Latest tape changer Tenders | Government tape changer Tenders

Central Government/Public Sector

CTN :45735703

06 Jul, 2026 NA

Jhansi - Uttar Pradesh

Tender For supply of set of spares for m/s. medha make vigilance control device for 25 kv tap changer locomotive as per consisting of 01 no.main unit and 02 no. cab unit as per rdso spec. no. rdso/2008/el/spec/0025/rev.-6 (june-2019) and confirming to rdso ms no.rdso/2016/el/ms/0450 (rev-0) dt.19.05.2016 [ warranty period: 30 months after the date of delivery ] ]

CTN :45733165

07 Jul, 2026 NA

Multi City - West Bengal

Tender For auction sale of depot non ferrous scrap - lot no.p.nfa-1.bin no- 2/a ,7/a & ground floor at near bin -37.exmp.06.2026-27.03 description- scrap aluminium with iron attachment, and other aluminium casting, field coil, lamp caps, aluminium boring etc. our offer: a) scrap aluminium with or without iron attachment. such as- scrap aluminium cylinder for tap changer, aluminium number plate, aluminium feeder wire, steady arm, anti wind clamp, wiper motor, bus bar connector (aluminium), part of filter element of emu motor coaches, compressor & air dryer spares, horn, gauge cover, piston sub assembly, and other aluminium misc.as in the lot which are kept in bin no-2/a & ground floor of near bin 37. qty= 1929 kgs. b) scrap aluminium rear & front cover with or without rubber and grease attachment. in bin no- 7/a . qty- 2462 kgs. loading will be done by purchaser's own arrangment.

CTN :45679372

02 Jul, 2026 20.16 Lacs

Delhi - Delhi

Tender For supply and replacement of defective parts of kirloskar make transformers of 1000/750/500 kva capacity at ugc & cag building, new delhi. - supply and fixing of over current earth fourth relay 24 dc l&t make etc complete as reqd. , supply and fixing of 11 kv indoor single phase resin cast current transformer 300/5amp etc complete as reqd., , supply and fixing of transformer 500 kva 11/0.433 kv wt1 scanner & rtd sencer lead., , supply & installation of suitable rating of 500 kva 11/0.433 kv lv bussing porcelain or epoxy-cast resin comply with is-1180 complete as required, , supply and fixing of suitable rating of 500 kva 11/0.433 kv lv flexible porcelain or epoxy-cast resin comply with is-1180 complete as required., , dismantling /loading and unloading of 500kva, 11kv/433volt, 3phase, 50hz, cast resin dry type kirloskar make indoor transformer hv/lv coil/core etc and repair of crack in hv/lv winding/core and putting cast resin/resin hardener, reassembling all the dismantle parts accessories confirming to is 11171 and iec 60076 etc including all tests i.e voltage ratio, magnetic balancing, vector group, ir magnetizing current, winding resistance etc complete as reqd., , supply & installation of 630a vcb vacuum interrupter etc complete as reqd., , sh-2 (old cag bldg), , supply and replacement of 750- 1000 kva transformer oil gas kit etc complete as reqd., , checking in 750-1000 kva transformer all type of protection etc complete as reqd., , supply and replacement of lv bushing oil seal in 750-1000 transformer etc complete as reqd. no.ryb) (4, , supply and replacement of hv bushing oil seal in 750-1000 transformer etc complete as reqd. (3 no. r,y, b), , supply and replacement of off load tape changer in 750-1000 kva transformer etc complete as reqd., , replacement of transformer oil in oltc top-up of main tank etc complete as reqd., transformer oil filtration and dehydration of 750 kva & 1000 kva transformer using high-vacuum oil filtration plant, including removal of moisture, dissolved gases, sludge and impurities from transformer oil, circulation of oil through filtration machine, achieving required bdv value, testing before and after filtration, manpower, tools & tackles, consumables, complete as required at site., , complete servicing, overhauling, cleaning, contact checking, lubrication, insulation resistance testing, contact resistance testing, functional testing and commissioning of oil circuit breaker (ocb), complete as required at site., , supply & installation of male contact, , supply & installation of female contact, , supply & installation of over current earth fault relay, , supply & installation of 24 volt dc power pack unit etc complete as reqd., , supply and fixing of transformer wti relay etc complete as reqd.., , supply and replacement of transformer oti relay etc complete as reqd.., , providing and fixing following rating and breaking capacity and pole mccb with thermomagnetic release and terminal spreaders in existing cubicle panel board including drilling holes in cubicle panel, making connections, ics=100% icu and operational voltage 690v etc. as required., , (make: schneider electric-nsx /siemens / lk/ abb/hager)

