Coupler Tenders

Central Government/Public Sector

CTN :45066238

11 May, 2026 NA

Multi City - Gujarat

Tender For auction sale of depot ferrous scrap - 98050060- scrap released cs and ms carriage and wagon items consisting of cbc components such as side frame, coupler body, bolster, draft gear with without rubber attachechment, yoke, knuckles, coupler rod, face plate, cp top and bottom, spring plank, wedge block, end buffer plunger, cvc, buffer,pulley, springs, ms angles, tie bars, fasteners, axle housing, melting items, pads, wagon census bogies, adopter such as wide jaw and narrow jaw, ingot with or without attachment and other carriage and wagon items etc., if any, unserviceable forrly, the lot is in two stacks. stack 1 is at open plot and stack 2 is at bin 8a/b. delivery of stack 1 will be given first.remark- revision of lot no: 622603003

Central Government/Public Sector

CTN :45066661

20 May, 2026 NA

Chennai - Tamil Nadu

Tender For supply of draft gear with elastomer pads for passenger locomotives(wap-7) fitted with 'h'-type tight lock coupler as per rdso spec. no. mp.0.41.00.06(rev. 0) of december 2008 [ warranty period: 30 months after the date of delivery ]

Central Government / Public Sector

CTN :45061692

11 May, 2026 NA

Multi City - Andhra Pradesh

Tender For auction sale of rolling stock - lot no : 3132604007 1)98110159 (01) (hsn code: 72044900 - gst 18% on fcm basis) scrap of cond. & u/s. 8 wheeler wagons, boxn m1 , bcn m1 , available on rails. 1) ser boxn m1 10079639360 ,2) ser boxn m1 10079666168 3) special repair boxn m1 10069661050, 4) ser boxn m1 10079561883,5) nr bcn m1 30039062397. location road no: 4 . at dump yard. rc items: 1.coupler bodies (nt), 2, yokes 3. knuckles , 4.draft gears, 5.striker castings (nt), 6. centre pivots 7. casnub bogies with out all fittings with wheel sets, 8.break cylinder 355 9.auxilary resivour,10.dustributor valve 11.cp pb with control revioser 12.sab, 13.boxn doors, 14.yoke pin support (1st plate),15. safety plate with anchor plate(2ndplate16.yoke support plate(3rdplate),17.cock of angle cock.18.yoke pin,19)draft gear followers, 20.knuckle pin.21.knuckle thrower.22.bcn swing, 23.bcnflap ds8no:0999603007. dt:.29.04.26. note to purchaser : before delivery of wagon cut off parts, the declared. rc items need to be handed over by the purchaser to sse/scrap at shop floor by transporting through purchaser¿s vehicle/labor approx weight: 47.174 (ms) .mt sold by number basis only.05 nos delivery in cut of parts on lot basis only. note:-if any non ferrous items found in cutting/delivery, purchaser should be handed over to railways. 05 nos.

Central Government/Public Sector

CTN :45058123

21 May, 2026 NA

Nashik - Maharashtra

Tender For supply of hardware items d d - adaptor , quick fix coupler , clip hose jubli clip , rubber hose air pressure , plug gi

CTN :45066527

09 May, 2026 NA

Kharagpur - West Bengal

Tender For supply of shank wear plate for coupler body for upgraded ht cbc. drawing no. : rdsos drg. no. sk. 62724, alt. 31 , item 10. material and specification : as per drawing and conforming to rdsos spec. no. wd-70- bd-10, (rev. 4). [ warranty period: 72 months after the date of delivery ]

Central Government / Public Sector

CTN :45056645

11 May, 2026 NA

Puri - Odisha

Tender For supply of knuckle for h type tight lock coupler for high tensile tight lock center buffer coupler withaar h type head and balanced draft gear. matl. & spec. : rdso specification no. rdso/2011/cg-03, (rev.-3) and frontier's drawing no. fasl/tlc/k/0506, make- frontier [ warranty period: 30 months after the date of delivery ]

