Tender For insulation monitoring relay,415 v ,3 phase, neutral isolated, voltagerange 0-500 v ac, insulation measuring range-10 k ohm to 150 k ohm, control supply 24-240 v ac/dc, place of installation - s1a7, used for insulation control 415 v of lhb type ac coaches, confirming to rdso spec. no.rdso/pe/spec/ac-0184-2015 (rev.1), suitable for lhb type ac coaches switch board cabinet (s1a7),accepted make as per s. no.68 of the common bom list issued vide rdso letter no. el/7.1.108/mssbc dated 17.09.2021 or any other rdso approved make. [ warranty period: 30 months after the date of delivery ] ]
Tender For supply and installation of aerosol based fire detection and suppression system cartridges (100gm+100gm), total 02 pieces as per detailed technical requirement specified in the annexure - g 1 of rdso specification no. rdso/pe/spec/ac/0192-2018 (rev-1) and rdso approved make only. the mounting arrangement shall be suitable for installation in switch board cabinet panel of lhb ac coaches. all necessary modification & accessories required for installation of this item shall be within scope of supplier.as per rdso spec. makes are firepro, stat-x, pyrogen technology and with prior approval of rdso. [ warranty period: 30 months after the date of delivery ] ]
Tender For supply of power contactor for feeder - 1 & feeder- 2 and bus coupler, 3 pole, 1000v ac, 50 hz, suitable for 500kva, 750v ac on load switching under ac-6a category at temperature of 70 degree celsius & coil voltage of 110v+25% -30% dc with surge suppressor, aux. contacts 2no+2nc as per rdso specification no. rdso/pe/spec/tl/0195-2019 (rev.0) suitable for switch board cabinet for hog compliant lslrd coaches.( as per attached specification) [ warranty period: 30 months after the date of delivery ] ]
Tender For provision of ss plate drain tray over switch board cabinet (sbc) of lhb coaches to prevent entry of rainwater into electrical system over ddn (72 nos.), ynrk (15 nos.) & be (30 nos.) coaching depots of moradabad division.
Tender For supplying electrical materials and repair maintenance services at. grampanchayat chimbali. - electrical material, supplying and erecting modular type switch6a / 10a ., supplying and erecting street light bracket for erection ofsingle fitting made from 40 mm. dia b class g.i. pipe 1.0 m in length along with pole cap of 300 mm length 100 mm dia duly welded ., providing cement concrete foundation including excavationfor the poles 60 cm x 60 cm x 1.5 m deep in 1:3:6 cement concrete (20 x 25 mm stone metal) and 45 cm x 45 cm x 45 cm/45 cm dia. x 45 cm height plinth duly plastered and with necessary curing and finishing in an approved manner.(for 8.5 to 9 m poles), supplying and erecting steel tubular swaged pole 139.7 x 114.3 x 88.9 mm. dia with 4.5x3.65x3.25 mm thickness (4.5 + 1.75 + 1.75m) length respectively and total 8 m long with pole cap, base plate in provided foundation., supplying and erecting steel tubular swaged pole 165.1 x 139.7 x 114.3 mm. dia with 4.5 x 4.5 x 3.65 mm thickness ( 5 + 2 + 2m ) length respectively and total 9 m long with pole cap, base plate in provided foundation., supplying and erecting steel tubular swaged pole 165.1 x 139.7 x 114.3 mm dia. with 4.5 x4.5 x3.65 mm thickness (5.60 + 2.7 + 2.7 m) length total 11 m long with pole cap, base plate in provided foundation ., supplying and erecting street light bracket made from 25mm. dia b class g.i. pipe, 0.6m. in lengthalong with polecap of 300 mm length and 80 mm dia duly welded with provided leads as per specification, supplying,tpmcb 40a to 63a in provided distributionboard, providing pair of duly tested rubber hand gloves as per is:4770 suitable for working upto 22kv supply., supplying and erecting insulated d.p. switch surface type/flush type 32a 240vwith indicator lamp & fuse, supplying h.c. pattern porcelain fuse bridge swith base & hc type fuse links240v 32a, supplying and erecting programmable