Latest pvc pipes fitting Tenders | Government pvc pipes fitting Tenders

Central Government/Public Sector

CTN :41710025

25 Sep, 2025 NA

Mumbai - Maharashtra

Tender For supply of thermoplastic textile reinforced water hose size: 31.5 mm x 15 mtrs. long to specn.is:12585-2023. type-2 [reinforcement synthetic textile cover 5 smooth finish] note: i] the water hose shall be warranted for a period of 18 months from the date of delivery at depot. ii] material should be flexible to insert in respective pipe joints and to tight hold the conventional worm drive clips to is: 4762-2002 reaffirmed-2021 or latest. iii] colour of water hose yellow/black. iv] manufacturer should be a bis registered source and indicate cm/l no. in the offer.

corporations/Associations/Others

CTN :41698903

11 Sep, 2025 8.29 Lacs

Kurnool - Andhra Pradesh

Tender For supply and delivery of cid joints cl-15, cl-10, cl-20, tail pieces, ms flanges, pipe end long neck, 6 kg/cm2 pvc couplings, elbows for regular maintenance of water supply distribution in 19 to 21 wards, 26 to 32 (panyam constituency wards) in kurnool municipal corporation.

Central Government/Public Sector

CTN :41669684

23 Sep, 2025 NA

East Singhbhum - Jharkhand

Tender For annual repair and maintenance of 500 mm dia di pipeline from kharkai to turamdih : : - patrolling or inspection of di pipe line for checking leakage detecting from intake well cum pump house to turamdih area where pipe line exists with technical persons minimum one fitter with transport facility daily and including tightening of nuts and bolts where ever required for rectification of leakages observed during routine inspection. , attending as and when required major breakdown or rectifying leakage of di pipe line including fixing of necessary mechanical joint and all accessary within twelve hours information or notice for rectification till the resumption of the service including labour charges equipment tools and tackles but excluding cost of materials etc , overhauling charges of valves including change of gland packing if required with all labour charges for joints for following sizes of gate or sluice valve or butterfly valves for four hundred mm dia , overhauling charges of valves including change of gland packing if required with all labour charges for joints etc for following sizes of gate or sluice valve or butterfly valves for five hundred mm dia. , repairing of air valves including charges of float ball with all labour charges tools and tackles , earth work in excavation in trenches or drains including dressing saides and ramming of bottoms lift upto one point five metre including getting out the excavated soil and disposal of surplus excavated soil as directed all kinds of soil , return earth filling by available excavated earth excluding rock i trenches plinth sides of foundation etc in layers not exceeding twenty cm in depth consolidating each deposited layer by ramming allow for breading up lumes shrinkage etc watering lead upto fifty metre and lift upto one point five metre complete as directed by the eic. , clearing jungle including uprooting of rank vegetation grass bush wood trees and saplings of girth upto thirty cm measured height of one metre above ground level and removal of rubbishe upto a distance of fifty metre outside the periphery of the area cleared. , surface dressing of the ground including removing vegetation and in equalities not exceeding fifteen cm deep and disposal rubbish lead upto fifty metre and lift upto one point five metrea all kinds of soil. , supplying and filling in plinth with sand under floors including watering ramming consolidating and dressing complete , providing and laying in position cement concrete of specifieda grade excluding the cost of centering and shuttering all work up to plinth level one cement isto three coarse sand six graded stone aggregate twenty mm nominal size. , rcc work below and above plinth level up to floor five level one cement isto one point five coarse sand isto three graded stone aggegate twenty mm nominal size is to be provided. , steel reinforcement for rcc work including straightening cutting bending placing in position and binding all complete. , centering and shuttering including strutting propping and removal of form for all heights. , 15mm thick cement plaster on rough side of single or half bricke wall of mix one cement isto six coarse sand to be provided. , neat cement punning , supply at site laying jointing including gasket nut bolts all complete miscellaneous di fittings like di bend mechanical joint tee gland packing all item as per is9523 for four hundred or five hundred mm dia di specials with spigot and flange combination like bend tee of class k12 suitable for push on jointing as per is9523 pipe all complete.

