Web Analytics Made Easy - StatCounter

Lt Pin Clamp Tenders

Get complete information related to latest Lt Pin Clamp Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Lt Pin Clamp Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Lt Pin Clamp Tenders .

Filter
Loading....
Loading....
Loading....
Loading....
Loading....

Bid Submission Date Range
Tender Value

CTN :42191802 Due date: 08 Dec, 202508 Dec, 2025 NA
Tender For bid to ras supply of silencer mounting plate , safety ring , silencer mounting plate nut , hex screw , m8 bolt , washer ss , m10 bolt , seat belt mounting plate , bolt , keel back part steel mounting plate lt-rt , tube elevator , elevator mounting plate , hinges , steel plate , hinge large , leading edge steel plate , nylon bush , leading edge mounting plate , washer , nylon nut , hinge , hex screw m8 , hex screw m6 , steel plate , plate , holder trim , saddle medium , sleeve , bolt m8 , seat belt male , seat belt female , bolt m6 , blot , trim operating , nylon distance sleeve , fin ss plate , hinge small , fitting leg , cable set x-air , distance sleeve , nylon washer , control stick assy plate , plate aileron , bolt mtg throttle , aluminum plate door small , aluminum plate door big , bidding , dashboard top , dashboard , door pin , holder , screen , screen upper , piston assy 71.93-71.94 mm , gasket 1.0m exhaust , front wheel complete with drum and brake assy size 03-50-10 , post nylon bush , batten tip , batten end , duc two blade windspoon standard tractor propeller r xair , engine mounting frame , engine mounting frame bolt , elevator cable holding , wing tension cable , elevator holding cable , distance nylon bush big , distance nylon bush small , elevator fork , fin trailing edge mounting plate , fuel tank co-pilot side , set of hoses , doors option left-right , impeller , cylinder head 12mm , supporting plate , electric starter assy , rotax revolution counter 0-8000 rpm , oil tank assy , clamp 16- 25 , tapit screw m6x20t , allen screw m6x16 , o ring 60 4 , mass cable 80mm , lock washer vh76 , hex screw m6 40 , rubber ring , spring cup , sieve sleeve , fuel pump df 52- 48 , clamp 7-11 , wind screen , wing tension cables complete set , front wing struts , rear wing struts , rudder mtg plate , control stick base , aluminum bush , cabin front tube , seat railing , main axle assy , pod rear bottom side l-r , pod rear bottom , floor board , canopy , nylon spacer , black saddle , mounting clip , control wire , mounting , nut hex , front pod up red 912cc , front pod bottom red 912cc , oil radiator mounting bracket l-r , coolant radiator mounting bracket l-r , short wing conversion kit for xairh silencer mounting plate (101058), safety ring (ab25), silencer mounting plate nut (vh06037), hex screw (vc06087), m8 bolt (ax08085), washer ss (rn0620), m10 bolt (vh08094), seat belt mounting plate (102125), safety ring (ab15), bolt (vh08109), m 8 bolt (ax06070), bolt (vh06052), keel back part steel mounting plate (lt & rt) (102126), tube (elevator) (102042), elevator mounting plate (102135), bolt (vh06047), hinges (102167), steel plate (103113), hinge large (103100), bolt (vh08089), leading edge steel plate (103111r), hinges (103101), nylon bush (104171), leading edge mounting plate (104129), hex screw (vc06067), washer (rm0612), nylon nut (ec06f), hinge (104101), hex screw m8 (vc08074), hex screw m6 (vc06072), steel plate (104112l), plate (104128), washer (rf0612), bolt (ax08040), bolt (ax06035), holder (trim) (107086), saddle medium (c02325), bolt (vh08134), sleeve (109135), bolt (vh08064), bolt (vh06057), bolt (vh08069), bolt m8 (vh06062), nylon bush (111401), bolt (vh06042), seat belt male (111237m), seat belt female (111237f), plate (111120), bolt (vh08099), bolt m8 (vh08039), bolt m6 (vh06072), blot (vh10044), holder (trim) (117087), trim operating //bid details 2 / 95

State Government

CTN :42985191 Due date: 19 Dec, 202519 Dec, 2025 NA
Tender For electric line materials under o&m head for f.y. 2025-26 - male female contact of 33 kv ab switch 600-630 a, male female contact of 11 kv ab switch 600 amp, male female contact of 11 kv ab switch 400 amp, connector pipe to panther, connector panther to panther, connector panther to ab switch, connector pipe to ab switch, connector dog to ab switch, led flood outdoor light with ip 66 protection rectangular (100w), suitable lugs, suspension clamp assembly suitable up to 70-95 mm2 bare messengers(including 1 no.suspension clamp with bracket 2 mtr. stainless steel strap &2nos.ss buckles), dead end clamp suitable above 70 s mm2 bare messengers (including 1 no. dead end bracket + 1 no. dead end + 2 mtr ss strap + 2 nos. ss buckle) (minimum breaking load-15 kn), lt ab cable accessory, 1.1 mtr. stainless steel strap if207(20x0.7), buckle for strap, insulation piercing connector for db charging, insulation piercing connector branching suitable for t joints, spring loaded distribution bus bar insulated box for fixing on pole suitable for ab xlpe cable and three phase connection 1 incoming and outgoing 3 phase connection as per field requirement, lt phase separator, service main anchor clamp for proper support of service cable (4 mm2 and 10 mm2), lt pre insulated mid span joint suitable 50 mm2 phases, lt pre insulated mid span joint suitable 95 mm2 phases, suspension clamp suitable for 95 mm2 bare messenger (including 1 no. suspension clamp with bracket 2 mtr stainless steel strap & 2 nos. ss buckle), p.g clamp for 200/150 mm2 conductor, p.g clamp for 80/100 mm2, aluminum pipe 40mm dia, rubber mat along length of panel, earthing g.i strip (65x6) mm2, aluminum winding wire/tape/strips etc.

State Government

CTN :42985193 Due date: 19 Dec, 202519 Dec, 2025 NA
Tender For supply of electric line materials under o&m head for f.y. 2025-26 - 25mm dia ms rod 3 m long for earth mat, 400 watt/250 v hpsv lamp fitting complete for 33/11 kv pss yard lightening, adhesive insulation tape, aluminum binding wire, aluminum pipe 40 mm dia, aluminum pipe connector, earthing g.i.strip (65x6)mm2, eye hook, dead end clamp 50-70 sq mm bare messenger, lt pre insulated mid span joint suitable 120 mm2 phases, lt pre insulated mid span joint suitable 70 mm2 phases, lt pre insulated mid span joint suitable 95 mm2 phases, p g clamp for 80/100mm2, p g clamps for 34/55mm2, pole clamp for i hook b type (0.8 kgs. each), service main anchor clamp for proper support of service cable, spike earthing made of 20mm gi solid rod, spring loaded cp multi conn bus-bar in insulated box single phase 1 in 9 out (dist. box for fixing on pole suitable for ab xlpe cable), stainless steel strip of 20mmx1mmx1000mm with buckle clip, jumpering wire (100 sq mm acsr conductor), jumpering wire (150 sq mm acsr conductor), hdpe pipe - 160 mm /6 pe 63 grade
 Loading, Please wait...

Connect us via What's Up