digital almanactimer microcontroller based with real time clock to operate on derived switching on & switching off street light as per daily sunset and sunrise respectively, 1.25 mm crca sheet metal enclosures with 20a., supplying pvc insulated pvc round sheathed 1.5 sq.mm (30 no. x 0.25 mm dia.) 3 core flexible multi stranded copper industrial cable ., supplying and erecting led street light fitting suitable for 60w lamp, including lamp, with pf > 0.95 class ip 65 and above housing of pressure die cast alluminium alloy and heat sink ., supplying and erectingled street light fitting suitable for 26w to 36w led street light, including lamp, with pf > 0.95 class ip 65 and above housing of pressure die cast alluminium alloy and heat sink., supplying and erectingled street light fitting suitable for 90 w led street light, including lamp, with pf > 0.95 class ip 65 and above housing of pressure die cast alluminium alloy and heat sink., supplying and erecting led flood light fitting of 120w, including lamp, with pf > 0.95,class ip 65 and above housing of pressure die cast aluminium alloy and heat sink extruded aluminium ., supplying & laying pvc armoured cable 4core 6sq mm, supplying & laying pvc armoured cable 4core 10 sq mm, supplying & laying pvc armoured cable 2core 10 sq mm, supplying & laying pvc armoured cable 4core 16 sq mm, supplying, erecting & marking spmcb 6a to 32a, b- series (for lighting), supplying, erecting & marking dpmcb 6 a to 32 a bseries (for lighting), supplying, erecting & marking tpmcb 6 a to 32amp ., supplying, erecting & marking fpmcb 40a to 63a ., supplying & erecting crimping type aluminium lugs for cable upto 16 sq mm., supplying & erecting crimping type coper lugs for cable upto 1.5 to 6sq mm., supplying and erecting two pole power contactor 250v 32a for time switch complete erected on wooden block/provided box, with necessary materials., supplying & erecting mains with2x1.5 sq.mm f.r copperpvc insulated wire laid in provided conduit/trunking/inside pole 1-3-3, supplying and e
Tender For power supply on/off switch, place of installation: s1s02 in switch board cabinet of lhbac coaches as per rdso spec. no. rdso/pe/spec/ac/0184-2015 (rev.1) or lat. and rdso ltr. no. el/7.1.108/mssbc dt.: 17-09-21. make as per bom are siemens cat. no. 3sb50002ab01+3sb54000e, l&tcat. no. emncsk1+ec1c, schneider cat. no. xb5ad33n+zbe101n+zbe102n, abb part no. m3ss1-10b+mcbh00+mcb-10 or only. [ warranty period: 30 months after the date of delivery ][quantity tolerance (+/-): 5 %age , item category : normal , total po value variation permitted: max 8 lacs ] ]
Tender For supply, erection, testing & commissioning of powerdistributionboard (pdb) panels outdoor type with accessories as per technical specification attached in annexure 'a' attached. [ warranty period: 12 months after the date of delivery ] ]
Tender For supply of hrc cylindrical fuse link 4 amp ( with out holder ),1.2 kv size 50x8 mm for voltage control as per s.no 13 and item code fo1 to fo6 and place of installation s1f90 tos1f96 of bill of material of rdso spec no: rdso/pe/spec/ac/0184-2015(rev.-1) used for voltage control fuse of lhb type ac coaches confirming to rdso spec no. rdso/pe/spec/ac/0184-2015 (rev-1) suitable for lhb type ac coaches switch board cabinet [ warranty period: 30 months after the date of delivery ] ]
