Get complete information related to latest Medical Gas Line Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Medical Gas Line Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Medical Gas Line Tenders.
Tender For requirement of spares of m/s ingersoll rand make conveying air compressor model r-160i-x 7.5wc and up5-22-7 for dry fly ash dense phase system,unit#3 and 4, ctpp, chhabra - model no. r160i-x7.5 wc, seal, shaft high pressure part no. 89292445, element, seprator tank 18 inch part no. 23566938/ 23545841, oil cooler, water cooled part no.23572415, after cooler, water-cooled part no.23572423, cap screw m6x25 soc hd cap w/nylon insert part no.22168710, pressure transducer 0-225 psig part no.47545275001, pressure transducer 0-15 psig part no.47560902001, assembly gear set 160 kw single stage 7.5 bar part no.23521859, pin dowel [motor] part no.39194915, pad pre filter part no.23523772, actuator service kit part no.23467251, inlet valve part no.23421217, elbow 1/4" 90 degree straight thread ms part no.96757604, spacer gear (ce177g) part no.39326483, sleeve motor shaft 4.25 od m132/160 part no.89292478, key,square both ends 0.88sq x1.25 part no.95135638, valve in line check part no.23453020, tube gear case scavenge part no.23453129, air cleaner assembly nlg37-42 pico standard part no.23390156, ultra coolant (208 litres) drum part no.39433743, key, rect one round end part no.96759212, clamp, plate part no.35295336, screw, socket head part no.32555819, housing, seal part no.22880744, gasket, gear case part no.39454558, pin, dowal [air end] part no.35295336, valve, orifice [separator tank] part no.23449200, oil filter assembly part no.23523434, o ring set part no.ok002222, pressure transducer cable part no.23529373, temprature sensor part no.23522246, valve min press check 132-160 kw part no.23521297, 5sv solinied cable part no.23562432, model no. up5-22-7, element coolant filter part no.54672654, element seprator 194cfm (spin-on) part no.54749247, pad pre filter part no.22053722, element air filter part no.89295976, kit, inlet valve repair part no.22067177, kit-mpcv part no.22064695, kit thermal valve repair part no.22393326/ 22832885, valve solenoid 125 inch npt part no.54774302, valve solenoid 1/2 in npt 110 volt part no.54654652, spring gas part no.54749114, elbow .31tx .50sae part no.95993572, elbow , 90deg male 37a10c3xz2 part no.95937686, tube oil feed (rear bearing) part no.85581858, tube, vmc block to bare part no.85581866, belt part no.89265052, ultra coolant (20litres) drum part no.38459582, tempreture sensor part no.22137848, conteroller part no.22128763, tube nylon part no.39124813, tube nylon part no.39124821, elbow part no.39155650, elbow part no.39155577, nipple part no.22354989
Tender For supply of rpl no 10 c c - suppl and fixing of 1 exhaust fan for kitchen room with 15amp socket , supply and fixing of electric wiring in chamber no 02 , supply and fixing of 06 15amp combination board , supply and fixing of 05 led bulb 9 watt , supply and fixing of 01 switch board 10inch x 12inch , supply and fixing of 10 switch 5amp , supply and fixing of 06 socket 5 amp , supply and fixing of 02 security light , replacement of existing 02 ms icon pipe bend of toilet outlet of master cabin toilet of sbs as per existing specification , repair of sea water pipe line of 2hp motor , replacement of existing tapet cover gas kit of main engine of both sides as per existing specification , repair of radiator fan vibrating defect of sbs of main engine , replacement of existing 02 iron battery box as per existing specification including all changes , supply and fixing of 02 exhaust fan of aux engine room , repair of leakage defect of pt pump of sbs and replacement of existing fuel line as per exiting specification
