Tender For supply of ferritic steel sheet 3x1250x2100mm., as per drawing: rdso spec. no. c-k201, grade x2crni12 (409m) table 1&2, heat treatment condition 2b as per table-5., packing instruction: stainless steel sheets, coils and plates:- (a) stainless steel (austenitic & ferritic steel) coils. the coil shall be protected in reasonably good condition to withstand normal handling hazard during transit with the following provision as the barest minimum: i) coil should be wrapped with a layer of water proof paper through out whole length. ii) coil should be wrapped with a layer of biodegradeable sheet. iii) outer & inner of coil should be wrapped with gi sheet. iv) side of the coil should be covered with card board sheet. v) after this whole coil should be wrapped with biodegradeable plastic sheet of suitable thickness. vi) the inner edge of the coil should be protected by gi ring followed by another iron ring. vii) outer edge of the coil should be wrapped with gi ring. viii) coil should be securely strapped with minium 5 steel bands through the eyes of the coil and minium 3 steel bands on the circumference of the eye. ix) whole coil should be mounted on wooden blocks for easy lifting/stacking. x) the sheets in coil form for thickness 2mm and above shall have: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 tonnes xi) the sheets in coil form for thickness below 2mm shall have: inner dia of coil 450-650mm outer dia of coil 1000-1300mm weight of coil5.0 - 10 tonnes. (b) stainless steel (austenitic & ferritic steel plates/sheets) i) the sheets/plates shall be supplied in bundles of optimum weight: 2mt+/-10% & each sheet/plate shall be seprated with a layer of water proof paper, after this the whole bundle should be wrapped with double layer of water proof paper and a biodegradeable plastic sheet of suitable thickness. a metal protection in edges should also be provided. ii) all bundles shall have a minimum of 2 hoops upto 1.2 meter in length and one extra hoop for every additional meter. the bundles shall also be provided with skid (wooden packing under neath) to facilitate handling. mechanical damange & corrosion during transit ifany shall be at the cost of supplier. [ warranty period: 30 months after the date of delivery ]
Tender For supply of plastic cover for 2 aspect signal unit cover opened from front side and bottom side and made of black polythene sheet of 100 micron thickness of size : 1200mm x 460mm x 205mm. on back side 75 mm wide corner to corner diagonal cross mark of white colour of 100 micron thickness to be provided. tie up cover with signal unit suitable nylon rope (black color) of 5mm dia and 4 meter length to be provided on front side & of 1.5 mtr length at centre. note:- sample must be approved before bulk supply. [ warranty period: 30 months after the date of delivery ]
Tender For supply of helmet for 48 head carousel gun , inlet spider set of 4 half part , outlet spider set of 4 half part , 48 head filling gun , load cell pcb 250kg c3 pc6 make flintec , load cell make jisl h310 p500 500kg , load cell 300kg c3 pc60 make flintec , trigger assembly with sensor , teflon hose , norgren x3047702 g1 by 8 5by 2 , sensor m15 m12 y1x h1141 , sensor ni10 m18 y1x h1141 , pneumatic fitting 8 by 1 by 8 , pneumatic fitting 8 by 1 by 4 , sick wll24 2x430s01 , sick wt24 2x400s26 , sick wl24 2x430s07 , roller ms 60 mm dia 400 mm length pipe thickness 4mm , cutting wheel 4 inch , welding rod 3point05x350 mm 90 piece , ss bolt all size in kg ss 304 hex and ln , crc 2 26 300 gram , supply of grinder bosch , supply of lc lc multimode duplex ofc patch cord 3 meter , supply of gigabit sfp module based media converter with power adaptor , sfp optical transceiver module dual fiber multimode 850nm 550mtr , utp cat6 patch cord 3mtr terminated with rj 45 connector both end , utp cat6 lan cable , camera cable for vision unit 48h and 24h , din rail 85 264vac to 5vdc 3amp industrial power supply , din rail 85 264vac to 12vdc 5amp industrial power supply , din rail 85 264vac to 24vdc 2amp industrial power supply , enclosed type 85 264vac to 5vdc industrial 3amp power supply , enclosed type 85 264vac to 5vdc industrial 10amp