Latest gravels Tenders | Government gravels Tenders

State Government

CTN :45705821

30 Jun, 2026 NA

Sirsa - Haryana

Tender For providing, lowering, laying, cutting (cut surface to be uniformly finished), jointing with rubber rings marked with is : 5382 and testing of spigot and socketted rcc, np2 marked with is : 458-1988 and specials into trenches for all depths including carriage, loading, unloading, stacking, handling, re-handling etc. complete is all respects to the satisfaction to the engineer - in -charge. 4. 350 mm i/d ,`jointing plain and reinforced concrete pipes and specials of all classes in trenches using collar joints jointed with 1:1 cement sand mortar nearly dry heavily caulked into joints and with end dowels filled with 1:1 cement sand mortar including facing trowelling and finishing the joints at an angle of 45 degrees with faces of collars keeping joints wet till curved testing the drain lines for leakage and making good all leakage and defects as laid down in the contract specifications complete with two spigot ends jointed to collar and internal diameter of sewer pipe or special , earth work in excavation by mechanical means (hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead up to 50 m and lift up to 1.5 m, as directed by engineer-in-charge. 1. all kinds of soil ,cement concrete (cast in situ) providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work below plinth level and up to floor iv level: 3. 1:2:4 (1 cement : 2 coarse sand (zone-iii) : 4 graded stone aggregate 40 mm nominal size),brick work brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 2. cement mortar 1:6 (1 cement : 6 coarse sand), cement plaster (in fine sand) 12 mm cement plaster of mix : 3. 1:4 (1 cement: 4 fine sand)

State Government

CTN :45702917

30 Jun, 2026 NA

Rohtak - Haryana

Tender For brick work brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 1. cement mortar 1:4 (1 cement : 4 coarse sand) ,lan and reinforced concrete pipes `jointing plain and reinforced concrete pipes and specials of all classes in trenches using collar joints jointed with 1:1 cement sand mortar nearly dry heavily caulked into joints and with end dowels filled with 1:1 cement sand mortar including facing trowelling and finishing the joints at an angle of 45 degrees with faces of collars keeping joints wet till curved testing the drain lines for leakage and making good all leakage and defects as laid down in the contract specifications complete with two spigot ends jointed to collar and internal diameter of sewer pipe or special being. ` 7. 350 mm internal diametre sewer pipe

State Government

CTN :45702921

30 Jun, 2026 NA

Rohtak - Haryana

Tender For brick work brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 1. cement mortar 1:4 (1 cement : 4 coarse sand) ,lan and reinforced concrete pipes `jointing plain and reinforced concrete pipes and specials of all classes in trenches using collar joints jointed with 1:1 cement sand mortar nearly dry heavily caulked into joints and with end dowels filled with 1:1 cement sand mortar including facing trowelling and finishing the joints at an angle of 45 degrees with faces of collars keeping joints wet till curved testing the drain lines for leakage and making good all leakage and defects as laid down in the contract specifications complete with two spigot ends jointed to collar and internal diameter of sewer pipe or special being. ` 7. 350 mm internal diametre sewer pipe

State Government

CTN :45723523

27 Jul, 2026 NA

Hisar - Haryana

Tender For sand and gravels for sand filter media

CTN :45704229

07 Jul, 2026 NA

Durg - Chhattisgarh

Tender For tender for supply of spares for wpil make pumps -a7tc 3 stage pump shaft , e14tc 2 stage impeller , e14tc 2 stage bowl , hm16tc suction bell , hm16tc bowl , a10tc 2 stage suction bell , a10tc 2 stage impeller , a10tc 2 stage rubber bearing , a10tc 2 stage shaft coupling , a10tc 2 stage column pipe , a10tc 2 stage head shaft , a10tc 2 stage bearing , a10tc 2 stage packing box bearing , a10tc 2 stage suction bell bearing , a10tc 2 stage discharge case bearing , a10tc 2 stage pump shaft , a10tc 2 stage flexible coupling , a10tc 2 stage lantern ring , a10tc 2 stage sand collar , a10tc 2 stage seal ring , a10tc 2 stage water deflector

