needle , coupling-holder , o ring , shaft , nut , ball bearing skf6307 , ball bearing , bearing , cyclam seal , bs ring , lipped seal , expansion bellow , o ring , pump tappet lo pipe , lub oil pipe , valve air lo pipe , coupling hollow screw , gasket , joint , flame arrestor , sealing joint , washer , pinion on reducer , bs ring , type c30 , nse 6.51 , 20 , loctite , filter ing element for particle detecting filt , o ring , indicator cock assembly , adaptor , fuel feed pump ccw tg0s , set of gaskets for fuel feed pump , set of oil seals for fuel feed pump , rucompensation probe for exh. pyrometric duct , flex hose for hydraulic tool , flexible hose for breather , pressure switch , overspeed air solenoid valve (241 no 24v)

CTN :44332619

15 Apr, 2026 9.48 Lacs

Multi City - Andhra Pradesh

Tender For corrigendum : replacement of damaged insulation and cladding of flue gas ducts, primary, secondary air ducts, boiler outer casing and external piping of unit-3 and 4 boilers of stage-ii during annual overhaul period, regular and break down maintenance works for the year 2026-27

CTN :44842601

17 Apr, 2026 7.57 Lacs

Nellore - Andhra Pradesh

Tender For repairs to secondary air duct (aph out let to wind box inlet) & flue gas duct (economizer outlet to aph and esp outlet to chimney area) in the boiler of unit-1 including t&p and consumable during the running and annual overhaul period 2026-27

CTN :44806856

20 Apr, 2026 3.25 Lacs

Kota - Rajasthan

Tender For for annual maintenance contract (amc) of hitachi make green gas duct able air conditioner total unit 80 ton at the 220 kv gss sakatpura kotafor11 month from 01.05.2026 to 31.03.2027.

CTN :44611362

16 Apr, 2026 NA

Multi City - Gujarat

Tender For corrigendum : work of replacement of casing liner plates of exhaust duct (chimney) of gt - 2 at dhuvaran gbps.

corporations/Associations/Others

CTN :44435146

09 Apr, 2026 NA

Tuticorin - Tamil Nadu

Tender For corrigendum : supply of various sizes of deflector plates for flue gas duct at aph outlet of unit iv

CTN :44757118

23 Apr, 2026 9.00 Lacs

Farrukhabad - Uttar Pradesh

Tender For fabrication work d d - places , replacing wornout runner base and installing a new runner base of cane carrier and baggage elevator and r b c , replacing wornout runner with new one of cane carrier and baggage elevator and r b c , removing wornout angle iron and t iron of the cane carrier and reinstalling it by straightening the crooked part , removing the wornout part of the suit from different places and fitting it with new one , chevron grooving of new rollers of the mill , chevron grooving of old rollers of the mill , remove the wornout partition plates of the juice box above and below the juice heater by 10 or 12 mm ms plate and install it , installing ribs at the top and bottom partitions of the juice heater , repairing save all of qurdbody , removing old wornout gutters installed at various places and installing it with new gutters , remove the old wornout save all from pan and quard and install it with new one , reinstalling the new umbrella fitted inside the pan by making a new one and removing the old one , replacement ribbon arm of the mascute receiving crystallizer , making new separator of a centrifugal machine , removing the wornout truff of the hopper and installing it with new one , making and installing new separators for continuous centrifugal machines , removing the tubes of quad juice heater and dynamic juice heater and expanding them by installing new tubes and giving their hydraulic testing satisfactory of size 42 mm , removing the tubes of pan installing new tubes and expanding them and giving hydraulic tesing with satisfactory trial of size 96 mm , removing the wornout flue gas ducting of both the boilers and installing it with newone making from new or old plates , removing the wornout front and roof plate at boiler number 1 and 2 and installing with a new plate , removing the damaged boiler damper and installing a new one , making bagasse suit and installing. , replacement of juice over flow box of clarifier , making and installing bed of motor and pumps at various places as per requirement , replacement 6 inch dia cooling pipe of sulfur furnace , removing the monitor casing of a machine from old machine and installing it and giving its a trial , making amd replacing manholes at various places , making and replacing the enternals of cather of the pan. , making and replacing the new hood of cane cutter , removing the old bottom plate of the lowest compartment of the clarifier and placing a new plate on it after placing an angle trap as per the instructions and giving a satisfactory water trial , reinstalling the stirrer of the clarifier and giving a satisfactory trial , removing the shaft of a pug mill and replacing the old bushes on both sides and fitting new ones , removing and refitting the shaft of a brown sugar magma mixer and installing with new bush , reinstalling the trufff of connecting rod of the hopper , making and installing new catcher strainer , removing the old rail line of the trolley of the unloader and fitting the new rail line satisfactorily and doing water level , reinstalling the old rail line of the unloader s bridge and fitting it and checking water level etc , removal of old and weak channels of 3 inches to 10 inches diameter installed at various places and installation of new ones as per requirement , cutting and straightening old plates installed at various places as per requirement , removal of old and wornout scrubber installed on sulfur furnace and making and replacing with 8 or 10 mm plate and making all the connections , removing the trufff plate including support corroded shell and top cover plate of the top chamber of the clarifier and fitting the new plate and giving it s a water proof trial , re-installation alignment and //bid details 2 / 47 trial of hopper driving end , making and installing the top cover of the centrifugal machine , making an arm and installing it on the shaft of pug mill , making and installing scrubber and bottle jackets of sulfur furnace , makin

Gas Duct Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

State Government

State Government

Central Government And Public Sector

corporations/Associations/Others