Tender For supply of oh of main steam line valve v2 6 , oh of steam by pass valve v2 27,15, and v2 7 , oh of es 3,4,5,6 and 7 , oh of v2 -82-84 and v2-81-a to 81c , oh of hd-21, hd-29, hd-30 and hd-31 , oh of nrv of h.p. heater and feed pump , oh of group protection valve of hph , oh of dw-4, 37,38,39,40,41 and ca 5 , oh of cst makeup valve v6 60 , oh of as-48 valve , oh of nrv of extraction line es-8 , oh of suction valve of bfp , oh condensate wtr throw off valve to condenser , oh throw off valve to cond and steam isolating of lph2 , oh of steam isolating valve of lph 3, 4 , oh of safety valve of aux prds or deaerator , oh of safety valve of h.p. heater , oh of safety valve of l.p. heater. , oh of safety valve of cbd tank. , oh of safety valve of flange or stud heatng , oh of safety valve of warm up line. , overhauling of actutator of as 48 valve , oh of actr feed line valvev2 81 or v2 82 or v2 83 or v2 84 , oh of actr of v2 7 or v2 15 or v2 27 , oh of actr drip line valve and ext line valve , oh of actr valve connected to condenser , oh of actr cst make valve , oh of actr of msv l and r , oh of actr of steam isolating valve to lph2 to 4 , oh of actr steam throw off valve to condenser , cut or weld or repl of hp valve 15 to 50mm , cut or weld or repl of hp valve 51 to 100mm , cut or weld or repl of h p valve 101 to 150mm , oh of butterfly valve of condenser , oh of dea and fst with internal painting , repair or replacement of broken hanger , tightening of loose hangers , cut or weld or repl of l.p. valve 15 to 50mm , cut or weld or repl of l.p. valve 51 to 100mm , cut or weld or joint of h.p. pipe 15 to 50mm , cut or weld or joint of h.p. pipe 51 to 100mm , cut or weld or joint of h.p. pipe 101 to 150mm , cut or weld or joint of h.p. pipe 151 to 300mm , lift or straight aprds hdr by cutting weldding , o h of lph 1a , 1b , o h of lph 2 3 and 4 , oh and attend flange leakage of gc i or ii , clean of turbine oil or h2 gas cooler str , repl of damaged sp. valve v2 38 , repl of damaged special valve v2 27 , oh of turbine oil coolers , oh of main ejectors of turbine , oh of h.p. heater , oh of lcv 3to15pcv-5, 14,16,17,tcv 8 , repl bend of lp drip connected to drip pump or condenser , cut damaged bend of hph drip cont to dea , cut weld or repl of h.p. valve 151 to 300mm , blank of crh line for ht and normalizing , oh of h.p. valve nrv in h.p. line , oh of l.p. valve nrv , oh of energy absorber of bfp , oh of dss of aux. prds.
Tender For supply of oh of main steam line valve v2 6 , oh of steam by pass valve v2 27,15, and v2 7 , oh of es 3,4,5,6 and 7 , oh of v2 -82-84 and v2-81-a to 81c , oh of hd-21, hd-29, hd-30 and hd-31 , oh of nrv of h.p. heater and feed pump , oh of group protection valve of hph , oh of dw-4, 37,38,39,40,41 and ca 5 , oh of cst makeup valve v6 60 , oh of as-48 valve , oh of nrv of extraction line es-8 , oh of suction valve of bfp , oh condensate wtr throw off valve to condenser , oh throw off valve to cond and steam isolating of lph2 , oh of steam isolating valve of lph 3, 4 , oh of safety valve of aux prds or deaerator , oh of safety valve of h.p. heater , oh of safety valve of l.p. heater. , oh of safety valve of cbd tank. , oh of safety valve of flange or stud heatng , oh of safety valve of warm up line. , overhauling of actutator of as 48 valve , oh of actr feed line valvev2 81 or v2 82 or v2 83 or v2 84 , oh of actr of v2 7 or v2 15 or v2 27 , oh of actr drip line valve and ext line valve , oh of actr valve connected to condenser , oh of actr cst make valve , oh of actr of msv l and r , oh of actr of steam isolating valve to lph2 to 4 , oh of actr steam throw off valve to condenser , cut or weld or repl of hp valve 15 to 50mm , cut or weld or repl of hp valve 51 to 100mm , cut or weld or repl of h p valve 101 to 150mm , oh of butterfly valve of condenser , oh of dea and fst with internal painting , repair or replacement of broken hanger , tightening of loose hangers , cut or weld