Tender For supply of switch proximity detector single channel dualoutput with phase reversal and line fault detection specification as per annexure b1 , switch proximity detector two channel single output for each channel specification as per annexure b2 , smart transmitter repeater 420ma hart specification as per annexure b3 , signal splitter nonintrinsically safe applications specification as per annexure b4 , ai barriers with dual op with hart compatibility at both ends specification as per annexure b5 , ai barriers for plc smart transmitter power supply output current sink specification as per annexure b6 , smart transmitter power supply dual output 4 ma 20 ma output current sink specification as per annexure b7 , current voltage driver specification as per annexure b8 , voltage repeater vibration transducer interface specification as per annexure b9 , resistance isolator specification as per annexure b10 , hart multiplexers specification as per annexure b11 , pulse isolator specification as per annexure b12 , frequency converter with trip values acdc supply voltage specification as per annexure b13 , general purpose trip amplifier input 420 ma15 vdc output two relay op and one 420 ma op specification as per annexure b14 , switch operated relay 2 channel is output specification as per annexure b15 , general purpose trip amplifier input 420 ma15 vdc output two relay op specification as per annexure b16 , do barriers for plc specification as per annexure b17 , repeater power supply 420ma hart 2 or 3 wire transmitters smart transmitter intrinsic safety applications specification as per annexure b18 bid number/ & ( * ) : gem/2025/b/6290918 dated/ + : 31-05-2025 bid document/ 3 3 1 / 17
Tender For supply of laboratory equipments /laptop/printer - flash chromatography system model a1700x-200ml yamazen carporation, japan make, programmable elution modes: isocratic step, linear & rf gradient, pumping flow rate: 5-200 ml/min, maximum pressure: 1.5 mpa (15 bar/217 psi), no. of solvents: use up to 4 solvents in a gradient, uv detection: dual variable wavelength pda uv vis, detector 200-800 nm,uv detector sensitivity: 0.02-10.24 saufs, fractionation modes: time manual, peak, peak& slope (valley)02, automated densitometer with 4 reading channelsmake- genaxy/thistle/cleaverdensitometer a universal densitometer scanner with software capable of reading 144test per min. is available for band quantitation following post electrophoresis staining ordering information-cell as gel application packages equipped with bridges applicator and clinical test kit, 1x4 -specimen semi micro applicator volume applied sample band with compatible strip size: 5.7x14cm, cell as gel wet membrane bridges and densitometer, 1x8.5 cm bridge for 1x5.7x7x14cm or 2x2.5x14cm cell as gel. strip cat no. cslbg8.55 terbo scan software densitometer (excludes computer and scanner) cat no. csldens flat belt scanner for turbo scan software cat no. csscan, uv transilluminatormake- genaxy/thistle/cleaverresearch model: 312nm single wavelength transilluminator for detection of more than 0.1 ng of dna filter area (cm) uv 20 x 20cm , analytical balance make- aczet/radwag/sartoriuscapacity :220gm readability : 0.1mg repairability: 0.2mg response time: 2-3 sec pan size : 90mm display: lcd backlite calibration : motorized internal calibration, probe sonicator (touch screen) with sound proof enclosure make-labman/aczet/sonic temperature indicator and controller touchscreen display - 4.3 inches tft user password protection available microprocessor controlled and completely programmable. large lcd display with time setting. auto-tuning for convenience and optimal processing efficiency. variable power output control. auto frequency tracking output amplitude 0-100% adjustment. automatic fault alarm. frequency 20-25khz-automatic tracking process capacity 0.5-500ml (approx.) probe dia (titanium alloy) standard 6mm (1/4") display 4.3 inches tft display function temperature, power, time, etc. temperature range( c) 0-99 c timer (selectable) yes overload protection yes user password protection available input method touch screen control, data memory 20 groups output power 6.5-650w (adjustable) power supply : ac 220v/50hz, pulveriser/grinder make-ideal/mac/amccommercial dry grinder are used for grinding different types of products like spices, fresh ginger, salt, sugar, leaves, herbal products, cattle and poultry feeds, icing sugar, custard powder, instant food, food colors and allied food production. 3 hp motor deluxe model camber size: 10 x 5 cm. capacity: 20-25kg./hr., decoction apparatus gas operated decoction making machinemake-ideal/mac/amcvessel capacity: 15 liters for 1 to 5 lit production capacity, motor: /1 hp single phase motor fuel: lpg (fitted with i no. burners) all contact parts in 304 grade stainless steel complete structure in mild steel ready to use with all standard accessories wi s.s. bucket 10 ltr., s.s. mesh, & s.s. round tank, cooling centrifuge make-remi/eppendrof/thermo programable compensation for true sample temperature: yes pre cooling: yes acceleration profiles: 9 deceleration profiles: 9 & coasting fast spin: yes display: lcd control communication: digital parameters setting switches: bi-directional encoder brushless motor with frequency drive: yes inverter fault detection with auto shut down: yes cfc free refrigeration system: yes no. of programs: 99 last set parameters recall: yes choice of rpm/ref setting: rpm/rcf digital countdown timer 0-99 min & continuous run: yes automatic rotor identification: yes emergency lid lock release: yes password protection: yes gas hinge to prevent door falling: yes imbalance detection with centrifugatio