power supply , enclosed type 85 264vac to 12vdc 5amp industrial power supply , enclosed type 85 264vac to 24vdc 2amp industrial power supply , msata high performance ssd for vision unit pitx , 4gb ddr4 ram for vision unit pitx , tensioning weight , sprocket 14 teeth , ms block , brass block , duplex chain lock , network cable 4 core 1 pin , network cable 4 core 2 pin , gd pt arm complete set assembly , communication cable with lan end , rubber damper , metallic gasket two point five inch , skf bearing 6304 2z , carousel wheel , filling scale wheel 48 head carousel , chain riveated type , 48 head star conveyor supporting chain , 48 head gun seal kit , sensor cable 1 meter , sensor cable 3 meter , sensor cable 5 meter , ss wheel assembly , 212 bearings, skf ntn only , ss plate , gd arm roller with bearing , gd arm set , sprocket 8 teeth , pneumatic reducer all size , air flow control valve 8 1 by 8 , air flow control valve 8 1 by 4 , cuc keypad kosan type , cuc keypad push button , socket for vcm , socket ball dedent , vcm s.s ball , shaft for vcm , gas stove valve seal kit brass
Tender For corrigendum : supply of safety related items : - industrial safety belt and harness technical specifications are as per annexure a , welder hand gloves technical specifications are as per annexure b , lux meter technical specifications are as per annexure c , ultrasonic thickness gauge technical specifications are as per annexure d , laser distance meter technical specifications are as per annexure e , integrated public address system technical specifications are as per annexure f , convex mirror road safety technical specifications are as per annexure g , conical traffic cone technical specifications are as per annexure h , caution tape technical specifications are as per annexure i , non asbestos fire blanket technical specifications are as per annexure j , wheel chock technical specifications are as per annexure k
Tender For supply of teflon tape nominally 25 mm width x 0.10 mm thickness in roll of 10 meter as per is 14643 :1999, make/brand- kohinoor/mazda. [ warranty period: 30 months after the date of delivery ]
Tender For corrigendum : supply of various consumable material at emd -1 lighting dept. stps. - flat cable 3 corex4 sqmm with copper conductor for submersible motor, flexible copper wire 1 corex2.5 sqmm (36/0.3 mm)1100v(1 coil is equal to 90 meter), flexible copper wire 1 corex1.5 sqmm (22 / 0.03) voltage grade up tp 1100 volt conf to is- 694, copper cable 2 cx1.5 sqmm, pvc twin wire 2.5mm sqr., self adhesive pvc electric insulation tape rolls with isi mark size 1.80 cm width x 7.5 mtr length x 0.125 mm thickness, of red colour, self adhesive pvc electric insulation tape rolls with isi mark size 1.80 cm width x 7.5 mtr length x 0.125 mm thickness, of yellow colour, self adhesive pvc electric insulation tape rolls with isi mark size 1.80 cm width x 7.5 mtr length x 0.125 mm thickness, of blue colour, self adhesive pvc electric insulation tape rolls with isi mark size 1.80 cm width x 7.5 mtr length x 0.125 mm thickness, of black colour, self adhesive pvc electric insulation tape rolls with isi mark size 1.80 cm width x 7.5 mtr length x 0.125 mm thickness, of green colour, porcelin kit kat fuse 16 amp, porcelain kit kat fuse 63 amp, 415 v , ac, porcelain kit kat fuse 100 amp, 415 v , ac, porcelain kit kat fuse 200 amp, 415 v , ac, din rail mounting channels, ring spanner set model 1812 taparia make, double ended spanner set dep 12, adjustable screw spanner size 8" (200 mm) p.no.1171-8 p, screw driver (tester) taparia product no: 818.special with neon bulb, generally confirming to is 5579-1985 grade - ii, yellow handle,, taparia combination plier, product no.1621-8,210 mm, digital insulation tester, range-0-2000 m-ohm, selectable test voltage-250/500/1000 v dc with rechargeable battery, digital clamp on meter lcd display with backlight, 3-3/4 digit., alluminium ladder self supported a type having 05 feet length, long nose plier insulated with thick c.a. sleeve,165 mm length, taparia make tool, allen key set, product no aki 10, allen key set mm size (09 piece) 1.5,2,2.5,3,4,5,6,8,10 mm, hand drill machine size 13mm, hand