Central Government/Public Sector

CTN :45702761

03 Jul, 2026 NA

Multi City - Tamil Nadu

Tender For auction sale of depot ferrous scrap - cond.& u/s diesel/emu/c&w/lhb, equilising beam, buffer, ac loco components such as tooth gears, crank shaft, brake disc, pinion, injector, gear wheel, cylinder liners, grease cup, alternator fan cover filter assembly, cattle guard, sab air brake components,air brake cylinder components, shock absorber, cattle guard, linear,traction motor spare parts, dust collector,tapperbearing with polimer cage,doubelcupcollar,shockabsorber,hp cylinder rail guard, outer/inner sleeves of bearing bolts& nuts, air filter, damper, lube oil filter, tiny springs,rotor, anchor link scrap, sab components, cutoff angle cock, control arm upper, ca lower, traction rod, anti roll bar assembly, axle box components, gears, brake disk, leaf spring, carrier assembly, bearing bolt, centering device, fork eye, coupler sleeve, air pipe assembly, break shoe bolster link, hoop coupler, parking break assembly,primary and secondary springs,footsteps,bolster hanger, dust guard, wearing plate, compensating ring, impeller, inner hanger,iron bracket above transformer, brake gear components, spring plate, coupler sleeve, brake hanger, yoke lead, coupler bearing, coupler rear plate, coupler clearance plates, wearing plate, brake beam, dust covers, collar, dashpot top, protective tube, gear case vocer, side bearer cover, pins for hanger, machinery items cut pieces, shock absorber, nipplers, cutout cocks, etc., tm pinion, tm parts as holder plate and end shield, axle box parts as axle box cover,boldter,oilcup,angles,equilising stay,pipes,nosepad,lsbeam,cibrakeblock , automobile parts,silentblock,impeller housing,cowl, axle guide and racer, traction link, the bar, traction housing,brake hangar, pull rod, slack adjuster, knuckle, clevis, screw coupling, cbc coupler and parts, fuffer, cattle guard, labyrinth, bearing for axle box, traction motor and aux motors, damper, sand box, sand ejector, sand pipe, foot step, sand ejector., angle cock and ferrous couplings, lathe machine head, junction box, cutting ferrous, angles, rod, ferrous heater coils, ferrous lamp pipe, transformet brackets, oil lubricator for suspension bearing, lid for gear case, linear, push rod &gudgeon pin, compressor, hood with impeller,ocb ducts, labyrinth, end frame tamper, hanger link, cylinder linear, oil dispersive, axle box cover, servo motor, striker casting with grease adherings(diesel),castiron components, impeller, guard, compartment sliding doors, compensating ring, end sheild, cartridge with nu bearing,pipe, drum,hoist, gear, impeller, eot crane wheels, eot crane gears , side rod, pull rod, pinion wheel, pull lift chain, door closer, emu coupler,inter cooler, engine head, covers, dooms, pipes, tank, front cover, rear cover, hand rail, after cooler, cylinder body, spring piston, holder plate,sand box, labyrinth, lhb bearings, outer bearing covers, end shield, piston trunk, adjusting rod, palm pull rod, control arm, dbr rf boxes,hoods, brake hanger, brake hanger with head, brake head & semi permanent coupler and parts, bmbc components, bend cover, inspection cover, centrifugal dust collector, cut off angle cock, safety rod, racker arm, valve plate, cylinder bore, bearing cover, emu sliding door, silencer, racer, raiser, bellow plate, door operating cylinder scrap, msu components scrap, labyrinth &pinion shaft(diesel), compensation ring, buff gear, hood with impeller, ront fork complete housing, lb spring set scrap, stator w/o coil, contering dis, anger link with or w/o silent block, oil cup and all other scraps released from diesel / ac loco/emu/c&w/lhb components and all other ms/ci with/without minor non ferrous attachments in as is where is condition. pl no. 98050126. custodian: cdms-rsf-gsd-per. note: 1) cutting permitted to loadable sizes only. 2) during delivery if any major non-ferrous items found the same should be handed over to custodian. 3) loading by crane / jcb is also permitted. location: bin n

Central Government/Public Sector

CTN :45684340

26 Jun, 2026 2.35 Lacs

Murshidabad - West Bengal

Tender For package-1-supply and laying of 40mm gravels/ pebbles at 1 x 660mw unit -5 sgtpp.

State Government

CTN :45654959

12 Jul, 2026 NA

Akola - Maharashtra

Tender For supply of filter media sand, grit, gravels and activated carbon for gravity filter at pre treatment plant unit iii, iv, v at wtp, paras tps.

State Government

CTN :45078390

06 Jul, 2026 50.72 Lacs

East Nimar - Madhya Pradesh

Tender For corrigendum : procurement of sand media, gravels, pebbles and anthracite along with work for top up of filter media in sand and activated carbon filter at stp 500, 900 kld shivariya colony, avgf and dm plant at 2x600 mw, stage i, sstpp, mppgcl, dongalia.

State Government

CTN :45614050

25 Jun, 2026 24.29 Lacs

South Tripura - Tripura

Tender For major works water supply scheme south tripura replacement 1 deep tube well including drilling development erw pipes pea gravels pump house staging column assembly pipeline reconnection works at ongc gajalia nabagram gp satchand rd block during 26-27

Gravels Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors