Get complete information related to latest Evaporator Tenders . from India at Classic Tenders. Search the best available tenders from Indian government tenders, domestic Evaporator Tenders , private tenders, online tenders, tender invitation notice, business tender notices, online tenders and bidding Evaporator Tenders.
Tender For corrigendum : procurement of electronic spare parts of chlorinators installed at 2x600mw, sstpp, mppgcl, dongalia - "chlorine gas flow indicator, rotameter type. accuracy +/- 4 %material- acrylic, 40mm x 300 mmtube: borosilicate glass, float: ptferange- 18-180 kg/hr, least count 18 kg/hr", "water level indicator for evaporator,process connection- npt (m) both sidehose pipe with (f). material-borosilicate glass tube with brass material for process connection.", "chlorine gas flow indicator, rotameter type accuracy +/- 4 %material- acrylic, 25mm x 300 mmtube: borosilicate glass, float: ptferange- 0-11 kg/hr, least count 1 kg/hr", "water level indicator, evaporator,process connection- npt (m) both side, hose pipe with (f).material-borosilicate glass tube with brass material for process connection."
Tender For supply, installation, testing & commissioning of floor mounted potable water purification sys tem with inbuilt drinking water cooler ro + uv, storage tank- inbuilt, storage tank capacity up to float val ve level- 120 ltr. capacity, material of water storage tank- stainless steel ss 304, conformity to standard f or ultraviolet system-is 14724 (latest) for water purification system with ultraviolet disinfection, output wa ter conforming standard-is 10500 (latest), power consumptions -775 watt, maximum input water tds allo w to the system- 2000 tds, operation mode- fully automatic with auto cut off, ro membrane rating- 80 gp d, type of compressor- rotary/reciprocating, cooling capacity: 40 ltr./hr., single phase 230/240 volt 50 hz , filtration water capacity - 80 ltr/hour, type of condenser-fin type/tube type, evaporator material- copper , water storage tank insulation- puf thermal insulation, number of cold water faucets- 1 no, number of no rmal water faucets- 1 no [ warranty period: 12 months after the date of delivery ]
Tender For supply and commissioning of oil chiller unit with the following specification: (1) rated operat ing voltage: 3phase, 415 v ac, 50 hz (2) nominal cooling capacity: 9,000 kcal/h/10.4 kw/3.0 tr (3) refrige rant used: r-407c or any environmental friendly refrigerant with lesser gwp. (4) medium of cooling hydrau lic oil viscosity grade: is0 vg 32 to 68 cst @ 40-degree c (5) duty type: indoor, continuous duty type (6) p umping capacity: minimum 40 lpm, geared pump with 3 phase, 415 v ac, motor (7) tank: without storage tank (8) temperature range ambient: +15-degree c to +45-degree c (9) temperature range of medium: + 15-degree c to +35-degree c (10). oil connection both suction & delivery: 1" bsp (11) type of enclosure: i ndustrial enclosure (12) compressor: hermetically sealed, air cooled, reciprocating/scroll compressor. (13 ) condenser: air cooled condenser, made of copper tube with aluminium fins, air inlet from the side & air o utlet on the top. (14) evaporator: stainless steel brazed plate heat exchanger (15) drier: filter drier (16) ex pansion device: expansion valve (17) pressure switches: low/high pressure switches (18) temperature co ntroller cum display unit: microprocessor based, programmable controller with digital display (19) auxiliary contact: potential free contact for general alarm 1 no & 1nc (20) motor protection: all motors with motor p rotection circuit breaker (mpcb). (21) conforming to ce compliance. [ warranty period: 12 months after t he date of delivery ]
Tender For tender for supply of lfh cable uniflex single core 1 sq.mm , teflon cable flu-tef single core 1 sq.mm , push button teknic 22.5 dia black(for reset) , cable gland size 6 , vibration eliminator for suction line , o ring star locating pin , main rotor , control transformer pri 0 to 415 v ac sec 0 to 230v ac 8a , vibration eliminator for liquid injection line , control transformer tape wound 415 v/110 v 150 va , set capacity regulator 24 v dc , set shut-off valve nw32 part no 08082 , setcrank shaft part no. 08056 , valve globe type 7/8inch ods , kit for power contactor for compressor stater , hrc fuse link ge ns4 4a with nh type fuse base , thermostatic exp. valve gfe-1.1/2jc charge 1/4inch x 1/2inch flare , hooter ems 0001016 24 v dc , set connecting rod part no. 08307 , set of bearing for 7.5 kw motor for 2x2.1 tr ref plant , vibration eliminator 1-3/8inch ods , evaporator pressure regulator sporlan ori(t)10 , aux contactor ge rl4 rd022td 2 no + 2nc coil -24v dc , mpcb ge 0 1.6a with 1no + 1nc contacts , valve angle type 1/4inch ntp(m) x 1/4inch flare , valve globe type 7/8inch ods , cooling fan , vibration eliminator 1-1/8inch ods , kit for power contactor for acu fan stater , power contactor ge 0 32a 415 v ac 3 pole , set oilsump heat 80w 220-240v part no.08425 , pres transmitter danfoss mbs 3100-2211-1ac04 range 0-16 bar , set of v belts , valve plate assembly part no 08436 , kit for power contactor for sw pump stater , vibration eliminator 7/8inch ods , thermostatic exp. valve gfe-1/2jc charge 1/4inch x 1/2inch flare , mcb ge 0 32a , valve globe type 1/2inch ods , valve three way type 1/4inch npt(m) x 1/4inch flare , set oil pump part no. 08044 , set of gaskets for condenser for 2 x 2.1 tr ref plant , vibration eliminator 5/8inch ods , set of bearing for 1.5 kw motor for 2x2.1 tr ref plant , set gaskets part no. 08072 , pres transmitter danfoss mbs 3100-2411-1ac04 range 0 -25 bar , temp transmitter mbt 5560-0000-0200-10-415 range - 50-150 c , set shaft seal part no. 08008 , coil for power contactor for compressor stater , safety valve 1/2inch npt(m) set pressure 12.5 kg/cm2 r134a , valve angle type 1/2inch ntp(m) x 1/2inch flare , bridge rectifer ems 0011132 25a , set piston dia 70 part no. 08035 , coil for power contactor for sw pump stater , coil for power contactor for acu fan stater , valve hand shut off type 1/4inch flare , set of push buttons (one of each type) for lcp , sea water pressure differential switch , ss needle valves 1/4inch , non return valve 3.5/8inch , fuses 1 amp 400v , compressor gauge , set of gasket ac-470 compr , gasket , crank shaft , lp-op cutout mp55r(r12-r22) , bolt hex head , three way valve 1/4inch , thermostatic expansion valve , oil filter , screw driver 10inch , pipewrench 10inch , temperature transducer , pressure transducer , ring end spanner set , angle valve 1/2inch , safety relief valve for condensor , compressore discharge pressure gauge , brg ball deep groove 55x90x18 , pump trailing (pompe pollard) type 100 pr.60.100 c.g.n. , element complete with o ring , hub clutch , spacer , gear output , key , key parallel , hose 1 1/4 bsp(f) , lock nut m 120x2 km24 , bearing spherical roller(skf24124/cc/w33) , pump assembly , gasket , o ring , temp switch , gasket , rubber bonded washer , washer plain steel , assly. union screw socket , main pump , gasket , ring piston outer , seal kit for filter assly , pressure switch xml a 0037 , heat exchanger , p.r.v , press gauge(lub) , gasket , plate lock , washer plain steel , o-ring viton 42.5x36.5x3xc , flexible gas charging line , steel foot rule 12inch , flaring tool kit , connector 1 8inch mpt x1/4inch sae , charging adopter 3 4inch fpt x 1 4inchsae , copper tube 1 4inchx 2mtr , connectors 1 4inch mpt x 1 4inch sae , indication lamp amber , set of push buttons (one of each type) for lcp , set of indication lamps (one of each type) for lcp , semi conductor fuses ge / feraaz 200a , 6.611 rd30-xx0315 , mc mccb ge 100a s 400a , with aux contact 2no+2nc
Tender For bailing out of sludges and precipiates in dm plant n pit cleaning of effluent sludges and precipiates deposited in solar evaporation pond and clearing of heavy jungles around solar evaporation ponds