grinder machine., aluminium tube terminals10.0 mm2, m.6, aluminium tube terminals16.0 mm2, m6, aluminium tube terminal 35 sqmm,m 8, aluminium tube terminals50.0 mm2, m10, aluminium tube terminals70.0 mm2, m8, aluminium tube terminals95 .0 mm2, m10, pin terminal 1.5 mm2, pin terminal 2.5 mm2, aluminium in line connector25.0 mm2,, 35mm alluminium in line connector als-2"dowell", aluminium in line connector 70 mm2, 95 sqmm crimping alluminium type in-line connectors cat no: hai-15 hex make, crimping tools capacity: 10 mm2 to 185 mm2., crimping tools, capacity: 6 mm2 to 50 mm2., alluminum ring type lug 25 sq. mm, pvc saddle 10 mm, pvc saddle 15 mm, pvc saddle 20 mm, pvc saddle 32 mm, multistrend copper flexible wire 1 core x 4.0 mm2, (7 strendes) pvc (double) insulated, without armourr, 1.1kv grade (100m/coil)
Tender For corrigendum : supply of various types of consumable items and miscellaneous items for day to day maintenance works for emd-6 utps. (emd-6 et-6203) - carbon cleaner spray, puff seal have polyurethene based foam sealing compound, stanvac pen oil rust remover 6030,500 ml/pac, 6084 red insulating varnish (500 ml) can, 901 easyclean (nf) 500 ml. spray can - on line electrical contact cleaner., 415v offline contact cleaner (700ml tin), z955 (sl) srippex sltape roll (silicon rubber, self amalgamating, high temperature resistance tape size:-25mmw0.50mmw15mtr./roll, feeler gauge: 0.05 - 1 mm, length - 150. size: 0.05 - 1mm step of 0.05mm, 20 leaves, self expanding cfc free one component polyurethane foam sealant. product2206 360 puf 3x in 700 ml spray can., w963 play safe high voltage tape (50 mm x 0.76 mm x 9.1 mtr) roll, w963 play safe high voltage tape (25 mm x 0.76 mm x 9.1 mtr) roll, self adhesive pvc electric insulation tape rolls with isi mark size 1.80 cm width x 7.5 mtr length x 0.125 mm thickness, of green colour, ht pvc insulation tape size 0.18 mm x25 mm x 65 mtr length, temperature measurement laser gun., araldite 180 gram/tube, z 801 fast steel epoxy stick (1 stick 114 grm), emery cloth roll 50mm w x 50 mtr grit 220 extra fine, cable tie 100 mm, cable tie 150 mm, cable tie 200 mm, impact wrench power/battery operated, taparia make utility knife. product no. uk-3., cordless screw driver power/battery operated, tools bag (taad patri type, thick cloth) with 3 to 4 pockets for artisian tools having size 16" x 4" x 10"approximate, weighing scale digital, crc-226 contact cleaner in 415 ml/300 gram spray bottle., wd -40 industrial 420 ml wd 40 spray bottle for rust removing purpose, hss ground thread hand tap set m 10x1, nylon braided pvc hose pipe suitable air/water handling ;at working pressure of 10kg/cm2 ,size; 12mm, molykote 1000 spray can (400ml/270gms/can), electrically operated angle grinder, size: 100 mm, model no:gws 6-100 g,p no: f002 g30 050, make: bosch, digital multimeter 4.1/2 digit (true rms), loctite 242 thred locking 250 ml/tube, 2 tb external usb powered hard disk, pebble ral 7032 color spray bottle for electrical ht / lt panel, high voltage detector, rubber hand gloves, long rang rechargeable torch with charger., ag-4 cutting wheel make:bosch, buffing wheel , size: 100 x 16 x 5/6 mm, circlip plier pvc dip coated sleeve , internal (straight nose type ) ,cap 19mm to 60mm, 185mm length, product no.1441-7n, external circlip plier ( straight nose type ) cap 8 mm to 25 mm.product no:1443-5s, hss ground thread hand tap set m 4x0.7, hss ground thread hand tap set m 5x0.8, hss ground thread hand tap set m 6x1, hss ground thread hand tap set m 8x1.25, hss ground thread hand tap set m 10x1.5, hss ground thread hand tap set m 12x1.75, hss ground thread hand tap set m 14x1.5, digital ma clamp on meter
Tender For heavy duty high tenacity 100% polyester quadruplex webbing sling of capacity 02 ton (safe working load), length 3.5 meter, width - 25 mm, thickness - 12mm , safety factor - 7:1 , confirming to is: 15041-2001/en 1492-1-2001/en 1492-4-2004 along with load test certificate from govt. approved person/lab. firm to submit purchase proof from oem/authorized distributor along with supply of material. make: blw, samson, harrison only. [ warranty period: 30 months after the date of delivery ]