Tender For supply of stainlesssteelsheet size: 0.8 x 1250 x 3000mm to specn. grade-304 , finish no. 4. length with a tolerance of +10mm, -0mm, width with a tolerance of +5mm, - 0mm. the st ainless steelsheet to be protected by pvc film coating not less than 20 microns thickness on finish side. [ warranty period: 30 months after the date of delivery ]
Tender For corrigendum : supply of ferritic steelsheet 6x1250x3500mm., as per drawing: rdso spec no.c-k201, gra de x2crni12 (409m) table 1&2. heat treatment condition 2d as per table-5., packing instructi on: stainlesssteelsheets, coils and plates:- (a) stainlesssteel (austenitic & ferritic ste el) coils. the coil shall be protected in reasonably good condition to withstand norm al handling hazard during transit with the following provision as the barest minimum: i) coil should be wrapped with a layer of water proof paper through out whole length. ii) coil should be wrapped with a layer of biodegradeable sheet. iii) outer & inne r of coil should be wrapped with gi sheet. iv) side of the coil should be covered with c ard board sheet. v) after this whole coil should be wrapped with biodegradeable plast ic sheet of suitable thickness. vi) the inner edge of the coil should be protected by gi r ing followed by another iron ring. vii) outer edge of the coil should be wrapped with gi ring. viii) coil should be securely strapped with minium 5 steel bands through the eye s of the coil and minium 3 steel bands on the circumference of the eye. ix) whole coil s hould be mounted on wooden blocks for easy lifting/stacking. x) the sheets in coil for m for thickness 2mm and above shall have: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 tonnes xi) the sheets in coil form for thickness belo w 2mm shall have: inner dia of coil 450-650mm outer dia of coil 1000-1300mm weight of c oil 5.0 - 10 tonnes. (b) stainlesssteel (austenitic & ferritic steel plates/sheets) i) the sh eets/plates shall be supplied in bundles of optimum weight: 2mt+/-10% & each sheet/plat e shall be seprated with a layer of water proof paper, after this the whole bundle sho uld be wrapped with double layer of water proof paper and a biodegradeable plastic s heet of suitable thickness. a metal protection in edges should also be provided. ii) all bundles shall have a minimum of 2 hoops upto 1.2 meter in length and one extra hoop f or every additional meter. the bundles shall also be provided with skid (wooden packi ng under neath) to facilitate handling. mechanical damange & corrosion during transi t if any shall be at the cost of supplier. , proction procedure: covered in pi [ warranty perio d: 30 months after the date of delivery ]
Tender For supply and installation of oxidize multimedia mud removal filter and test, odor carbon cham ber filter , raw water pump motor 0.5 and 1.5 hp high pressure pump ro module flow rate 500lph lifting a nd connection of pipe fitting tanks to the roof of the site building along with all complete pipe fitting till chill water point and it is totally covered by gs sheet installation of a steel truss and on the concrete base make aqua fresh, blue mount or make similar. [ warranty period: 30 months after the date of delivery ]
Tender For supply of ply wood for gen purpose 12mm , ply wood for gen purpose 10mm , m seal , fevicol sr 998 , steel angles 20x20x3mm , elect rodes welding rod , steelsheet carbon sprinh , nails steel wire round 40mm , cable elect p v c insulated , sheet cellular 37mm