Tender For nit 21 work of replacement of submersible pump sets and accessories of tubewell at various locations under uwss chomu under jen section chomu (urban) under sub div chomu in jurisdiction of executive engineer, phed district division ii, jaipur - 2.15 supply & installation of 3 phase isi marked submersible motor pump set of three star or better rating of bee and as per is: 8034-2018 (pump) and is 9283-2013 (motor) or as amended up to date of approved make of following duty condition with required accessories including making connection suitable for tube well/dcb. the job includes lowering of motor pump, installation of complete fitting & accessories, jointing of electrical cables up to switch board, testing of submersible pump set and interconnection up to water mains, complete in all respect.2.15.2 up to 5.5 kw (7.5 hp) & head above 120 mtr., 2.15 supply & installation of 3 phase isi marked submersible motor pump set of three star or better rating of bee and as per is: 8034-2018 (pump) and is 9283-2013 (motor) or as amended up to date of approved make of following duty condition with required accessories including making connection suitable for tube well/dcb. the job includes lowering of motor pump, installation of complete fitting & accessories, jointing of electrical cables up to switch board, testing of submersible pump set and interconnection up to water mains, complete in all respect.2.15.4 7.5 kw (10 hp) & head above 120 mtr., 2.15 supply & installation of 3 phase isi marked submersible motor pump set of three star or better rating of bee and as per is: 8034-2018 (pump) and is 9283-2013 (motor) or as amended up to date of approved make of following duty condition with required accessories including making connection suitable for tube well/dcb. the job includes lowering of motor pump, installation of complete fitting & accessories, jointing of electrical cables up to switch board, testing of submersible pump set and interconnection up to water mains, complete in all respect.2.15.6 9.3 kw (12.5 hp) & head above 120 mtr., 2.18 supply and fixing of electric control feeder panel comprising of suitable rating mccb , fully automatic star-delta starter, over load relay, ampere meter with cts, volt meter, phase preventer, suitable starting capacitors, phase indicators, lighting arrangement etc complete suitable for three phase pump set. the panel should have space for energy meter ( supplied by discom). all these equipments shall be housed by panel box made out from 18 gauge m.s. sheet with powder coating. panel should be of minimum size 900 x 600 x 450 mm with stand ( made of angle iron of size 35x35x5mm) duly bolted/screwed with enclosure box having 4 legs, each leg s length 18 and double door including in built locking system. the legs should be embedded in m-15 cement concrete plat form. the size of cc platform should be equal or bigger than the base size of panel having height of at least 200 mm from ground level. the panel should have opening of suitable size in front of space for energy meter with glass for meter reading. the operation of panel should be suitable for on 440 volt ac supply.2.18.1 above 5 hp and up to 10 hp, 2.18 supply and fixing of electric control feeder panel comprising of suitable rating mccb , fully automatic star-delta starter, over load relay, ampere meter with cts, volt meter, phase preventer, suitable starting capacitors, phase indicators, lighting arrangement etc complete suitable for three phase pump set. the panel should have space for energy meter ( supplied by discom). all these equipments shall be housed by panel box made out from 18 gauge m.s. sheet with powder coating. panel should be of minimum size 900 x 600 x 450 mm with stand ( made of angle iron of size 35x35x5mm) duly bolted/screwed with enclosure box having 4 legs, each leg s length 18 and double door including in built locking system. the legs should be embedded in m-15 cement concrete plat form. t
Tender For supply of feeders-1&2 and bus coupler power contactors, 3pole, 1000v ac, 50hz, suitable for 500 kva, 750v ac on load switching under ac-6a category at temperature of 70%b0 c & coil voltage of 110v +25%-30% dc with surge suppressor, 2no+2nc, as per rdso spec no. rdso/pe/spec/tl/0195-2019 (rev.-0) or latest. acceptable make abb- af1250-30-11, l&t - mvo 820, siemens- 3tf69338df4z a02+3tx75723h suitable for switch board cabinet of hog compliant lslrd coaches. [ warranty period: 30 months after thedate of delivery ] ]