or repl of l.p. valve 15 to 50mm , cut or weld or repl of l.p. valve 51 to 100mm , cut or weld or joint of h.p. pipe 15 to 50mm , cut or weld or joint of h.p. pipe 51 to 100mm , cut or weld or joint of h.p. pipe 101 to 150mm , cut or weld or joint of h.p. pipe 151 to 300mm , lift or straight aprds hdr by cutting weldding , o h of lph 1a , 1b , o h of lph 2 3 and 4 , oh and attend flange leakage of gc i or ii , clean of turbine oil or h2 gas cooler str , repl of damaged sp. valve v2 38 , repl of damaged special valve v2 27 , oh of turbine oil coolers , oh of main ejectors of turbine , oh of h.p. heater , oh of lcv 3to15pcv-5, 14,16,17,tcv 8 , repl bend of lp drip connected to drip pump or condenser , cut damaged bend of hph drip cont to dea , cut weld or repl of h.p. valve 151 to 300mm , blank of crh line for ht and normalizing , oh of h.p. valve nrv in h.p. line , oh of l.p. valve nrv , oh of energy absorber of bfp , oh of dss of aux. prds. , 2coat paint bcw,clr,bfp,cep,drip pump and line , 2coat paint cst,bcw pump ,swc tank,line,valve , 2coat paint hcplg,sw,bcw,cw exc clr line , 2coat paint air washer sys,cep or phos orhyd , 2coat spray paint syn super enamel lpc , 2coat spray paint front ped,barring gear , 2coat spray paint brg and housing turbine , 2coat spray paint cntl valve casing , 2coat spray paint condenser and line , 2coat spray paint main oil tank , 2coat spray paint main ejector , 2coat spray paint centrifuging machine , 2coat spray paint lube oil cooler , letter writing 2 inch size dia
Tender For proposed construction of compound wall, main entrance arch other development works of uchc additional construction of 3rd floor of uchc and fire fighting, medicalgasline pump room sump of uchc at kondithopu basin bridge road in dn 53 zn 5
Tender For repair of bag house equipment in crmp- 1) cage repair( bending minor welding & painting), 2) cleaning and fixing of bags( opening the chamber, removing the venturies, taking out bags cleaning with and refixing) once in year, 3) cleaning of dust collecting hopper of bag house, 4) repair of dust hopper and its doors, 5) bag house screw conveyor body repair, 6) bag house screw conveyor hanger bearing with shaft changing, 7) bag house screw conveyor end bearing changing, 8) bag house screw conveyor coupling repairs, 9) bag house screw conveyor changing, 10) en masse conveyor drive sprocket changing, 11) en masse conveyor tail sprocket changing., 12) en masse conveyor drive chain fixing, 13) en masse conveyor links changing, 14) en masse conveyor drive unit coupling repair, 15) en masse conveyor drive chain rejointing in snap, 16) maintenance of rotary air locks (twice in a year), 17) bucket elevator belt rejointing in case of snap, 18) bucket elevator drive pulley changing, 19) bucket elevator boot pulley changing, 20) bucket elevator fallen buckets fixin, 21) pulse jet solenoid valves repair and maintenance, 22) drier maintenance in compressor house (4 driers), 23) maintenance of compressed air pipe line, 24) id fan casing removal and fixing back to faciltate for fan changing, 25) id fan casing cutting and fixing back during bearing changing, 26) id fan casing changing, 27) id fan casing repair work, 28) id fan suction duct patch work, 29) id fan delivery duct patch work, 30) to make arrangement for chimney cleaning on id fan delivery duct near chimney and duct opening and closing there.., 31) dust hopper gate replacement, 32) dust hopper vibrofeeder replacement, 33) dust hopper body repair patch work, 34) flexible hose to pulse jet replacement, 35) pulsing pipe changing, 36) pulsing pipe repair, 37) cyclone patch work, 38) flue gas duct leaks arresting patch works.
Tender For work of flue gas duct repair from economiser outlet to aph inlet, hot &cold air duct repairs above 9 mtr. level, g.s. line valve servicing of unit 4 boiler at ntps 210 mw during coh.