Latest level sensor Tenders | Government level sensor Tenders

Central Government/Public Sector

CTN :45418597

06 Jul, 2026 40.00 Lacs

Coimbatore - Tamil Nadu

Tender For corrigendum : renewal/ replacement of water level sensors, panels, controllers units and connected control panels miscellaneous e/m items for water supply distribution system at afs sulur

Central Government/Public Sector

CTN :45713835

18 Jul, 2026 30.00 Lacs

Mumbai - Maharashtra

Tender For repair/replacement of external electric supply distribution network with other connected items at malad, marve and kandivali under ge (n) santacruz, mumbai - supply, install, testing & commissioning pedestal cubical type double door lt bus bar chamber box of suitable size factory made modular construction fabricated out of 3 mm thick crca sheet, angle iron, channels, epoxy powder coated to give a superior finish , outdoor type , totally enclosed dust & vermin proof with locking arrangements front & back side opening system including rain shed, busbar chamber should be suitable for accomodating all aluminium bus bar strips (50mm x 10mm x 04 nos) & gi strip for earth fixed on porcelain insulators, and one independent metering module suitable for accomodating three phase volt meters & ammeter digital type, indicator lamps, cable entry/exits cut outs at bottom part, with fixing arrangement on pcc (1:3:6) type c-2 bed block with studs, bolts, nuts & washers, danger notice board with scull suitable for 415 volts or required size to be fixed on pannel including dismantling of old bus bar panel all as specified and directed by engr-in charge.notes:-(a) aluminium bus bar duly covered with colour coded shrinkable sleeves of required size for phases and neutral - 01 set(b) mccb 4 pole , ics=100%icu- 25 ka, 415 volts, 100 amps , with thermal adjustable and fixed magnetic setting with extended terminals -02 nos.(c) digital multifunction meter of size 96x96 mm to measure current, voltage, frequency and power factor with built in selector switch and programable ct of appropriate ratio.-01 no make- imp/automatic electrical(ae)/ l&t / havells/ meco(d) panel indicating lamp neon/led type (red ,yellow & blue) with lamp holders - 03 nos(e) panel instrumental wiring with frls suitable size but not less than 2.5 sqmm copper wire single core - 01 job(f) necessary sizes of lugs for fixing of cables in bus bar deemded to be included rate quoted by the contractor.make of mccb & mcb: larsen &toubro/ abb/ siemens/ schneider/ havells/ legrand/ indo asian/ c & s electric/ bhartia cuttler hammer (bch)/benlo, supply & fixing mccb 4 pole 36 ka 400 amp with adjustable thermal & adjustable magnetic setting, including taking down old unserviceable mccb, all as specified and directed by engr-in-charge. make:- larsen &toubro/ abb/ siemens/ schneider/ havells/ legrand/ indo asian/ c & s electric/ bhartia cuttler hammer (bch)/benlo, supply & fixing mccb 4 pole 36 ka 160 amp with adjustable thermal & adjustable magnetic setting, including taking down old unserviceable mccb, all as specified and directed by engr-in-charge. make:-larsen &toubro/ abb/ siemens/ schneider/ havells/ legrand/ indo asian/ c & s electric/ bhartia cuttler hammer (bch)/benlo, supply & fixing mccb 4 pole 16 ka 100 amp with adjustable thermal & adjustable magnetic setting, including taking down old unserviceable mccb, all as specified and directed by engr-in-charge. make:-larsen &toubro/ abb/ siemens/ schneider/ havells/ legrand/ indo asian/ c & s electric/ bhartia cuttler hammer (bch)/benlo, supply & fixing mccb 4 pole 36 ka 250 amp with adjustable thermal & adjustable magnetic setting, including taking down old unserviceable mccb all as specified and directed by engr-in-charge make:-larsen &toubro/ abb/ siemens/ schneider/ havells/ legrand/ indo asian/ c & s electric/ bhartia cuttler hammer (bch)/benlo, supplying, laying,connecting, testing & commissioning lt ug pvc insulated, heavy duty, 1100 v grade electric cable with aluminium conductor of size 16 sqmm x 4 core, laid in trenches or passing through pipe or fixed to wall, making all connections with and including provision of necessary glands, lugs, bushing etc as required including taking down old unserviceable cable complete all as specified and as directed by engineer-in-charge of following sizes:-note : earthwork excavation, dwc

Central Government / Public Sector

CTN :45736481

30 Jul, 2026 NA

Hyderabad-T - Telangana

Tender For fluid level switch (hydraulic oil level sensor) equivalent to cil part no.: 4084368 of tube length 475 mm approx. suitable for 1400 hp demu dpc. note: one sample to be got approved before bulk supply [ warranty period: 30 months after the date of delivery ] ]

Central Government/Public Sector

CTN :45722314

14 Jul, 2026 NA

Bangalore - Karnataka

Tender For expression of interest to manufacture of parts and assembly of external fuel tanks for lca af mk1a aircraft - 1.fwd lug, 2.rear lug, 3.crutch cover plate, 4. electrical connector, 5.fv-av, (self sealing coupling), 6.joint ring, 7.joint ring bolts, 8.fwd filler cap, 9.rear filler cap, 10.i/o valve, 11.fwd drain valve, 12.rear drain valve, 13. rts valve, 14. low level sensor, 15. high level sensor, 16. metal nose cap, 17. metal rear cap, 18. sealing diaphragm, 19. bulk head, 20. rear hook bracket, 21. rear hook, 22. rack assembly

CTN :45617089

02 Jul, 2026 NA

Uttara Kannada - Karnataka

Tender For corrigendum : providing of repair, maintenance, and installation of plant/ systems/equipments (version 2) - ins vikramaditya; repair of ups for tank level sensor part no el007w ttls pc 001 qty 01; service provider

CTN :45704509

06 Jul, 2026 NA

Uttara Kannada - Karnataka

Tender For tender for repair and refurbishment of cupola high level sensor and underwater cable for snorting system

CTN :45704279

08 Jul, 2026 NA

Leh - Jammu And Kashmir

Tender For supply of spring pad - spring pad , oil seal , cap assy radiator , cable assy clutch , cylinder bassy master with booster , cord set high tension , bearing , lens backup lh , bush , weather strip door , oil filter assy , door glass rh , accelerator cable , assy tail lamp lh , bushing , assy universal joint yoke , horn 12v , field coil assy , drive assy , head light , pipe coolant pump , lamp incandescent , blade wind shield wiper , relay emergency valve , valve relay air pressure , regulator vehicle window , handle door , s a coolant pump , pump hand fuel pump , universal joint , filter assy shorter , shoe return spring , stop light switch , assy rear view mirror , dust cap for reservoir , diff lock rotary switch , regulator assy rh , knob shift lever , regulator assy lh , rear view mirror , needle roller brg , plug drain thread magnetic , drift pinion oil seal , cap filter opening , tail lamp lh , lamp unit vehicular map reading lamp , warning lamp demister , lamp unit vehicular , roof maker lamp rh , push switch for sump heater glow plug , light blackout , fuel filter insert cloth type , bearing bush , door glass lh , gasket oil drain from tc , knob inner lock , metal cleaner and dust remover , clutch cover assy * /bid number : gem/2026/b/7714403 + /dated: 26-06-2026 ' ' / bid document 1 / 44

corporations/Associations/Others

CTN :45727503

06 Jul, 2026 33.45 Lacs

Multi City - Gujarat

Tender For supply, installation, testing & commissioning mechanical screen ps-b & ps-c, moc-ms and level sensor at dwarka district devbhumi dwarka. (2nd attempt)

State Government

CTN :45713795

18 Jul, 2026 4.98 Lacs

Doda - Jammu And Kashmir

Tender For supply, installation, testing and commissioning of dewatering submersible 20 hp pump, automatic control panel with water level sensors in adit-ii hrt of bhep ii

State Government

CTN :45525068

06 Jul, 2026 41.51 Lacs

Raichur - Karnataka

Tender For corrigendum : routine monitoring / preventive maintenance / breakdown / emergency /regular servicing of pneumatic cylinders, solenoid valves, limit switches & pressures switches pertainsto units-5,6 &7 mill reject handling system(mrhs).operation and maintenance of dense phase mill reject handling systemof unit-8.the work involves-a)operation and maintenance of dpmrhs plc systemb)i&c maintenance works of air compressor.c)servicing/re-calibration of solenoid valves,limit/proximity switches & pressures switches etc.routine monitoring/maintenance of spm analyzer systemspertains to unit-5 to 8.the work involves-a)operation and maintenance of dpmrhs plc system.b)i&c maintenance works of air compressor.c)servicing/re-calibration of solenoid valves, limit/proximity switches & pressures switches etc.routine monitoring/maintenance of spm analyzer systems pertains to unit-5 to 8.the work involves-a)cleaning/servicing of transmitters & reflector units and blower filters of spm analyzers, pertains to units-5 to 8.b)carrying out maintenance works under the supervision of i&c engineerregular monitoring/checking healthiness of unit-7&8 coal bunker level monitoring systems.routine maintenance of bunker level monitoring systems.the work involves- a) cleaning/checking of 3d level sensors.b) cleaning/checking healthiness of local control panel at bunker floor.c) ensuring healthiness of signals to control room pc,dcs&chp control room digital indicators.regular monitoring/maintenance of hfo tanks level measurement systems.the work involves-a)cleaning/checking healthiness of radar level transmitters installed at hfo tanksb)cleaning/checking healthiness of local digital indicators installed at foph.c)cleaning/checking healthiness of plc unit installed at unit control room-7.the nature of work is round the clock maintenance.the cleaning/servicing and maintenance works of all the above mentioned systems shall be carried out during units aoh period.the required t&p and ppe for carrying out maintenance works shall be arranged by the contractor/agency itself.

Level Sensor Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government/Public Sector

Central Government / Public Sector

Central Government/Public Sector

corporations/Associations/Others

State Government

State Government