Tender For supply and installation of laboratory equipments for bansberia 15 mgd wtp under bansberia municipality. - ph 700 meter,ph 700 meter with glass body open pore ph electrode, atc probe, integral electrode holder & 100/240 vac adapter and with 4, 7 ,10 480ml colored calibration buffer solution,range: -2 to 16, turbidity meter,waterproof tn-100 handheld turbidity meter with set of 4 calibration standards (800, 100, 20.0 & 0.02 ntu), set of sample vials, lint-free cloth, silicone oil, batteries, and hard carrying case,range:- 0 to 2000 ntu, conductivity meter,700 conductivity meter up to 5-point push button calibration, nan-volatile memory that holds up to 100 data points, and integral electrode holder and electrode. along with 1413 calibration solution,range:-0-2000 s/cm, lab weighing machine/ analytical balance,microprocessor based analytical balance, 220 gm capacity, 0.1 mg readability with internal calibration facility, air-shield, ss pan, lcd display, under hook facility, piece counting facility, lq oq pq certificates with internal calibration facility, air-shield,range:-0.1mg to 220 gm, chloroscope test kit ,range 0 05-5 ppm, 500 tests, range:-0.05-5 ppm
Tender For purchase of lab equipments for chemistry lab in basic engineering department - purchase, digital electronic balance /analytical balance load capacity: minimum 500 g readability: 0.01 g linearity: 0.02g display: lcd/led tare function: required top pan type power supply: 220 240 v ac, 50 hz, digital tds metermeasuring range: 0 9990 ppm resolution: 1 ppm display: lcd automatic temperature compensation (atc): required waterproof: minimum ip67 protection power source: battery operated (button cell/aaa battery), digital ph meter benchtop model ph type microprocessor/microcontroller ph range: 0 14 resolution: 0.01 ph accuracy: 0.05 ph or better combined ph electrode with temperature sensor two or three-point calibration facility temperature compensation type automatic display: lcd power supply: 220 240 v ac 50 hz warranty minimum 1 year, laboratory heating mantle (knitted glass yarn) capacity: 500ml temperature range: ambient to 350 c energy regulator/control knob: required power supply: 220-240 v ac 50 hz, electric bunsen burnerelectrically operated energy regulator/ control knob operating temperature 800 c body: stainless steel power supply source: corded electric, supplied with a heavy-duty, heat-resistant, earth-grounded, 3-pin power cord (minimum length 1.2 meters). power consumption: between 350 and 500w power supply: 220-240 v ac 50 hz, water distillation unitoutput capacity: 4 litres per hour (lph) ph value: 5.5 to 7.0 conductivity (raw water distillation):3.0 4.0 s/cm or less glassware material: borosilicate 3.3 glass (pyrex/duran equivalent) heating elements: silica- enclosed quartz heaters or chromium-plated element variants power supply: 220 240 v ac 50 hz / 60 hz, single phase automatic water level cut-off
Tender For establishment of material testing laboratory under o/o the agm(c) design and projects aegcl kahilipara - civil works, compression testing machine (2000kn) with digital reading, automatic pace control with all attachment for testing concrete cube & bricks conforming to indian standards (is: 516, is: 14858) and can also be supplied as per british standards (bs: 1881), astm c-39 with calibration certificate. it should be typically calibrated to class 1 accuracy ( 1%); featuring a robust, fully welded loading unit and hardened, ground, and polished platens, often with a self-aligning upper platen; with display type as pc-controlled with software. it should have pace rate of full three-term pid feedback control with fully automated data acquisition, storage, and analysis. the operation should be fully automated, stress & strain controlled loading., aggregate impact test, crushing value apparatus with hammer weight of 13.75 kg 0.25 kg (or 14 kg 0.5 kg), height of free fall of 380 mm 5 mm, impact cup (mould) inner diameter of 102 mm 0.25 mm and impact cup depth of 50 mm 0.25 mm as per is 2386 (part iv), bs 812-112. automation grade often semi-automatic with a digital counter. display type digital for the blow counter; sometimes includes a digital gauge for other measurements. overall weight (approx.) should be of 45 kg to 60 kg (total machine mass). standards compliance conforms to international standards like is: 2386 (part iv), bs 812-112, etc. , sieves: (40, 20, 10, 4.75, 2.36, 1. 18) mm with lid and pan and (0.6, 0.3, 0. 15, 0.075) with lid and pan (all 200mm diameter size) metal : gi, weighing balance-30kg (accuracy-1gm)., weighing balance-5kg (accuracy-0.1gm)., hot air oven with double walled design, thick glass wool insulation to prevent heat loss, micro processor based auto tune pid digital temp controller cum indicators and 230 volt 50hz single phase ac supply, heavy duty stainless steel lock, indoor hinge and sample placement trays, temp range should be 50 degree c 250 degree c with temp accuracy 0.5 degree c. it should have digital led display of size 45 cm x 45 cm x 45 cm (inner)., cube mould (cast iron) of size 150mmx150mmx150mm, isi marked as per is:10086. weight of the mould will be about 13.5 kg, strictly as per bis specifications and within required tolerance., slump cone test apparatus-(isi marked)-with tamping rod (complete set ) as per is: 7320 and is: 1199 part 2, consisting of slump cone, base plate and graduated tamping rod - made of stainless steel., proctor test apparatus with all accessories as per is: 2720 part 8 and is: 10074(1982), complete with base plate and collar., measuring cylinder-borosilicate (1 complete set ) glass of sizes 100 ml, 250 ml, 500 ml and 1000 ml., field density test app-core cutter method ( complete set) complete with core cutter of 100 mm dia x 130 mm long with chromium plating, dolly for 100 mm dia core cutter, and rammer with steel rod as per is : 2720, rebound hammer digital (original/silver schmidt type n) with calibration certificate as per is 516 part 5, sec 4 with impact energy of 2.207 nm (1.63 ft-lbf), concrete strength range of 10 100 mpa (1450 14500 psi) and weight of 570 g (1.3 lb) with display as graphic lcd (e.g., 17x71 pixels) or analog/digital and battery life: >5000 impacts., ultrasonic pulse velocity test apparatus (proceq, acoustic control systems, vedantrik technologies) with calibration certificate and frequency range of 24 500 khz (nominal transducer); measurement resolution of 0.1 s (microseconds); pulse voltage ranging from 125 v to 500 v (adjustable); receiver gain of 1x, 10x, 100x, auto, up to 1000x (lab+ model); pulse shape as square wave; measurement modes as pulse velocity, surface velocity, e-modulus, compressive strength correlation, crack depth; memory which stores >500 measured values; display should be 79x21 mm passive matrix oled; connectivity through usb for pc connection; software: pundit link for analysis and export. standards compliance
Tender For supply of coil 5 ohm , resistance coil 10 ohm , reversing key , sonometer with weight , spherometer 1 mm pitch , viscosity apparatus , youngs modulus , vernier callipers ime type , metallic sphere with hook , zener diode characteristics apparatus , pn junction diode chartersics apparatus , transistor characterstics apparatus pnp and npn , study of logic gate apparatus , friction board apparatus , thermometer 220 f , fraction weight box , plier taparia , screw driver set multipurpose , transformer step up and step down , led 2 watt , inclined plane , milli ammeter , milli voltmeter , ohms law apparatus , retort stand with clamp and bose head , helical sprinf slinky , split cork , travelling microscope , spirit level small , overflow cane , one way key , two way key , four way key , jockey , constantan wire , magnesium wire , watch glass 3 inch , watch glass 2 inch , hanger with weight 50 gm , newton colour disc , spirit lamp , tornedo working model , archmedies principle working model , hand generator working model , solenoid engine working model , electric mlotor working