Central Government/Public Sector

CTN :45682384

01 Jul, 2026 NA

Jhansi - Uttar Pradesh

Tender For supply of set of spares for m/s. medha make vigilance control device for 25 kv tap changer locomotive as per consisting of 01 no.main unit and 02 no. cab unit as per rdso spec. no. rdso/2008/el/spec/0025/rev.-6 (june-2019) and confirming to rdso ms no.rdso/2016/el/ms/0450 (rev-0) dt.19.05.2016 [ warranty period: 30 months after the date of delivery ] ]

CTN :45048307

31 Jul, 2026 NA

Tarapur - Maharashtra

Tender For corrigendum : : supply, installation, testing & commissioning of electrical equipment for dg block 119a of inrp - ht panels (119a)supply, installation, testing & commissioning of indoor type floor mounted, single front, metal clad, 1250 a, 6.6 kv, 3 phase, 3 wire, vcb switchgear panel suitable for a short circuit current of 31.5 ka for 3 seconds, internally arc tested for 31.5 ka for 1 second, comprising of following incoming & outgoing feeders : incoming feeder: 1 no. 1250 a, 3p vcb outgoing feeders: i) 7 nos. 630 a, 3p vcbii) 1 no. 1250 a, 3p vcb as tie feederwith surge arrestors, relays, pts, cts & other necessary accessories including associated structural steel required for complete installation of the panel & equipment earthing of the panel from both the earthing terminals of the panel to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & drawings. reference drg. nos: ip1/119a/05027339/dwg/001/r0 & ip1/119a/05027339/dwg/002/r0(note: terminal box of each incomer of 6.6kv switchboard shall be suitable for terminating 4x3cx400 sq.mm., 6.35/11kv (e), a2xwy cables.), supply of spares for ht panels as per attached spares list mentiond in section c, part ii of tender, 2.5 mva, 6.6/0.433 kv dry type transformers (119a)supply, installation, testing & commissioning of 6.6/0.433 kv, 2.5 mva, dyn11 dry type cast resin transformer having percentage impedance of 8.5% complete with ht cable end box, lt bus duct flange, off load tap changer on ht side with range of +/-5% in steps of 2.5%, wti scanner, ct for restricted earth fault protection and other necessary accessories including associated structural steel required for complete installation of the transformer & equipment & neutral earthing of the transformer from both the earthing terminals of the transformer to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & drawings.reference drg. no. : ip1/119a/05034347/dwg/001/r0, supply of spares for dry type transformers as per attached spares list mentiond in section c, part ii of tender, 2000 kva diesel generator sets (119a)supply, installation, testing & commissioning of 3 phase 2000 kva prime power 433v, 50hz, 0.8 p.f. diesel-generator sets with 110% overload capacity for 1 hr with four (4) stroke inline or vee type cylinder arrangement having engine speed 1500 rpm, 24v electric battery starting system with a provision of interchangeability of battery bank between two dg sets, complete with all auxiliary equipment including amf control panel, auxiliary mcc panels, heat exchanger cooling system, raw water pump, remote radiator with fans on terrace, ms exhaust piping, exhaust structure (maximum 30 m stack), 4 nos. of 3.6 cubic metre fuel day tank outside dg building (for all 4 dg sets) & 1 no. of 990 ltr intermittent tank inside each dg room, ms "c" class fuel piping between engine & fuel tank, dg room accoustic treatment & complete ventilation of dg room, brushless excitation for alternator, one no. 3200 amp 415 v 4p acb, ms structural steel supports/ channels/ angles & other necessary accessories including associated structural steel required for complete installation of the dg & equipment & neutral earthing of the dg from both the earthing terminals of the dg to the nearest earthing grid conductor existing at site using copper conductors of size as per tender technical specifications & necessary statutory clearances from cpcb etc. as required and as per tender technical specifications & drawings. design and construction of foundation for exhaust pipe rack/ structure of dg set is included in the scope of the contractor.reference drg. nos. : i) ip1/119a/05034347/dwg/001/r0ii) ip1/119a/05044831/dwg/003/r0iii) ip1/119a/05044831/dwg/004/r0iv) ip1/119a/05044831/dwg/005/r0v) ip1/119a/05044831/dwg/006/r0, supply of sp