Central Government/Public Sector

CTN :41666756

22 Sep, 2025 44.00 Lacs

Mumbai - Maharashtra

Tender For repair/replacement of water supply distribution pipe, joints, repair to internal wiring, submain wiring, security light, control panel, high mast light and other connected electrical works at various pockets of af stn mumbai under ge(af)thane

State Government

CTN :41703326

08 Sep, 2025 3.89 Lacs

Mandi - Himachal Pradesh

Tender For laying and jointing of gi pipe 125mm dia mc by cutting welding of joints and bends at various rds along with 22 no anchor blocks

State Government

CTN :41474282

08 Sep, 2025 NA

Karur - Tamil Nadu

Tender For corrigendum : attending leak in the weld joints of various steam lines in the pipe rack at energy mechanical in tnpl unit -1.

CTN :41704765

15 Sep, 2025 1.30 Lacs

Kupwara - Jammu And Kashmir

Tender For supply of pipe joints , english seat cera , english seat pearl , pvc pipe , pvc pice

CTN :41601724

06 Sep, 2025 NA

Dehradun - Uttarakhand

Tender For supply of assy joint cross right , assy joint cross left , cartridge oil filter , cable park brake , assy line shoe lh and rh , pipe breather , metal set main bearing 0 25us , king pin and bush kit , bearing assy w o race , mudguard protector , lens , side indi lamp lh , side indi lamp rh , cyl assy hyd brake wheel , de bracket assy , ball joint lower , assy ball joints upper wishbone , tie rod assy , linkage bush kit , oil seal rear axle shaft , hydraulic pipe

Central Government/Public Sector

CTN :41605725

06 Sep, 2025 3.21 Lacs

Bhadrawati - Maharashtra

Tender For providing and fixing of open / green gym item in palasgaon village under kuchana housing complex of majri area. - earth work in excavation by mechanical means (hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.all kinds of soil., supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete., providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level : 1:3:6 (1 cement : 3 coarse sand (zone-iii) derived from natural sources : 6 graded stone aggregate 20 mm nominal size derived from natural sources) , providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level : 1:1 :3 (1 cement:1 coarse sand (zone-iii) derived from natural sources: 3 graded stone aggregate 20 mm nominal size derived from natural sources), providing and laying 60mm thick factory made cement concrete paver block of approved shape and colour of m - 30 grade made of c&d waste by block making machine with vibratory compaction laid in required pattern and including over 50mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge., providing and fixing pommel horse size 2200 x 710 x 610 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing / pole cap made of hdpe/frp material and seat structure made of m.s sheet laminated by frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing sky walker size 1700 x 710 x 1700 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bearing / pole cap made of hdpe/frp material and foot rest structure made of m.s sheet laminated by frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing single shoulder press size 1200 x 760 x 1670 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bearing / pole cap made of hdpe/frp material and seat structure made of m.s sheet laminated by frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing seating standing twister size 1820 x 610 x 1520 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. round plate of 6 to 8 mm thickness. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bearing / pole cap made of hdpe/frp material and twister plate structure made of m.s sheet / frp of 3 to 4 mm thickness and panit by powder coated ( 80 to 90 micron). all complete job as per the instruction of engineer in charge., providing and fixing outdoor traidmill size 1200 x 610 x 1220 mm with pipe shall be structure pipe made of gi pipe of 4 42od nd 32 od of 3 to 4 mm thickness, bottom support m.s. plate. the arm with structure made of 32 od gi pipe of 3 to 4 mm thickness, bearing ball bearing (skf) ,bea

corporations/Associations/Others

CTN :41655752

11 Sep, 2025 NA

Kanpur - Uttar Pradesh

Tender For tender for supply of providing and laying vitrified tiles in floor , providing and fixing tiled false ceiling at all height , providing and applying white cement based putty , distempering with 1st quality acrylic distemper , supply and installation g i fire sprinkler pipe for extension , supply and installation of recess led lights in false ceiling , supply & installation of 2 tone split air conditioners , single core cable in the pvc conduit as required 3x4 sq mm , providing & installation of 5 kva wall mounted voltage stabilizers , supplying & fixing suitable size modular box wih modular plate , providing and fixing 18 mm thick gang saw cut mirror polished , providing and fixing 12 mm thick frameless toughened glass door shutter , dismentailing flush door door frame and repairing , providing and fixing s s handle , providing and fixing stainless steel toughned glass door lock , dismantling old plaster or skirting raking out joints and cleaning the surface , 12 mm cement plaster of mix , providing and laying in position cement concrete

Pvc Pipes Fitting Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors