Latest nylon membrane Tenders | Government nylon membrane Tenders

Central Government/Public Sector

CTN :40252741

28 May, 2025 NA

Kanpur - Uttar Pradesh

Tender For supply of membrane , carbon activated filter , sediment filter , smps , 20 inches boul filter housing , flote sensor , lps

CTN :40228797

26 May, 2025 NA

Vadodara - Gujarat

Tender For supply of repair to tata mobile 088271h - labour charge for servicing and replacement and fixing of unserviceable filter , engine oil 15w40 , diesel fuel filter , oil filter , coolant , steering oil , break oil , clutch oil , air filter , labour charge computerised wheel alignment and wheel balancing , labour charge for removing and refixing after fuel tank cleaning , labour charge servicing replacement defective parts of door and making up the bends and rubber hose , labour charge servicing and replacement of unserviceable front disc , brake rubber boot , labour charge for servicing external clogging of intercoolers and radiator making up defects as reqd , material and labour for servicing and replacement of unservicable drive belts , labour charge serving and making up defects for bleeding of clutch actuation system , labour charge servicing and replacement of necessary defects for proper sealing of air intake system , labour charge servicing and tightening all fasterners , fasterners with acessories , labour charge for checking and replacement as necessary defects in electrical system ensure usage of genuine fuses with correct ratings condition of fuse and relay holding , fuses with relay , labour charge for check steering wheel play check for proper condition of ball joints and rubber boots of tie rod drag link for looseness damage , rubber boots of tie rod , labour charge for complete servicing of door with necessary replacement , labour charge for checking of wiper assembly and replacement of unserviceables parts and painting , wiper motor stator rewinding , wiper motor armature winding , wiper motor fxing materials , wiper linkage , wiper blade , wiper arm , labour charge for complete dismantling and servicing of rear load leaf spring and bending and refitting the same and replacement of unserviceables parts , rear spring bushing kit , centre bolt , clamp , labour charge for complete burnt starter from vehicle and replacing following parts , solenoid switch , carbon brush set , bushing set , fitting kit , labour charge for complete dismantling of steering from the vehicle , replacement of steering center line assy , replacement of steering center line pin kit , material and labour for rectifing denting filling painting as existing , material and labour for servicing washing and greasing

CTN :40228887

26 May, 2025 NA

Pithoragarh - Uttarakhand

Tender For supply of self startor assy air comp , avr half round , carbon bush with holder , e v r , self startor assy 7 5 kva , oil filter , fuel filter , paper filter , air filter , fuel pipe 19x19 , door lock , rear hinge door , push button switch , ignition switch , volt meter , amp meter , nozzel , pipe connector , connector small

CTN :40231770

26 May, 2025 NA

Howrah - West Bengal

Tender For supply of water cooler cum purifier ro + uv floor mounted, in built stainless steel tank storage c apacity120 litre. specification storage capacity -120 litre condensor material - copper + aluminium water filter type storage tank material - stainless steel 304 warranty of machine -1 year number of f ree services during warranty %u2013 2 installation and demonstration to be given before acceptance -yes life of ro lters(liters) - 4000-5000 warranty of compressor %u2013 1 water cooler unit conform s to is 1475-1 %u2013yes uv lamps rating (watt) %u2013 16 refrigerent - r134a evaporator material - pure copper number of faucets %u2013 3 insulation %u2013 puf no of uv circuit purification %u20 13 3 stages of purification - sediment purification, carbon block purification, post carbon block lteratio n,uv purification. input quality of water in tds for pre-lteration - >=1200 water filter type %u2013 u v auto using system %u2013 yes ro membrane rating in gpd %u2013 50 no of ro membrane corres ponding to given rating %u2013 na cooling capacity, ltr/hr -50 operating temperature - 35 degree c elsius ro booster pump operating voltage - na ro booster pump available - na output quality of wate r in tds post lteration - <300 purication capacity, ltr/hr - 120 power requirement - 220-240v ac max ow rate, ltr/min - 100 [ warranty period: 12 months after the date of delivery ]

CTN :40218970

12 May, 2025 88

Yelahanka - Karnataka

Tender For pump motor repair - guide vane, oil seal steel bush(oil seal sleeve), oil seal(pump oil seal), intermediate piece (i.p.) with i.p. leaded bronze bush, pump bowls, rewinding of motor of 20 hp, rewinding of motor of 17.5 hp, rewinding of motor of 15 hp, rewinding of motor of 12.5 hp, rewinding of motor of 10 hp, rewinding of motor of 7.5 hp, rewinding of motor of 5 hp, rewinding of motor upto 3 hp, transportation of pumping machinaries, motor base with pin, circlips(small), bearing (gun metal bush) centrifugal cost aluminium bronze bearing bush, studs and nuts, tip carbon/ferrode padding, thrust bearing block assembly (tb bottom), carbon housing(tb plate), lock ring(circlip big), lower housing, upper housing, lower flange, upper flange, labour charges (overhauling of pump only), brass filter, strainer, cable guard, pump coupling (stainless), pump key (stainless steel) upto 8 stages, pump shaft (stainless steel) counter less ground with key way upto 8 stages, allen screw, steel bush (i.d.o. ss sleeve), d.o. bearing( i.d.o lb bush), discharge outlet (d.o.) bearing(lb bush) and d.o steel bush(ss sleeve), impeller shell moulded with aluminium & bronze, supply and fixing of voltmeter, supply and fixing of ammeter, supply and fixing of led indicator, supply and fixing of wiring kit(sd upto 25hp), supply and fixing of wiring kit(dol upto 7.5hp)(mr), supply and fixing of no-volt (nv) coil, supply and fixing of terminal plate (connector 60a), supply and fixing of terminal plate (connector 30a)(mr), supply and fixing of ryb rotary switch(volt selector), supply and fixing of single phase preventer(20 to 30 hp), supply and fixing of single phase preventer(7.5 to 15 hp) (mr), supply and fixing of 15 amps relay (mr), supply and fixing of 23 amps relay (mr), supply and fixing of 33 amps relay, supply and fixing of 25 amps contactor, supply and fixing of 16 amps contactor(mr), erection of panel board & ms box (outdoor type) (gulbarga pred, pg.no.57, lt.no.12.2), supplying and fixing angle iron frame work fabricated out of m.s. angle iron and m.s. flat with bolt, washer etc and painted with 2 coats of red oxide and then two coats of approved paint 75x75x6mm (pwd ele sr 2014-15, pg.no.49, lt.no.6.39.3), refilling available earth around pipe lines, cable in layers not exceeding 20cms in depth, compacting each deposited layer by ramming after watering with lead upto 50m and lift upto 1.5m including cost of all labour complete as per specification pre sr 2011-12, p-3,1-6., labour charges for laying u.g. cable upto 3.5 core 25 sq.mm as per pwd electrical sr 2010-11, p-68,1-1, class a pvc cable, lifting of struck up submersible pump set above 300 ft (bwssb sr 2017-18/o150g/sl no.27), lifting of struck up submersible pump set upto 300 ft (bwssb sr 2017-18/o150g/sl no.26), labour charges overhauling, lifting of submersible pumpsets, re-errection charges of pumping machinery including overhauling and painting, cable joint, g.l. pipe threading including transportation, labour charges (for over hauling), supply and fixing of ct coil 50/5 & 75/5, supply and fixing of blade set 25a, supply and fixing of blade set 16a(mr), supply and fixing of hylum brand hand plastic sheet 3mm thick with necessary nitches for fixing switches, regulators etc and fixing of exciting wood or metal box using nf screw , supplying and fixing polished wood board made out of not less than 15mm thick planks at both sides with planks made out of not more than 2 pieces and fixing the same to the wall using tapered wooden plugs screws etc, fabricating, supplying and mounting ms box made out 14 swg suitable for foor/wall mounting, fully weather proof with provision for better heat dissipation, provided with hinged front over equipped with temper proof locking arrangements with suitable size clamps with necessary cable entry pipe with gland and box should be finished with 2 coats of red oxide primer paint and finally finished with approved colour enamelled metal paint etc., com

CTN :40218057

17 Jun, 2025 NA

Goa - Goa

Tender For supply of disc , lead assembly black , housing magnet assembly , brush holder , connector , stud fastner , brush electrical contact (carbon brush) , pin , nut , screw , fuse , re-cell 12v connecting cable rb85a , nut , re-cell 4v connecting cable rb85a , gasket , battery for ins gps , strap , spring , cap fuel filter , motor assembly dc , cover gasket , scraper ring , solid rivets , bulb , bearing ball , screw , nut , fuse incl. housing , lead assembly black , insulator plate , washer insulating , flash disk , inductor , sleeve ring , o ring , o-ring , armature , brush and spring assembly , screw , spring support rod , rotor assy-tacho , bushing , bolt , race , bolt , bearing ball

Central Government And Public Sector

CTN :40217362

24 May, 2025 NA

Chittorgarh - Rajasthan

Tender For tender for supply of spares of high pressure ba compressor - suction filter cartridge mch13/16 (p/n- sc000370) , v-bell (p/n- cing a-73) , safety valve 330 bar (p/n- 6-05-015/3/330) , filling valve drv 300 bar (p/n- drv300) , maxi filter a. carbon/m. sieve cartridge (p/n-sc000440/pp) , flanged pressure gauge 0-16 bar/psi (pin- 13-05-0120) , flanged pressure gauge 0-100 bar/psi (13-05-0130) , flanged pressure gauge 0-500 bar/psi (p/n- 13-04-0211/500) , fitting inox 1/4npt - 7/16 pipe6 (p/n - 13 -00-0025/x1) , micro - hose 1/4 - 7/16 500mm (p/n - 13-04-0213) , condensate discharge nylon (p/n- 13-00-0162/1/1) , synthetic coltri oil st 755 1l (p/n- sc000871) , refill hose 1200 mm (p/n- 13-04-0238/air/420) , adopter o ring (p/n- or116) , servicing and spare installation charges (per trip)

CTN :40211205

23 May, 2025 17.56 Lacs

Chandigarh - Chandigarh

Tender For supply of sitc of water purifier system - sediment filter for 20 inches , water filter , sediment filter for 20 inches housing under one year warranty period , sediment filter 1st year cmc , sediment filter 2nd year cmc , sediment filter 3rd year cmc , sediment filter 4th year cmc , cmc for 1st year , cmc for 2nd year , cmc for 3rd year , cmc for 4th year , sediment filter and carbon filter 8 inches , sediment filter and carbon filter 8 inches under one year warranty period , sediment filter and carbon filter 8 inches 1st year cmc period. , sediment filter and carbon filter 8 inches 2nd year cmc period. , sediment filter and carbon filter 8 inches 3rd year cmc period. , sediment filter and carbon filter 8 inches 4th year cmc period.

CTN :40201149

21 May, 2025 NA

Panchkula - Haryana

Tender For procurement of equipment for karnal signage cfc private limited, karnal - karnal signage cfc pvt. ltd. karnal, rotary termo processing equipment (calender/heat press), structural design, editing and nesting software, flat bed 3-meter x 2 meter cutting table, genset 100 kva, computer/desktop, laserjet printer, scanjet enterprises printer, ups with battery circuit breaker and inbuilt isolation transformer (1) battery 12v, 150 ah (34) battery rack, battery interconnectioin cable ups to battery cable 4m along with installation (1), screw air compressor (scx 8 scb bar) with intergrated ref. air dryer and air receiver of 215 liter capacity with carbon combination filter (2 qty), carbon combination filter, air conditioners

CTN :40194778

22 May, 2025 5.00 Lacs

Kapurthala - Punjab

Tender For supply of v belt , lub oil filter assy , fuel pipe , brushes carbon , m seal

Nylon Membrane Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government And Public Sector