Tender For tender for supply of spares of stabiliser and steering gear system 24blec101 e e - interposing relay , relay , relay , interposing relay , soft starter , ats48c17q , ss ratng 90kw , motor ratng 75kw , plc relay (coil24v dc contact 6a , 230 vac) , plc relay (24v single contact , 2pdt , 6a) , 15 pin male d-sub , dc to dc converter 24v to 5v 50w , dc dc converter , hand steering unit (hsu) with hall sensor , 4-20ma o p , transformer rectifier unit (380v , 50hz , 3phase o/p 2 , vme sbc 2c106 , fast ethernet switch esc 67-10 tp05u(harting) , powersupply connector for ethernet switch (harting) , interface connector for ethernet switch (harting) , multipurpose isolation amplifier , 12.1 inch hmi display , boost pressure (supercharge) fil element 10 , servo pilot filter element , 3 , servo pressure switch , sea water flow switch , limit switch , actuator seal kit , pump seal kit , gland packing , radial lip seal , pump motor coupling , axial piston pump seal kit , boots pressure (supercharge) filter , pressure switch boots , accumulator , tube shell cooler , pressure switch -servo , pressure gauge , sea water flow switch , proximity switch , low pressure inline filter element , replenishing (low pressure inline) filter element , vme 64 x discrete output card (optocoupler) v2 , vme 64 x discrete input card v2 , vme 64 x ai-16 card , vme 64 x ao-16 card , vme 10 chanel serial isolator card (aitech c106) , dual encoder feedback unit (dfu) , rudder angle transmitter-rat(p15b-sg) , rudder angle indicator rat p15b sg , ssi to serial distribution card (ssdc) , signal conditioner card (scc) , relay card -12 channel , driving end bearing lub motor , non driving end bearing lub motor , driving end bearing main motor , non driving end bearing main motor , power er contactor , power er contactor , push button , fuse , interposing relay , interposing relay , lamp , lamp , power er supply , relay , relay , fuse , boost pressure switch , pressure gauge , 100 mm mail , 0-25bar
Tender For igbt based 3-phase drive propulsion system with composite converter for wap-7 as per rd so specification no. rdso/2008/el/spec/0071, rev.5 (propulsion equipment except traction converter) an d clw specification no. clw/es/3/ig/0/0518 alt. c (traction converter having hlc part of rating 2x600kva for wap-7) for complete three phase wap-7 locomotive along with physical medium i.e. esd/emd/ofg for multi functional vehicle bus (mvb) to inter-connect all the bus stations as per iec-61375, terminal bracket s, bus bar links and copper braids required for connection between main transformer and traction convert ers, auxiliary converters, interfacing connectors, cables and cable looms with connectors required for co nnection from vcu1/2 to sb1/2 panel, traction motor speed sensors, complete assembled and wired panel c fitted with driver display unit(s) and interface for both cab, as per following specifications: (i)rdso/2008 /el/spec/0071,rev.5 for igbt based 3-phase drive propulsion equipment except traction converter (ii) cl w/es/3/igbt/0518 alt. c for composite converter (iii) clw/es/3/0528 alt-a for tm speed sensor for igbt t raction converter (iv) clw/es/3/0138 alt-a for copper braid (v) clw/es/3/0458 alt.e for control cables (v i) clw/es/3/0459 alt.c for screened cables (vii) clw/es/3/0124 alt.'o' for set of connectors. (viii) clw/e s/3/0240 alt-b for panel c (without diagnostic terminal). (ix) rdso modification sheet no. rdso/2012 /ms/0413 rev 1 (x) rdso modification sheet no. rdso/2020/el/ms/0482, rev'1' (xi) rdso modificati on sheet no. rdso/2017/el/ms/0457 rev-0 (xii) all the relevant rdso modification sheets applicable for the sub-components of igbt based 3-phase drive propulsion equipment should be implemented. in add ition to above description, the propulsion system with composite converter should also co mply requirement mentioned in "schedule of requirement" (sor), copy attached with tender documents. warranty period: 72 months from the date of supply. [ warranty period: 72 months after th e date of delivery ]
Tender For igbt based 3-phase drive propulsion system with composite converter for wap-5 locomotiv e as per rdso specification no. rdso/2008/el/spec/0071, rev.5 (propulsion equipment except traction co nverter) and in place of traction converter, composite converter as per clw specification no. clw/es/3/igb t/0518 alt. b (composite converter) for three phase wap-5 locomotive along with physical medium i.e. es d/emd/ofg for multi functional vehicle bus (mvb) to inter-connect all the bus stations as per iec-61375, t erminal brackets, bus bar links and copper braids required for connection between main transformer and composite converters, auxiliary converters, interfacing connectors, cables and cable looms with connect ors required for connection from vcu1/2 to sb1/2 panel, traction motor speed sensors 04 nos, complete a ssembled and wired panel c fitted with driver display unit(s) and interface for both cab, as per following s pecifications: (a)rdso/2008/el/spec/0071,rev.5 for igbt based 3-phase drive propulsion equipment exce pt traction converter (b) clw/es/3/igbt/0518 alt. b for composite converter (c) clw/es/3/0528 alt-a for tm speed sensor for igbt traction converter (d) clw/es/3/0458 alt.e for control cables (e) clw/es/3/045 9 alt.c for screened cables (f) clw/es/3/0124 alt.'o' for set of connectors. in addition to this propulsion system with composite converter also comply requirement mentioned in revision 01 for additional scope o f supply and work[c-d&d/t/38(part) ]
