Latest screw clamp Tenders | Government screw clamp Tenders

CTN :43206566

12 Jan, 2026 NA

Ferozepur - Punjab

Tender For corrigendum : material and labour for construction of 3800 mtr x chain link fence in ferozepur - s&f structural steel post of angle iron 65x65x6mm, 4.50 mtr long, weight as per is 2062-1984 including fabrication of 0.60 mtr both side long top portion swan neck v type at 30 degree to vertical, including making six round holes of 15 mm dia on vertical posts and for fixing of nuts and bolts and three nos of 15 mm dia holes for fixing strut and five nos notches on the swan neck and welding of two nos of 16 mm ms rod each of 0.23 mtr length to bottom end of picket for anchorage including one coat of red oxide primer and two coat of synthetic enamel paint for exposed surface of angle above gl complete and two coat of bituminous paint embedded portion of angle 0.45mtr. make : jindal/ sail/ tata/equivalent isi marked complete all as specified and directed by engineer-in-charge, s&f structural steel post of angle iron 65x65x6mm, 3.30 mtr long, weight as per is 2065- 1984+b12, including fabrication for strut post bending at top portion, including making three nos holes of 15 mm dia on vertical posts for fixing of nuts and bolts and three nos of 15 mm dia including 0.23 mtr 16 mm dia ms rod two piece to be welded at bottom for anchoring purpose including one coat of red oxide primer and two coat of synthetic enamel paint for exposed surface of angle above gl complete and two coat of bituminous paint for stud 0.45mtr below gl for one side of the post complete all as specified and directed by engineer-in-charge. make : jindal/ sail/ tata/equivalent isi marked, s&f galvanised two or three strand steel barbed wire (line wire) of 2.24mm diameter of wire, barbs at 75mm spacing. the barbs are (point wire) 02mm thick wire shall be isi marked as per is:278 of 1978 (third revision) with amdt no 1 to 4. the points of barbs shall be sharp. the line and point wires shall be circular in section free from scales and point wires shall be circular in section free from scales and defects and shall be uniformity galvalium. the barbed wire shall be manufactured as per clause 11.2.1 and 11.2.2 respectively of is specification cited above read with is 4826/79 (first revision).make:sail/tata/ aplapollo/rinl/jsw complete all as specified and directed by engineer-in-charge, s&f galvanised steel chain link fence fabric of mesh size 125mm x 125mm (+/-) 4mm of 4.00mm nominal diameter. the size of chain link fence fabric shall be 2.7 mtr x 15 mtr mesh wire. galvalium chain link shall be manufactured as per is 4823 complete all as specified and directed by engineer-in-charge. make : tata/jsw/rinl/ jindal/sail., s&f ms plat of 40x3 mm, 2.70 mtr long with 6 holes of 15 mm dia, including one coat of red oxide primer and two coats of synthetic enamel paint. 3.02 kg per flat. make of steel: jindal/ sail/ tata/equivalent isi marked complete all as specified and directed by engineer-in-charge., s&f mild steel bolts with hexagonal head at one end and screwed the other end fitted with one nut and two washers. the bolts shall be 12mm dia and 50mm long. strong long lasting, resistant to corrosion and 100% recyclable complete all as specified and directed by engineer-in-charge. make: jindal / sail/ tata/ apl apollo/ jsw/ rinl, s&f ms round bars 10mm dia with hook on both sides made to shape including two coats of synthetic enamel paint over a coat of red oxide primer. make: jindal/ sail/ tata/ apl appolo/ jsw/ rinl complete all as specified and directed by engineer-in-charge., s&f ms round bars 16mm dia with hook on both sides made to shape including two coats of synthetic enamel paint over a coat of red oxide primer make: jindal/sail/tata/apl apollo/jsw/rinl complete all as specified and directed by engineer-in-charge., material and labour for excavating in soft and dense soil trenches, exc 1.5 m wide and exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and exc 1.5 m in dept

CTN :43521836

20 Jan, 2026 NA

Multi City - Multi State

Tender For supply of main girder , cross girder , ramp girder , a frame , b frame , anchor winch , aluminum welding for main girder qty 50 nos and ramp girder qty 150 nos , s frame , h frame , panel bb , transom bb , stringer button , ramp button , ramp plain , post end male bb , post end female , bearing bailey bridge , base plate , steel chasses large , steel chasses small , racker , sway braces bb , bolt bracing , riband bb , plain roller , riband bolt , packing timber 9 inch x 3 inch x 6 feet , packing timber 9 inch x 6 inch x 3 feet , rocking roller , panel pin , transom clamp , carrying hook , box spanner , screw clamp , hinged clamp

CTN :43321880

12 Jan, 2026 NA

Parganas - West Bengal

Tender For bid to ras tender for supply of washer(price list sl-239) , spacer(page-03) , ratchet(price list sl-538) , roll pin , starter handle(price list sl-539) , starter rope(price list sl-504) , power head gasket set (13 nos items)(sl-434) , starter lock lever , bushing(page-07) , washer , screw , clamp , clip , ignition coil(ctlg sl-17) , spacer , lanyard assy(mariner plate elect component) , clamp , bushing , washer , nut , fuel pump assy (price list sl-566) , gasket , float needle , carburetor repair kit (containing 11 nos items) , clamps , upper end cap , cylinder head , spark plug(ngk-b7hs-10) (sl-464) , exhaust cover , crankshaft , piston (standard)(ctlg sl no 14) , piston set (standard)(sl-477) , ball bearing , reed block assembly , lockwasher , washer , friction plate , upper thrust plate , buttom yoke(black) , set plate , bracket , wave washer , wave washer(sl-9) , collar(sl-19) , washer , water plug , plug , trim tab , cam rod (long) , bushing , pinion gear(sl-479) , pipe , oil seal(sl-418) , dowel pin , water pump repairs kit (containing 07 no of items) , holder(price list sl-54) , needle bearing

Central Government/Public Sector

CTN :43252742

16 Jan, 2026 5.32 Lacs

Anuppur - Madhya Pradesh

Tender For corrigendum : supply of coal tub accessories haulage accessories and track line installation materials d d ? g? g -block pdstl ci 235x76x135mm grv 55mm , clip haulage rope screw typ 19 22mm , link d dgms w pin coupling chain , accessory j hook coal tub , nail 3in 3 8in ms dog

Central Government/Public Sector

CTN :43484392

17 Jan, 2026 NA

Ernakulam - Kerala

Tender For supply of 8mm dia short liink chain with hook - stainless steel (1075 mm length)

CTN :43487526

22 Jan, 2026 10.00 Lacs

Indore - Madhya Pradesh

Tender For supply of chasis dynamometer d d -air compressor , spark plug cleaning machine , screw driver set , ring spanner set , open end spanner set , socket goti spanner set , pliers , monkey pliers , outer and inner pliers , tool box , tee spanner , allen key set , tappet puller , tappet gauge , digital multimeter , tachometer , hammer set , tyre pressure gauge , oil measurement can , oil cane mannual pump , tool trolley , magnetic coil , drain pain , hydraulic jack , bench vice , pneumatic rivet nut gun , oil pressure gauge , allen watch , chain watch , locking watch , carbon scraper , gasket , scraper 01 set , vernier caliper digital , micrometer , flow meter , temperature gauge , dial gauge , hand tools , power tools , lifting jack tools , brake roller tester , chassis dynamometer , portable car washer , tools , gloves , safety shoes , fire extinguisher , safety glasses , head protection , safety rescue hook , insulated rubber mat , warning sign stickers , post and chain , face mask , two wheeler ev trainer kit , two wheeler work bench , dc fast charger , hand fire extinguisher , air racket , stud remover , stud remover with socket , tap and dive , torque wrench , tubeless tyre repair kit , threat wear indicator , 4 point relay , 5 point relay , three wheeler , old second hand lead acid battery , bms tester , bldc motor , soldering iron kit , ev charging system , power steering , suspension kit , battery load tester , battery charger , hub motor kit , disck brake assembly , battery cell lithium ion , powertrain with differential ) /bid number: gem/2026/b/7072277 * /dated: 07-01-2026 & & / bid document1 / 57

