Get complete information related to latest Loco Transformer Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Loco Transformer Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Loco Transformer Tenders.
Tender For estimate for supply, erection & commissioning of various electromechanical equipment like 5 no. 5 cs. vt pump, electric motors, starter panel and other allied material for flood protection works from the field area of village dang khurd & outfall at rd 65000-r of nigana feeder in lift w/s (m) division, bhiwani for the year 2026-27. - supply, erection & commissioning of 5 c/s axial/mix flow water lubricated vertical flood pumps of 5 cs. discharge at 1440 rpm at static head of approx 6.0 mtr. having adjustable height, including ms bend including flange welding, ss/ht nut & bolts etc complete in all respect as per site requirement with epoxy coating & as per approved specifications of the department, supply, erection & commissioning of solid shaft motor of capacity 30 hp, 1440 rpm, 3 phase, 380 volt+- 10%, with eficiency class ie2 (with 35 mtr compatible 3 phase submersible cu cable from motor to panel/starter) suitable for fitment with 5 cs. v.t axial/mix flow pump type vertical flange mounted as per approved specifications of the department., supply, erection & commissioning of fully automatic star delta starter of cap. 150 amp including all accessories as one incomer of mccb (150amp) with 1 no mcb for lighting load, contactor rating 120 amp, 90 amp, 70 amp with control transformer for control supply, outgoing indicator, having mpr & all types of protections i.e.uv/ov/ over current, phase imbalance/phase reversal protection, locked rotor, dry run etc, digital meters, push buttons, bus bars, capacitor bank, seperate relay for single phase protection etc. complete in all respect suitable for open fields operation of 1 no. motor of capacity of 30 hp with a stand of ms channel with canopy having suitable operating height above the kachha open fields as per approved specifications of the department. (suitable for voltage range 380 +- 10%,) panel should be outdoor type., supply, erection & commissioning of m.s delivery pipe 10" dia. made of ms plate both end flanged (equal to or less than 6 mtr length of pipe) as per approved specification & make. (including ss/ht nut & bolt, rubber packing & other fitment accessory required), supply, erection and commissioning of ms girder parallel flange section ismb 150 with primer and bituminous based paint inside & outside of length 4mtr (approx wt 60 kg per pc) as per approved make & conforming to is808:2021.
Tender For supply of galvanised head hex bolt with nut size m-14x65.full threaded as per is 1364/2002.grade 8.8with 02 flat washers is -3063/1994 & 02 spring washers is 2016/1967 for bushing connection of locotransformer. it is used for bushing connection of 5400kva transformer. [ warranty period: 30 months after the date of delivery ] ]
Tender For corrigendum : supply of service 11 kv ht panel as per sepcifications , sf new mineral oil for panel etc as per sepcifications , calibration relay etc as per sepcifications , replacement digital ammeter for ht panel , replacement digital voltmeter for ht panel , replacment ryb ind lamp led type in ht panel , sf 2a hrc fuselink in ht panel , servicing 1500kva dry type transformer as per sepcifications , servicing 2 runs 2500a tpn bustrunking as per sepcifications , service mv lt panel with 2500a 4p acb 3 nos as per specifications , service mvlt panel with mccb incoming as per specifications , checking and repair of em intelocking , dismentaling 3.5 sq mm 240 or 300 sq mm al cable as required , pf adaptor box aprx 1.5 ft x 1.5 ft x 1.5ft of 16swg ms sheet as reqd , pvdg panel module door key as reqd , pvd and fixing operating handle for 250a 4p changeover as reqd , replacement 160a hrc fuse with base in extg cap panel , replacement 3p 50kvar cap duty contactor in extg cap panel , replacement 25sq mm cu lead wire 1ft length in extg cap panel , checking etxg 2no 25kvar cap bank and fault repair reinstallation , dismentaling uv protection connections as reqd , replacement digital ammeter for lt panel , replacement digital voltmeter for lt panel , replacment selector switch in lt panel , replacment ryb ind lamp led type in lt panel , sf 2a hrc fuselink in lt panel , sf 32a hrc fuseling incl removing faulty item from lt panel as reqd , sf 63a hrc fuseling incl removing faulty item from lt panel as reqd , sf 100a or125a hrc fuseling incl removing faulty item from lt panel as reqd , sf 250a hrc fuseling incl removing faulty item from lt panel as reqd , sf new 5 or 6 amp piano switch in replacement of faulty item , sf new 5 or 6 amp 3pin socket outlet in replacement of faulty item , sf new 15 or 16 amp piano switch in replacement of faulty item , sf new 15 or 16 amp 6pin socket outlet in replacement of faulty item , rewinding ceiling fan motor , sf 4ft 20w led fitting against faulty fitting , service of 750kva dg set as per specification , service dgset control panel 1250a 4p acb as per specification , repacement ryb ind lamp in dg set panel , repacement digital ammeter in dg set panel , earthing testing in existing earth pits and report submission
Tender For corrigendum : design, supply, installation, testing, commissioning including dismantling, replacement of control and relay panel for 66kv line feeder & transformer feeder at ukai hps. (emd-hps et-6186)