Tender For supply of rubber goods items - rubber strip for dorr scrapper as per our drg.no.b-38/82 enclosed. , rubber sheet for juice heater double beat valve as per our drg.no.101/90 , enclosed sore hardness 60-65. , discharge valve rubber seat for pan no.4 & 7 as per our drg.no.b 21/81r , rubber strip for c/f. m/c of size width - 70mm, thickness, 6mm , rubber seat for main hole drg. no. b-68/86 , rubbber bush as per drg. no. 25/82 dholak type , 18.25mmidx40mmodx35mm long. , rubbber hose pipe for vacuum filter id 2-1/2"xlengtyh 1-1/2". , rubber taper plug fore evaporator tubes plugging sutiable for 42/45 m.m. , tubes , rubber taper plug fore evaporator tubes plugging sutiable for 39/42 m.m. , tubes , rubber taper plug fore evaporator tubes plugging sutiable for 98/102 m.m. , tubes , rubber seat for quad man hole as per drg.no. b-209/2000 , #name? , rubber seat for pan condensor as per skech no.b/248/2012 , rubber seat for pan condensor as per spary box strainer skech no.479/24 , rubber seat for pan main hole as per skech no. b/272/2003 for pan , no.01,03,05,06 & 07 (5 nos) , rubber seat for exhaust valve of pan no.2 vapour cell & semi kestner as per , drg. no.b294/2005. , rubber star for star coupling sl-100 of p.g. drive , rubber buffer for lever support of juice weighing scale drg. b-79/88 , rubber seat for juice weighing scale drg. b-85/89r , rubber seat for condenser drg b-348/2012 , water weighing scale valve rubber sheet drg. no. kcsf 154/85 , rubber coupling for sugar grader , telescopic value rubber seat as per drg. b111a/91 , rubber sheet for water weighing scale ( top & bottom) drg. b-354/2014 , & 366/2015 , mud seal for clarifier as per drg. no 71/82 r1 , rubber strip for vibro screen as per sample , neop rubber bucket with m.s. plate as per sample big size , rubber o' ring size 362x4mm , do but size 188x6mm , do but size 217x6 mm , rubber screwzzer for clearifier 30"x3"x3/4" , rubber bush for cane leveler as per drg no m-6/81 r , rubber tyre complete tc-10 , rubber tyre tc-10 , rubber tyre ph-116 , rubber spare tyre for c/f m/c as per sample tc-022 , mill hydraulic bucket size 303/300mm as per drg no kcsf 359/2018 , hardness 85-90 0 , rubber strip 75mm(width)6mm thick , rubber strip 50mm( width) x5mm thick , rubber ( as per sample) nk-1100 c/f machine , tyre coupling complete tc-11 , rubber tyre coupling spare tyre tc-013 , rubber strip as per drg & as per sample dynamic juice heater , neoprone rubber strip or semikesner as per sample , neoprone rubber seat 335x200x20 , rubber seat ( 550x400x25mm) , rubber seat ( 600x450x25mm) , rubber seat ( 900x750x25mm) , rubber seat ( 950x800x25mm) , neoprene rubber strip for nk-1100 c/f m/c as per sample , neoprene rubber strip for nk-1500 c/f m/c as per sample , neoprene rubber strip for nk-1350 c/f m/c as per sample , rubber sheet for 3 angle valve as per drg. 420/2021 , rubber sheet for 4 angle valve as per drg. 420/2021 , rubber sheet for 6 angle valve as per drg. 420/2021 , rubber seat ( 650x500x25mm) , rubber star l-75 , rubber mud seas as per sample , rubber seat for main hole size 540x425x20mm , rubber seat for main hole size 550x440x20mm , rubber seat for main hole size 540x440x20mm , rubber seat for main hole size 340x200x25mm , rubber seat for pan pneumatic cut over valve size 8 puri make for pan , no.05/06 & 08 ( 210x135x20mm) , rubber seat for pan pneumatci cut over valve size 10 puri make for pan , no.01/02 & 03( 265x175x20mm) , rubber seat for pan pneumatic discharge valve size 20 ( puri make) for , pan no.02/05 & 8( 550x430x22mm) , rubber seat for pan pneumatic discharge valve size 24 ( puri make) for , pan no.01 & 03 ( 655x490x25mm) , tyre for coupling t.c 0-20 , tyre for coupling t.c 120 , rubber sheet size 235x30x12 mm thik. for all j.h double beat valve and , glove valve , rubber sheet for man hole 530x430x25mm thik. , rubber sheet 850x730x25mm thik. for ezehaust valve of s.k x v.c m.o.cs. , b.r , canvas belt 8 ply width 6" tot