Central Government/Public Sector

CTN :45645873

30 Jun, 2026 NA

Kalyan - Maharashtra

Tender For auction sale of rolling stock - condemned electric loco no. wcam/2p no- 21865, with iron, steel along with all types of ferrous and non-ferrous materials along with waste. r/items - nil items removed for departmental use: a. smoothing reactor sl-30- (02 nos) b. ba frame -02 nos (ctf, reverser, copper busbar, l1-l6 contactor, c-145, shunting contactor, copper pipe, rs1&2. c. transformer with tap changer, radiator etc ( 01 no) d. rps (01 no) e. inhibited tfp oil. f. atfex-01 nos. g. aux machines (mph) 01 nos. h. spares of siv. i. different released relays-50 nos. j. battery charger and other electronic items-01 no. remark: 1. electric loco is sold on as is where is basis along with wheel sets and trolleys. 2. lot no is painted on the loco. 3. lot is sold on number basis. 4. approach road is available up to the lot. 5. cutting is allowed for easy loading. 6.loco is at present placed in kalyan els yard behind the old auxiliary section in the custody of sse/store/trs/els/kalyan and at the time of handing over loco will be placed on suitable cutting line at els/kalyan. 7. stock holder will be fully responsible for any addition, deletion, alteration, and variation after joint inspection report. 8. purchaser has to personally visit the site and see the lot. no claim will be entertained after sale of lot. 9. purchaser has to keep fire safety equipment/items i.e. water/sand/fire extinguisher etc. at the cutting site. 10. lots are ok for sale on above observations. note:- purchaser should ensure to clean the cutting line premises of scrap loco before final delivery. location : lying at els/kyn stock holder : sse/store/els/trs/kyn

Central Government/Public Sector

CTN :45548247

17 Jun, 2026 NA

Jhansi - Uttar Pradesh

Tender For supply of set of spares for m/s. medha make vigilance control device for 25 kv tap changer locomotive as per consisting of 01 no.main unit and 02 no. cab unit as per rdso spec. no. rdso/2008/el/spec/0025/rev.-6 (june-2019) and confirming to rdso ms no.rdso/2016/el/ms/0450 (rev-0) dt.19.05.2016 [ warranty period: 30 months after the date of delivery ] ]

Central Government/Public Sector

CTN :45396077

08 Jun, 2026 NA

Jhansi - Uttar Pradesh

Tender For supply of set of spares for m/s. medha make vigilance control device for 25 kv tap changer locomotive as per consisting of 01 no.main unit and 02 no. cab unit as per rdso spec. no. rdso/2008/el/spec/0025/rev.-6 (june-2019) and confirming to rdso ms no.rdso/2016/el/ms/0450 (rev-0) dt.19.05.2016 [ warranty period: 30 months after the date of delivery ] ]