model , magnetic induction working model , domestic circuit parallel working model , domestic circuit series working model , battery eliminator 2 amp , magnetic compass medium size , wire cutter stripper cutter , dry cell charger , rehostat 50 ohm , rehostat 100 ohm , telescope , battery 6 volt , 9 volt dry cell , battery 12 volt , galvanometer , voltmeter , ammeter , dc copper connection wire roll insulated , nicrome wire , simple torch , laser torch red , laser torch green , laboratory stop watch 60 sec timer , white screen for image formation , plane mirror mounted on wooden block 10 x 15 cm , compass magnet small , iron filling , thread roll , geomerical instrument box , paper pin box , thumb pin box , lens cleaner fluid , multimeter digital , ebonite rod , glass rod 20 to 25 cm , test tube , test tube stand , solar system model , soldering iron , solder flux , soder wire resin 100gm , paper tape , plain stickers or label pkt , electric apparatus chart , prism refraction chart , eye defect and correction chart , inertia of 3d body , reflection of convex mirror on different position , reflection of concave mirror on different position , human eye chart , symbols of components used in circuit diagram , flaming left and right hand rule , sound wave refraction and compression , carbon resistance band reading chart , dry cell part chart , solar system chart , albert einstein portrait , prafulla chandra roy portrait , chandrasekhara venkata raman portrait , homi jehangir bhabha portrait , jagadish chandra bose portrait , dr apj abdul kalam portrait , sir issac newton portrait , ammonium chloride 500 gm chemical , copper sulphate 500 gm chemical , zinc sulphate 500 gm chemical , zinc rod , spirit solution for spirit lamp 1 ltr , first aid kit , sitting stools , cupboard or almirah shelf , lab open rack
Tender For supply of lab equipments and accessories - upgradation of laboratory equipment, pycnometer: (refer nit) capacity: 900 ml; material: glass body with rubber seal and screwed brass cone cap; conforming to is: 2720 (part 3) and is: 2386 (part 3); graduated with high precision; used for measuring and comparing densities or specific gravities of liquids and solids ( aggregates for concrete), including soil.; accuracy: 0.01 g/ml. supplied with brass cone and rubber seal. , field density kit (i): sand replacement method: as per the nit annexure enclosed., field density kit (ii): core cutter method: as per the nit annexure enclosed., electrical oven: as per the nit annexure enclosed., unconfined compression testing apparatus: as per the nit annexure enclosed., water bath: as per the nit annexure enclosed., constant head permeability test apparatus for soil &falling head permeability test apparatus for soil: as per the nit annexure enclosed.
Tender For supply of 2 to 20ul variable pipette , 20ul to 200ul , 100 to 1000ul , 500 to 5000ul , 1000 to 10000ul , 0 point 5 to 20 ul pack size 1000 , 1 to 200 ul pack size 1000 , 1 to 300 ul pack size 1000 , 100 to 1000 ul pack size 500 , 1 to 5 ml pack size 250 , 10 ml pack size 200 , 100 ml 64 into 105 mm , 250 ml to 85 into 145 mm , 500 ml to 105 into 180 mm , 1000 ml 131 into 220 mm , 100 ml 50 into 70 mm , 250 ml 70 into 95 , 500 ml 83 into 115 , 1000 ml 105 into 145 , 5 ml approx o d into length mm 12 into 75 , 7 ml 12 into 100 mm , 15 ml 15 into 150 mm , 27 ml 18 into 150 mm , 15 ml pack size 25 into20 , 50 ml pack size 25 into20 , 1point5 ml pack size 500 pack , 2 ml pack size 500 pack , 3 point 5mi quartz cuvette pair , funnel for 50mm pack size 36qty , glassfilter funnel short stem 50 mm dia , wash bottle 500ml pack of 6 , ice bucket for 2.5l , ice bucket for 5l , glass petriplates 100 into 15 mm , parafilm sealing film 50mm , niltrile exam gloves i blue small size pack of 50 , niltrile exam gloves i blue large size , laboratory tray
Tender For making aluminium partition wall one third glass and two third acp at dr nandini ghosh laboratory of microbiology dept in the campus of vidyasagar university