Tender For analog and digital electronics lab equipment - purchase of analog & digital electronics lab equipment for eee department, vi characteristics of pnjunction diode and zener diode kit built in power supply (0-6v) for forward bias and (0-24v) for reverse bias to carryout forward and reverse vi characteristics of pn junction diode experiments provision to connect desk top meters externally, wooden closed cabinet, characteristics of bjt in ce configuration kit to carryout input and output characteristics of npn transistor in ce configuration necessary power supplies provision to connect necessary digital meters externally legend printed in the pcb necessary test points wooden closed cabinet, vi characteristics of fet & ujt kit built in 0-6v power supply in the input side and 0-30v power supply in the output side to carryout drain output characteristics and transfer characteristics of jfet experiments provision to connect necessary desk top meters externally, wooden closed cabinet., half wave rectifier with and without filter kit to observe variation in the ripple with load current without and with filter to observe voltage regulation with load current without and with filter provision to connect necessary desk top meters externally legend printed in the pcb necessary test points wooden closed cabinet, bridge rectifier with and without filter kit to observe variation in the ripple with load current without and with filter to observe voltage regulation with load current without and with filter provision to connect necessary desk top meters externally legend printed in the pcb necessary test points wooden closed cabinet, inverting amplifier and non-inverting amplifier using op-amp ic 741 and test its performance kit. to carry out the inverting amplifier, non-inverting amplifier, provision to connect resistances built in two variable voltage sources and power supply for op-amp legend printed in the pcb wooden closed cabinet, summing amplifier and difference amplifier using op-amp ic 741 and test its performance kit summing amplifier and difference amplifier, voltage follower experiments provision to connect resistances built in two variable voltage sources and power supply for op-amp legend printed in the pcb wooden closed cabinet, zero crossing detector and voltage comparator using op-amp ic 741 and test its performance kit. zero crossing detector and voltage comparator experiments provision to connect resistances built in two variable voltage sources and power supply for op-amp legend printed in the pcb wooden closed cabinet, astable multivibrator circuit using ic 555 and test its performance kit to carryout schemitt trigger, astable multivibrator andmonostable multivibrator experiments provision to connect resistances and capacitances to change the frequency. built in power supply legend printed in the pcb necessary test points wooden closed cabinet, kit to test the performance of ic voltage regulator power supplies using ic 7805, ic 7912. to carryout schemitt trigger, astable multivibrator and monostable multivibrator experiments provision to connect resistances and capacitances to change the frequency. built in power supply legend printed in the pcb necessary test points wooden closed cabinet, realization of basic gates using nand & nor gates. digital ic trainer kit with 16 digital input as toggle switch digital ic trainer kit with 16 digital output as led. two bread board on board fixed clock 2-digit bcd segment one buzzer, half adder and full adder circuit using discrete ic s and test its performance. digital ic trainer kit with 16 digital input as toggle switch digital ic trainer kit with 16 digital output as led. two bread board on board fixed clock 2-digit bcd segment one buzzer,mono pulse., parity generator and checker using parity checker/generator ic s and test its performance. to wire 3 bit parity generator and reader using logic gates to test 8 bit parity generator and reader using ic signal inputs and led out
Tender For supply of thermal imager, hand hold with following specification: display size: 3 inch (min), detector resolutio n (min): 100000 pixels, temperature range of objects (degree celsius): -20 to +500, temperature measuring accu racy of reading: 2% deg c, image capture frequency/ frame rate (hz): n = 9 or better. make/brand: testo/ fluke /tes to/flir/tempsens/tipl [ warranty period: 30 months after the date of delivery ]