CTN :44938298

04 May, 2026 NA

Dimapur - Nagaland

Tender For bid to ras supply of shelter constr mtrls ppr elect and furniture items for office shelter e e - 5 sqmm dia conf to isi marked , pvc sheathered unarmoured standrad copper conductor cable of size 4 sqmm dia conf to isi marked , modular switch piano type5 amp isi marked , modular switch outlet socket multipurpose 3 pin 15 amps by 3 pin 6 amps flush button type , pvc switch board of size 10 inch into 12 inch conf to isi 14772 , pvc switch board of size 8 inch into 10 inch conf to isi 14772 , pvc switch board of size 7 inch into 4 inch conf to isi 14772 , cealing rose surface bakelite 65 into 50mm 2 to 3 terminals , flexible pipe pvc heavy duty isi marked , pvc pipe 20mm dia heavy duty isi marked , pvc elbow 20mm dia pvc pipe , pvc space bar sadles for 20mm dia pvc pipe , pvc coupler for 20mm dia pvc pipe , pvc tee for 20mm dia pvc pipe , pvc casing capping 25mm conf to is , pvc coupler for 25mm casing capping , pvc tee for 25mm dia for casing capping , pvc socket for casing capping 25mm conf to is , pvc elbow for casing capping 25mm conf to is , pvc corner bend for casing capping 25mm conf to is , pvc junction box two way 20mm conf to is , pvc junction box three way 20mm conf to is , pvc junction box four way 20mm conf to is , pvc junction linker 75 into 75 mm , house service bracket hook type complete with 3mm long gi pipe 40mm dia , mcb db 8 way spn 240 volt , mcb 10 a sp 240 volt , mcb 20 amp sp 240 volt , mcb 40 dp 240 volt , insulation tape 3 by 8 inch 9 mtr roll , black screw full threaded 1 inch 500 nos in each pkt , black screw full threaded 1 point 5 inch 500 nos in each pkt , black screw full threaded 2 inch in each pkt , no 8 into 75 bolt and nuts full threaded , stone boulders 63 to 150mm graded conf to is 383 to 1970 , nails 4 inch long , ply wood 12mm thick size 8 feet into 4 feet , 110 mm dia pvc pipe ldpe of rating 6 kg for weep holes , perforated drainage cover 600 into 750 into 75mm thick , wooden runners 2 inch into 2 inch , office chair as per tech specification given in appx e , writing table as per tech specification given in appx e , water dispenser as per tech specification given in appx e , afo automatic fire ball with stand as per ts given in appx e , power coated or textured almirah steel large as per ts given in appx f

Central Government/Public Sector

CTN :45054943

11 May, 2026 NA

Multi City - Tamil Nadu

Tender For auction sale of depot ferrous scrap - pl no: 98050126. condemned and unserviceable ferrous melting scrap consisting of side buffer plungers, buffer casings with/without spindle, knuckles and coupler yoke for cbc,end shields,control arms,connecting rods, axle boxes, axle box housings with or without original attachments, bmbc components ,side bearer covers,gear wheels of sizes ,screw couplings and its link parts, bearing cover casings,grease collors,tensioning rods,anchor links with or without silent blocks, brake shoes with or with out brake blocks, draw hooks, draw beams,draft keys,iron pulleys, pipes of sorts and sizes, spacers,sims,washers, bolts,nuts, studs,pins, brackets,brake shoe keys, metal rings, rods of sorts and sizes, cotter pins, full/broken coil springs, hanger blocks, iron balls of roller bearings and its inner and outer spacers, huck bolts,huck bolt tails , ms plate cuttings, traction motor end shields, end locking screws ,bearing racers, locking plates, bearing adapters,valves of sorts and sizes , brake rigging components, ctrb bearings and its components, connecting rod assemblies, buffer plunger full assemblies , valve springs , buffer spindles, axle box covers, angle cut pieces , main bearing caps, connection straps, cam shaft parts, cut off angle cocks, bss hanger pins, pull rods,damper brackets,center pivot top and bottom parts,cbc couplers,compensating beams,bearing housings/axle box caps, transmission bars, right angle gear covers, cr tanks,traction motor components , vibration dampers, gate valves, isolating valves, ball joint traction lever,tm motor ip cores,cooler headers,roll links,traction centers, liner sleeves,air duct assemblies,brake headers, and other similar items melting in nature.note: 1] crane loading is permitted. 2] if any non ferrous items found, should be removed and returned to railways by the purchaser.

Central Government/Public Sector

CTN :45056956

12 May, 2026 NA

Valsad - Gujarat

Tender For supply of 13 pin uic coupler plug assembly consists of 1.3 meteres cables and polyamide hose with uic plug on both ends as per rdso modification sheet no. rdso/pe/ms/ac/0051-2011 rev-2. note: uic plug as per clw drawing no-clw/es/3/ sk-4/0047/e similar to schaitbau part no-uic st 13 p eo d2 and polyamideconduit as per rdso specification rdso/ pe/spec /ac-0138-2009 rev-2 or latest [ warranty period: 30 months after the date of delivery ]

Central Government/Public Sector

CTN :45012718

06 May, 2026 NA

Chandrapur - Maharashtra

Tender For supply of set of spare parts of h-type cbc, each set consisting of the following items as per drawing no.h5502f: (1) lock, as per part no.h40ae-01 no.(2)double rotary lock lift assembly , as per part no.h16a-01 no.(3) knuckle pivot pin , as per part no.h16 mp-c10-n-01 no.(4) clevis, as per partno.c50690-01 no.(5) cotter pin, as per part no.016mp-ch-n.-01 no.(6) knuckle, as per part no.h50be-01 no. (item should be interchangeable with fas make h-type tight lock coupler). [ warranty period: 30 months after the date of delivery ]

By Cities

By States

By Agencies

By Ownerships

By Sectors