Tender For supply installation testing commissioning of dg set, 10 kva, 3 phase, 415 volts, 10.4 amp, 50 hz, 1500 rpm, air/liquid cooled diesel engine. kirlosker. type da 01. suitable for lifting plateform of 8 wheeler tower wagon.make- kirlosker, general motor volvopanta , with remote sencering system. or better or similar firm should integrated the item with existing system [ warranty period:30 months after the date of delivery ]
Tender For supply of air blower tangential motor (right hand side) insulation class h conforming to rcf specification no. edts-130, rev-b, corr- 6 suitable for hot case of lhb type ac coaches. make- cat no.qlz06/0030 (rh) of m/s ebm-nadi or equivalent of m/s. rosenberg/ reiber/ fergas only. [ warranty period: 30 months after the date of delivery ]
Tender For centrifugal blower double inlet complete (type-1) with fan motor supply voltage of fan motor -415v +/- 10%,3-phase, sweep -133mm, rpm1500, frequency - 50 hz, minimum air volume cmh -625, input power (max) -200w, nominal current -0.4 amps. noise level- 60 db, ingress protection (ip): ip-44. suitable for use as exhaust fan in lhb type ac coaches. confirming to rcf specification no. edts -331. amn 1, corrigendum-3. scope of supply: type-1 as per rdso letter no. el/0.6.2/lhb eog ac coaches dated : 07.09.2018. [ warranty period: 30 months after the date of delivery ]
Tender For auction sale of rolling stock - condemned diesel loco no. 36157 wds/6 with iron steel and non-ferrous. restricted items: 1. complete bogie frame with wheel set, axel box and gear case = 01 nos., 2. 03 nos. of wheel sets with axel boxes without gear case = 01 nos. removed items: 1. pneumatic valve and air dryer = 01 nos., 2. radiator core = 01 nos., 3. came shaft = 01 nos., 4. extension shaft = 01 nos., 5. lube oil junction 01 and junction pipe 02 = 01 nos., 6. lube oil cooler pipe = 01 nos., 7. lube oil strainer, bottom pipe and cock = 01 nos., 8. steel balo and upper rode lower = 01 nos., 9. water tank = 01 nos., 10. fuel primary filter body and secondary filter body = 01 nos., 11. sensor loader balo = 01 nos., 12. tsc foundation plate = 01 nos., 13. bubble collector pipe ( z pipe, c pipe) = 01 nos., 14. water temperature gauge, pipe = 01 nos. 15. traction motor = 06 nos. remark: 1. restricted items to be returned to the stock holder in good condition by the purchaser at the time of delivery. 2. lot no. is painted on loco. 3. approach road is available up to lot. 4. hsd oil and lubricants if found to be returned to the stock holder. 5. locos are presently stabled at diesel shed kurla. after auction and before handing over, loco will be placed at cla yard for cutting and delivery purpose. purchaser is advised that loco will be placed only after certification of line by sse/pway/mnkd and as advised by sse/d/cla. 6. after purchaser submit all the documents and d.o after auction to dme/d/cla office, sse/d/cla in consultation with sse/p.way/mnkd will decide the date of placement of loco at cutting yard and only after handing over of loco will be done. 6. purchaser has to ensure safety of railway asset and his labour while working in railway premises. if any losses arise due to negligence, the purchaser will be fully responsible. 7. purchaser has to personally visit the site and see the lot. no claim will be entertained after sale of lot. 9. purchaser has to keep enough water/sand at the cutting site. 10.lot is ok for sale. qty : 01 number. location: presently stabled at diesel loco shed kurla. stock holder: dme d cla .
Tender For provision, commissioning and testing of existing igbt-based three-phase propulsion (medha) non-ac motor coach for conversion into ac-enabled coach, including mounting and installation of rmpus, supply andfitment of stainless-steel trough assembly below rmpus, air-distribution ducting, and drain-water pipe arrangement to ensure zero leakage into passenger area, as per enclosed specification/annexure. note: rmpus, control panel, and necessary roof-wiring cables will be supplied by railways. prior approval of coach ga drawings for rewiring and modification shall be obtained before commencement of work. [ warranty period: 30 months after the date of delivery ]
Tender For corrigendum : supply of motor pulley od-350 mm with 4 nos spc-5300 belts, p. no: 35347010, for 2ha2qt air compressor , pulley for station inst. air compressor motor 98 kw/140 hp having od310mm width 260 mm 6 nos. v belts , pulley for air washery blower motor of unit no. 5 four groove v-pulley section" c" , pulley for air washery blower motor of unit 3 & 4, five groove v- pulley section" c"
Tender For supply of air cooled oil cooler with filter and separate motor for fan & pump suitable for enklo 320 or equiva , spare oil filter, size: micron for the above oil cooler.
Tender For corrigendum : carrying out certain electrical works, networking , epabx system , providing of air conditioners units, motor pump sets and 7.5kva ups in the quarter no 8 at road no 12 banjarahills, hyderabad. part c:providing epabx system (4th call)
Tender For special repair / replacement of motor earthings and replacement of aluminium wire with copper wire at pump houses andstps and special repair/ replacement of sluice valves, air release valves of different sizes and gate valves with connected pipeline
Tender For supply of traction motor air filter suitable for provision in ht cabin of 03 phase medha memu rake dmc as per drg no. icf/sk3-6-4-026. [ warranty period: 30 months after the date of delivery ]