CTN :43456912

12 Jan, 2026 NA

Parganas - West Bengal

Tender For supply of twin shutt off valve part no 1003515110, washer part no 2102919038a, weather strip wind shield part no 2145206050, wheel/wheel assy steering part no 2003402015, wing nut, slotted link part no 2125204024a2, bearing box part no 236u1701203, breather part no 298430p10, breather part no 2142401025, bushing part no 2361701138, bushing(bracket) part no 214b1602069, chain pawl split pin comp towing hook a part no 255b2707222, emblem manufacture part no 2148401300b1, glass raiser handle part no 214b6104096, nut & bolt for combination light part no nk, qtr glass hinges(rubber) part no nk, qtr glass lock part no niv, qtr glass rubber part no nk

CTN :43207861

13 Jan, 2026 5.10 Lacs

Nagpur - Maharashtra

Tender For corrigendum : supply of set of internal threading tooling of vardex make consists of: (a) nvr16d-3lh= 01no (b) 3il a60 vtx= 50n , turing tool holder as per iso code nosvjcl2020 k16 with screw clamp. a) set of spares 1 no each sui

CTN :43452016

20 Jan, 2026 4.00 Lacs

Ananthnag - Jammu And Kashmir

Tender For supply of electric gyser , gyser bolt , angle valve , pvc connection , gi elbow , gi tee , gi socket , gi pipe , ss combine , socket , switch , electric copper wire , electric copper wire1 , electric copper wire 2 , electric copper wire3 , casing caping , mcb 16 amp , mcb 32 amp , mcb dp 32 amp , mason trowel , led bulb 9w , led tube light 18w , security light 50w , curtain rod with sider and mounting bracket , enamel paint white , distemper white , white putty , varnish , primer wood and metal , glass for window 5mm , wood plainer machine electric , tile cutter machine electric , tile cutter blade , wood cutter machine electric , iron cutter machine , iron cutter blade , chair cushions 2ftx2ft 8 inch thick , ms pipe 60mm external dia 6 mtrs length , ss double peacock swing chain , pipe wrinch 18 inch , pipe wrinch 12 inch , pipe wrinch 14 inch , pipe wrinch 10 inch , gi pipe die 1 by 2 inch , j hook with nut and bolt , u hook with nut and bolt , glass beading , rectangular bathroom mirror. , fflushing cistern , pvc connection for wc , waste pipe for wash basin , waste coupling for wash basin , gi nipple 15mm x 6 to 02 inch , measuring tape mettalic 50 mtr , wire 1 pt 5 sqmm 2 core , glass beading wooden , wire nails , tower bolt , bow handle , al drops , door closer

State Government

CTN :43388519

10 Jan, 2026 46.95 Lacs

Bengaluru - Karnataka

Tender For supply of various rescue equipments as per tender documents -reg. - anchorage lines 50 mtrs, long semi static ropes., anchorage lines 100 mtrs. long semi static rope, electric operated chain saw-wood cutting - 36, basic tools box & paratech rescue tools, spine board with straps, foldable stretcher, chipping hammer heavy weight , rubber lined delivery hose, petrol operated chain saw, multi-purpose rescue (hi-lift) jack 60, rain suits, battery operated area lighting system., petrol operated circular concrete cutter saw 14 with pressurised water tank, fire & rescue blade., rescue hand gloves with 5-cut., bolt cutter 48., electrical gloves (36 kva di-electric tested), hammering machine, metal cutter battery operated, metal cutter electric operated, helmet , gum boot, working gloves (leather), concrete cutter (dual blade cutter & break) with spare blades, heavy duty 50 mm x 10 mtrs x 5 ton capacity ratchet laying belt with hook., heavy duty 50 mm x 15 mtrs x 5 ton capacity ratchet laying belt with hook.

Screw Clamp Tenders

By Cities

By States

By Agencies

By Ownerships

By Sectors

Central Government/Public Sector

Central Government/Public Sector

State Government