Tender For supply of lab items for eee and mechanical - eee and mechanical lab items, single phase transformer rating: 1 kva, 50 hz input: 230 v ac output: 115 v ac type: air-cooled, single-phase step-down transformer properly insulated input and output terminals brought out for safe operation, three phase transformer type: three phase transformer rating: 3 kva input voltage: 415 v ac, 3-phase output voltage: 230 v ac, 3-phase frequency: 50 hz winding material: copper wound insulation class: class b or higher duty: continuous duty suitable for laboratory use bench/floormounted suitable for laboratory operation. all winding terminals shall be brought out to insulated terminals and enclosed within a protective outer cover for safe laboratory operation , on / off control of lamp using solid state relay kit type : solid state relay (ssr) trainer kit control/input voltage : 12 v / 24 v dc or up to 30 v dc output load voltage : 230 v ac, single phase load control : on/off control of ac lamp load solid state relay based switching circuit opto-isolated input control built-in ac lamp load manual on/off switching arrangement led indication for input and output status , mcb elcb trainer kit 1 phase/3 phase, 2/3/4 pole, 3a-16a single pole mcb 2-5amps two pole elcb 30ma lamp load single phase 5amps panel enclosure and terminal outlets , single phase induction motor kit for load test by speed control of vfd (variable frequency drive) 2 hp single phase 230v complete load test experimental setup(with brake drum/pulley) induction motor -1 no work bench setup with digital meter -1 no motor stand with ant vibration bush 1 set loading arrangement with spring balance non-vibrating brake arrangement with stand and electrical work bench , 3 phase induction motor kit three phase squirrel cage induction motor with rope brake arrangement non-vibrating brake arrangement with stand and electrical work bench three phase squirrel cage induction motor 5 hp, 440 v, 1440 rpm, foot mounted type, frame size 132 mm, core length 110 mm, mechanical rope loading set up with 1" screw rods 2 nos, 6" adjustable wheels 6" 2 nos, back support frame, 9" aluminium drum, 0 50 kg spring balances 2 nos , dc shunt motor kit for load test dc shunt motor rope brake arrangement non-vibrating brake arrangement with stand and electrical work bench d.c. shunt motor 5hp, 220v, 1500 rpm, foot mounted type, frame size 132 mm, core length 110 mm, field current 0.5a, armature current 11a, 4 pole with inter poles, mechanical rope loading set up with 1" screw rods 2 nos, 6" adjusting wheels 6" 2 nos, back support frame 9" aluminum drum, 0 50 kg spring balances 2 nos. , bldc motor kit with electrical work bench *36v 400w bldc pro motor 1 no inbuilt volt and ammeter and rpm meter inbuilt power supply input 230v ac
Tender For repair and maintenance of tube wells and boosters including repair of water level gauge, ms panel, sluice valves and allied items of civil / electrical at various buildings i.e. punjab raj bhawan, haryana raj bhawan & residence sector-7, under maintennace booth, sector-7, chandigarh. (ch to: 2216 (np) mtc. and repair ) - repair of ci sluice valve up to 150 mm dia including dismantling, repair / replacement of spindle, nut , rubber packing, nuts and bolts complete., up to 100 mm dia, lifting and lowering of submersible pump set including dismantling of flenged joints, taking out column pipes, re-jointing etc including replacement of defective packing, nuts and bolts etc complete, tube well, booster, supplying and fixing of single phase preventor make minilec or equivalent model of approved make to the satisfaction of eic , supplying and fixing of current transformer ( ct ) for ampere meter of suitable rating complete., supplying and fixing of overload relay of following capacities, 14 to 23 amp, 30 to 42 amp, 45 to 75 amp, providing and fixing of star delta starter timer of make l&t or equivalent model of approved make to the satisfaction of eic, providing and fixing of kit kat 500 amp complete in all respect, supplying and fixing of capacitor of 20 to 50 mfd make l&t, siemens or equivalent model of approved make to the satisfaction of eic , supplying and fixing of analog meter of make l&t ( rishabh ) or equivalent model of approved make to the satisfaction of eic , volt meter, ampere meter, supplying and fixing of 3 pole mccb of following capacity of make l&t, bch, havells or equivalent model of approved make to the satisfaction of eic , 100 amp, supplying & fixing of contactors block of make l&t, bch or equivalent model of approved make to the satisfaction of eic , mnx - 25, mnx - 32, mnx - 50, mnx - 70, supplying and lowering of submersible cable 16mm2 of make havells, finolex, l&t or equivalent model of approved make to the satisfaction of eic , supplying and lowering of submersible cable 25mm2 of make havells, finolex, l&t or equivalent model of approved make to the satisfaction of eic , providing and fixing hydro pneumatic pump of size 0.5 hp of approved make with 24 ltr capacity tank, pressure switch, pressure gauge, nrv accessories and making connections complete of make crompton or equivalent model of approved make to the satisfaction of eic, repair and rewinding of submersible pump set including carriage from installation to workshop and back. the rate include replacement of all defective parts of pump and motor rewinding., 5 hp, 7.5 to 10 hp, 35 hp to 55 hp, repair and rewinding of monoblock submersible pumping set including repacement of defective parts as required and carriage from installation to workshop and back., 0.5 h.p, 1 h.p, 2 h.p, manufacturing, supplying and fixing of ms control panel 16 gauge of size 600x700mm with door including wiring of inside panel, complete in all respect, providing and fixing of self pumping monoblock single phase pump for boosting of make crompton or equivalent model of approved make to the satisfaction of eic, 0.5 h.p, 1 h.p, 2 h.p, providing and fixing of pressure gauge make h-guru or equivalent model of approved make to the satisfaction of eic, providing and fixing of elcb 63 amp make l&t/havells or equivalent model of approved make to the satisfaction of eic, repair of internal control wiring 1.5mm wire with thimbles, nut bolt etc. complete