Tender For igbt based 3-phase drive propulsion system with composite converter for wap-7 as per rd so specification no. rdso/2008/el/spec/0071, rev.5 (propulsion equipment except traction converter) an d clw specification no. clw/es/3/ig/0/0518 alt. c (traction converter having hlc part of rating 2x600kva for wap-7) for complete three phase wap-7 locomotive along with physical medium i.e. esd/emd/ofg for multi functional vehicle bus (mvb) to inter-connect all the bus stations as per iec-61375, terminal bracket s, bus bar links and copper braids required for connection between main transformer and traction convert ers, auxiliary converters, interfacing connectors, cables and cable looms with connectors required for co nnection from vcu1/2 to sb1/2 panel, traction motor speed sensors, complete assembled and wired panel c fitted with driver display unit(s) and interface for both cab, as per following specifications: (i)rdso/2008 /el/spec/0071,rev.5 for igbt based 3-phase drive propulsion equipment except traction converter (ii) cl w/es/3/igbt/0518 alt. c for composite converter (iii) clw/es/3/0528 alt-a for tm speed sensor for igbt t raction converter (iv) clw/es/3/0138 alt-a for copper braid (v) clw/es/3/0458 alt.e for control cables (v i) clw/es/3/0459 alt.c for screened cables (vii) clw/es/3/0124 alt.'o' for set of connectors. (viii) clw/e s/3/0240 alt-b for panel c (without diagnostic terminal). (ix) rdso modification sheet no. rdso/2012 /ms/0413 rev 1 (x) rdso modification sheet no. rdso/2020/el/ms/0482, rev'1' (xi) rdso modificati on sheet no. rdso/2017/el/ms/0457 rev-0 (xii) all the relevant rdso modification sheets applicable for the sub-components of igbt based 3-phase drive propulsion equipment should be implemented. in add ition to above description, the propulsion system with composite converter should also co mply requirement mentioned in "schedule of requirement" (sor), copy attached with tender documents. warranty period: 72 months from the date of supply. [ warranty period: 72 months after th e date of delivery ]
Tender For supply of spares for honeywell make fire detection systems - vesda panel , facp cpu card , display and operating unit , serial essernet interface , esserbus transponder , infra-red heat sensor , technical alarm device , loop card esserbus
Tender For supply of integrated command and control system - security customised ai enabled unmanned sub system , patrolling customised ai enabled unmanned sub system , response customised ai enabled unmanned sub system , payload devices bundle camera day and night , fabrication and modification for payload kit , protocol and integration application , automated charging platform , charging platform control software , customized ai enabled unmanned sub system data cyber and encryption kit , precision landing beacon system , precision landing controller , ground data display , dual satellite navigation system , dual satellite navigation system controller , data base system , data storage security and encryption application , user interface , predictive analytics and control ai system , automated monitoring and flight control protocol ai , integration and customization application , sensor control application , workstation i9 , access control customisation , ai virtual perimeter system , ai monitoring sensor controller , monitoring sensor lc version short range , monitoring sensor lc version medium range , monitoring sensor lc version long range , command sensor lc version , communication network rf lc version , communication network ofc lc version , communication network weather protection and installation lc version , eccm controller , vdit algorithm , iff system , integration software , rf based customised ai enabled unmanned sub system detector , video based customised ai enabled unmanned sub system identification and tracking , radar sensor , data fusion and command center , display unit , customised ai enabled unmanned sub system rf jammer , setup kit , counter customised ai enabled unmanned sub system communication system , hardware setup , weather protection , power backup , api controller , data encryption , tracking software , customised ai enabled unmanned sub system locator , iot maintained sensor suit controller , iot maintained sensors , report generator , cooling unit , manual controller , training support , ai predictive algorithm , gis mapper , cyber security suit , mounting frame and support